519 research outputs found
Effect of Preliminary Torsional Strain on Low-Cycle Fatigue of Q345B Structural Steel
Effect of preliminary torsional strain on low-cycle fatigue of Q345B steel was studied. The specimens were first 0, 180, and 360° twisted, then the low-cycle fatigue of Q345B steel was evaluated in the strain range of 0.3–0.8% by the method of axisymmetrical strain. The cycling response, cyclic stress–strain relationship, strain–life relationship, fatigue life prediction model, and seismic stability at different torsion angles were obtained and analyzed. The strain–life curve is shown to slope down as a power function. The fatigue life comes down with preliminary torsional strain at a constant level. The cycling response varied from cyclic hardening to cyclic softening in preliminary torsion, and the cyclic hardening rate increased linearly with the strain amplitude. The parameters of the Coffin–Manson relation are corroborated with experimental data. After heat treatment, the seismic stability of the material is improved, with torsional strain greatly reducing this characteristic. Electron microscope examination of fatigue fracture revealed a fatigue crack initiating on the surface of the specimen. The propagating crack deviated from its direction, and plasticity of the material dropped as a result of preliminary torsional strain.Изучено влияние деформации предварительного кручения на малоцикловую усталость стали Q345B. Вначале образцы скручивали на 0, 180 и 360°, затем методом осесимметричной деформации определяли малоцикловую усталость стали Q345B в диапазоне деформаций 0.3 0.8%. Получены и проанализированы характеристика циклических изменений, зависимость циклического изменения напряжения от деформации, зависимость деформация долговечность, модель прогнозирования усталостной долговечности и сейсмостойкость при различных углах кручения. Показано, что кривая деформация долговечность идет вниз и описывается степенной функцией. Усталостная долговечность снижается с увеличением деформации предварительного кручения при постоянном уровне последней. Характеристика циклических изменений варьировала от циклического упрочнения до циклического разупрочнения при кручении, скорость циклического упрочнения возрастала линейно с повышением амплитуды деформации. Параметры зависимости Коффина Мэнсона подтверждаются экспериментальными данными. После термообработки сейсмостойкость материала улучшается, при этом деформация предварительного кручения существенно снижает ее. Электронно-микроскопическое исследование усталостного разрушения выявило зарождение усталостной трещины на поверхности образца. Растущая трещина отклонялась от своего направления, пластичность материала снижалась в результате деформации предварительного кручения.Вивчено вплив деформації попереднього кручення на малоціклову втому стали Q345B. Спочатку зразки скручували на 0, 180 і 360 °, потім методом вісесиметричної деформації визначали малоціклову втому стали Q345B в діапазоні деформацій 0.3-0.8%. Отримано і проаналізовано характеристику циклічних змін, залежність циклічної зміни напржень від деформації, залежність деформація-довговічність, модель прогнозування втомної довговічності і сейсмостійкості при різних кутах кручення. Показано, що крива деформація - довговічність йде вниз і описується ступеневою функцією. Втомна довговічність знижується зі збільшенням деформації попереднього кручення при постійному рівні останньої. Характеристика циклічних змін варіювала від циклічного зміцнення до циклічного знеміцнення при крученні, швидкість циклічного зміцнення зростала лінійно з підвищенням амплітуди деформації. Параметри залежності Коффина-Менсона підтверджуються експериментальними даними. Після термообробки сейсмостійкість матеріалу поліпшується, при цьому деформація попереднього кручення істотно знижує її. Електронно-мікроскопічне дослідження втомного руйнування виявило зародження втомної тріщини на поверхні зразка. Зростаюча тріщина відхилялася від свого напрямку, пластичність матеріалу знижувалася в результаті деформації попереднього кручення
The ARGO-YBJ Experiment Progresses and Future Extension
Gamma ray source detection above 30TeV is an encouraging approach for finding
galactic cosmic ray origins. All sky survey for gamma ray sources using wide
field of view detector is essential for population accumulation for various
types of sources above 100GeV. To target the goals, the ARGO-YBJ experiment has
been established. Significant progresses have been made in the experiment. A
large air shower detector array in an area of 1km2 is proposed to boost the
sensitivity. Hybrid detection with multi-techniques will allow a good
discrimination between different types of primary particles, including photons
and protons, thus enable an energy spectrum measurement for individual specie.
Fluorescence light detector array will extend the spectrum measurement above
100PeV where the second knee is located. An energy scale determined by balloon
experiments at 10TeV will be propagated to ultra high energy cosmic ray
experiments
High Altitude test of RPCs for the ARGO-YBJ experiment
A 50 m**2 RPC carpet was operated at the YangBaJing Cosmic Ray Laboratory
(Tibet) located 4300 m a.s.l. The performance of RPCs in detecting Extensive
Air Showers was studied. Efficiency and time resolution measurements at the
pressure and temperature conditions typical of high mountain laboratories, are
reported.Comment: 16 pages, 10 figures, submitted to Nucl. Instr. Met
Search for the Lepton Flavor Violation Processes and
The lepton flavor violation processes and are
searched for using a sample of 5.8 events collected with
the BESII detector. Zero and one candidate events, consistent with the
estimated background, are observed in and
decays, respectively. Upper limits on the branching ratios are determined to be
and at the 90% confidence level (C.L.).Comment: 9 pages, 2 figure
The pole in
Using a sample of 58 million events recorded in the BESII detector,
the decay is studied. There are conspicuous
and signals. At low mass, a large
broad peak due to the is observed, and its pole position is determined
to be - MeV from the mean of six analyses.
The errors are dominated by the systematic errors.Comment: 15 pages, 6 figures, submitted to PL
Direct Measurements of the Branching Fractions for and and Determinations of the Form Factors and
The absolute branching fractions for the decays and
are determined using singly
tagged sample from the data collected around 3.773 GeV with the
BES-II detector at the BEPC. In the system recoiling against the singly tagged
meson, events for and events for decays are observed. Those yield
the absolute branching fractions to be and . The
vector form factors are determined to be
and . The ratio of the two form
factors is measured to be .Comment: 6 pages, 5 figure
Observation of the decay \psip\rar\kstark
Using 14 million events collected with the BESII detector,
branching fractions of \psip\rar\kstarkpm and \kstarknn are determined to
be: \calB(\psip\rar\kstarkpm)=(2.9^{+1.3}_{-1.7}\pm0.4)\times 10^{-5} and
\calB(\psip\rar\kstarknn)=(13.3^{+2.4}_{-2.7}\pm1.9)\times 10^{-5}. The
results confirm the violation of the "12%" rule for these two decay channels
with higher precision. A large isospin violation between the charged and
neutral modes is observed.Comment: 5 pages, 3 figure
Single Spin Asymmetry in Polarized Proton-Proton Elastic Scattering at GeV
We report a high precision measurement of the transverse single spin
asymmetry at the center of mass energy GeV in elastic
proton-proton scattering by the STAR experiment at RHIC. The was measured
in the four-momentum transfer squared range \GeVcSq, the region of a significant interference between the
electromagnetic and hadronic scattering amplitudes. The measured values of
and its -dependence are consistent with a vanishing hadronic spin-flip
amplitude, thus providing strong constraints on the ratio of the single
spin-flip to the non-flip amplitudes. Since the hadronic amplitude is dominated
by the Pomeron amplitude at this , we conclude that this measurement
addresses the question about the presence of a hadronic spin flip due to the
Pomeron exchange in polarized proton-proton elastic scattering.Comment: 12 pages, 6 figure
High non-photonic electron production in + collisions at = 200 GeV
We present the measurement of non-photonic electron production at high
transverse momentum ( 2.5 GeV/) in + collisions at
= 200 GeV using data recorded during 2005 and 2008 by the STAR
experiment at the Relativistic Heavy Ion Collider (RHIC). The measured
cross-sections from the two runs are consistent with each other despite a large
difference in photonic background levels due to different detector
configurations. We compare the measured non-photonic electron cross-sections
with previously published RHIC data and pQCD calculations. Using the relative
contributions of B and D mesons to non-photonic electrons, we determine the
integrated cross sections of electrons () at 3 GeV/10 GeV/ from bottom and charm meson decays to be = 4.0({\rm
stat.})({\rm syst.}) nb and =
6.2({\rm stat.})({\rm syst.}) nb, respectively.Comment: 17 pages, 17 figure
Evolution of the differential transverse momentum correlation function with centrality in Au+Au collisions at GeV
We present first measurements of the evolution of the differential transverse
momentum correlation function, {\it C}, with collision centrality in Au+Au
interactions at GeV. {\it C} exhibits a strong dependence
on collision centrality that is qualitatively similar to that of number
correlations previously reported. We use the observed longitudinal broadening
of the near-side peak of {\it C} with increasing centrality to estimate the
ratio of the shear viscosity to entropy density, , of the matter formed
in central Au+Au interactions. We obtain an upper limit estimate of
that suggests that the produced medium has a small viscosity per unit entropy.Comment: 7 pages, 4 figures, STAR paper published in Phys. Lett.
- …