479 research outputs found
Bimanual coordination in stroke recovery: Kinematic analysis provides open leads to individualize upper limb rehabilitation
Design and construction of a Cherenkov imager for charge measurement of nuclear cosmic rays
A proximity focusing Cherenkov imager called CHERCAM, has been built for the
charge measurement of nuclear cosmic rays with the CREAM instrument. It
consists of a silica aerogel radiator plane across from a detector plane
equipped with 1,600 1" diameter photomultipliers. The two planes are separated
by a ring expansion gap. The Cherenkov light yield is proportional to the
charge squared of the incident particle. The expected relative light collection
accuracy is in the few percents range. It leads to an expected single element
separation over the range of nuclear charge Z of main interest 1 < Z < 26.
CHERCAM is designed to fly with the CREAM balloon experiment. The design of the
instrument and the implemented technical solutions allowing its safe operation
in high altitude conditions (radiations, low pressure, cold) are presented.Comment: 24 pages, 19 figure
Recommended from our members
Impact of particles on the Planck HFI detectors: Ground-based measurements and physical interpretation
The Planck High Frequency Instrument (HFI) surveyed the sky continuously from
August 2009 to January 2012. Its noise and sensitivity performance were
excellent, but the rate of cosmic ray impacts on the HFI detectors was
unexpectedly high. Furthermore, collisions of cosmic rays with the focal plane
produced transient signals in the data (glitches) with a wide range of
characteristics. A study of cosmic ray impacts on the HFI detector modules has
been undertaken to categorize and characterize the glitches, to correct the HFI
time-ordered data, and understand the residual effects on Planck maps and data
products. This paper presents an evaluation of the physical origins of glitches
observed by the HFI detectors. In order to better understand the glitches
observed by HFI in flight, several ground-based experiments were conducted with
flight-spare HFI bolometer modules. The experiments were conducted between 2010
and 2013 with HFI test bolometers in different configurations using varying
particles and impact energies. The bolometer modules were exposed to 23 MeV
protons from the Orsay IPN TANDEM accelerator, and to Am and Cm
-particle and Fe radioactive X-ray sources. The calibration data
from the HFI ground-based preflight tests were used to further characterize the
glitches and compare glitch rates with statistical expectations under
laboratory conditions. Test results provide strong evidence that the dominant
family of glitches observed in flight are due to cosmic ray absorption by the
silicon die substrate on which the HFI detectors reside. Glitch energy is
propagated to the thermistor by ballistic phonons, while there is also a
thermal diffusion contribution. The implications of these results for future
satellite missions, especially those in the far-infrared to sub-millimetre and
millimetre regions of the electromagnetic spectrum, are discussed.Comment: 11 pages, 13 figure
Pattern and process in Amazon tree turnover, 1976-2001
Previous work has shown that tree turnover, tree biomass and large liana densities have increased in mature tropical forest plots in the late twentieth century. These results point to a concerted shift in forest ecological processes that may already be having significant impacts on terrestrial carbon stocks, fluxes and biodiversity. However, the findings have proved controversial, partly because a rather limited number of permanent plots have been monitored for rather short periods. The aim of this paper is to characterize regional-scale patterns of 'tree turnover' (the rate with which trees die and recruit into a population) by using improved datasets now available for Amazonia that span the past 25 years. Specifically, we assess whether concerted changes in turnover are occurring, and if so whether they are general throughout the Amazon or restricted to one region or environmental zone. In addition, we ask whether they are driven by changes in recruitment, mortality or both. We find that: (i) trees 10 cm or more in diameter recruit and die twice as fast on the richer soils of southern and western Amazonia than on the poorer soils of eastern and central Amazonia; (ii) turnover rates have increased throughout Amazonia over the past two decades; (iii) mortality and recruitment rates have both increased significantly in every region and environmental zone, with the exception of mortality in eastern Amazonia; (iv) recruitment rates have consistently exceeded mortality rates; (v) absolute increases in recruitment and mortality rates are greatest in western Amazonian sites; and (vi) mortality appears to be lagging recruitment at regional scales. These spatial patterns and temporal trends are not caused by obvious artefacts in the data or the analyses. The trends cannot be directly driven by a mortality driver (such as increased drought or fragmentation-related death) because the biomass in these forests has simultaneously increased. Our findings therefore indicate that long-acting and widespread environmental changes are stimulating the growth and productivity of Amazon forests
Improved annotation of 3' untranslated regions and complex loci by combination of strand-specific direct RNA sequencing, RNA-seq and ESTs
The reference annotations made for a genome sequence provide the framework
for all subsequent analyses of the genome. Correct annotation is particularly
important when interpreting the results of RNA-seq experiments where short
sequence reads are mapped against the genome and assigned to genes according to
the annotation. Inconsistencies in annotations between the reference and the
experimental system can lead to incorrect interpretation of the effect on RNA
expression of an experimental treatment or mutation in the system under study.
Until recently, the genome-wide annotation of 3-prime untranslated regions
received less attention than coding regions and the delineation of intron/exon
boundaries. In this paper, data produced for samples in Human, Chicken and A.
thaliana by the novel single-molecule, strand-specific, Direct RNA Sequencing
technology from Helicos Biosciences which locates 3-prime polyadenylation sites
to within +/- 2 nt, were combined with archival EST and RNA-Seq data. Nine
examples are illustrated where this combination of data allowed: (1) gene and
3-prime UTR re-annotation (including extension of one 3-prime UTR by 5.9 kb);
(2) disentangling of gene expression in complex regions; (3) clearer
interpretation of small RNA expression and (4) identification of novel genes.
While the specific examples displayed here may become obsolete as genome
sequences and their annotations are refined, the principles laid out in this
paper will be of general use both to those annotating genomes and those seeking
to interpret existing publically available annotations in the context of their
own experimental dataComment: 44 pages, 9 figure
Выращивание из поликристаллического кремния солнечного качества квазимонокристаллических (mono-like) слитков методом направленной кристаллизации
In the frame of permanent objective to increase solar cell efficiency and to decrease production cost the monolike ingot process was designed which combine multicrystalline (mc) productivity and monocrystalline structure performances. As a raw material the mc-Solar Grade silicon (SoG-Si) was used because it is less expensive than the Si purified by gas chemical route (Siemens process or equivalent), Usage of the mc-SoG-Si for growing silicon ingots by monolike process should contribute to the ingot and wafer manufacturing cost decrease. SoG silicon using would be developed all the more fast since it enables to produce high efficiency solar cells. It is why the monolike process have been tested and optimized for Kazakhstan mc-SoG silicon. The objective of this work was study of the higher level content impurities influences on the crystal defect generation (mainly dislocations) of the monocrystalline structure. Visual monocrystalline structure, minority carrier lifetime mapping, and photoluminescence techniques were used to study the monolike ingots obtained from Kazakhstan’s mc-SoG silicon.В целях повышения эффективности солнечных элементов и снижение затрат на производство разработан процесс получения слитков кремния, по так называемой mono-like-технологии. Mono-like-процесс предназначен для получения монокристаллических слитков при использовании технологии производства мультикристаллического кремния (МК-Si). При этом в качестве сырья используют поликристаллический кремний (ПК-Si) «солнечного» качества (solar grade — SoG), технология получения которого является менее затратной, чем очистка кремния газохимическим процессом (Сименс-процесс или его эквивалент). Использование ПК-Si SoG для выращивания слитков по mono-like технологии должно способствовать снижению затрат на получение слитков и пластин. Новые технологии производства солнечных элементов, использующие ПК-Si SoG, разрабатываются быстрыми темпами, так как это позволяет производить при меньших затратах солнечные элементы с достаточно высоким КПД. Именно поэтому mono-like-процесс апробирован и оптимизирован для казахстанского ПК-Si SoG. Изучено влияние более высокой концентрации примесей в ПК-Si SoG на образование кристаллических дефектов (главным образом дислокаций) в монокристаллических структурах. Для исследования свойств mono-like слитка, полученного в промышленных масштабах из казахстанского ПК-Si SoG, использованы визуализация монокристаллической структуры, картирование времени жизни неосновных носителей заряда и фотолюминесценция
Survival endpoints in colorectal cancer and the effect of second primary other cancer on disease free survival
<p>Abstract</p> <p>Background</p> <p>In cancer research the selection and definitions of survival endpoints are important and yet they are not used consistently. The aim of this study was to compare different survival endpoints in patients with primary colorectal cancer (CRC) and to understand the effect of second primary other cancer on disease-free survival (DFS) calculations.</p> <p>Methods</p> <p>A population-based cohort of 415 patients with CRC, 332 of whom were treated with curative intention between the years 2000-2003, was analysed. Events such as locoregional recurrence, distant metastases, second primary cancers, death, cause of death and loss to follow-up were recorded. Different survival endpoints, including DFS, overall survival, cancer-specific survival, relapse-free survival, time to treatment failure and time to recurrence were compared and DFS was calculated with and without inclusion of second primary other cancers.</p> <p>Results</p> <p>The events that occurred most often in patients treated with curative intention were non-cancer-related death (n = 74), distant metastases (n = 66) and death from CRC (n = 59). DFS was the survival endpoint with most events (n = 170) followed by overall survival (n = 144) and relapse-free survival (n = 139). Fewer events were seen for time to treatment failure (n = 80), time to recurrence (n = 68) and cancer-specific survival (n = 59). Second primary other cancer occurred in 26 patients and its inclusion as an event in DFS calculations had a detrimental effect on the survival. The DFS for patients with stage I-III disease was 62% after 5 years if second primary other cancer was not included as an event, compared with 58% if it was. However, the difference was larger for stage II (68 vs 60%) than for stage III (49 vs 47%).</p> <p>Conclusions</p> <p>The inclusion of second primary other cancer as an endpoint in DFS analyses significantly alters the DFS for patients with CRC. Researchers and journals must clearly define survival endpoints in all trial protocols and published manuscripts.</p
Active and Passive Radiative Transfer Modeling of the Olympic Mountains Experiment
Sensor forward models are an important tool for interpreting remote sensing observations of geophysical phenomena. By implementing a three-dimensional framework, we can simulate and analyze observations from various sensors on disparate platforms. To demonstrate our model framework, we simulate observations from the Olympic Mountains Experiment (OLYMPEX). The use of cloud model simulations allows us to understand sensor response to cloud ice, falling snow, and other processes and features, and the application of model tools to observations allows us to quantify precipitation.MIIST 3D Forward ModelThe Multi-Instrument Inverse Solver Testbed(MIIST) uses the Atmospheric Radiative TransferSimulator (ARTS) for solving the vector radiativetransfer (RT) equation in up to three spatialdimensions within a spherical geometry Gas absorptiono Line-by-line calculationso Fast transmittance tables Hydrometeor scattering solverso Discrete ordinateo RT4 (Evans, 1D)o Radar Single Scattering (1D or 3D)o Monte Carlo (3D)Scattering TablesHigh-fidelity hydrometeor scatteringtables are necessary for accurateand consistent forward modeling ofmulti-frequency observations Requires full Stokes matriceso And absorption vector Randomly oriented particleso Discrete Dipole Approximationo Characteristic Basis Function Method(coming soon) Horizontally-oriented plateso Invariant Imbedding T-matrix MethodCloud Resolving SimulationsCloud resolving simulations (e.g.,NU-WRF) supply output consistentwith ARTS needs Atmospheric Informationo Temperatureo Pressure / heighto Water vapor Hydrometeor Profileso ARTS architecture ripe for explicit binmicrophysics Examples use Morrison 2M schemeThe Olympic Mountains Experiment (OLYMPEX)Validation for GPM of mid-latitudefrontal systems approaching nearcoastalmountains from the ocean Large collection of ground-based andairborne sensorso Radarso Radiometerso In situ Contemporaneous with RADEXo Two sets of radar at same frequenciesRadiometer Simulation (3 km NUWRF, 20151203, 15:00)2018.12.14 7Simulate 166 GHz polarizationdifference Corresponds to the presence of aligned icecrystals Look at trends for both simulations andobservations Simulations can tolerate lower resolutiono Larger domainSimulations from Observations: OLYMPEXSimulate sensor response usinggeophysical retrievals as input Single frequency radar retrievals Multiple scattering enhancementapparent at W band Spatially dependent phenomenonModeling Application: 1D Retrievals03 December 2015 DC-8 and ER-2 flightso Focus on APR-3 (DC-8) Citationo Stacked microphysics legso Qualitative comparisonso Range of frozen habitso Presence of supercooledliquid cloudsResults Retrievals match probeso Good qualitative match Bands of increasedreflectivity correspond tolarge Dm and highaggregate fraction Significant amounts ofsupercooled liquid wate
Recurrence of Dupuytren’s contracture: A consensus-based definition
Purpose: One of the major determinants of Dupyutren disease (DD) treatment efficacy is recurrence of the contracture. Unfortunately, lack of agreement in the literature on what constitutes recurrence makes it nearly impossible to compare the multiple treatments alternatives available today. The aim of this study is to bring an unbiased pool of experts to agree upon what would be considered a recurrence of DD after treatment; and from that consensus establish a much-needed definition for DD recurrence. Methods: To reach an expert consensus on the definition of recurrence we used the Delphi method and invited 43 Dupuytren’s research and treatment experts from 10 countries to participate by answering a series of questionnaire rounds. After each round the answers were analyzed and the experts received a feedback report with another questionnaire round to further hone in of the definition. We defined consensus when at least 70% of the experts agreed on a topic. Results: Twenty-one experts agreed to participate in this study. After four consensus rounds, we agreed that DD recurrence should be defined as “more than 20 degrees of contracture recurrence in any treated joint at one year post-treatment compared to six weeks post-treatment”. In addition, “recurrence should be reported individually for every treated joint” and afterwards measurements should be repeated and reported yearly. Conclusion: This study provides the most comprehensive to date definition of what should be considered recurrence of DD. These standardized criteria should allow us to better evaluate the many treatment alternatives
- …