284 research outputs found
Expectations and intertemporal separability in an empirical model of consumption and investment under uncertainty
Consumer Choice;Separability
On the estimated variances of regression coefficients in misspecified error components models
Reduced Dwell-Fatigue Resistance in a Ni-Base Superalloy After Short-Term Thermal Exposure
The effect of short-term thermal exposure on microstructure and dwell-fatigue resistance of Ni-base superalloy 718Plus was investigated. Contrary to previous studies performed after long-term exposure, an increase in the dwell-fatigue crack growth rate was observed, which was connected to a small increase in the size of the hardening precipitates. The proposed controlling mechanism was the stress relaxation rate at the crack tip, and based on this a schematic model for the development of the properties during exposure is presented
Search for the glueball candidates f0(1500) and fJ(1710) in gamma gamma collisions
Data taken with the ALEPH detector at LEP1 have been used to search for gamma
gamma production of the glueball candidates f0(1500) and fJ(1710) via their
decay to pi+pi-. No signal is observed and upper limits to the product of gamma
gamma width and pi+pi- branching ratio of the f0(1500) and the fJ(1710) have
been measured to be Gamma_(gamma gamma -> f0(1500)). BR(f0(1500)->pi+pi-) <
0.31 keV and Gamma_(gamma gamma -> fJ(1710)). BR(fJ(1710)->pi+pi-) < 0.55 keV
at 95% confidence level.Comment: 10 pages, 3 figure
Search for supersymmetry with a dominant R-parity violating LQDbar couplings in e+e- collisions at centre-of-mass energies of 130GeV to 172 GeV
A search for pair-production of supersymmetric particles under the assumption
that R-parity is violated via a dominant LQDbar coupling has been performed
using the data collected by ALEPH at centre-of-mass energies of 130-172 GeV.
The observed candidate events in the data are in agreement with the Standard
Model expectation. This result is translated into lower limits on the masses of
charginos, neutralinos, sleptons, sneutrinos and squarks. For instance, for
m_0=500 GeV/c^2 and tan(beta)=sqrt(2) charginos with masses smaller than 81
GeV/c^2 and neutralinos with masses smaller than 29 GeV/c^2 are excluded at the
95% confidence level for any generation structure of the LQDbar coupling.Comment: 32 pages, 30 figure
In situ degradability of corn stover and elephant-grass harvested at four stages of maturity
Among tropical forages, corn silage is largely used by farmers trying to explore the maximum genetic potential from the animals. However, other tropical forages, such as elephant-grass (Pennisetum purpureum), are more productive and therefore cheaper to use than corn silage. Our objective was to compare the in situ degradability of elephant-grass with that from corn hybrids, all harvested at four stages of maturity. The experimental design followed a randomized block design with nested subplots. Two corn hybrids: AG5011, ZN8392 were harvested with 25, 30, 35, and 40% dry matter (DM) in the whole plant, and separated in stem + leaf sheath + leaf blade (stover), and cobs. Elephant-grass was harvested with 30, 40, 50 and 60 days after a leveling cut. Dried and ground samples were incubated in nylon bags inside the rumen for 0, 6, 12, 24, 48 and 72 h to estimate the kinetics of ruminal DM and neutral detergent fiber (NDF) degradation. The advance of maturity increased the NDF and acid detergent fiber (ADF) content in elephant-grass, and reduced its DM degradability. However, maturity had little or no effect on fiber content and DM degradability of corn stover. Elephant-grass had a higher NDF degradability than corn stover, and there was no effect of maturity on NDF degradability of either elephant-grass or corn stover. Fiber degradability of elephant-grass was not worse than that of corn stover, and therefore the choice of forage should be made on economical analysis rather than assuming an intrinsic low production potential for elephant-grass based diets.Dentre as forragens, a silagem de milho é amplamente utilizada pelos fazendeiros que visam explorar o máximo do potencial genético dos animais. No entanto, outros volumosos tropicais como o capim-elefante (Pennisetum purpureum) são mais produtivos e, portanto, mais baratos do que a silagem de milho. Nosso objetivo foi comparar a degradabilidade in situ do capim-elefante com a degradabilidade de híbridos de milho, colhidos em quatro estágios de maturidade. O experimento seguiu um delineamento de blocos ao acaso com sub-parcelas. Dois híbridos de milho: AG5011 e ZN8392 foram colhidos com 25, 30, 35 e 40% matéria seca (MS) na planta toda e separados na fração colmo + bainha + folhas e espigas. Capim elefante foi colhido 30, 40, 50 e 60 dias após o corte de nivelamento. As amostras secas e trituradas foram incubadas no rúmen por 0, 6, 12, 24, 48 e 72 h para cálculo da cinética da degradação ruminal da MS e da fibra em detergente neutro (FDN). O avanço da maturidade aumentou os teores de FDN e fibra em detergente ácido (FDA) do capim elefante e reduziu a degradabilidade da MS. Entretanto, a maturidade teve pouco efeito sobre os teores de fibra e a degradabilidade da MS da fração planta dos híbridos de milho. O capim elefante apresentou maior degradabilidade da FDN do que híbridos de milho, e não houve efeito da maturidade sobre a degradabilidade da FDN das duas espécies. A degradabilidade da fibra de capim-elefante não é pior do que a de híbridos de milho e, portanto a escolha da forragem deve ser feita com base em análises econômicas ao invés de assumir um menor potencial de produção em dietas a base de capim elefante
flavour tagging using charm decays at the LHCb experiment
An algorithm is described for tagging the flavour content at production of
neutral mesons in the LHCb experiment. The algorithm exploits the
correlation of the flavour of a meson with the charge of a reconstructed
secondary charm hadron from the decay of the other hadron produced in the
proton-proton collision. Charm hadron candidates are identified in a number of
fully or partially reconstructed Cabibbo-favoured decay modes. The algorithm is
calibrated on the self-tagged decay modes and using of data collected by the LHCb
experiment at centre-of-mass energies of and
. Its tagging power on these samples of
decays is .Comment: All figures and tables, along with any supplementary material and
additional information, are available at
http://lhcbproject.web.cern.ch/lhcbproject/Publications/LHCbProjectPublic/LHCb-PAPER-2015-027.htm
- …