226 research outputs found
Transport Phenomena in Alcator C-Mod H-Modes
Abstract. Several interesting new results have come from studies of ICRF-heated, H-mode plasmas in Alcator C-Mod. Dimensionless scaling studies have found gyro-Bohm-like transport similar to that reported on other devices; however, the dependence on collisionality was surprisingly strong, with BE −1. Despite high edge temperatures and strong edge pressure gradients, type I edge-localized modes (ELMs) are not observed in C-Mod. Instead we obtain a regime that we have dubbed enhanced D (EDA) which is accompanied by high-frequency density fluctuations. For all H-modes, core gradients were found to increase linearly with edge temperature, suggesting the importance of critical gradient/marginal stability behaviour. Comparisons with the IFS-PPPL model have begun, showing quantitative agreement in some cases. Impurity particle transport was studied via the laser blow-off technique with impurity confinement found to be effectively infinite for ELM-free discharges but reduced into the range 0.1–0.2 s for the EDA plasmas. 1
Recommended from our members
Gyrokinetic Stability Studies of the Microtearing Mode in the National Spherical Torus Experiment H-mode
Insight into plasma microturbulence and transport is being sought using linear simulations of drift waves on the National Spherical Torus Experiment (NSTX), following a study of drift wave modes on the Alcator C-Mod Tokamak. Microturbulence is likely generated by instabilities of drift waves, which cause transport of heat and particles. Understanding this transport is important because the containment of heat and particles is required for the achievement of practical nuclear fusion. Microtearing modes may cause high heat transport through high electron thermal conductivity. It is hoped that microtearing will be stable along with good electron transport in the proposed low collisionality International Thermonuclear Experimental Reactor (ITER). Stability of the microtearing mode is investigated for conditions at mid-radius in a high density NSTX high performance (H-mode) plasma, which is compared to the proposed ITER plasmas. The microtearing mode is driven by the electron temperature gradient, and believed to be mediated by ion collisions and magnetic shear. Calculations are based on input files produced by TRXPL following TRANSP (a time-dependent transport analysis code) analysis. The variability of unstable mode growth rates is examined as a function of ion and electron collisionalities using the parallel gyrokinetic computational code GS2. Results show the microtearing mode stability dependence for a range of plasma collisionalities. Computation verifies analytic predictions that higher collisionalities than in the NSTX experiment increase microtearing instability growth rates, but that the modes are stabilized at the highest values. There is a transition of the dominant mode in the collisionality scan to ion temperature gradient character at both high and low collisionalities. The calculations suggest that plasma electron thermal confinement may be greatly improved in the low-collisionality ITER
Dynamic Evolution Model of Isothermal Voids and Shocks
We explore self-similar hydrodynamic evolution of central voids embedded in
an isothermal gas of spherical symmetry under the self-gravity. More
specifically, we study voids expanding at constant radial speeds in an
isothermal gas and construct all types of possible void solutions without or
with shocks in surrounding envelopes. We examine properties of void boundaries
and outer envelopes. Voids without shocks are all bounded by overdense shells
and either inflows or outflows in the outer envelope may occur. These
solutions, referred to as type void solutions, are further
divided into subtypes and
according to their characteristic behaviours across the sonic critical line
(SCL). Void solutions with shocks in envelopes are referred to as type
voids and can have both dense and quasi-smooth edges.
Asymptotically, outflows, breezes, inflows, accretions and static outer
envelopes may all surround such type voids. Both cases of
constant and varying temperatures across isothermal shock fronts are analyzed;
they are referred to as types and
void shock solutions. We apply the `phase net matching procedure' to construct
various self-similar void solutions. We also present analysis on void
generation mechanisms and describe several astrophysical applications. By
including self-gravity, gas pressure and shocks, our isothermal self-similar
void (ISSV) model is adaptable to various astrophysical systems such as
planetary nebulae, hot bubbles and superbubbles in the interstellar medium as
well as supernova remnants.Comment: 24 pages, 13 figuers, accepted by ApS
Search for single top quarks in the tau+jets channel using 4.8 fb of collision data
We present the first direct search for single top quark production using tau
leptons. The search is based on 4.8 fb of integrated luminosity
collected in collisions at =1.96 TeV with the D0 detector
at the Fermilab Tevatron Collider. We select events with a final state
including an isolated tau lepton, missing transverse energy, two or three jets,
one or two of them tagged. We use a multivariate technique to discriminate
signal from background. The number of events observed in data in this final
state is consistent with the signal plus background expectation. We set in the
tau+jets channel an upper limit on the single top quark cross section of
\TauLimObs pb at the 95% C.L. This measurement allows a gain of 4% in expected
sensitivity for the observation of single top production when combining it with
electron+jets and muon+jets channels already published by the D0 collaboration
with 2.3 fb of data. We measure a combined cross section of
\SuperCombineXSall pb, which is the most precise measurement to date.Comment: 12 pages, 5 figure
b-Jet Identification in the D0 Experiment
Algorithms distinguishing jets originating from b quarks from other jet
flavors are important tools in the physics program of the D0 experiment at the
Fermilab Tevatron p-pbar collider. This article describes the methods that have
been used to identify b-quark jets, exploiting in particular the long lifetimes
of b-flavored hadrons, and the calibration of the performance of these
algorithms based on collider data.Comment: submitted to Nuclear Instruments and Methods in Physics Research
Measurement of the dijet invariant mass cross section in proton anti-proton collisions at sqrt{s} = 1.96 TeV
The inclusive dijet production double differential cross section as a
function of the dijet invariant mass and of the largest absolute rapidity of
the two jets with the largest transverse momentum in an event is measured in
proton anti-proton collisions at sqrt{s} = 1.96 TeV using 0.7 fb^{-1}
integrated luminosity collected with the D0 detector at the Fermilab Tevatron
Collider. The measurement is performed in six rapidity regions up to a maximum
rapidity of 2.4. Next-to-leading order perturbative QCD predictions are found
to be in agreement with the data.Comment: Published in Phys. Lett. B, 693, (2010), 531-538, 8 pages, 2 figures,
6 table
Measurement of Z/gamma*+jet+X angular distributions in ppbar collisions at sqrt{s}=1.96 TeV
We present the first measurements at a hadron collider of differential cross
sections for Z+jet+X production in delta phi(Z, jet), |delta y(Z, jet)| and
|y_boost(Z, jet)|. Vector boson production in association with jets is an
excellent probe of QCD and constitutes the main background to many small cross
section processes, such as associated Higgs production. These measurements are
crucial tests of the predictions of perturbative QCD and current event
generators, which have varied success in describing the data. Using these
measurements as inputs in tuning event generators will increase the
experimental sensitivity to rare signals.Comment: Published in Physics Letters B 682 (2010), pp. 370-380. 15 pages, 6
figure
Search for the standard model Higgs boson in tau final states
We present a search for the standard model Higgs boson using hadronically
decaying tau leptons, in 1 inverse femtobarn of data collected with the D0
detector at the Fermilab Tevatron ppbar collider. We select two final states:
tau plus missing transverse energy and b jets, and tau+ tau- plus jets. These
final states are sensitive to a combination of associated W/Z boson plus Higgs
boson, vector boson fusion and gluon-gluon fusion production processes. The
observed ratio of the combined limit on the Higgs production cross section at
the 95% C.L. to the standard model expectation is 29 for a Higgs boson mass of
115 GeV.Comment: publication versio
Search for scalar bottom quarks and third-generation leptoquarks in ppbar collisions at sqrt(s) = 1.96 TeV
We report the results of a search for pair production of scalar bottom quarks
(sbottom) and scalar third-generation leptoquarks in 5.2 fb-1 of ppbar
collisions at the D0 experiment of the Fermilab Tevatron Collider. Scalar
bottom quarks are assumed to decay to a neutralino and a quark, and we set
95% C.L. lower limits on their production in the (m_sbottom, m_neutralino) mass
plane such as m_sbottom>247 GeV for m_neutralino=0 and m_neutralino>110 GeV for
160<m_sbottom<200 GeV. The leptoquarks are assumed to decay to a tau neutrino
and a quark, and we set a 95% C.L. lower limit of 247 GeV on the mass of a
charge-1/3 third-generation scalar leptoquark.Comment: Published by Phys. Lett.
Search for charged Higgs bosons in top quark decays
We present a search for charged Higgs bosons in top quark decays. We analyze
the \eplus, \muplus, , , , \etau and \mutau final states from
top quark pair production events, using data from about 1 of
integrated luminosity recorded by the \dzero experiment at the Fermilab
Tevatron Collider. We consider different scenarios of possible charged Higgs
boson decays, one where the charged Higgs boson decays purely hadronically into
a charm and a strange quark, another where it decays into a lepton and a
neutrino and a third one where both decays appear. We extract limits on
the branching ratio for all these models. We use two methods,
one where the production cross section is fixed, and one where the
cross section is fitted simultaneously with . Based on the
extracted limits, we exclude regions in the charged Higgs boson mass and parameter space for different scenarios of the minimal supersymmetric
standard model.Comment: 10 pages, 8 figures, submitted to PL
- …