Atomistic modeling and experimental studies of radiation damage in monazite-type LaPO4 ceramics

We simulated the threshold displacement energies (Ed), the related displacement and defect formation probabilities, and the energy barriers in LaPO4 monazite-type ceramics. The obtained Ed values for La, P, O primary knock-on atoms (PKA) are 56eV, 75eV and 8eV, respectively. We found that these energies can be correlated with the energy barriers that separate the defect from the initial states. The Ed values are about twice the values of energy barriers, which is explained through an efficient dissipation of the PKA kinetic energy in the considered system. The computed Ed were used in simulations of the extent of radiation damage in La0.2Gd0.8PO4 solid solution, investigated experimentally. We found that this lanthanide phosphate fully amorphises in the ion beam experiments for fluences higher than ~1013 ions/cm2

Retention of technetium-99 by grout and backfill cements: Implications for the safe disposal of radioactive waste

Technetium-99 (99Tc) is an important radionuclide when considering the disposal of nuclear wastes owing to its long half-life and environmental mobility in the pertechnetate (Tc(VII)) redox state. Its behaviour in a range of potential cement encapsulants and backfill materials has been studied by analysing uptake onto pure cement phases and hardened cement pastes. Preferential, but limited, uptake of pertechnetate was observed on iron-free, calcium silicate hydrates (C–S–H) and aluminate ferrite monosulphate (AFm) phases with no significant adsorption onto ettringite or calcium aluminates. Diffusion of 99Tc through cured monolithic samples, representative of cements being considered for use in geological disposal facilities across Europe, revealed markedly diverse migration behaviour, primarily due to chemical interactions with the cement matrix rather than differential permeability or other physical factors. A backfill cement, developed specifically for the purpose of radionuclide retention, gave the poorest performance of all formulations studied in terms of both transport rates and overall technetium retention. Two of the matrices, pulverised fuel ash: ordinary Portland cement (PFA:OPC) and a low-pH blend incorporating fly ash, effectively retarded 99Tc migration via precipitation in narrow, reactive zones. These findings have important implications when choosing cementitious grouts and/or backfill for Tc-containing radioactive wastes

Monazite-Type SmPO4_{4} as Potential Nuclear Waste Form: Insights into Radiation Effects from Ion-Beam Irradiation and Atomistic Simulations

Single-phase monazite-type ceramics are considered as potential host matrices for the conditioning of separated plutonium and minor actinides. Sm-orthophosphates were synthesised and their behaviour under irradiation was investigated with respect to their long-term performance in the repository environment. Sintered SmPO$_{4}$ pellets and thin lamellae were irradiated with 1, 3.5, and 7 MeV Au ions, up to fluences of 5.1 × 10$^{14}$ ions cm$^{-2}$ to simulate ballistic effects of recoiling nuclei resulting from α-decay of incorporated actinides. Threshold displacement energies for monazite-type SmPO$_{4}$ subsequently used in SRIM/TRIM simulations were derived from atomistic simulations. Raman spectra obtained from irradiated lamellae revealed vast amorphisation at the highest fluence used, although local annealing effects were observed. The broadened, but still discernible, band of the symmetrical stretching vibration in SmPO4 and the negligible increase in P–O bond lengths suggest that amorphisation of monazite is mainly due to a breaking of Ln–O bonds. PO$_{4}$ groups show structural disorder in the local environment but seem to behave as tight units. Annealing effects observed during the irradiation experiment and the distinctively lower dose rates incurred in actinide bearing waste forms and potential α-radiation-induced annealing effects indicate that SmPO$_{4}$-based waste forms have a high potential for withstanding amorphisation

Microtomography-based Inter-Granular Network for the simulation of radionuclide diffusion and sorption in a granitic rock

Field investigation studies, conducted in the context of safety analyses of deep geological repositories for nuclear waste, have pointed out that in fractured crystalline rocks sorbing radionuclides can diffuse surprisingly long distances deep into the intact rock matrix; i.e. much longer distances than those predicted by reactive transport models based on a homogeneous description of the properties of the rock matrix. Here, we focus on cesium diffusion and use detailed micro characterisation data, based on micro computed tomography, along with a grain-scale Inter-Granular Network model, to offer a plausible explanation for the anomalously long cesium penetration profiles observed in these in-situ experiments. The sparse distribution of chemically reactive grains (i.e. grains belonging to sorbing mineral phases) is shown to have a strong control on the diffusive patterns of sorbing radionuclides. The computed penetration profiles of cesium agree well with an analytical model based on two parallel diffusive pathways. This agreement, along with visual inspection of the spatial distribution of cesium concentration, indicates that for sorbing radionuclides the medium indeed behaves as a composite system, with most of the mass being retained close to the injection boundary and a non-negligible part diffusing faster along preferential diffusive pathways.Peer reviewe

Modelling of the LTDE-SD radionuclide diffusion experiment in crystalline rock at the Aspo Hard Rock Laboratory (Sweden)

This study shows a comparison and analysis of results from a modelling exercise concerning a field experiment involving the transport and retention of different radionuclide tracers in crystalline rock. This exercise was performed within the Swedish Nuclear Fuel and Waste Management Company (SKB) Task Force on Modelling of Groundwater Flow and Transport of Solutes (Task Force GWFTS). Task 9B of the Task Force GWFTS was the second subtask within Task 9 and focused on the modelling of experimental results from the Long Term Sorption Diffusion Experiment in situ tracer test. The test had been performed at a depth of about 410m in the Aspo Hard Rock Laboratory. Synthetic groundwater containing a cocktail of radionuclide tracers was circulated for 198 days on the natural surface of a fracture and in a narrow slim hole drilled in unaltered rock matrix. Overcoring of the rock after the end of the test allowed for the measurement of tracer distribution profiles in the rock from the fracture surface (A cores) and also from the slim hole (D cores). The measured tracer activities in the rock samples showed long profiles (several cm) for non-or weakly-sorbing tracers (Cl-36, Na-22), but also for many of the more strongly-sorbing radionuclides. The understanding of this unexpected feature was one of the main motivations for this modelling exercise. However, re-evaluation and revision of the data during the course of Task 9B provided evidence that the anomalous long tails at low activities for strongly sorbing tracers were artefacts due to cross-contamination during rock sample preparation. A few data points remained for Cs-137, Ba-133, Ni-63 and Cd-109, but most measurements at long distances from the tracer source (>10mm) were now below the reported detection limits. Ten different modelling teams provided results for this exercise, using different concepts and codes. The tracers that were finally considered were Na-22, Cl-36, Co-57, Ni-63, Ba-133, Cs-137, Cd-109, Ra-226 and Np-237. Three main types of models were used: i) analytical solutions to the transport-retention equations, ii) continuum -porous-medium numerical models, and iii) microstructure-based models accounting for small-scale heterogeneity (i.e. mineral grains, porosities and/or microfracture distributions) and potential centimetre-scale fractures. The modelling by the different teams led to some important conclusions, concerning for instance the presence of a disturbed zone (a few mm in thickness) next to the fracture surface and to the wall of the slim hole and the role of micro-fractures and cm-scale fractures in the transport of weakly sorbing tracers. These conclusions could be reached after the re-evaluation and revision of the experimental data (tracer profiles in the rock) and the analysis of the different sets of model results provided by the different teams.Peer reviewe

Retention and diffusion of radioactive and toxic species on cementitious systems: Main outcome of the CEBAMA project

Cement-based materials are key components in radioactive waste repository barrier systems. To improve the available knowledge base, the European CEBAMA (Cement-based materials) project aimed to provide insight on general processes and phenomena that can be easily transferred to different applications. A bottom up approach was used to study radionuclide retention by cementitious materials, encompassing both individual cement mineral phases and hardened cement pastes. Solubility experiments were conducted with Be, Mo and Se under high pH conditions to provide realistic solubility limits and radionuclide speciation schemes as a prerequisite for meaningful adsorption studies. A number of retention mechanisms were addressed including adsorption, solid solution formation and precipitation of radionuclides within new solid phases formed during cement hydration and evolution. Sorption/desorption experiments were carried out on several anionic radionuclides and/or toxic elements which have received less attention to date, namely: Be, Mo, Tc, I, Se, Cl, Ra and 14C. Solid solution formation between radionuclides in a range of oxidation states (Se, I and Mo) with the main aqueous components (OH−, SO4 −2, Cl−) of cementitious systems on AFm phases were also investigated

The Testing by Fire of the Builders' Works: 1 Corinthians 3.10-15

Wetensch. publicati

Modelling of the LTDE-SD radionuclide diffusion experiment in crystalline rock at the Äspö Hard Rock Laboratory (Sweden)

This study shows a comparison and analysis of results from a modelling exercise concerning a field experiment involving the transport and retention of different radionuclide tracers in crystalline rock. This exercise was performed within the Swedish Nuclear Fuel and Waste Management Company (SKB) Task Force on Modelling of Groundwater Flow and Transport of Solutes (Task Force GWFTS). Task 9B of the Task Force GWFTS was the second subtask within Task 9 and focused on the modelling of experimental results from the Long Term Sorption Diffusion Experiment in situ tracer test. The test had been performed at a depth of about 410m in the Äspö Hard Rock Laboratory. Synthetic groundwater containing a cocktail of radionuclide tracers was circulated for 198 days on the natural surface of a fracture and in a narrow slim hole drilled in unaltered rock matrix. Overcoring of the rock after the end of the test allowed for the measurement of tracer distribution profiles in the rock from the fracture surface (A cores) and also from the slim hole (D cores). The measured tracer activities in the rock samples showed long profiles (several cm) for non-or weakly-sorbing tracers (Cl-36, Na-22), but also for many of the more strongly-sorbing radionuclides. The understanding of this unexpected feature was one of the main motivations for this modelling exercise. However, re-evaluation and revision of the data during the course of Task 9B provided evidence that the anomalous long tails at low activities for strongly sorbing tracers were artefacts due to cross-contamination during rock sample preparation. A few data points remained for Cs-137, Ba-133, Ni-63 and Cd-109, but most measurements at long distances from the tracer source (>10mm) were now below the reported detection limits. Ten different modelling teams provided results for this exercise, using different concepts and codes. The tracers that were finally considered were Na-22, Cl-36, Co-57, Ni-63, Ba-133, Cs-137, Cd-109, Ra-226 and Np-237. Three main types of models were used: i) analytical solutions to the transport-retention equations, ii) continuum-porous-medium numerical models, and iii) microstructure-based models accounting for small-scale heterogeneity (i.e. mineral grains, porosities and/or microfracture distributions) and potential centimetre-scale fractures. The modelling by the different teams led to some important conclusions, concerning for instance the presence of a disturbed zone (a few mm in thickness) next to the fracture surface and to the wall of the slim hole and the role of micro-fractures and cm-scale fractures in the transport of weakly sorbing tracers. These conclusions could be reached after the re-evaluation and revision of the experimental data (tracer profiles in the rock) and the analysis of the different sets of model results provided by the different teams.The comments from Dr. Kersti Nilsson, the analytical work by VKTA (Dresden, Germany) for some of the rock samples, and the initial review by Dr. Anna-Maria Jakobsson are gratefully acknowledged. The constructive comments and suggestions by Dr. Jordi Cama and an anonymous reviewer contributed to a significant improvement of the manuscript. Funding was provided through the Task Force partner organisations participating in this modelling exercise (SKB, Sweden; POSIVA OY, Finland; SÚRAO, Czech Republic; BMWi, Germany; KAERI, Republic of Korea; NUMO and JAEA, Japan). IDAEA-CSIC is a Severo Ochoa Centre of Research Excellence (Spanish Ministry of Science and Innovation, Project CEX2018-000794-S). The contributions of TUL, CTU and PROGEO are the result of the SÚRAO project “Research support for Safety Evaluation of Deep Geological Repository”. JAEA’s modelling was performed as a part of “The project for validating assessment methodology in geological disposal system” funded by the METI of Japan. A.I., P.T., M.V., G.D., and D.B. gratefully acknowledge the computing time granted by the JARA Vergabegremium and provided on the JARA Partition part of the supercomputer JURECA at Forschungszentrum Jülich.Peer reviewe