One-electron oxidation of [M(PtBu3)2] (M=Pd, Pt) : isolation of monomeric [Pd(PtBu3)2]+and redox-promoted C−H bond cyclometalation

Oxidation of zero-valent phosphine complexes [M(PtBu3)2] (M=Pd, Pt) has been investigated in 1,2-difluorobenzene solution using cyclic voltammetry and subsequently using the ferrocenium cation as a chemical redox agent. In the case of palladium, a mononuclear paramagnetic PdI derivative was readily isolated from solution and fully characterized (EPR, X-ray crystallography). While in situ electrochemical measurements are consistent with initial one-electron oxidation, the heavier congener undergoes C−H bond cyclometalation and ultimately affords the 14 valence-electron PtII complex [Pt(κ2PC-PtBu2CMe2CH2)(PtBu3)]+ with concomitant formation of [Pt(PtBu3)2H]+

Intercalation of Hydrotalcites with Hexacyanoferrate(II) and (III)-a ThermoRaman Spectroscopic Study

Raman spectroscopy using a hot stage indicates that the intercalation of hexacyanoferrate(II) and (III) in the interlayer space of a Mg,Al hydrotalcites leads to layered solids where the intercalated species is both hexacyanoferrate(II) and (III). Raman spectroscopy shows that depending on the oxidation state of the initial hexacyanoferrate partial oxidation and reduction takes place upon intercalation. For the hexacyanoferrate(III) some partial reduction occurs during synthesis. The symmetry of the hexacyanoferrate decreases from Oh existing for the free anions to D3d in the hexacyanoferrate interlayered hydrotalcite complexes. Hot stage Raman spectroscopy reveals the oxidation of the hexacyanoferrate(II) to hexacyanoferrate(III) in the hydrotalcite interlayer with the removal of the cyanide anions above 250 °C. Thermal treatment causes the loss of CN ions through the observation of a band at 2080 cm-1. The hexacyanoferrate (III) interlayered Mg,Al hydrotalcites decomposes above 150 °C

Electrical manipulation of spin states in a single electrostatically gated transition-metal complex

We demonstrate an electrically controlled high-spin (S=5/2) to low-spin (S=1/2) transition in a three-terminal device incorporating a single Mn2+ ion coordinated by two terpyridine ligands. By adjusting the gate-voltage we reduce the terpyridine moiety and thereby strengthen the ligand-field on the Mn-atom. Adding a single electron thus stabilizes the low-spin configuration and the corresponding sequential tunnelling current is suppressed by spin-blockade. From low-temperature inelastic cotunneling spectroscopy, we infer the magnetic excitation spectrum of the molecule and uncover also a strongly gate-dependent singlet-triplet splitting on the low-spin side. The measured bias-spectroscopy is shown to be consistent with an exact diagonalization of the Mn-complex, and an interpretation of the data is given in terms of a simplified effective model.Comment: Will appear soon in Nanoletter

Phototrophic Fe(II)-oxidation in the chemocline of a ferruginous meromictic lake

© 2014 Walter, Picazo, Miracle, Vicente, Camacho, Aragno and Zopfi. Precambrian Banded Iron Formation (BIF) deposition was conventionally attributed to the precipitation of iron-oxides resulting from the abiotic reaction of ferrous iron (Fe(II)) with photosynthetically produced oxygen. Earliest traces of oxygen date from 2.7 Ga, thus raising questions as to what may have caused BIF precipitation before oxygenic photosynthesis evolved. The discovery of anoxygenic phototrophic bacteria thriving through the oxidation of Fe(II) has provided support for a biological origin for some BIFs, but despite reports suggesting that anoxygenic phototrophs may oxidize Fe(II) in the environment, a model ecosystem of an ancient ocean where they are demonstrably active was lacking. Here we show that anoxygenic phototrophic bacteria contribute to Fe(II) oxidation in the water column of the ferruginous sulfate-poor, meromictic lake La Cruz (Spain). We observed in-situ photoferrotrophic activity through stimulation of phototrophic carbon uptake in the presence of Fe(II), and determined light-dependent Fe(II)-oxidation by the natural chemocline microbiota. Moreover, a photoferrotrophic bacterium most closely related to Chlorobium ferrooxidans was enriched from the ferruginous water column. Our study for the first time demonstrates a direct link between anoxygenic photoferrotrophy and the anoxic precipitation of Fe(III)-oxides in a ferruginous water column, providing a plausible mechanism for the bacterial origin of BIFs before the advent of free oxygen. However, photoferrotrophs represent only a minor fraction of the anoxygenic phototrophic community with the majority apparently thriving by sulfur cycling, despite the very low sulfur content in the ferruginous chemocline of Lake La Cruz

Optimization of the MgO-SiO₂ binding system for fiber-cement production with cellulosic reinforcing elements

A range of MgO and SiO2 blends mixed with water are analyzed to develop clinker-free fiber-cement products reinforced with cellulosic fibers. The target is the development of a binder which is not chemically aggressive to the fibers, but which develops high mechanical strength Mechanical performance of the materials developed is not only influenced by magnesium silicate hydrate (M-S-H) gel content, but is more related to the void content within the paste due to unreacted water, meaning that the gel-space ratio concept is valuable in describing the compressive strengths of these materials. A higher MgO content in the mix formulation leads to M-S-H gels with increased Mg/Si ratio. The Mg/Si ratio also increases over time for each mix, indicated by changes in the gel structure as reaction is not yet complete after 28 days. SEM shows a heterogeneous microstructure which also has regions of high Si content. The 60 wt%MgO-40 wt%SiO2 system is chosen as the optimal formulation since it is the least alkaline binder with high mechanical strength. Bending tests on pastes reinforced with cellulosic pulps prove the efficiency of this binder, which preserves the reinforcing capacity of the fibers much better than Portland cement pastes after 200 cycles of accelerated ageing

Prebiotic synthesis of phosphoenol pyruvate by α-phosphorylation-controlled triose glycolysis

Phosphoenol pyruvate is the highest-energy phosphate found in living organisms and is one of the most versatile molecules in metabolism. Consequently, it is an essential intermediate in a wide variety of biochemical pathways, including carbon fixation, the shikimate pathway, substrate-level phosphorylation, gluconeogenesis and glycolysis. Triose glycolysis (generation of ATP from glyceraldehyde 3-phosphate via phosphoenol pyruvate) is among the most central and highly conserved pathways in metabolism. Here, we demonstrate the efficient and robust synthesis of phosphoenol pyruvate from prebiotic nucleotide precursors, glycolaldehyde and glyceraldehyde. Furthermore, phosphoenol pyruvate is derived within an α-phosphorylation controlled reaction network that gives access to glyceric acid 2-phosphate, glyceric acid 3-phosphate, phosphoserine and pyruvate. Our results demonstrate that the key components of a core metabolic pathway central to energy transduction and amino acid, sugar, nucleotide and lipid biosyntheses can be reconstituted in high yield under mild, prebiotically plausible conditions

Layered hydroxide anion exchanger and their applications related to pesticides: a brief review

Layered double hydroxides and layered hydroxide salts have generated enormous excitement in the inorganic field due to their potential to act as versatile host materials in fabricating novel host–guest layered materials. The ability of the layered hydroxide anion exchanger to be incorporated with a wide range of guest ions enable them to be exploited in various applications related to pesticides. This review sums up the different methods of preparing layered hydroxide anion exchanger, summarises the types of anion intercalated into these layered hydroxide anion exchanger based on their respective systems, and elucidates their potential applications in pesticide-related fields

Two approaches to the study of the origin of life.

This paper compares two approaches that attempt to explain the origin of life, or biogenesis. The more established approach is one based on chemical principles, whereas a new, yet not widely known approach begins from a physical perspective. According to the first approach, life would have begun with - often organic - compounds. After having developed to a certain level of complexity and mutual dependence within a non-compartmentalised organic soup, they would have assembled into a functioning cell. In contrast, the second, physical type of approach has life developing within tiny compartments from the beginning. It emphasises the importance of redox reactions between inorganic elements and compounds found on two sides of a compartmental boundary. Without this boundary, ¿life¿ would not have begun, nor have been maintained; this boundary - and the complex cell membrane that evolved from it - forms the essence of life

Potential applications of nanostructured materials in nuclear waste management.

This report summarizes the results obtained from a Laboratory Directed Research & Development (LDRD) project entitled 'Investigation of Potential Applications of Self-Assembled Nanostructured Materials in Nuclear Waste Management'. The objectives of this project are to (1) provide a mechanistic understanding of the control of nanometer-scale structures on the ion sorption capability of materials and (2) develop appropriate engineering approaches to improving material properties based on such an understanding