Improving the performance of free space optical systems: a space-time orthogonal frequency division modulation approach

Free space optical (FSO) communication systems are known for high capacity and information security. The overall system performances of FSO systems are however significantly affected by atmospheric turbulence induced fading. This paper, therefore, proposes a technique to mitigate this effect through the introduction of an additional degree of error correction capacity by exploiting the spectral dimension in the coding space. A space-time trellis coded orthogonal frequency division modulation (OFDM) scheme was developed, simulated and evaluated for optical communication through a Gamma-Gamma channel. The evaluation of the coding gain obtained from the simulation results, the mathematical analysis and the truncation error analysis shows that the proposed technique is a promising and viable technique for improving the error correction performance of space-time codes for free space optical communication links

Bandwidth density optimization of misaligned optical interconnects

In this paper, the bandwidth density of misaligned free space optical interconnects (FSOIs) system with and without coding under a fixed bit error rate is considered. In particular, we study the effect of using error correction codes of various codeword lengths on the bandwidth density and misalignment tolerance of the FSOIs system in the presence of higher order modes. Moreover, the paper demonstrates the use of the fill factor of the detector array as a design parameter to optimize the bandwidth density of the communication. The numerical results demonstrate that the bandwidth density improves significantly with coding and the improvement is highly dependent on the used codeword length and code rate. In addition, the results clearly show the optimum fill factor values that achieve the maximum bandwidth density and misalignment tolerance of the system

Mitigating Turbulence-Induced Fading in Coherent FSO Links: An Adaptive Space-Time Code Approach

Free space optical communication systems have witnessed a significant rise in attention over the last half a decade owing largely to their enormous bandwidth and relative ease of deployment. Generally, free space optical communication systems differ in their detection mechanism as various detection mechanisms are being reported, including intensity modulation/direct detection FSO, differential FSO and coherent FSO. In this chapter, we explore the prospect of obtaining an optimally performing FSO system by harnessing the cutting-edge features of coherent FSO systems and the coding gain and diversity advantage offered by a four-state space-time trellis code (STTC) in order to combat turbulence-induced fading which has thus far beleaguered the performance of FSO systems. The initial outcomes of this technique are promising as a model for various visible light communication applications

Experimental Evaluation and Comparison of Time-Multiplexed Multi-FPGA Routing Architectures

Emulating large complex designs require multi-FPGA systems (MFS). However, inter-FPGA communication is confronted by the challenge of lack of interconnect capacity due to limited number of FPGA input/output (I/O) pins. Serializing parallel signals onto a single trace effectively addresses the limited I/O pin obstacle. Besides the multiplexing scheme and multiplexing ratio (number of inter-FPGA signals per trace), the choice of the MFS routing architecture also affect the critical path latency. The routing architecture of an MFS is the interconnection pattern of FPGAs, fixed wires and/or programmable interconnect chips. Performance of existing MFS routing architectures is also limited by off-chip interface selection. In this dissertation we proposed novel 2D and 3D latency-optimized time-multiplexed MFS routing architectures. We used rigorous experimental approach and real sequential benchmark circuits to evaluate and compare the proposed and existing MFS routing architectures. This research provides a new insight into the encouraging effects of using off-chip optical interface and three dimensional MFS routing architectures. The vertical stacking results in shorter off-chip links improving the overall system frequency with the additional advantage of smaller footprint area. The proposed 3D architectures employed serialized interconnect between intra-plane and inter-plane FPGAs to address the pin limitation problem. Additionally, all off-chip links are replaced by optical fibers that exhibited latency improvement and resulted in faster MFS. Results indicated that exploiting third dimension provided latency and area improvements as compared to 2D MFS. We also proposed latency-optimized planar 2D MFS architectures in which electrical interconnections are replaced by optical interface in same spatial distribution. Performance evaluation and comparison showed that the proposed architectures have reduced critical path delay and system frequency improvement as compared to conventional MFS. We also experimentally evaluated and compared the system performance of three inter-FPGA communication schemes i.e. Logic Multiplexing, SERDES and MGT in conjunction with two routing architectures i.e. Completely Connected Graph (CCG) and TORUS. Experimental results showed that SERDES attained maximum frequency than the other two schemes. However, for very high multiplexing ratios, the performance of SERDES & MGT became comparable

High Performance Silicon Photonic Interconnected Systems

Advances in data-driven applications, particularly artificial intelligence and deep learning, are driving the explosive growth of computation and communication in today’s data centers and high-performance computing (HPC) systems. Increasingly, system performance is not constrained by the compute speed at individual nodes, but by the data movement between them. This calls for innovative architectures, smart connectivity, and extreme bandwidth densities in interconnect designs. Silicon photonics technology leverages mature complementary metal-oxide-semiconductor (CMOS) manufacturing infrastructure and is promising for low cost, high-bandwidth, and reconfigurable interconnects. Flexible and high-performance photonic switched architectures are capable of improving the system performance. The work in this dissertation explores various photonic interconnected systems and the associated optical switching functionalities, hardware platforms, and novel architectures. It demonstrates the capabilities of silicon photonics to enable efficient deep learning training. We first present field programmable gate array (FPGA) based open-loop and closed-loop control for optical spectral-and-spatial switching of silicon photonic cascaded micro-ring resonator (MRR) switches. Our control achieves wavelength locking at the user-defined resonance of the MRR for optical unicast, multicast, and multiwavelength-select functionalities. Digital-to-analog converters (DACs) and analog-to-digital converters (ADCs) are necessary for the control of the switch. We experimentally demonstrate the optical switching functionalities using an FPGA-based switch controller through both traditional multi-bit DAC/ADC and novel single-wired DAC/ADC circuits. For system-level integration, interfaces to the switch controller in a network control plane are developed. The successful control and the switching functionalitiesachieved are essential for system-level architectural innovations as presented in the following sections. Next, this thesis presents two novel photonic switched architectures using the MRR-based switches. First, a photonic switched memory system architecture was designed to address memory challenges in deep learning. The reconfigurable photonic interconnects provide scalable solutions and enable efficient use of disaggregated memory resources for deep learning training. An experimental testbed was built with a processing system and two remote memory nodes using silicon photonic switch fabrics and system performance improvements were demonstrated. The collective results and existing high-bandwidth optical I/Os show the potential of integrating the photonic switched memory to state-of-the-art processing systems. Second, the scaling trends of deep learning models and distributed training workloads are challenging network capacities in today’s data centers and HPCs. A system architecture that leverages SiP switch-enabled server regrouping is proposed to tackle the challenges and accelerate distributed deep learning training. An experimental testbed with a SiP switch-enabled reconfigurable fat tree topology was built to evaluate the network performance of distributed ring all-reduce and parameter server workloads. We also present system-scale simulations. Server regrouping and bandwidth steering were performed on a large-scale tapered fat tree with 1024 compute nodes to show the benefits of using photonic switched architectures in systems at scale. Finally, this dissertation explores high-bandwidth photonic interconnect designs for disaggregated systems. We first introduce and discuss two disaggregated architectures leveraging extreme high bandwidth interconnects with optically interconnected computing resources. We present the concept of rack-scale graphics processing unit (GPU) disaggregation with optical circuit switches and electrical aggregator switches. The architecture can leverage the flexibility of high bandwidth optical switches to increase hardware utilization and reduce application runtimes. A testbed was built to demonstrate resource disaggregation and defragmentation. In addition, we also present an extreme high-bandwidth optical interconnect accelerated low-latency communication architecture for deep learning training. The disaggregated architecture utilizes comb laser sources and MRR-based cross-bar switching fabrics to enable an all-to-all high bandwidth communication with a constant latency cost for distributed deep learning training. We discuss emerging technologies in the silicon photonics platform, including light source, transceivers, and switch architectures, to accommodate extreme high bandwidth requirements in HPC and data center environments. A prototype hardware innovation - Optical Network Interface Cards (comprised of FPGA, photonic integrated circuits (PIC), electronic integrated circuits (EIC), interposer, and high-speed printed circuit board (PCB)) is presented to show the path toward fast lanes for expedited execution at 10 terabits. Taken together, the work in this dissertation demonstrates the capabilities of high-bandwidth silicon photonic interconnects and innovative architectural designs to accelerate deep learning training in optically connected data center and HPC systems

Control Plane Hardware Design for Optical Packet Switched Data Centre Networks

Optical packet switching for intra-data centre networks is key to addressing traffic requirements. Photonic integration and wavelength division multiplexing (WDM) can overcome bandwidth limits in switching systems. A promising technology to build a nanosecond-reconfigurable photonic-integrated switch, compatible with WDM, is the semiconductor optical amplifier (SOA). SOAs are typically used as gating elements in a broadcast-and-select (B\&S) configuration, to build an optical crossbar switch. For larger-size switching, a three-stage Clos network, based on crossbar nodes, is a viable architecture. However, the design of the switch control plane, is one of the barriers to packet switching; it should run on packet timescales, which becomes increasingly challenging as line rates get higher. The scheduler, used for the allocation of switch paths, limits control clock speed. To this end, the research contribution was the design of highly parallel hardware schedulers for crossbar and Clos network switches. On a field-programmable gate array (FPGA), the minimum scheduler clock period achieved was 5.0~ns and 5.4~ns, for a 32-port crossbar and Clos switch, respectively. By using parallel path allocation modules, one per Clos node, a minimum clock period of 7.0~ns was achieved, for a 256-port switch. For scheduler application-specific integrated circuit (ASIC) synthesis, this reduces to 2.0~ns; a record result enabling scalable packet switching. Furthermore, the control plane was demonstrated experimentally. Moreover, a cycle-accurate network emulator was developed to evaluate switch performance. Results showed a switch saturation throughput at a traffic load 60\% of capacity, with sub-microsecond packet latency, for a 256-port Clos switch, outperforming state-of-the-art optical packet switches

Techniques for Processing TCP/IP Flow Content in Network Switches at Gigabit Line Rates

The growth of the Internet has enabled it to become a critical component used by businesses, governments and individuals. While most of the traffic on the Internet is legitimate, a proportion of the traffic includes worms, computer viruses, network intrusions, computer espionage, security breaches and illegal behavior. This rogue traffic causes computer and network outages, reduces network throughput, and costs governments and companies billions of dollars each year. This dissertation investigates the problems associated with TCP stream processing in high-speed networks. It describes an architecture that simplifies the processing of TCP data streams in these environments and presents a hardware circuit capable of TCP stream processing on multi-gigabit networks for millions of simultaneous network connections. Live Internet traffic is analyzed using this new TCP processing circuit

Architecture and Advanced Electronics Pathways Toward Highly Adaptive Energy- Efficient Computing

With the explosion of the number of compute nodes, the bottleneck of future computing systems lies in the network architecture connecting the nodes. Addressing the bottleneck requires replacing current backplane-based network topologies. We propose to revolutionize computing electronics by realizing embedded optical waveguides for onboard networking and wireless chip-to-chip links at 200-GHz carrier frequency connecting neighboring boards in a rack. The control of novel rate-adaptive optical and mm-wave transceivers needs tight interlinking with the system software for runtime resource management