Field test experience

As a part of the Flat-Plate Solar Array Project (FSA), a field-test program was developed to obtain solar photovoltaic (PV) module performance and endurance data. These data are used to identify the specific characteristics of module designs under various environmental conditions. The information obtained from field testing is useful to all participants in the National Photovoltaics Program, from the research planner to the life-cycle cost analyst

FSA field test

The 12 continental remote sites were decommissioned. Testing was consolidated into a five-site network consisting of the four Southern California sites and a new Florida site. 16 kW of new state-of-the-art modules were deployed at the five sites. Testing of the old modules continued at the Goldstone site but as a low-priority item. Array testing of modules is considered. Additional new testing capabilities were added. A battery-powered array data logger is discussed. A final set of failure and degradation data was obtained from the modules

FSA field test report, 1980 - 1982

Photovoltaic modules made of new and developing materials were tested in a continuing study of weatherability, compatibility, and corrosion protection. Over a two-year period, 365 two-cell submodules have been exposed for various intervals at three outdoor sites in Southern California or subjected to laboratory acceptance tests. Results to date show little loss of maximum power output, except in two types of modules. In the first of these, failure is due to cell fracture from the stresses that arise as water is regained from the surrounding air by a hardboard substrate, which shrank as it dried during its encapsulation in plastic film at 150 C in vacuo. In the second, the glass superstrate is sensitive to cracking, which also damages the cells electrostatically bonded to it; inadequate bonding of interconnects to the cells is also a problem in these modules. In a third type of module, a polyurethane pottant has begun to yellow, though as yet without significant effect on maximum power output

Hot-water aquifer storage: A field test

The basic water injection cycle used in a large-scale field study of heat storage in a confined aquifer near Mobile, Alabama is described. Water was pumped from an upper semi-confined aquifer, passed through a boiler where it was heated to a temperature of about 55 C, and injected into a medium sand confined aquifer. The injection well has a 6-inch (15-cm) partially-penetrating steel screen. The top of the storage formation is about 40 meters below the surface and the formation thickness is about 21 meters. In the first cycle, after a storage period of 51 days, the injection well was pumped until the temperature of the recovered water dropped to 33 c. At that point 55,300 cubic meters of water had been withdrawn and 66 percent of the injected energy had been recovered. The recovery period for the second cycle continued until the water temperature was 27.5 C and 100,100 cubic meters of water was recovered. At the end of the cycle about 90 percent of the energy injected during the cycle had been recovered

Field-test of a robust, portable, frequency-stable laser

We operate a frequency-stable laser in a non-laboratory environment where the test platform is a passenger vehicle. We measure the acceleration experienced by the laser and actively correct for it to achieve a system acceleration sensitivity of $\Delta f / f$ = $11(2) \times 10^{-12}$/g, $6(2) \times 10^{-12}$/g, and $4(1) \times 10^{-12}$/g for accelerations in three orthogonal directions at 1 Hz. The acceleration spectrum and laser performance are evaluated with the vehicle both stationary and moving. The laser linewidth in the stationary vehicle with engine idling is 1.7(1) Hz

Field Test of a Remote Multi-Path CLaDS Methane Sensor

Existing technologies for quantifying methane emissions are often limited to single point sensors, making large area environmental observations challenging. We demonstrate the operation of a remote, multi-path system using Chirped Laser Dispersion Spectroscopy (CLaDS) for quantification of atmospheric methane concentrations over extended areas, a technology that shows potential for monitoring emissions from wetlands

Field test of quantum key distribution in the Tokyo QKD Network

A novel secure communication network with quantum key distribution in a metropolitan area is reported. Different QKD schemes are integrated to demonstrate secure TV conferencing over a distance of 45km, stable long-term operation, and application to secure mobile phones.Comment: 21 pages, 19 figure

Scale Model and Flow Visualization of Jack Rabbit II Chlorine Field Test

The release of hazardous gases, especially accidental releases, can have a major impact on the surrounding environment and population. The history of accidental hazardous gas releases is filled with plant destruction, civilian injury, and even death. Knowledge of how these gases travel and disperse once released can significantly lessen physical harm and improve emergency procedures. The Jack Rabbit II field test was conducted in pursuit of this knowledge for a chlorine release. In this field test, a purpose-built chlorine tank was surrounded by CONEX trailers assembled in the desert in Utah to model an urban setting. Multiple releases of chlorine in this setting were conducted, and the concentrations downwind were measured and analyzed. Because of the limitations of field tests, a wind tunnel model of this field test program would be beneficial. Such model testing would allow for more releases while changing many of the test variables. A wind tunnel model would have repeatable tests, allowing for ensemble averages to improve data. In pursuit of this goal, a 1:50 scale model of the field test was created. Once the model was complete, several preliminary tests were conducted to test the design of the experiment. Using fog to represent chlorine, videos of these preliminary tests were obtained and compared to the field test videos