Supply Risk Considerations for the Elements in Nickel-Based Superalloys

Nickel-based superalloys contain various elements which are added in order to make the alloys more resistant to thermal and mechanical stress and to the adverse operating environments in jet engines. In particular, higher combustion temperatures in the gas turbine are important, since they result in higher fuel efficiency and thus in lower CO2 emissions. In this paper, a semi-quantitative assessment scheme is used to evaluate the relative supply risks associated with elements contained in various Ni-based superalloys: aluminium, titanium, chromium, iron, cobalt, niobium, molybdenum, ruthenium, tantalum, tungsten, and rhenium. Twelve indicators on the elemental level and four aggregation methods are applied in order to obtain the supply risk at the alloy level. The supply risks for the elements rhenium, molybdenum and cobalt are found to be the highest. For three of the aggregation schemes, the spread in supply risk values for the different alloy types (as characterized by chemical composition and the endurance temperature) is generally narrow. The fourth, namely the cost-share’ aggregation scheme, gives rise to a broader distribution of supply risk values. This is mainly due to the introduction of rhenium as a component starting with second-generation single crystal alloys. The resulting higher supply risk appears, however, to be acceptable for jet engine applications due to the higher temperatures these alloys can endur

Investigating African trace gas sources, vertical transport, and oxidation using IAGOS-CARIBIC measurements between Germany and South Africa between 2009 and 2011

Between March 2009 and March 2011 a commercial airliner equipped with a custom built measurement container (IAGOS-CARIBIC observatory) conducted 13 flights between South Africa and Germany at 10–12 km altitude, traversing the African continent north-south. In-situ measurements of trace gases (CO, CH4, H2O) and aerosol particles indicated that strong surface sources (like biomass burning) and rapid vertical transport combine to generate maximum concentrations in the latitudinal range between 10°N and 10°S coincident with the inter-tropical convergence zone (ITCZ). Pressurized air samples collected during these flights were subsequently analyzed for a suite of trace gases including C2-C8 non-methane hydrocarbons (NMHC) and halocarbons. These shorter-lived trace gases, originating from both natural and anthropogenic sources, also showed near equatorial maxima highlighting the effectiveness of convective transport in this region. Two source apportionment methods were used to investigate the specific sources of NMHC: positive matrix factorization (PMF), which is used for the first time for NMHC analysis in the upper troposphere (UT), and enhancement ratios to CO. Using the PMF method three characteristic airmass types were identified based on the different trace gas concentrations they obtained: biomass burning, fossil fuel emissions, and “background” air. The first two sources were defined with reference to previously reported surface source characterizations, while the term “background” was given to air masses in which the concentration ratios approached that of the lifetime ratios. Comparison of enhancement ratios between NMHC and CO for the subset of air samples that had experienced recent contact with the planetary boundary layer (PBL) to literature values showed that the burning of savanna and tropical forest is likely the main source of NMHC in the African upper troposphere (10–12 km). Photochemical aging patterns for the samples with PBL contact revealed that the air had different degradation histories depending on the hemisphere in which they were emitted. In the southern hemisphere (SH) air masses experienced more dilution by clean background air whereas in the northern hemisphere (NH) air masses are less diluted or mixed with background air still containing longer lived NMHC. Using NMHC photochemical clocks ozone production was seen in the BB outflow above Africa in the NH

Case management in oncology rehabilitation (CAMON): The effect of case management on the quality of life in patients with cancer after one year of ambulant rehabilitation. A study protocol for a randomized controlled clinical trial in oncology rehabilitation

Background Cancer diseases and their therapies have negative effects on the quality of life. The aim of this study is to assess the effectiveness of case management in a sample of oncological outpatients with the intent of rehabilitation after cancer treatment. Case management wants to support the complex information needs of the patients in addition to the segmented structure of the health care system. Emphasis is put on support for self-management in order to enhance health - conscious behaviour, learning to deal with the burden of the illness and providing the opportunity for regular contacts with care providers. We present a study protocol to investigate the efficacy of a case management in patients following oncology rehabilitation after cancer treatment. Methods The trial is a multicentre, two-arm randomised controlled study. Patients are randomised parallel in either 'usual care' plus case management or 'usual care' alone. Patients with all types of cancer can be included in the study, if they have completed the therapy with chemo- and/or radiotherapy/surgery with curative intention and are expected to have a survival time >1 year. To determine the health-related quality of life the general questionnaire FACT G is used. The direct correlation between self-management and perceived self-efficacy is measured with the Jerusalem & Schwarzer questionnaire. Patients satisfaction with the care received is measured using the Patient Assessment of Chronic Illness Care 5 As (PACIC-5A). Data are collected at the beginning of the trial and after 3, 6 and 12 months. The power analysis revealed a sample size of 102 patients. The recruitment of the centres began in 2009. The inclusion of patients began in May 2010. Discussion Case management has proved to be effective regarding quality of life of patients with chronic diseases. When it comes to oncology, case management is mainly used in cancer treatment, but it is not yet common in the rehabilitation of cancer patients. Case management in oncology rehabilitation is not well-established in Switzerland. A major challenge of the study will therefore probably be the recruitment of the patients due to the physicians' and patients' scarcely existing awareness of this issue

The seaweeds Fucus vesiculosus and Ascophyllum nodosum are significant contributors to coastal iodine emissions

Based on the results of a pilot study in 2007, which found high mixing ratios of molecular iodine (I2) above the intertidal macroalgae (seaweed) beds at Mweenish Bay (Ireland), we extended the study to nine different locations in the vicinity of Mace Head Atmospheric Research Station on the west coast of Ireland during a field campaign in 2009. The mean values of \chem{I_2} mixing ratio found above the macroalgae beds at nine different locations ranged from 104 to 393 ppt, implying a high source strength of I2. Such mixing ratios are sufficient to result in photochemically driven coastal new-particle formation events. Mixing ratios above the Ascophyllum nodosum and Fucus vesiculosus beds increased with exposure time: after 6 h exposure to ambient air the mixing ratios were one order of magnitude higher than those initially present. This contrasts with the emission characteristics of Laminaria digitata, where most I2 was emitted within the first half hour of exposure. Discrete in situ measurements (offline) of I2 emission from ambient air-exposed chamber experiments of L. digitata, A. nodosum and F. vesiculosus substantially supported the field observations. Further online and time-resolved measurements of the I2 emission from O3-exposed macroalgal experiments in a chamber confirmed the distinct I2 emission characteristics of A. nodosum and F. vesiculosus compared to those of L. digitata. The emission rates of A. nodosum and F. vesiculosus were comparable to or even higher than L. digitata after the initial exposure period of ~20–30 min. We suggest that A. nodosum and F. vesiculosus may provide an important source of photolabile iodine in the coastal boundary layer and that their impact on photochemistry and coastal new-particle formation should be reevaluated in light of their longer exposure at low tide and their widespread distribution

An Overview of the Potential Environmental Impacts of Large Scale Microalgae Cultivation

Cultivation of microalgae for applications such as fuel, food, pharmaceuticals and farming is a rapidly developing area of research and investment. Whilst microalgae promises to deliver many environmental benefits compared with existing biofuel technology, there are also issues to overcome in relation to wastewater management, emissions control, land use change and responsible development of genetically modified organisms. This review seeks to highlight both the positive and negative impacts of microalgae cultivation, focusing on impacts to the aquatic, atmospheric and terrestrial biospheres that may occur and would need to be managed should the microalgae cultivation industry continue to grow

Supply risks associated with CdTe and CIGS thin-film photovoltaics

As a result of the global warming potential of fossil fuels there has been a rapid growth in the installation of photovoltaic generating capacity in the last decade. While this market is dominated by crystalline silicon, thin-film photovoltaics are still expected to make a substantial contribution to global electricity supply in future, due both to lower production costs and to recent increases in conversion efficiency. At present, cadmium telluride (CdTe) and copper-indium-gallium diselenide (CuIn_xGa_1−xSe₂) seem to be the most promising materials and currently have a share of ≈9% of the photovoltaic market. An expected stronger market penetration by these thin-film technologies raises the question as to the supply risks associated with the constituent elements. Against this background, we report here a semi-quantitative, relative assessment of mid- to long-term supply risk associated with the elements Cd, Te, Cu, In, Ga, Se and Mo. In this approach, the supply risk is measured using 11 indicators in the four categories “Risk of Supply Reduction”, “Risk of Demand Increase”, “Concentration Risk” and “Political Risk”. In a second step, the single indicator values, which are derived from publicly accessible databases, are weighted relative to each other specifically for the case of thin film photovoltaics. For this purpose, a survey among colleagues and an Analytic Hierarchy Process (AHP) approach are used, in order to obtain a relative, element-specific value for the supply risk. The aggregation of these elemental values (based on mass share, cost share, etc.) gives an overall value for each material. Both elemental and “technology material” supply risk scores are subject to an uncertainty analysis using Monte Carlo simulation. CdTe shows slightly lower supply risk values for all aggregation options