Ley de Fitts: Sobre el Cálculo del Rendimiento y Tareas No ISO

We used a target-selection task to evaluate head-tracking as an input method for mobile devices. First, the method of calculating Fitts’ throughput is described by means of a raw data detailed example. Then, the method of calculating throughput is discussed for non-ISO tasks, since the procedure targets were randomly positioned from trial to trial. Due to a non-constant amplitude within each sequence of trials, throughput was calculated using two methods of data aggregation: the first one, by sequence of trials using the mean amplitude, and the second one, by common A-W conditions. For each data set, we used four methods for calculating throughput. The grand mean for throughput (calculated through the division of means and the adjustment for accuracy) was of 0.74 bps, which is 45 % lower than the value obtained using an ISO task. We recommend to calculate throughput using the division of means plus the adjustment for accuracy, and to avoid using the reciprocal slope of the regression model. We present various design recommendations for non-ISO tasks, such as: i) to keep amplitude and constant target within each sequence of trials, and ii) to use strategies to avoid or remove reaction time.En este trabajo se presenta el uso de una tarea de selección de objetivos en la evaluación de un head-tracker para dispositivos móviles. Primero, se describe el método de cálculo del rendimiento mediante un ejemplo detallado. A continuación, se discute el método de cálculo para tareas que no cumplen el estándar ISO. Debido a la amplitud no constante de la tarea dentro de cada secuencia, se calcula el rendimiento utilizando dos métodos de agregación de datos: por secuencia, calculando la amplitud media, y por condiciones comunes A-W. Se recomienda calcular el rendimiento utilizando la división de medias y el ajuste de precisión. La media general de rendimiento ha sido de 0,74 bps (un 45 % menor que con una tarea ISO). Se presentan dos recomendaciones de diseño para tareas que no cumplen el estándar ISO: mantener constantes A-W dentro de cada secuencia y utilizar estrategias para evitar el tiempo de reacción

Using Reaction Times and Binary Responses to Estimate Psychophysical Performance: An Information-Theoretic Analysis

As the strength of a stimulus increases, the proportions of correct binary responses increases, which define the psychometric function. Simultaneously, mean reaction times (RT) decrease, which collectively define the chronometric function. However, RTs are traditionally ignored when estimating psychophysical parameters, even though they may provide additional Shannon information. Here, we extend Palmer et al's (2005) proportional-rate diffusion model (PRD) by: (a) fitting individual RTs to an inverse Gaussian distribution, (b) including lapse rate, (c) point-of-subjective-equality (PSE) parameters, and, (d) using a two-alternative forced choice (2AFC) design based on the proportion of times a variable comparison stimulus is chosen. Maximum likelihood estimates of mean RT values (from fitted inverse Gaussians) and binary responses were fitted both separately and in combination to this extended PRD (EPRD) model, to obtain psychophysical parameter values. Values estimated from binary responses alone (i.e., the psychometric function) were found to be similar to those estimated from RTs alone (i.e., the chronometric function), which provides support for the underlying diffusion model. The EPRD model was then used to estimate the mutual information between binary responses and stimulus strength, and between RTs and stimulus strength. These provide conservative bounds for the average amount of Shannon information the observer gains about stimulus strength on each trial. For the human experiment reported here, the observer gains between 2.68 and 3.55 bits/trial. These bounds are monotonically related to a new measure, the Shannon increment, which is the expected value of the smallest change in stimulus strength detectable by an observer

Predictive feedback control and Fitts' law

Fitts’ law is a well established empirical formula, known for encapsulating the “speed-accuracy trade-off”. For discrete, manual movements from a starting location to a target, Fitts’ law relates movement duration to the distance moved and target size. The widespread empirical success of the formula is suggestive of underlying principles of human movement control. There have been previous attempts to relate Fitts’ law to engineering-type control hypotheses and it has been shown that the law is exactly consistent with the closed-loop step-response of a time-delayed, first-order system. Assuming only the operation of closed-loop feedback, either continuous or intermittent, this paper asks whether such feedback should be predictive or not predictive to be consistent with Fitts law. Since Fitts’ law is equivalent to a time delay separated from a first-order system, known control theory implies that the controller must be predictive. A predictive controller moves the time-delay outside the feedback loop such that the closed-loop response can be separated into a time delay and rational function whereas a non- predictive controller retains a state delay within feedback loop which is not consistent with Fitts’ law. Using sufficient parameters, a high-order non-predictive controller could approximately reproduce Fitts’ law. However, such high-order, “non-parametric” controllers are essentially empirical in nature, without physical meaning, and therefore are conceptually inferior to the predictive controller. It is a new insight that using closed-loop feedback, prediction is required to physically explain Fitts’ law. The implication is that prediction is an inherent part of the “speed-accuracy trade-off”

Comparing Smartphone Speech Recognition and Touchscreen Typing for Composition and Transcription

International audienceRuan et al. found transcribing short phrases with speech recognition nearly 200% faster than typing on a smartphone. We extend this comparison to a novel composition task, using a protocol that enables a controlled comparison with transcription. Results show that both composing and transcribing with speech is faster than typing. But, the magnitude of this difference is lower with composition, and speech has a lower error rate than keyboard during composition, but not during transcription. When transcribing, speech outperformed typing in most NASA-TLX measures, but when composing, there were no significant differences between typing and speech for any measure except physical demand

Paving the Way to Eureka-Introducing "Dira" as an Experimental Paradigm to Observe the Process of Creative Problem Solving

“Dira” is a novel experimental paradigm to record combinations of behavioral and metacognitive measures for the creative process. This task allows assessing chronological and chronometric aspects of the creative process directly and without a detour through creative products or proxy phenomena. In a study with 124 participants we show that (a) people spend more time attending to selected vs. rejected potential solutions, (b) there is a clear connection between behavioral patterns and self-reported measures, (c) the reported intensity of Eureka experiences is a function of interaction time with potential solutions, and (d) experiences of emerging solutions can happen immediately after engaging with a problem, before participants explore all potential solutions. The conducted study exemplifies how “Dira” can be used as an instrument to narrow down the moment when solutions emerge. We conclude that the “Dira” experiment is paving the way to study the process, as opposed to the product, of creative problem solving

Even Turing Should Sometimes Not Be Able To Tell: Mimicking Humanoid Usage Behavior for Exploratory Studies of Online Services

Online services such as social networks, online shops, and search engines deliver different content to users depending on their location, browsing history, or client device. Since these services have a major influence on opinion forming, understanding their behavior from a social science perspective is of greatest importance. In addition, technical aspects of services such as security or privacy are becoming more and more relevant for users, providers, and researchers. Due to the lack of essential data sets, automatic black box testing of online services is currently the only way for researchers to investigate these services in a methodical and reproducible manner. However, automatic black box testing of online services is difficult since many of them try to detect and block automated requests to prevent bots from accessing them. In this paper, we introduce a testing tool that allows researchers to create and automatically run experiments for exploratory studies of online services. The testing tool performs programmed user interactions in such a manner that it can hardly be distinguished from a human user. To evaluate our tool, we conducted - among other things - a large-scale research study on Risk-based Authentication (RBA), which required human-like behavior from the client. We were able to circumvent the bot detection of the investigated online services with the experiments. As this demonstrates the potential of the presented testing tool, it remains to the responsibility of its users to balance the conflicting interests between researchers and service providers as well as to check whether their research programs remain undetected

Intelligent Interfaces to Empower People with Disabilities

Severe motion impairments can result from non-progressive disorders, such as cerebral palsy, or degenerative neurological diseases, such as Amyotrophic Lateral Sclerosis (ALS), Multiple Sclerosis (MS), or muscular dystrophy (MD). They can be due to traumatic brain injuries, for example, due to a traffic accident, or to brainste