214 research outputs found
The rf control and detection system for PACO the parametric converter detector
In this technical note the rf control and detection system for a detector of
small harmonic displacements based on two coupled microwave cavities (PACO) is
presented. The basic idea underlying this detector is the principle of
parametric power conversion between two resonant modes of the system,
stimulated by the (small) harmonic modulation of one system parameter. In this
experiment we change the cavity length applying an harmonic voltage to a
piezo-electric crystal. The system can achieve a great sensitivity to small
harmonic displacements and can be an interesting candidate for the detection of
small, mechanically coupled, interactions (e.g. high frequency gravitational
waves).Comment: 13 pages, 4 postscript figure
A detector of small harmonic displacements based on two coupled microwave cavities
The design and test of a detector of small harmonic displacements is
presented. The detector is based on the principle of the parametric conversion
of power between the resonant modes of two superconducting coupled microwave
cavities. The work is based on the original ideas of Bernard, Pegoraro, Picasso
and Radicati, who, in 1978, suggested that superconducting coupled cavities
could be used as sensitive detectors of gravitational waves, and on the work of
Reece, Reiner and Melissinos, who, {in 1984}, built a detector of this kind.
They showed that an harmonic modulation of the cavity length l produced an
energy transfer between two modes of the cavity, provided that the frequency of
the modulation was equal to the frequency difference of the two modes. They
achieved a sensitivity to fractional deformations of dl/l~10^{-17} Hz^{-1/2}.
We repeated the Reece, Reiner and Melissinos experiment, and with an improved
experimental configuration and better cavity quality, increased the sensitivity
to dl/l~10^{-20} Hz^{-1/2}. In this paper the basic principles of the device
are discussed and the experimental technique is explained in detail. Possible
future developments, aiming at gravitational waves detection, are also
outlined.Comment: 28 pages, 12 eps figures, ReVteX. \tightenlines command added to
reduce number of pages. The following article has been accepted by Review of
Scientific Instruments. After it is published, it will be found at
http://link.aip.org/link/?rs
Parametric gravity wave detector
Since 1978 superconducting coupled cavities have been proposed as a sensitive
detector of gravitational waves. The interaction of the gravitational wave with
the cavity walls, and the esulting motion, induces the transition of some
energy from an initially excited cavity mode to an empty one. The energy
transfer is maximum when the frequency of the wave is equal to the frequency
difference of the two cavity modes. In 1984 Reece, Reiner and Melissinos built
a detector of the type proposed, and used it as a transducer of harmonic
mechanical motion, achieving a sensitivity to fractional deformations of the
order dx/x ~ 10^(-18). In this paper the working principles of the detector are
discussed and the last experimental results summarized. New ideas for the
development of a realistic gravitational waves detector are considered; the
outline of a possible detector design and its expected sensitivity are also
shown.Comment: 9 pages, 6 figures. Talk given at the Workshop on Electromagnetic
Probes of Fundamentals Physics, Erice (Italy), October 200
A detector of gravitational waves based on coupled microwave cavities
Since 1978 superconducting coupled cavities have been proposed as sensitive
detector of gravitational waves. The interaction of the gravitational wave with
the cavity walls, and the resulting motion, induces the transition of some
electromagnetic energy from an initially excited cavity mode to an empty one.
The energy transfer is maximum when the frequency of the wave is equal to the
frequency difference of the two cavity modes. In this paper the basic
principles of the detector are discussed. The interaction of a gravitational
wave with the cavity walls is studied in the proper reference frame of the
detector, and the coupling between two electromagnetic normal modes induced by
the wall motion is analyzed in detail. Noise sources are also considered; in
particular the noise coming from the brownian motion of the cavity walls is
analyzed. Some ideas for the developement of a realistic detector of
gravitational waves are discussed; the outline of a possible detector design
and its expected sensitivity are also shown.Comment: 29 pages, 12 eps figures. Typeset by REVTe
Two Coupled Superconducting Cavities as a Gravitational Wave Detector: First Experimental Results
First experimental results of a feasibility study of a gravitational wave
detector based on two coupled superconducting cavities are presented. Basic
physical principles underlying the detector behaviour and sensitivity limits
are discussed. The detector layout is described in detail and its rf properties
are showed. The limit sensitivity to small harmonic displacements at the
detection frequency (around 1 MHz) is showed. The system performance as a
potential g.w. detector is discussed and future developments are foreseen.Comment: 7 pages, 3 figures. Presented at the 9th Workshop on RF
Superconductivity, November 1-5, 1999, Santa Fe, New Mexico, US
Microwave apparatus for gravitational waves observation
In this report the theoretical and experimental activities for the
development of superconducting microwave cavities for the detection of
gravitational waves are presented.Comment: 42 pages, 28 figure
Ontogenetic scaling patterns and functional anatomy of the pelvic limb musculature in emus (Dromaius novaehollandiae)
Emus (Dromaius novaehollandiae) are exclusively terrestrial, bipedal and cursorial ratites with some similar biomechanical characteristics to humans. Their growth rates are impressive, as their body mass increases eighty-fold from hatching to adulthood whilst maintaining the same mode of locomotion throughout life. These ontogenetic characteristics stimulate biomechanical questions about the strategies that allow emus to cope with their rapid growth and locomotion, which can be partly addressed via scaling (allometric) analysis of morphology. In this study we have collected pelvic limb anatomical data (muscle architecture, tendon length, tendon mass and bone lengths) and calculated muscle physiological cross sectional area (PCSA) and average tendon cross sectional area from emus across three ontogenetic stages (n = 17, body masses from 3.6 to 42 kg). The data were analysed by reduced major axis regression to determine how these biomechanically relevant aspects of morphology scaled with body mass. Muscle mass and PCSA showed a marked trend towards positive allometry (26 and 27 out of 34 muscles respectively) and fascicle length showed a more mixed scaling pattern. The long tendons of the main digital flexors scaled with positive allometry for all characteristics whilst other tendons demonstrated a less clear scaling pattern. Finally, the two longer bones of the limb (tibiotarsus and tarsometatarsus) also exhibited positive allometry for length, and two others (femur and first phalanx of digit III) had trends towards isometry. These results indicate that emus experience a relative increase in their muscle force-generating capacities, as well as potentially increasing the force-sustaining capacities of their tendons, as they grow. Furthermore, we have clarified anatomical descriptions and provided illustrations of the pelvic limb muscle–tendon units in emus
Recommended from our members
Release of live baitfish by recreational anglers drives fish pathogen introduction risk
Emerging diseases of wildlife are an existential threat to biodiversity, and human-mediated movements of live animals are a primary vector of their spread. Wildlife disease risk analyses offer an appealing alternative to precautionary approaches because they allow for explicit quantification of uncertainties and consideration of tradeoffs. Such considerations become particularly important in high-frequency invasion pathways with hundreds of thousands of individual vectors, where even low pathogen prevalence can lead to substantial risk. The purpose of this study was to examine the landscape-level dynamics of human behavior-mediated pathogen introduction risk in the context of a high-frequency invasion pathway. One such pathway is the use and release of live fish used as bait by recreational anglers. We used a stochastic risk assessment model parameterized by angler survey data from Minnesota, USA, to simulate one year of fishing in Minnesota and estimate the total number of risky trips for each of three pathogens: viral hemorrhagic septicemia virus, the microsporidian parasite Ovipleistophora ovariae, and the Asian fish tapeworm Schizocotyle acheilognathi. We assessed the number of introductions under four scenarios: current/baseline conditions, outbreak conditions (increased pathogen prevalence), source-focused control measures (decreased pathogen prevalence), and angler-focused control measures (decreased rates of release). We found that hundreds of thousands of introduction events can occur per year, even for regulated pathogens at low pathogen prevalence. Reducing the rate of illegal baitfish release had significant impact on risky trips in scenarios where a high number of anglers were involved, but was less impactful in circumstances with limited outbreaks and fewer affected anglers. In contrast, reducing pathogen prevalence in the source populations of baitfish had relatively little impact. In order to make meaningful changes in pathogen introduction risk, managers should focus efforts on containing local outbreaks and reducing illegal baitfish release to reduce pathogen introduction risk. Our study also demonstrates the risk associated with high-frequency invasion pathways and the importance of incorporating human behaviors into wildlife disease models and risk assessments
Don't forget the jumper's knee in the young sportsman: evaluation of patellar tendinopathy with a high frequency ultrasound probe.
8Patellar tendinopathy, or Jumper's knee, is a painful knee condition caused by inflammation of the patella tendon. This condition is most frequently observed in subjects who play sports that require repetitive regular jumping. Jumper's knee is frequently misdiagnosed as a minor injury and many athletes, like our patient, keep on training and competing and either tend to ignore the injury or attempt to treat it themselves. However, jumper's knee is a serious condition that requires a correct and timely diagnosis, which often necessitates ultrasound investigation in order to start the most appropriate treatment.openopenRuaro B; Cutolo M; Alessandri E; Zaottini F; Picasso R; Pistoia F; Ferrari G; Martinoli C.Ruaro, B; Cutolo, M; Alessandri, E; Zaottini, F; Picasso, R; Pistoia, F; Ferrari, G; Martinoli, C
- …