The University of Hawaii Institute for Astronomy CCD camera control system

The University of Hawaii Institute for Astronomy CCD Camera Control System consists of a NeXT workstation, a graphical user interface, and a fiber optics communications interface which is connected to a San Diego State University CCD controller. The UH system employs the NeXT-resident Motorola DSP 56001 as a real time hardware controller. The DSP 56001 is interfaced to the Mach-based UNIX of the NeXT workstation by DMA and multithreading. Since the SDSU controller also uses the DPS 56001, the NeXT is used as a development platform for the embedded control software. The fiber optic interface links the two DSP 56001's through their Synchronous Serial Interfaces. The user interface is based on the NeXTStep windowing system. It is easy to use and features real-time display of image data and control over all camera functions. Both Loral and Tektronix 2048 x 2048 CCD's have been driven at full readout speeds, and the system is intended to be capable of simultaneous readout of four such CCD's. The total hardware package is compact enough to be quite portable and has been used on five different telescopes on Mauna Kea. The complete CCD control system can be assembled for a very low cost. The hardware and software of the control system has proven to be quite reliable, well adapted to the needs of astronomers, and extensible to increasingly complicated control requirements

Many-body approach to proton emission and the role of spectroscopic factors

The process of proton emission from nuclei is studied by utilizing the two-potential approach of Gurvitz and Kalbermann in the context of the full many-body problem. A time-dependent approach is used for calculating the decay width. Starting from an initial many-body quasi-stationary state, we employ the Feshbach projection operator approach and reduce the formalism to an effective one-body problem. We show that the decay width can be expressed in terms of a one-body matrix element multiplied by a normalization factor. We demonstrate that the traditional interpretation of this normalization as the square root of a spectroscopic factor is only valid for one particular choice of projection operator. This causes no problem for the calculation of the decay width in a consistent microscopic approach, but it leads to ambiguities in the interpretation of experimental results. In particular, spectroscopic factors extracted from a comparison of the measured decay width with a calculated single-particle width may be affected.Comment: 17 pages, Revte

Embracing additive manufacture: implications for foot and ankle orthosis design

<p>Abstract</p> <p>Background</p> <p>The design of foot and ankle orthoses is currently limited by the methods used to fabricate the devices, particularly in terms of geometric freedom and potential to include innovative new features. Additive manufacturing (AM) technologies, where objects are constructed via a series of sub-millimetre layers of a substrate material, may present the opportunity to overcome these limitations and allow novel devices to be produced that are highly personalised for the individual, both in terms of fit and functionality.</p> <p>Two novel devices, a foot orthosis (FO) designed to include adjustable elements to relieve pressure at the metatarsal heads, and an ankle foot orthosis (AFO) designed to have adjustable stiffness levels in the sagittal plane, were developed and fabricated using AM. The devices were then tested on a healthy participant to determine if the intended biomechanical modes of action were achieved.</p> <p>Results</p> <p>The adjustable, pressure relieving FO was found to be able to significantly reduce pressure under the targeted metatarsal heads. The AFO was shown to have distinct effects on ankle kinematics which could be varied by adjusting the stiffness level of the device.</p> <p>Conclusions</p> <p>The results presented here demonstrate the potential design freedom made available by AM, and suggest that it may allow novel personalised orthotic devices to be produced which are beyond the current state of the art.</p

A Systematic Review of Music Therapy Practice and Outcomes with Acute Adult Psychiatric In-Patients

PMCID: PMC3732280This is an open-access article distributed under the terms of the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original author and source are credited

Gallbladder Cancer Incidence Among American Indians and Alaska Natives, US, 1999–2004

BACKGROUND. Gallbladder cancer (GBC) is rare; however, it disproportionately affects the American Indian and Alaska Natives (AI/AN) population. The purpose of the study was to characterize GBC among AI/AN in the US population. METHODS. Cases of GBC diagnosed between 1999 and 2004 and collected by state-based cancer registries were included. Registry records were linked with Indian Health Service (IHS) administration records to decrease race misclassification of AI/AN. GBC rates and/or percent distributions for AI/AN and non-Hispanic whites (NHW) were calculated by sex, IHS region, age, and stage for all US counties and IHS Contract Health Service Delivery Area (CHSDA) counties, in which approximately 56% of US AI/AN individuals reside. RESULTS. In CHSDA counties, the GBC incidence rate among AI/AN was 3.3 per 100,000, which was significantly higher than that among NHW (P \u3c .05). Rates varied widely among IHS regions and ranged from 1.5 in the East to 5.5 in Alaska. Rates were higher among AI/AN females than males in all regions, except the Northern Plains. Higher percentages of GBC were diagnosed among AI/AN aged CONCLUSIONS. To the authors’ knowledge to date, this is the most comprehensive study of GBC incidence among AI/AN in the US. The accurate characterization of GBC in this population could help inform the development of interventions aimed at reducing morbidity and mortality from this diseas

Nanometer Scale Dielectric Fluctuations at the Glass Transition

Using non-contact scanning probe microscopy (SPM) techniques, dielectric properties were studied on 50 nanometer length scales in poly-vinyl-acetate (PVAc) films in the vicinity of the glass transition. Low frequency (1/f) noise observed in the measurements, was shown to arise from thermal fluctuations of the electric polarization. Anomalous variations observed in the noise spectrum provide direct evidence for cooperative nano-regions with heterogeneous kinetics. The cooperative length scale was determined. Heterogeneity was long-lived only well below the glass transition for faster than average processes.Comment: 4 pages, 4 embedded PS figures, RevTeX - To appear in Phys. Rev. Let

An RxLR effector from phytophthora infestans prevents re-localisation of two plant NAC transcription factors from the endoplasmic reticulum to the nucleus

The plant immune system is activated following the perception of exposed, essential and invariant microbial molecules that are recognised as non-self. A major component of plant immunity is the transcriptional induction of genes involved in a wide array of defence responses. In turn, adapted pathogens deliver effector proteins that act either inside or outside plant cells to manipulate host processes, often through their direct action on plant protein targets. To date, few effectors have been shown to directly manipulate transcriptional regulators of plant defence. Moreover, little is known generally about the modes of action of effectors from filamentous (fungal and oomycete) plant pathogens. We describe an effector, called Pi03192, from the late blight pathogen Phytophthora infestans, which interacts with a pair of host transcription factors at the endoplasmic reticulum (ER) inside plant cells. We show that these transcription factors are released from the ER to enter the nucleus, following pathogen perception, and are important in restricting disease. Pi03192 prevents the plant transcription factors from accumulating in the host nucleus, revealing a novel means of enhancing host susceptibility

Transgressing the moral economy: Wheelerism and management of the nationalised coal industry in Scotland

This article illuminates the links between managerial style and political economy in post-1945 Britain, and explores the origins of the 1984–1985 miners' strike, by examining in longer historical context the abrasive attitudes and policies of Albert Wheeler, Scottish Area Director of the National Coal Board (NCB). Wheeler built on an earlier emphasis on production and economic criteria, and his micro-management reflected pre-existing centralising tendencies in the industries. But he was innovative in one crucial aspect, transgressing the moral economy of the Scottish coalfield, which emphasised the value of economic security and changes by joint industrial agreement

Patterns of impact resulting from a 'sit less, move more' web-based program in sedentary office employees.

PURPOSE: Encouraging office workers to 'sit less and move more' encompasses two public health priorities. However, there is little evidence on the effectiveness of workplace interventions for reducing sitting, even less about the longer term effects of such interventions and still less on dual-focused interventions. This study assessed the short and mid-term impacts of a workplace web-based intervention (Walk@WorkSpain, W@WS; 2010-11) on self-reported sitting time, step counts and physical risk factors (waist circumference, BMI, blood pressure) for chronic disease. METHODS: Employees at six Spanish university campuses (n=264; 42±10 years; 171 female) were randomly assigned by worksite and campus to an Intervention (used W@WS; n=129; 87 female) or a Comparison group (maintained normal behavior; n=135; 84 female). This phased, 19-week program aimed to decrease occupational sitting time through increased incidental movement and short walks. A linear mixed model assessed changes in outcome measures between the baseline, ramping (8 weeks), maintenance (11 weeks) and follow-up (two months) phases for Intervention versus Comparison groups. RESULTS: A significant 2 (group) × 2 (program phases) interaction was found for self-reported occupational sitting (F[3]=7.97, p=0.046), daily step counts (F[3]=15.68, p=0.0013) and waist circumference (F[3]=11.67, p=0.0086). The Intervention group decreased minutes of daily occupational sitting while also increasing step counts from baseline (446±126; 8,862±2,475) through ramping (+425±120; 9,345±2,435), maintenance (+422±123; 9,638±3,131) and follow-up (+414±129; 9,786±3,205). In the Comparison group, compared to baseline (404±106), sitting time remained unchanged through ramping and maintenance, but decreased at follow-up (-388±120), while step counts diminished across all phases. The Intervention group significantly reduced waist circumference by 2.1cms from baseline to follow-up while the Comparison group reduced waist circumference by 1.3cms over the same period. CONCLUSIONS: W@WS is a feasible and effective evidence-based intervention that can be successfully deployed with sedentary employees to elicit sustained changes on "sitting less and moving more"