Biosorption mechanism of Methylene Blue from aqueous solution onto White Pine (Pinus durangensis) sawdust: Effect of operating conditions

In this work, the biosorption mechanism of the cationic dye Methylene Blue (MB) on natural White Pine sawdust (NS) (Pinus durangensis) was investigated. Likewise, the surface charge distribution of NS was determined, and its point of zero charge was found to be 4.3. Besides, the capacity of the NS for adsorbing MB was increased 1.7, 2.0 and 4.6 times when the pH was raised from 3 to 4.25, 3 to 7 and 3 to 10, respectively. This behavior was attributed to the electrostatic attraction between the negatively charged surface of NS and the cationic species MBþ. The adsorption capacity increased with increased temperature because the adsorption was an endothermic process. The adsorption capacity was drastically reduced by increasing the ionic strength of the solution corroborating with the fact that the electrostatic attractions played a crucial role in the adsorption of MB on NS. It was also shown that the MB was chemisorbed because the adsorption was not reversible. The predominant adsorption mechanisms were the electrostatic attraction and chemisorption and not ion exchange.This work was funded by the Consejo Nacional de Ciencia y Tecnologia, CONACyT, Mexico, through grants: CONAFOR-2010- C02-148302 and CB-2012-02-182779

Regeneration of ortho-chlorophenol-exhausted activated carbons with liquid water at high pressure and temperature

[EN]A study was undertaken of the regeneration of three activated carbons exhausted with ortho-chlorophenol. The regeneration process was carried out using liquid water at 623 K and 150 atm in the absence of oxygen. The efficiency of this procedure was analyzed by determining the rate and amount of ortho-chlorophenol adsorbed in successive adsorption–regeneration cycles. The present procedure showed a much greater efficiency than that reported for chemical and/or thermal regeneration. Effects of this regeneration on the adsorption kinetics, adsorption capacity and textural characteristics of the carbon were investigated. The increase in adsorption capacity of the regenerated carbon compared with that of the original carbon seems mainly due to the opening of porosity during the regeneration treatment

Participación del carbón activado en procesos de eliminación de fármacos presentes en las aguas

págs.: 273-324Capítulo incluido en el libro: Desarrollo y aplicaciones de materiales avanzados de carbón. Miguel Ángel Álvarez Merino, Francisco Carrasco Marín, Francisco José Maldonado Hódar (Editores). Sevilla: Univeridad Internacional de Andalucía, 2014. ISBN: 978-84-7993-247-3. Enlace: http://hdl.handle.net/10334

Mineralisation of surfactants using ultrasound and the Advanced Fenton Process

The destruction of the surfactants, sodium dodecylbenzene sulfonate (DBS) and dodecyl pyridinium chloride (DPC), using an advanced oxidation process is described. The use of zero valent iron (ZVI) and hydrogen peroxide at pH = 2.5 (the advanced Fenton process), with and without, the application of 20 kHz ultrasound leads to extensive mineralisation of both materials as determined by total organic carbon (TOC)measurements. For DBS, merely stirring with ZVI and H2O2 at 20°C leads to a 51% decrease in TOC, but using 20 kHz ultrasound at 40°C, maintaining the pH at 2.5 throughout and adding extra amounts of ZVI and H2O2 during the degradation, then the extent of mineralisation of DBS is substantially increased to 93%. A similar result is seen for DPC where virtually no degradation occurs at 20°C, but if extra amounts of both ZVI and hydrogen peroxide are introduced during the reaction at 40°C and the pH is maintained at 2.5, then an 87% mineralisation of DPC is obtained. The slow latent remediation of both surfactants and the mechanism of degradation are also discussed

Influence of radiation and TiO2 concentration on the hydroxyl radicals generation in a photocatalytic LED reactor. Application to dodecylbenzenesulfonate degradation

One of the main issues associated to the development of photocatalysis is the lack of adequate indexes that allow the comparison of the results obtained in different experimental setup designs. The hydroxyl radicals (o OH) generation rate is a key factor to determine the overall oxidation rate. In this work, using a Light Emitting Diodes (LEDs) reactor aimed to maximize light ef?ciency and minimize energy consumption, the o OH generated have been determined as a function of the radiation and catalyst concentration following an indirect method based on the reaction between o OH and dimethyl sulfoxide (DMSO) to produce formaldehyde. Finally, the methodology has been applied to analyze the degradation kinetics of the anionic surfactant dodecylbenzenesulfonate (DBS), frequently used in shampoo formulations and detergents for washing machines. We propose a method based on the indirect determination of o OH radicals generation rate that allows the assessment and comparison of the kinetics of photocatalytic oxidation of pollutants.Financial support from the Spanish Ministry of Economy and Competitiveness and from FEDER funds (projects CTM2012-33917 and CTQ2012-31639) are gratefully acknowledged

Effect of the carbon nanotube surface characteristics on the conductivity and dielectric constant of carbon nanotube/poly(vinylidene fluoride) composites

Commercial multi-walled carbon nanotubes (CNT) were functionalized by oxidation with HNO3, to introduce oxygen-containing surface groups, and by thermal treatments at different temperatures for their selective removal. The obtained samples were characterized by adsorption of N2 at -196°C, temperature-programmed desorption and determination of pH at the point of zero charge. CNT/poly(vinylidene fluoride) composites were prepared using the above CNT samples, with different filler fractions up to 1 wt%. It was found that oxidation reduced composite conductivity for a given concentration, shifted the percolation threshold to higher concentrations, and had no significant effect in the dielectric response

Protocol for the detection and nutritional management of high-output stomas

Introduction: An issue of recent research interest is excessive stoma output and its relation to electrolyte abnormalities. Some studies have identified this as a precursor of dehydration and renal dysfunction. A prospective study was performed of the complications associated with high-output stomas, to identify their causes, consequences and management.Materials and methods: This study was carried out by a multidisciplinary team of surgeons, gastroenterologists, nutritionists and hospital pharmacists. High-output stoma (HOS) was defined as output ≥1500 ml for two consecutive days. The subjects included in the study population, 43 patients with a new permanent or temporary stoma, were classified according to the time of HOS onset as early HOS (<3 weeks after initial surgery) or late HOS (≥3 weeks after surgery). Circumstances permitting, a specific protocol for response to HOS was applied. Each patient was followed up until the fourth month after surgery.Results: Early HOS was observed in 7 (16 %) of the sample population of 43 hospital patients, and late HOS, in 6 of the 37 (16 %) non-early HOS population. By type of stoma, nearly all HOS cases affected ileostomy, rather than colostomy, patients. The patients with early HOS remained in hospital for 18 days post surgery, significantly longer than those with no HOS (12 days). The protocol was applied to the majority of EHOS patients and achieved 100 % effectiveness. 50 % of readmissions were due to altered electrolyte balance. Hypomagnesaemia was observed in 33 % of the late HOS patients.Conclusion: The protocol developed at our hospital for the detection and management of HOS effectively addresses possible long-term complications arising from poor nutritional status and chronic electrolyte alteration

Vulnerable marine ecosystems and biological features of Gazul mud volcano (Gulf of Cádiz): A contribution towards a potential "Gulf of Cádiz" EBSA

The Gulf of Cádiz (GoC) represents an area of socioeconomic and scientific importance for oceanographic, geological and biological processes. An interesting feature of the GoC is the presence of a large amount of mud volcanoes (MVs) and diapirs that display different seepage, seabed types, oceanographic settings and biological communities. Detailed exploration of some MVs is still needed for detecting Vulnerable Marine ecosystems (VMEs) that seem to be rare in other areas of the GoC, improving the current knowledge on its biodiversity and ecological attributes. During different expeditions (MEDWAVES-ATLAS, INDEMARES-CHICA 0610 & 0412 and ISUNEPCA 0616) carried out in different years, biological samples and videos were obtained in Gazul MV (Spanish Margin of the GoC). The study of those samples and videos has revealed the presence of several ecologically important VMEs (e.g. 3 species of reef framework-forming corals, coral gardens including solitary scleractinians, gorgonians and antipatharians, as well as deep-sea sponge aggregations and chemosynthesis-related structures) and a large number of species occurring in this MV, including new records for the European margin, threatened species and non-previously described species. The combination of different environmental and anthropogenic factors allowed the present-day persistence of these VMEs in the GoC. Some of Gazul MV biological and ecological attributes fit several criteria of the Convention on Biological Diversity for EBSA description (e.g. 1,3,4,6) that, together with those of other areas of the GoC, may contribute to the future potential nomination of an EBSA in this area of the NE Atlantic

Vermiculite bio-barriers for Cu and Zn remediation: an eco-friendly approach for freshwater and sediments protection

The increase in heavy metal contamination in freshwater systems causes serious environmental problems in most industrialized countries, and the effort to find ecofriendly techniques for reducing water and sediment contamination is fundamental for environmental protection. Permeable barriers made of natural clays can be used as low-cost and eco-friendly materials for adsorbing heavy metals from water solution and thus reducing the sediment contamination. This study discusses the application of permeable barriers made of vermiculite clay for heavy metals remediation at the interface between water and sediments and investigates the possibility to increase their efficiency by loading the vermiculite surface with a microbial biofilm of Pseudomonas putida, which is well known to be a heavy metal accumulator. Some batch assays were performed to verify the uptake capacity of two systems and their adsorption kinetics, and the results indicated that the vermiculite bio-barrier system had a higher removal capacity than the vermiculite barrier (?34.4 and 22.8 % for Cu and Zn, respectively). Moreover, the presence of P. putida biofilm strongly contributed to fasten the kinetics of metals adsorption onto vermiculite sheets. In open-system conditions, the presence of a vermiculite barrier at the interface between water and sediment could reduce the sediment contamination up to 20 and 23 % for Cu and Zn, respectively, highlighting the efficiency of these eco-friendly materials for environmental applications. Nevertheless, the contribution of microbial biofilm in open-system setup should be optimized, and some important considerations about biofilm attachment in a continuous-flow system have been discussed.This work has been produced thanks to the collaboration of Dip.SA (University of Bologna) and IBB (University of Minho). A particular acknowledgment is due to Dr. E. Rosales. The work was partially financed by the FCT Strategic Project Pest-OE/EQB/LA0023 and the Project ‘‘BioEnv—Biotechnology and Bioengineering for a sustainable world,’’ co-funded by the Programa Operacional Regional do Norte (ON.2–O Novo Norte), QREN, FEDER