Influence of Ileo-Caecal Cannulation and Oxytetracycline on Ileo-Caecal and Rectal Coliform Populations in Pigs

The effect of surgery (insertion of an ileo-caecal cannula) and a subsequent parenteral treatment with oxytetracycline on the ileo-caecal and rectal coliform populations in 7 Swedish Yorkshire castrates were studied. Samples were collected during surgery as well as 3, 7, 14 and 20 days post surgery. The diversity of the enteric coliform flora was initially high both in the ileo-caecal ostium and in rectum. No alteration in the diversity of the enteric coliform flora was observed following surgery and treatment with oxytetracycline. As the insertion of ileo-caecal cannulas did not affect the intestinal coliform flora this study gives support to the use of this technique to mirror processes in the small intestine of pigs. Further, the diversity of the enteric coliform flora was unaffected by the parenteral treatment with oxytetracycline

Knowing, Learning and Teaching - How Homo Became Docens

Copyright © The McDonald Institute for Archaeological Research. This article discusses the relation between knowing, learning and teaching in relation to early Palaeolithic technologies. We begin by distinguishing between three kinds of knowledge: knowing how, knowing what and knowing that. We discuss the relation between these types of knowledge and different forms of learning and long-term memory systems. On the basis of this analysis, we present three types of teaching: (1) helping and correcting; (2) showing; and (3) explaining. We then use this theoretical framework to suggest what kinds of teaching are required for the pre-Oldowan, the Oldowan, the early Acheulean and the late Acheulean stone-knapping technologies. As a general introductory overview to this special section, the text concludes with a brief presentation of the papers included

Time-Dependent Density-Functional Theory for the Stopping Power of an Interacting Electron Gas for Slow Ions

Based on the time-dependent density-functional theory, we have derived a rigorous formula for the stopping power of an {\it interacting} electron gas for ions in the limit of low projectile velocities. If dynamical correlation between electrons is not taken into account, this formula recovers the corresponding stopping power of {\it noninteracting} electrons in an effective Kohn-Sham potential. The correlation effect, specifically the excitonic one in electron-hole pair excitations, however, is found to considerably enhance the stopping power for intermediately charged ions, bringing our theory into good agreement with experiment.Comment: 4 pages, 1 figure, Accepted to Phys. Rev. B (Rapid Communication

The Still Bay points of Apollo 11 Rock Shelter, Namibia : an inter-regional perspective

Abstract: Dating to roughly 80,000 to 70,000 years ago, components of the Still Bay technocomplex of southern Africa and their potential behavioural implications have been widely discussed. Stone points with invasive retouch, as defined over 90 years ago by Goodwin and van Riet Lowe, serve as markers for Still Bay assemblages, yet many Still Bay sites remain undated and comprehensive, comparable sets of data for their point assemblages remain unpublished. Much of the Middle Stone Age at the site of Apollo 11 in Namibia was undated until 2010, when a potential Still Bay component was announced. Although a Still Bay assemblage at Apollo 11 would represent the most northwesterly and inland expression of this technocomplex, its points have never been fully analysed. This paper presents their morphometric data and an interpretation of point-production strategies. These results are then compared with data obtained for two South African sites: Hollow Rock Shelter in the Western Cape and Umhlatuzana in KwaZulu-Natal. This comparison demonstrates that whereas there are no statistically significant differences in the morphometric data sets between the three sites, there are both similarities and differences in point-production strategies, cross-section shapes and the use of raw materials for knapping. It is suggested that these similarities and variations represent aspects of how knowledge-transfer systems and knapping conventions were followed on both intra-regional and inter-regional scales

Re‐examining the evidence for the mother tree hypothesis – resource sharing among trees via ectomycorrhizal networks

Seminal scientific papers positing that mycorrhizal fungal networks can distribute carbon (C) among plants have stimulated a popular narrative that overstory trees, or 'mother trees', support the growth of seedlings in this way. This narrative has far-reaching implications for our understanding of forest ecology and has been controversial in the scientific community. We review the current understanding of ectomycorrhizal C metabolism and observations on forest regeneration that make the mother tree narrative debatable. We then re-examine data and conclusions from publications that underlie the mother tree hypothesis. Isotopic labeling methods are uniquely suited for studying element fluxes through ecosystems, but the complexity of mycorrhizal symbiosis, low detection limits, and small carbon discrimination in biological processes can cause researchers to make important inferences based on miniscule shifts in isotopic abundance, which can be misleading. We conclude that evidence of a significant net C transfer via common mycorrhizal networks that benefits the recipients is still lacking. Furthermore, a role for fungi as a C pipeline between trees is difficult to reconcile with any adaptive advantages for the fungi. Finally, the hypothesis is neither supported by boreal forest regeneration patterns nor consistent with the understanding of physiological mechanisms controlling mycorrhizal symbiosis

Electronic structure investigation of Ti3AlC2, Ti3SiC2, and Ti3GeC2 by soft-X-ray emission spectroscopy

The electronic structures of epitaxially grown films of Ti3AlC2, Ti3SiC2 and Ti3GeC2 have been investigated by bulk-sensitive soft X-ray emission spectroscopy. The measured high-resolution Ti L, C K, Al L, Si L and Ge M emission spectra are compared with ab initio density-functional theory including core-to-valence dipole matrix elements. A qualitative agreement between experiment and theory is obtained. A weak covalent Ti-Al bond is manifested by a pronounced shoulder in the Ti L-emission of Ti3AlC2. As Al is replaced with Si or Ge, the shoulder disappears. For the buried Al and Si-layers, strongly hybridized spectral shapes are detected in Ti3AlC2 and Ti3SiC2, respectively. As a result of relaxation of the crystal structure and the increased charge-transfer from Ti to C, the Ti-C bonding is strengthened. The differences between the electronic structures are discussed in relation to the bonding in the nanolaminates and the corresponding change of materials properties.Comment: 15 pages, 8 figure

Magnetic properties of polymerized C60_{60} with Fe

We provide evidence that high-pressure high-temperature (2.5 GPa and 1040 K) treatment of mixtures of iron with fullerene powders leads to the complete transformation of iron into iron carbide Fe$_3$C. The comparison of the magnetic properties (Curie temperature and magnetic moment) of the here studied samples and those for the ferromagnetic polymer Rh-C$_{60}$ indicates that the main ferromagnetic signal reported in those samples is due to Fe$_3$C and not related to the ferromagnetism of carbon as originally interpreted. Taking into account the results obtained in this study the original paper on ``Magnetic carbon" (Nature {\bf 413}, 716 (2001)) was recently retracted.Comment: 5 Figures, 4 page

Guidelines for the establishment of microbiological criteria for foods

O Grupo de Trabalho Ocorrência Microbiológica na Cadeia Alimentar (GTOMCA) do Programa PortFIR considerou de grande importância o desenvolvimento de um documento que compilasse uma seleção de legislação e de informações relativas a Critérios Microbiológicos (CM), visando apoiar e facilitar, aos operadores e entidades do setor alimentar, a sua aplicação na validação do processo de produção, na segurança e/ou higiene dos géneros alimentícios, na adesão a boas práticas de fabrico dos mesmos, e/ou, ainda, na manutenção da sua qualidade durante o seu tempo de vida útil. Deste modo, o GTOMCA desenvolveu o Guia para o estabelecimento de critérios microbiológicos em géneros alimentícios, que foi publicado em abril de 2017, contemplando a identificação, caraterísticas e propósito dos CM, os fatores a considerar para a sua definição, nomeadamente: a categoria do alimento, o microrganismo e/ou as suas toxinas, os metabolitos e a virulência, os valores limite, o plano de amostragem, o tipo de utilização e consumo assim como o método de análise laboratorial, o ponto da cadeia alimentar onde se aplica, as medidas a tomar no caso de resultados não satisfatórios e a necessidade de revisão e atualização dos CM.The Working Group on Microbiological Occurrence on the Food Chain (GTOMCA) of Por tFIR Program considered unanimously, as an important need, the existence of a document with a selection and compilation of existing legislation and information concerning microbiological criteria (CM) as a tool to suppor t and facilitate its application by operators and entities in the food sector to validate the acceptability of the production process or the food safety or hygiene, the obser vance to good manufacturing practices or the maintenance of the food quality during its lifetime. So, GTOMCA developed a Guide for the establishment of microbiological criteria in foodstuf fs, which was published in April 2017, regarding the identification, characteristics and purpose of microbiological criteria, the factors to consider for its definition, identification, characteristics and purpose of CM and, as impor tant factors to consider the food categor y, the micro-organism and its metabolites, toxins and virulence factors, the limit values, the sampling plan, the type of food consumption as well as the analy tical method for testing the food, the point of the food chain where it is applied, the measures to be taken in the event of unsatisfactor y results and the need to review and update of the CM.info:eu-repo/semantics/publishedVersio

Ti3SiC2-formation during Ti–C–Si multilayer deposition by magnetron sputtering at 650 °C

Titanium Silicon Carbide films were deposited from three separate magnetrons with elemental targets onto Si wafer substrates. The substrate was moved in a circular motion such that the substrate faces each magnetron in turn and only one atomic species (Ti, Si or C) is deposited at a time. This allows layer-by-layer film deposition. Material average composition was determined to Ti0.47Si0.14C0.39 by energy-dispersive X-ray spectroscopy. High-resolution transmission electron microscopy and Raman spectroscopy were used to gain insights into thin film atomic structure arrangements. Using this new deposition technique formation of Ti3SiC2 MAX phase was obtained at a deposition temperature of 650 °C, while at lower temperatures only silicides and carbides are formed. Significant sharpening of Raman E2g and Ag peaks associated with Ti3SiC2 formation was observed