Corrosion behaviour of aluminium alloy metal matrix composite joints obtained by FSW

It was studied the corrosion behaviour of two joints, obtained by Friction Stir Welding (FSW), of aluminium alloy metal matrix composites (MMCs), reinforced with alumina particles. W6A20A and W7A10A composite joints were examined. Corrosion tests were performed in EXCO or 3.5% NaCl solutions. The corrosion rates of MMCs and joints were compared. Corrosion tests were performed on both the nugget and the thermally affected zones of the joints. Pitting potentials were measured on electrodes prepared by isolating the different zones. Short-circuit currents were measured between the nugget, the thermally affected zone and the base. The results indicated the different behaviour of the two joints: the corrosive attack on the W7A10 joint was concentrated on the nugget and in its adjacent zones both in EXCO and 3.5% sodium chloride solution; in the case of W6A20A, the nugget remained protected while the adjacent zones and the base material were corroded. Electrochemical measurements confirmed these results.However, FSW, which produces welds without the formation of a fused zone, causes structural modifications in zones near the nugget, due to the higher temperature produced by the presence of the reinforcement. This negatively affects the corrosion resistance of the composite, also in relation to the base alloy composition

Acetylenic alcohols as inhibitors of iron acid corrosion. Improvement of the inhibition efficiency of a class of substances based on their action mechanism

n/

210Pb-derived history of PAHs and PCBs accumulationin sediments of a tropical inner Lagoon (Las Matas,Gulf of Mexico) near a major oil refinery

Concentrations of polycyclic aromatic hydrocarbons (PAHs) and polychlorinated biphenyls (PCBs) were measured in a sediment core from the tropical freshwater inner lagoon of Las Matas, near the petroleum industrial area of Minatitla´n-Coatzacoalcos, in the Gulf of Mexico. A 210Pb-derived chronology was used to reconstruct the historical PAH and PCB accumulation in the site during one century (1906–2005). Both geochemical and sedimentological data indicated that a major change occurred in 1947 ± 4, including a shift to coarser sediments and a significant decrease of Al, Li, Fe, organic C and total N contents. This was likely due to the changes in hydrology caused by the confinement of Las Matas Lagoon due to the construction of the Trans-Isthmus road in 1946. PAHs in these samples show relatively low concentrations (259–1176 ng g1), and the congener relative abundances indicate the influence of pyrogenic (petroleum combustion) sources. Total PCB concentrations in the sediments ranged from 24 to 77 ng g1, and are composed by low chlorinated PCBs, with 3- and 4-CB as the prevalent species (51–65% and 29–40%, respectively). PAHs and PCBs were detected at depths corresponding to the early 1900s, when Minatitla´n refinery started operations, although their time evolution appears to be influenced by different accumulation processes. The PCB background is most likely produced by the combustion of natural organic matter, and an industrial contribution can be recognized when normalizing with OC contents. We concluded that atmospheric deposition is the most significant source of PAHs and PCBs for this water body. This study also provided evidence of the alteration of the wetlands surrounding this industrial area due to urbanization; the fragmentation and alteration of Las Matas Lagoon hydrology contributes to the gradual loss of the wetlands in the zone

Electrochemical Oxidation Assessment and Interaction of 2-aminoethanol and N, N-diethylethanamine Propagation in Acidic Medium

Electro�oxidation and inhibitor performance of copper specimens in 1 M hydrochloric acid solu� tion was investigated at room temperature by linear potentiodynamic polarization and gravimetric method in the presence of 2�aminoethanol (A) and N, N�diethylethanamine (D) as an inorganic inhibitor. The effect of the inhibitory concentration on the corrosion behavior of copper was studied over 288 hrs at 298°K. The inhibitory efficiency rise up to 96% for single induced and 98% for synergistic behavior. The adsorption mechanism characteristic was supported by SEM/EDX analysis and adsorption isotherm. From all indica� tion, the inhibitive efficiency of these compounds majorly depends on their molecular structure and concen� tration. The blocking effects of the surface interface were also explained on the basis of the inhibitor active action. 2�aminoethanol and N, N�diethylethanamine inhibits copper in 1 M HCl by strictly affecting both the anodic and cathodic sites. Portion of the surface covered calculated was also found to follow Langmuir adsorption isotherm

Polarized Neutron Reflectometry of Nickel Corrosion Inhibitors.

Polarized neutron reflectometry has been used to investigate the detailed adsorption behavior and corrosion inhibition mechanism of two surfactants on a nickel surface under acidic conditions. Both the corrosion of the nickel surface and the structure of the adsorbed surfactant layer could be monitored in situ by the use of different solvent contrasts. Layer thicknesses and roughnesses were evaluated over a range of pH values, showing distinctly the superior corrosion inhibition of one negatively charged surfactant (sodium dodecyl sulfate) compared to a positively charged example (dodecyl trimethylammonium bromide) due to its stronger binding interaction with the surface. It was found that adequate corrosion inhibition occurs at significantly less than full surface coverage.X-ray photoelectron spectra were obtained at the National Engineering and Physical Sciences Research Council (EPSRC) XPS User’s Service (NEXUS) at Newcastle University, an EPSRC midrange facility. NR data were obtained on the D17 instrument, and samples were treated in the laboratories of the Partnership for Soft Condensed Matter (PSCM) at the Institut Laue-Langevin. M.H.W. is grateful for funding from the Oppenheimer Trust.This is the final version of the article. It first appeared from the American Chemical Society via http://dx.doi.org/10.1021/acs.langmuir.5b0171

Gender Differences in Sleep Deprivation Effects on Risk and Inequality Aversion: Evidence from an Economic Experiment

Excessive working hours—even at night—are becoming increasingly common in our modern 24/7 society. The prefrontal cortex (PFC) is particularly vulnerable to the effects of sleep loss and, consequently, the specific behaviors subserved by the functional integrity of the PFC, such as risk-taking and pro-social behavior, may be affected significantly. This paper seeks to assess the effects of one night of sleep deprivation on subjects’ risk and social preferences, which are probably the most explored behavioral domains in the tradition of Experimental Economics. This novel cross-over study employs thirty-two university students (gender-balanced) participating to 2 counterbalanced laboratory sessions in which they perform standard risk and social preference elicitation protocols. One session was after one night of undisturbed sleep at home, and the other was after one night of sleep deprivation in the laboratory. Sleep deprivation causes increased sleepiness and decreased alertness in all subjects. After sleep loss males make riskier decisions compared to the rested condition, while females do the opposite. Females likewise show decreased inequity aversion after sleep deprivation. As for the relationship between cognitive ability and economic decisions, sleep deprived individuals with higher cognitive reflection show lower risk aversion and more altruistic behavior. These results show that one night of sleep deprivation alters economic behavior in a gender-sensitive way. Females’ reaction to sleep deprivation, characterized by reduced risky choices and increased egoism compared to males, may be related to intrinsic psychological gender differences, such as in the way men and women weigh up probabilities in their decision-making, and/or to the different neurofunctional substrate of their decision-making.The authors acknowledge financial support from the Spanish Ministry of Economic Competititveness (ECO2012-34928), Italian Ministry of University and Research MIUR (PRIN 20103S5RN3_002), Generalitat Valenciana (Research Projects Gruposo3/086), the Instituto Valenciano de Investigaciones Económicas (IVIE), and the Ministero della Salute (RF-2009-1528677)

Harmful Elements in Estuarine and Coastal Systems

Estuaries and coastal zones are dynamic transitional systems which provide many economic and ecological benefits to humans, but also are an ideal habitat for other organisms as well. These areas are becoming contaminated by various anthropogenic activities due to a quick economic growth and urbanization. This chapter explores the sources, chemical speciation, sediment accumulation and removal mechanisms of the harmful elements in estuarine and coastal seawaters. It also describes the effects of toxic elements on aquatic flora and fauna. Finally, the toxic element pollution of the Venice Lagoon, a transitional water body located in the northeastern part of Italy, is discussed as a case study, by presenting the procedures adopted to measure the extent of the pollution, the impacts on organisms and the restoration activities

Gli usi nella Convenzione di Vienna sulla vendita internazionale di beni mobile

Il presente lavoro si occupa della rilevanza degli usi e delle prassi contrattuali nei contratti di vendita internazionale di beni mobili alla luce della disciplina posta dalla Convenzione di Vienna del 1980 sulla vendita internazionale di beni mobil