Manufacturing flow line systems: a review of models and analytical results

The most important models and results of the manufacturing flow line literature are described. These include the major classes of models (asynchronous, synchronous, and continuous); the major features (blocking, processing times, failures and repairs); the major properties (conservation of flow, flow rate-idle time, reversibility, and others); and the relationships among different models. Exact and approximate methods for obtaining quantitative measures of performance are also reviewed. The exact methods are appropriate for small systems. The approximate methods, which are the only means available for large systems, are generally based on decomposition, and make use of the exact methods for small systems. Extensions are briefly discussed. Directions for future research are suggested.National Science Foundation (U.S.) (Grant DDM-8914277

Search for gravitational waves associated with the gamma ray burst GRB030329 using the LIGO detectors

We have performed a search for bursts of gravitational waves associated with the very bright gamma ray burst GRB030329, using the two detectors at the LIGO Hanford Observatory. Our search covered the most sensitive frequency range of the LIGO detectors (approximately 80 - 2048 Hz), and we specifically targeted signals shorter than 150ms. Our search algorithm looks for excess correlated power between the two interferometers and thus makes minimal assumptions about the gravitational waveform. We observed no candidates with gravitational-wave signal strength larger than a predetermined threshold. We report frequency-dependent upper limits on the strength of the gravitational waves associated with GRB030329. Near the most sensitive frequency region, around 250Hz, our root-sum-square (RSS) gravitational-wave strain sensitivity for optimally polarized bursts was better than hRSS 6×10-21Hz-1/2. Our result is comparable to the best published results searching for association between gravitational waves and gamma ray bursts. © 2005 The American Physical Society

Limits on gravitational-wave emission from selected pulsars using LIGO data

We place direct upper limits on the amplitude of gravitational waves from 28 isolated radio pulsars by a coherent multidetector analysis of the data collected during the second science run of the LIGO interferometric detectors. These are the first direct upper limits for 26 of the 28 pulsars. We use coordinated radio observations for the first time to build radio-guided phase templates for the expected gravitational-wave signals. The unprecedented sensitivity of the detectors allows us to set strain upper limits as low as a few times 10-24. These strain limits translate into limits on the equatorial ellipticities of the pulsars, which are smaller than 10-5 for the four closest pulsars. © 2005 The American Physical Society

Emerging CO2 capture systems

In 2005, the IPCC SRCCS recognized the large potential for developing and scaling up a wide range of emerging CO2 capture technologies that promised to deliver lower energy penalties and cost. These included new energy conversion technologies such as chemical looping and novel capture systems based on the use of solid sorbents or membrane-based separation systems. In the last 10 years, a substantial body of scientific and technical literature on these topics has been produced from a large number of R&D projects worldwide, trying to demonstrate these concepts at increasing pilot scales, test and model the performance of key components at bench scale, investigate and develop improved functional materials, optimize the full process schemes with a view to a wide range of industrial applications, and to carry out more rigorous cost studies etc. This paper presents a general and critical review of the state of the art of these emerging CO2 capture technologies paying special attention to specific process routes that have undergone a substantial increase in technical readiness level toward the large scales required by any CO2 capture system

Pathways for Deploying Low-emission Technologies in an Integrated Electricity Market: An Australian Case Study

AbstractIn this paper, Australia is used as a case study to evaluate potential pathways for staged deployment of low-emission technologies in an integrated, emission intensive electricity market. We assume that carbon capture and storage is implemented at existing and new power plants. To meet projected demand increase by 2050, the total generation capac ty increases by 35%. The cost of electricity in 2050 is more than double the current value, with a moderate annual increase between now and then. An 80% emission reduction target can be achieved by 2050. The results are compared with the future generation scenarios previously analysed by CSIRO and AEMO