758 research outputs found
Seasonal cycle in atmospheric HCl at 45 deg S
High resolution Fourier transform infrared interferometric atmospheric solar absorption measurements have been performed at the National Institute for Water and Atmospheric Research Laboratory at Lauder, New Zealand on a routine basis since October 1989. This laboratory has been selected as the Mid-latitude Charter Site of the Network for the Detection of Stratospheric Change and is at a latitude of 45 deg S. Particular attention has been paid to the absorption by atmospheric hydrogen chloride at 2925.9 cm(exp -1) and in this paper the results of the seasonal cycle in CHl above Lauder will be presented. Because of the very clean troposphere at this site, the CHl column measured from the ground is essentially a stratospheric column measurement
Dynamical Masses for Pre-Main Sequence Stars: A Preliminary Physical Orbit for V773 Tau A
We report on interferometric and radial-velocity observations of the
double-lined 51-d period binary (A) component of the quadruple pre-main
sequence (PMS) system V773 Tau. With these observations we have estimated
preliminary visual and physical orbits of the V773 Tau A subsystem. Among other
parameters, our orbit model includes an inclination of 66.0 2.4 deg, and
allows us to infer the component dynamical masses and system distance. In
particular we find component masses of 1.54 0.14 and 1.332 0.097
M_{\sun} for the Aa (primary) and Ab (secondary) components respectively.
Our modeling of the subsystem component spectral energy distributions finds
temperatures and luminosities consistent with previous studies, and coupled
with the component mass estimates allows for comparison with PMS stellar models
in the intermediate-mass range. We compare V773 Tau A component properties with
several popular solar-composition models for intermediate-mass PMS stars. All
models predict masses consistent to within 2-sigma of the dynamically
determined values, though some models predict values that are more consistent
than others.Comment: ApJ in press; 25 pages, 6 figures; data tables available in journal
versio
Particles at oil–air surfaces : powdered oil, liquid oil marbles, and oil foam
The type of material stabilized by four kinds of fluorinated particles (sericite and bentonite platelet clays and spherical zinc oxide) in air–oil mixtures has been investigated. It depends on the particle wettability and the degree of shear. Upon vigorous agitation, oil dispersions are formed in all the oils containing relatively large bentonite particles and in oils of relatively low surface tension (γla < 26 mN m⁻¹) like dodecane, 20 cS silicone, and cyclomethicone containing the other fluorinated particles. Particle-stabilized oil foams were obtained in oils having γla > 26 mN m⁻¹ where the advancing air–oil–solid contact angle θ lies between ca. 90° and 120°. Gentle shaking, however, gives oil-in-air liquid marbles with all the oil–particle systems except for cases where θ is <60°. For oils of tension >24 mN m⁻¹ with omniphobic zinc oxide and sericite particles for which advancing θ ≥ 90°, dry oil powders consisting of oil drops in air which do not leak oil could be made upon gentle agitation up to a critical oil:particle ratio (COPR). Above the COPR, catastrophic phase inversion of the dry oil powders to air-in-oil foams was observed. When sheared on a substrate, the dry oil powders containing at least 60 wt % of oil release the encapsulated oil, making these materials attractive formulations in the cosmetic and food industries
Recommended from our members
Phosphorus sources for phosphatic Cambrian carbonates
The fossilization of organic remains and shell material by calcium phosphate minerals provides an illuminating, but time-bounded, window into Ediacaran–Cambrian animal evolution. For reasons that remain unknown, phosphatic fossil preservation declined significantly through Cambrian Series 2. Here, we investigate the phosphorus (P) sources for phosphatic Cambrian carbonates, presenting sedimentological, petrographic, and geochemical data from the Cambrian Series 2–3 Thorntonia Limestone, Australia, some of the youngest Cambrian strata to display exceptional phosphatic preservation of small shelly fossils. We find that within Thorntonia sediments, phosphate was remobilized by organic decay and bacterial iron reduction, with subsequent reprecipitation largely as apatite within the interiors of small shelly fossils. We discuss the merits of bioclastic-derived, organic matter–bound, or iron-bound P as potential sources to these strata. Petrographic observations suggest that the dissolution of phosphatic skeletal material did not provide the P for fossil preservation. In contrast, high organic carbon contents imply significant organic fluxes of P to Thorntonia sediments. Sedimentology and iron-speciation data indicate that phosphorus enrichment occurred during times of expanded anoxic, ferruginous conditions in subsurface water masses, suggesting that phosphorus adsorption to iron minerals precipitating from the water column provided a second significant P source to Thorntonia sediments. Simple stoichiometric models suggest that, by themselves, neither organic carbon burial nor an iron shuttle can account for the observed phosphorus enrichment. Thus, we infer that both processes were necessary for the observed phosphorus enrichment and subsequent fossil preservation in the Thorntonia Limestone.Earth and Planetary Science
Oceanospirillales containing the DMSP lyase DddD are key utilisers of carbon from DMSP in coastal seawater
Background: Ubiquitous and diverse marine microorganisms utilise the abundant organosulfur molecule dimethylsulfoniopropionate (DMSP), the main precursor of the climate-active gas dimethylsulfide (DMS), as a source of carbon, sulfur and/or signalling molecules. However, it is currently difficult to discern which microbes actively catabolise DMSP in the environment, why they do so and the pathways used. Results: Here, a novel DNA-stable isotope probing (SIP) approach, where only the propionate and not the DMS moiety of DMSP was 13C-labelled, was strategically applied to identify key microorganisms actively using DMSP and also likely DMS as a carbon source, and their catabolic enzymes, in North Sea water. Metagenomic analysis of natural seawater suggested that Rhodobacterales (Roseobacter group) and SAR11 bacteria were the major microorganisms degrading DMSP via demethylation and, to a lesser extent, DddP-driven DMSP lysis pathways. However, neither Rhodobacterales and SAR11 bacteria nor their DMSP catabolic genes were prominently labelled in DNA-SIP experiments, suggesting they use DMSP as a sulfur source and/or in signalling pathways, and not primarily for carbon requirements. Instead, DNA-SIP identified gammaproteobacterial Oceanospirillales, e.g. Amphritea, and their DMSP lyase DddD as the dominant microorganisms/enzymes using DMSP as a carbon source. Supporting this, most gammaproteobacterial (with DddD) but few alphaproteobacterial seawater isolates grew on DMSP as sole carbon source and produced DMS. Furthermore, our DNA-SIP strategy also identified Methylophaga and other Piscirickettsiaceae as key bacteria likely using the DMS, generated from DMSP lysis, as a carbon source. Conclusions: This is the first study to use DNA-SIP with 13C-labelled DMSP and, in a novel way, it identifies the dominant microbes utilising DMSP and DMS as carbon sources. It highlights that whilst metagenomic analyses of marine environments can predict microorganisms/genes that degrade DMSP and DMS based on their abundance, it cannot disentangle those using these important organosulfur compounds for their carbon requirements. Note, the most abundant DMSP degraders, e.g. Rhodobacterales with DmdA, are not always the key microorganisms using DMSP for carbon and releasing DMS, which in this coastal system were Oceanospirillales containing DddD. [MediaObject not available: see fulltext.]
A new interpretation of total column BrO during Arctic spring
Emission of bromine from sea-salt aerosol, frost flowers, ice leads, and snow results in the nearly complete removal of surface ozone during Arctic spring. Regions of enhanced total column BrO observed by satellites have traditionally been associated with these emissions. However, airborne measurements of BrO and O3 within the convective boundary layer (CBL) during the ARCTAS and ARCPAC field campaigns at times bear little relation to enhanced column BrO. We show that the locations of numerous satellite BrO “hotspots” during Arctic spring are consistent with observations of total column ozone and tropopause height, suggesting a stratospheric origin to these regions of elevated BrO. Tropospheric enhancements of BrO large enough to affect the column abundance are also observed, with important contributions originating from above the CBL. Closure of the budget for total column BrO, albeit with significant uncertainty, is achieved by summing observed tropospheric partial columns with calculated stratospheric partial columns provided that natural, short-lived biogenic bromocarbons supply between 5 and 10 ppt of bromine to the Arctic lowermost stratosphere. Proper understanding of bromine and its effects on atmospheric composition requires accurate treatment of geographic variations in column BrO originating from both the stratosphere and troposphere
Scoping review of priority setting of research topics for musculoskeletal conditions
Objective Describe research methods used in priority-setting exercises for musculoskeletal conditions and synthesise the priorities identified. Design Scoping review. Setting and population Studies that elicited the research priorities of patients/consumers, clinicians, researchers, policy-makers and/or funders for any musculoskeletal condition were included. Methods and analysis We searched MEDLINE and EMBASE from inception to November 2017 and the James Lind Alliance top 10 priorities, Cochrane Priority Setting Methods Group, and Cochrane Musculoskeletal and Back Groups review priority lists. The reported methods and research topics/questions identified were extracted, and a descriptive synthesis conducted. Results Forty-nine articles fulfilled our inclusion criteria. Methodologies and stakeholders varied widely (26 included a mix of clinicians, consumers and others, 16 included only clinicians, 6 included only consumers or patients and in 1 participants were unclear). Only two (4%) reported any explicit inclusion criteria for priorities. We identified 294 broad research priorities from 37 articles and 246 specific research questions from 17 articles, although only four (24%) of the latter listed questions in an actionable format. Research priorities for osteoarthritis were identified most often (n=7), followed by rheumatoid arthritis (n=4), osteoporosis (n=4) and back pain (n=4). Nearly half of both broad and specific research priorities were focused on treatment interventions (n=116 and 111, respectively), while few were economic (n=8, 2.7% broad and n=1, 0.4% specific), implementation (n=6, 2% broad and n=4, 1.6% specific) or health services and systems research (n=15, 5.1% broad and n=9, 3.7% specific) priorities. Conclusions While many research priority-setting studies in the musculoskeletal field have been performed, methodological limitations and lack of actionable research questions limit their usefulness. Future studies should ensure they conform to good priority-setting practice to ensure that the generated priorities are of maximum value. PROSPERO registration number CRD42017059250
Recommended from our members
Sediment structure and physicochemical changes following tidal inundation at a large open coast managed realignment site
Managed realignment (MR) schemes are being implemented to compensate for the loss of intertidal saltmarsh habitats by breaching flood defences and inundating the formerly defended coastal hinterland. However, studies have shown that MR sites have lower biodiversity than anticipated, which has been linked with anoxia and poor drainage resulting from compaction and the collapse of sediment pore space caused by the site's former terrestrial land use. Despite this proposed link between biodiversity and soil structure, the evolution of the sediment sub-surface following site inundation has rarely been examined, particularly over the early stages of the terrestrial to marine or estuarine transition. This paper presents a novel combination of broad- and intensive-scale analysis of the sub-surface evolution of the Medmerry Managed Realignment Site (West Sussex, UK) in the three years following site inundation. Repeated broad-scale sediment physiochemical datasets are analysed to assess the early changes in the sediment subsurface and the preservation of the former terrestrial surface, comparing four locations of different former land uses. Additionally, for two of these locations, high-intensity 3D-computed X-ray microtomography and Itrax micro-X-ray fluorescence spectrometry analyses are presented. Results provide new data on differences in sediment properties and structure related to the former land use, indicating that increased agricultural activity leads to increased compaction and reduced porosity. The presence of anoxic conditions, indicative of poor hydrological connectivity between the terrestrial and post-inundation intertidal sediment facies, was only detected at one site. This site has experienced the highest rate of accretion over the terrestrial surface (ca. 7 cm over 36 months), suggesting that poor drainage is caused by the interaction (or lack of) between sediment facies rather than the former land use. This has significant implications for the design of future MR sites in terms of preparing sites, their anticipated evolution, and the delivery of ecosystem services
The economic and innovation contribution of universities: a regional perspective
Universities and other higher education institutions (HEIs) have come to be regarded as key sources of knowledge utilisable in the pursuit of economic growth. Although there have been numerous studies assessing the economic and innovation impact of HEIs, there has been little systematic analysis of differences in the relative contribution of HEIs across regions. This paper provides an exploration of some of these differences in the context of the UK’s regions. Significant differences are found in the wealth generated by universities according to regional location and type of institution. Universities in more competitive regions are generally more productive than those located in less competitive regions. Also, traditional universities are generally more productive than their newer counterparts, with university productivity positively related to knowledge commercialisation capabilities. Weaker regions tend to be more dependent on their universities for income and innovation, but often these universities under-perform in comparison to counterpart institutions in more competitive regions. It is argued that uncompetitive regions lack the additional knowledge infrastructure, besides universities, that are more commonly a feature of more competitive regions
- …