140 research outputs found
Microscopic mechanisms of spin-dependent electric polarization in 3d oxides
We present a short critical overview of different microscopic models for
nonrelativistic and relativistic magnetoelectric coupling including the
so-called "spin current scenario", ab-initio calculations, and several recent
microscopic approaches to a spin-dependent electric polarization in 3d oxides.Comment: 8 pages, 3 figure
Wavefunction topology of two-dimensional time-reversal symmetric superconductors
We discuss the topology of the wavefunctions of two-dimensional time-reversal
symmetric superconductors. We consider (a) the planar state, (b) a system with
broken up-down reflection symmetry, and (c) a system with general spin-orbit
interaction. We show explicitly how the relative sign of the order parameter on
the two Fermi surfaces affects this topology, and clarify the meaning of the
classification for these topological states.Comment: only the Introduction has been modified from v
Far-infrared optical excitations in multiferroic TbMnO_3
We provide a detailed study of the reflectivity of multiferroic TbMnO_3 for
wave numbers from 40 cm^{-1} to 1000 cm^{-1} and temperatures 5 K < T < 300 K.
Excitations are studied for polarization directions E || a, the polarization
where electromagnons are observed, and for E || c, the direction of the
spontaneous polarization in this material. The temperature dependencies of
eigenfrequencies, damping constants and polar strengths of all modes are
studied and analyzed. For E || a and below the spiral ordering temperature of
about 27 K we observe a transfer of optical weight from phonon excitations to
electromagnons, which mainly involves low-frequency phonons. For E || c an
unusual increase of the total polar strength and hence of the dielectric
constant is observed indicating significant transfer of dynamic charge probably
within manganese-oxygen bonds on decreasing temperatures.Comment: 8 pages, 7 figures, accepted for submission in European Physical
Journal
Plasma-wall interaction studies within the EUROfusion consortium: Progress on plasma-facing components development and qualification
This work has been carried out within the framework of the EUROfusion Consortium and has received funding from the Euratom research and training programme 2014-2018 under grant agreement No 633053. The views and opinions expressed herein do not necessarily reflect those of the European Commission.The provision of a particle and power exhaust solution which is compatible with first-wall components and edge-plasma conditions is a key area of present-day fusion research and mandatory for a successful operation of ITER and DEMO. The work package plasma-facing components (WP PFC) within the European fusion programme complements with laboratory experiments, i.e. in linear plasma devices, electron and ion beam loading facilities, the studies performed in toroidally confined magnetic devices, such as JET, ASDEX Upgrade, WEST etc. The connection of both groups is done via common physics and engineering studies, including the qualification and specification of plasma-facing components, and by modelling codes that simulate edge-plasma conditions and the plasma-material interaction as well as the study of fundamental processes. WP PFC addresses these critical points in order to ensure reliable and efficient use of conventional, solid PFCs in ITER (Be and W) and DEMO (W and steel) with respect to heat-load capabilities (transient and steady-state heat and particle loads), lifetime estimates (erosion, material mixing and surface morphology), and safety aspects (fuel retention, fuel removal, material migration and dust formation) particularly for quasi-steady-state conditions. Alternative scenarios and concepts (liquid Sn or Li as PFCs) for DEMO are developed and tested in the event that the conventional solution turns out to not be functional. Here, we present an overview of the activities with an emphasis on a few key results: (i) the observed synergistic effects in particle and heat loading of ITER-grade W with the available set of exposition devices on material properties such as roughness, ductility and microstructure; (ii) the progress in understanding of fuel retention, diffusion and outgassing in different W-based materials, including the impact of damage and impurities like N; and (iii), the preferential sputtering of Fe in EUROFER steel providing an in situ W surface and a potential first-wall solution for DEMO.European Commission; Consortium for Ocean Leadership 633053; Institute of Solid State Physics, University of Latvia as the Center of Excellence has received funding from the European Union’s Horizon 2020 Framework Programme H2020-WIDESPREAD-01-2016-2017-TeamingPhase2 under grant agreement No. 739508, project CAMART
On the mechanisms governing gas penetration into a tokamak plasma during a massive gas injection
A new 1D radial fluid code, IMAGINE, is used to simulate the penetration of gas into a tokamak plasma during a massive gas injection (MGI). The main result is that the gas is in general strongly braked as it reaches the plasma, due to mechanisms related to charge exchange and (to a smaller extent) recombination. As a result, only a fraction of the gas penetrates into the plasma. Also, a shock wave is created in the gas which propagates away from the plasma, braking and compressing the incoming gas. Simulation results are quantitatively consistent, at least in terms of orders of magnitude, with experimental data for a D 2 MGI into a JET Ohmic plasma. Simulations of MGI into the background plasma surrounding a runaway electron beam show that if the background electron density is too high, the gas may not penetrate, suggesting a possible explanation for the recent results of Reux et al in JET (2015 Nucl. Fusion 55 093013)
Velocity-space sensitivity of the time-of-flight neutron spectrometer at JET
The velocity-space sensitivities of fast-ion diagnostics are often described by so-called weight functions. Recently, we formulated weight functions showing the velocity-space sensitivity of the often dominant beam-target part of neutron energy spectra. These weight functions for neutron emission spectrometry (NES) are independent of the particular NES diagnostic. Here we apply these NES weight functions to the time-of-flight spectrometer TOFOR at JET. By taking the instrumental response function of TOFOR into account, we calculate time-of-flight NES weight functions that enable us to directly determine the velocity-space sensitivity of a given part of a measured time-of-flight spectrum from TOFOR
Relationship of edge localized mode burst times with divertor flux loop signal phase in JET
A phase relationship is identified between sequential edge localized modes (ELMs) occurrence times in a set of H-mode tokamak plasmas to the voltage measured in full flux azimuthal loops in the divertor region. We focus on plasmas in the Joint European Torus where a steady H-mode is sustained over several seconds, during which ELMs are observed in the Be II emission at the divertor. The ELMs analysed arise from intrinsic ELMing, in that there is no deliberate intent to control the ELMing process by external means. We use ELM timings derived from the Be II signal to perform direct time domain analysis of the full flux loop VLD2 and VLD3 signals, which provide a high cadence global measurement proportional to the voltage induced by changes in poloidal magnetic flux. Specifically, we examine how the time interval between pairs of successive ELMs is linked to the time-evolving phase of the full flux loop signals. Each ELM produces a clear early pulse in the full flux loop signals, whose peak time is used to condition our analysis. The arrival time of the following ELM, relative to this pulse, is found to fall into one of two categories: (i) prompt ELMs, which are directly paced by the initial response seen in the flux loop signals; and (ii) all other ELMs, which occur after the initial response of the full flux loop signals has decayed in amplitude. The times at which ELMs in category (ii) occur, relative to the first ELM of the pair, are clustered at times when the instantaneous phase of the full flux loop signal is close to its value at the time of the first ELM
Coordination compounds of some d metals with anthrapyridinedione derivatives: Crystal structure of 2-phenyl-4-(piperidyl-1)-anthra[1,2-b] pyridine-7,12-dionium hexabromodicuprate(II) (HL1) 2[Cu2Br6]
Complexes of copper(II), nickel(II), and cobalt(II) chlorides and bromides with 2-phenyl-4- (piperidyl-1)-anthra[1,2-b]pyridine-7,12-dione (L1) and 2-[phenyl-4-(octylamino)-anthra[1,2-b]pyridine- 7,12-dione (L2) were synthesized from neutral and acidic media. The molecular and crystal structure of 2-phenyl-4-(piperidyl-1)-anthra[1,2-b]pyridine-7,12-dionium hexabromodicuprate(II) (HL1)2[Cu2Br6] was determined by X-ray diffraction analysis. The spectral characteristics of L1 and L2 and their complexes are presented. Formation of their complexes in solutions was studied. © Pleiades Publishing, Ltd., 2012
- …