125 research outputs found
Canopy Temperature and Vegetation Indices from High-Throughput Phenotyping Improve Accuracy of Pedigree and Genomic Selection for Grain Yield in Wheat
Citation: Rutkoski, J., . . . Singh, R. (2016). Canopy Temperature and Vegetation Indices from High-Throughput Phenotyping Improve Accuracy of Pedigree and Genomic Selection for Grain Yield in Wheat. G3-Genes Genomes Genetics, 6(9), 2799-2808.
https://doi.org/10.1534/g3.116.032888Genomic selection can be applied prior to phenotyping, enabling shorter breeding cycles and greater rates of genetic gain relative to phenotypic selection. Traits measured using high-throughput phenotyping based on proximal or remote sensing could be useful for improving pedigree and genomic prediction model accuracies for traits not yet possible to phenotype directly. We tested if using aerial measurements of canopy temperature, and green and red normalized difference vegetation index as secondary traits in pedigree and genomic best linear unbiased prediction models could increase accuracy for grain yield in wheat, Triticum aestivum L., using 557 lines in five environments. Secondary traits on training and test sets, and grain yield on the training set were modeled as multivariate, and compared to univariate models with grain yield on the training set only. Cross validation accuracies were estimated within and across-environment, with and without replication, and with and without correcting for days to heading. We observed that, within environment, with unreplicated secondary trait data, and without correcting for days to heading, secondary traits increased accuracies for grain yield by 56% in pedigree, and 70% in genomic prediction models, on average. Secondary traits increased accuracy slightly more when replicated, and considerably less when models corrected for days to heading. In across-environment prediction, trends were similar but less consistent. These results show that secondary traits measured in high-throughput could be used in pedigree and genomic prediction to improve accuracy. This approach could improve selection in wheat during early stages if validated in early-generation breeding plots
Wheat quality improvement at CIMMYT and the use of genomic selection on it
Citation: Guzman, C., Pena, R. J., Singh, R., Autrique, E., Dreisigacker, S., Crossa, J., . . . Battenfield, S. (2016). Wheat quality improvement at CIMMYT and the use of genomic selection on it. Applied and Translational Genomics, 11, 3-8.
https://doi.org/10.1016/j.atg.2016.10.004The International Center for Maize and Wheat Improvement (CIMMYT) leads the Global Wheat Program, whose main objective is to increase the productivity of wheat cropping systems to reduce poverty in developing countries. The priorities of the program are high grain yield, disease resistance, tolerance to abiotic stresses (drought and heat), and desirable quality. The Wheat Chemistry and Quality Laboratory has been continuously evolving to be able to analyze the largest number of samples possible, in the shortest time, at lowest cost, in order to deliver data on diverse quality traits on time to the breeders formaking selections for advancement in the breeding pipeline. The participation of wheat quality analysis/selection is carried out in two stages of the breeding process: evaluation of the parental lines for new crosses and advanced lines in preliminary and elite yield trials. Thousands of lines are analyzed which requires a big investment in resources. Genomic selection has been proposed to assist in selecting for quality and other traits in breeding programs. Genomic selection can predict quantitative traits and is applicable to multiple quantitative traits in a breeding pipeline by attaining historical phenotypes and adding high-density genotypic information. Due to advances in sequencing technology, genome-wide single nucleotide polymorphism markers are available through genotyping-by-sequencing at a cost conducive to application for genomic selection. At CIMMYT, genomic selection has been applied to predict all of the processing and end-use quality traits regularly tested in the spring wheat breeding program. These traits have variable levels of prediction accuracy, however, they demonstrated that most expensive traits, dough rheology and baking final product, can be predicted with a high degree of confidence. Currently it is being explored how to combine both phenotypic and genomic selection to make more efficient the genetic improvement for quality traits at CIMMYT spring wheat breeding program. (C) 2016 The Authors. Published by Elsevier B.V. This is an open access article under the CC BY-NC-ND license
Application of unmanned aerial systems for high throughput phenotyping of large wheat breeding nurseries
Citation: Haghighattalab, A., Perez, L. G., Mondal, S., Singh, D., Schinstock, D., Rutkoski, J., . . . Poland, J. (2016). Application of unmanned aerial systems for high throughput phenotyping of large wheat breeding nurseries. Plant Methods, 12, 15.
https://doi.org/10.1186/s13007-016-0134-6Background: Low cost unmanned aerial systems (UAS) have great potential for rapid proximal measurements of plants in agriculture. In the context of plant breeding and genetics, current approaches for phenotyping a large number of breeding lines under field conditions require substantial investments in time, cost, and labor. For field-based high-throughput phenotyping (HTP), UAS platforms can provide high-resolution measurements for small plot research, while enabling the rapid assessment of tens-of-thousands of field plots. The objective of this study was to complete a baseline assessment of the utility of UAS in assessment field trials as commonly implemented in wheat breeding programs. We developed a semi-automated image-processing pipeline to extract plot level data from UAS imagery. The image dataset was processed using a photogrammetric pipeline based on image orientation and radiometric calibration to produce orthomosaic images. We also examined the relationships between vegetation indices (VIs) extracted from high spatial resolution multispectral imagery collected with two different UAS systems (eBee Ag carrying MultiSpec 4C camera, and IRIS+ quadcopter carrying modified NIR Canon S100) and ground truth spectral data from hand-held spectroradiometer. Results: We found good correlation between the VIs obtained from UAS platforms and ground-truth measurements and observed high broad-sense heritability for VIs. We determined radiometric calibration methods developed for satellite imagery significantly improved the precision of VIs from the UAS. We observed VIs extracted from calibrated images of Canon S100 had a significantly higher correlation to the spectroradiometer (r = 0.76) than VIs from the MultiSpec 4C camera (r = 0.64). Their correlation to spectroradiometer readings was as high as or higher than repeated measurements with the spectroradiometer per se. Conclusion: The approaches described here for UAS imaging and extraction of proximal sensing data enable collection of HTP measurements on the scale and with the precision needed for powerful selection tools in plant breeding. Low-cost UAS platforms have great potential for use as a selection tool in plant breeding programs. In the scope of tools development, the pipeline developed in this study can be effectively employed for other UAS and also other crops planted in breeding nurseries
Multivariate Genomic Selection and Potential of Rapid Indirect Selection with Speed Breeding in Spring Wheat
Genomic selection (GS) can be effective in breeding for quantitative traits, such as yield, by reducing the selection cycle duration. Speed breeding (SB) uses extended photoperiod and temperature control to enable rapid generation advancement. Together, GS and SB can synergistically reduce the breeding cycle by quickly producing recombinant inbred lines (RILs) and enabling indirect phenotypic selection to improve for key traits, such as height and flowering time, prior to field trials. In addition, traits measured under SB (SB traits) correlated with field-based yield could improve yield prediction in multivariate GS. A 193-line spring wheat (Triticum aestivum L.) training population (TP), tested for grain yield in the field in multiple environments, was used to predict grain yield of a 350-line selection candidate (SC) population, across multiple environments. Four SB traits measured on the TP and SC populations were used to derive principal components, which were incorporated into multivariate GS models. Predictive ability was significantly increased by multivariate GS, in some cases being twice as high as univariate GS. Based on these results, an efficient breeding strategy is proposed combining SB and multivariate GS using yield-correlated SB traits for yield prediction. The potential for early indirect SB phenotypic selection for targeted population improvement prior to trials was also investigated. Plant height and flowering time showed strong relative predicted efficiency to indirect selection, in some cases as high as direct field selection. The higher selection intensity and rate of generation turnover under SB may enable a greater rate of genetic gain than direct field phenotyping
CGIAR modeling approaches for resource-constrained scenarios: I. Accelerating crop breeding for a changing climate.
Crop improvement efforts aiming at increasing crop production (quantity, quality) and adapting to climate change have been subject of active research over the past years. But, the question remains 'to what extent can breeding gains be achieved under a changing climate, at a pace sufficient to usefully contribute to climate adaptation, mitigation and food security?'. Here, we address this question by critically reviewing how model-based approaches can be used to assist breeding activities, with particular focus on all CGIAR (formerly the Consultative Group on International Agricultural Research but now known simply as CGIAR) breeding programs. Crop modeling can underpin breeding efforts in many different ways, including assessing genotypic adaptability and stability, characterizing and identifying target breeding environments, identifying tradeoffs among traits for such environments, and making predictions of the likely breeding value of the genotypes. Crop modeling science within the CGIAR has contributed to all of these. However, much progress remains to be done if modeling is to effectively contribute to more targeted and impactful breeding programs under changing climates. In a period in which CGIAR breeding programs are undergoing a major modernization process, crop modelers will need to be part of crop improvement teams, with a common understanding of breeding pipelines and model capabilities and limitations, and common data standards and protocols, to ensure they follow and deliver according to clearly defined breeding products. This will, in turn, enable more rapid and better-targeted crop modeling activities, thus directly contributing to accelerated and more impactful breeding efforts.Online Version of Record before inclusion in an issue
GenomeâWide Association Mapping for Leaf Tip Necrosis and Pseudoâblack Chaff in Relation to Durable Rust Resistance in Wheat
Scanning and filling : ultra-dense SNP genotyping combining genotyping-by-sequencing, SNP array and whole-genome resequencing data
Genotyping-by-sequencing (GBS) represents a highly cost-effective high-throughput genotyping
approach. By nature, however, GBS is subject to generating sizeable amounts of
missing data and these will need to be imputed for many downstream analyses. The extent
to which such missing data can be tolerated in calling SNPs has not been explored widely.
In this work, we first explore the use of imputation to fill in missing genotypes in GBS datasets.
Importantly, we use whole genome resequencing data to assess the accuracy of the
imputed data. Using a panel of 301 soybean accessions, we show that over 62,000 SNPs
could be called when tolerating up to 80% missing data, a five-fold increase over the number
called when tolerating up to 20% missing data. At all levels of missing data examined
(between 20% and 80%), the resulting SNP datasets were of uniformly high accuracy (96â
98%). We then used imputation to combine complementary SNP datasets derived from
GBS and a SNP array (SoySNP50K). We thus produced an enhanced dataset of >100,000
SNPs and the genotypes at the previously untyped loci were again imputed with a high level
of accuracy (95%). Of the >4,000,000 SNPs identified through resequencing 23 accessions
(among the 301 used in the GBS analysis), 1.4 million tag SNPs were used as a reference
to impute this large set of SNPs on the entire panel of 301 accessions. These previously
untyped loci could be imputed with around 90% accuracy. Finally, we used the 100K SNP
dataset (GBS + SoySNP50K) to perform a GWAS on seed oil content within this collection
of soybean accessions. Both the number of significant marker-trait associations and the
peak significance levels were improved considerably using this enhanced catalog of SNPs
relative to a smaller catalog resulting from GBS alone at 20% missing data. Our results
demonstrate that imputation can be used to fill in both missing genotypes and untyped loci
with very high accuracy and that this leads to more powerful genetic analyses
Machine Learning Approach for Prescriptive Plant Breeding
We explored the capability of fusing high dimensional phenotypic trait (phenomic) data with a machine learning (ML) approach to provide plant breeders the tools to do both in-season seed yield (SY) prediction and prescriptive cultivar development for targeted agro-management practices (e.g., row spacing and seeding density). We phenotyped 32 SoyNAM parent genotypes in two independent studies each with contrasting agro-management treatments (two row spacing, three seeding densities). Phenotypic trait data (canopy temperature, chlorophyll content, hyperspectral reflectance, leaf area index, and light interception) were generated using an array of sensors at three growth stages during the growing season and seed yield (SY) determined by machine harvest. Random forest (RF) was used to train models for SY prediction using phenotypic traits (predictor variables) to identify the optimal temporal combination of variables to maximize accuracy and resource allocation. RF models were trained using data from both experiments and individually for each agro-management treatment. We report the most important traits agnostic of agro-management practices. Several predictor variables showed conditional importance dependent on the agro-management system. We assembled predictive models to enable in-season SY prediction, enabling the development of a framework to integrate phenomics information with powerful ML for prediction enabled prescriptive plant breeding
Boosting predictive ability of tropical maize hybrids via genotype-by-environment interaction under multivariate GBLUP models.
Genomic selection has been implemented in several plant and animal breeding programs and it has proven to improve efficiency and maximize genetic gains. Phenotypic data of grain yield was measured in 147 maize (Zea mays L.) singlecross hybrids at 12 environments. Single-cross hybrids genotypes were inferred based on their parents (inbred lines) via single nucleotide polymorphism (SNP) markers obtained from genotyping-by-sequencing (GBS). Factor analytic multiplicative genomic best linear unbiased prediction (GBLUP) models, in the framework of multienvironment trials, were used to predict grain yield performance of unobserved tropical maize single-cross hybrids. Predictions were performed for two situations: untested hybrids (CV1), and hybrids evaluated in some environments but missing in others (CV2). Models that borrowed information across individuals through genomic relationships and within individuals across environments presented higher predictive accuracy than those models that ignored it. For these models, predictive accuracies were up to 0.4 until eight environments were considered as missing for the validation set, which represents 67% of missing data for a given hybrid. These results highlight the importance of including genotype-by-environment interactions and genomic relationship information for boosting predictions of tropical maize single-cross hybrids for grain yield
- âŠ