451 research outputs found

    Theoretical design proposal for simulated hot asphalt mixture at a temperature below zero degrees Celsius

    Get PDF
    In the world there are adverse climates, climates that hinder the good construction and paving of roads, generating insecurity among the locals and visitors. This over time affects the economy of a country, as a road boosts tourism, transport and commerce. Therefore, a mixture was designed to mitigate a problem in the placement of hot asphalt mixture at temperatures below zero degrees Celsius. That is, a conventional mix design was proposed, but with different types of filler (lime, Portland cement type I and silica) tested with the Marshall and Lottman method which are governed according to the EG-2013 standards [1] and parameters established in the Asphalt Institute [2]. To find the optimum, it was tested with 5.0%, 5.5% 6.0% and 6.5% asphalt cement. Then with the results obtained a comparative analysis was performed. Finally, specimens without any additives were made, the specimens once prepared at 140°C were subjected to freezing, resulting in the three types of filler, that the hot asphalt mixture with incorporation of Portland cement type I to a 5, 90% of asphalt cement is the optimum since, subject to extreme temperatures below 0°C they comply with the parameters required in the standards

    Lifetimes of Confined Acoustic Phonons in Ultra-Thin Silicon Membranes

    Get PDF
    We study the relaxation of coherent acoustic phonon modes with frequencies up to 500 GHz in ultra-thin free-standing silicon membranes. Using an ultrafast pump-probe technique of asynchronous optical sampling, we observe that the decay time of the first-order dilatational mode decreases significantly from \sim 4.7 ns to 5 ps with decreasing membrane thickness from \sim 194 to 8 nm. The experimental results are compared with theories considering both intrinsic phonon-phonon interactions and extrinsic surface roughness scattering including a wavelength-dependent specularity. Our results provide insight to understand some of the limits of nanomechanical resonators and thermal transport in nanostructures

    Modification of Akhieser mechanism in Si nanomembranes and thermal conductivity dependence of the Q-factor of high frequency nanoresonators

    Get PDF
    We present and validate a reformulated Akhieser model that takes into account the reduction of thermal conductivity due to the impact of boundary scattering on the thermal phonons' lifetime. We consider silicon nanomembranes with mechanical mode frequencies in the GHz range as textbook examples of nanoresonators. The model successfully accounts for the measured shortening of the mechanical mode lifetime. Moreover, the thermal conductivity is extracted from the measured lifetime of the mechanical modes in the high-frequency regime, thereby demonstrating that the Q-factor can be used as an indication of the thermal conductivity and/or diffusivity of a mechanical resonator

    Modification of Akhieser mechanism in Si nanomembranes and thermal conductivity dependence of the Q-factor of high frequency nanoresonators

    Get PDF
    We present and validate a reformulated Akhieser model that takes into account the reduction of thermal conductivity due to the impact of boundary scattering on the thermal phonons' lifetime. We consider silicon nanomembranes with mechanical mode frequencies in the GHz range as textbook examples of nanoresonators. The model successfully accounts for the measured shortening of the mechanical mode lifetime. Moreover, the thermal conductivity is extracted from the measured lifetime of the mechanical modes in the high-frequency regime, thereby demonstrating that the Q-factor can be used as an indication of the thermal conductivity and/or diffusivity of a mechanical resonator

    High quality single crystal Ge nano-membranes for opto-electronic integrated circuitry

    Get PDF
    Under the terms of the Creative Commons Attribution (CC BY) license to their work.-- et al.A thin, flat, and single crystal germanium membrane would be an ideal platform on which to mount sensors or integrate photonic and electronic devices, using standard silicon processing technology. We present a fabrication technique compatible with integrated-circuit wafer scale processing to produce membranes of thickness between 60 nm and 800 nm, with large areas of up to 3.5 mm2. We show how the optical properties change with thickness, including appearance of Fabry-Pérot type interference in thin membranes. The membranes have low Q-factors, which allow the platforms to counteract distortion during agitation and movement. Finally, we report on the physical characteristics showing sub-nm roughness and a homogenous strain profile throughout the freestanding layer, making the single crystal Ge membrane an excellent platform for further epitaxial growth or deposition of materials.This work was carried out under the RCUK Basic Technology Programme supported by research Grant Nos. EP/F040784/1, EP/J001074/1, and EP/L007010/1. It also received funding from the European Community's Seventh Framework Programme (FP7/2007-2013) under Grant Agreement NANOFUNCTION n°257375 alongside funding from TAPHOR (MAT2012–31392) and FP7 Project MERGING (Grant No. 309150). Vibrational property measurements were funded by the ERC under Grant No. 202735, NonContactUltrasonic.Peer Reviewe

    Implementation of sensory stimulation technology in an interactive room for the diffusion of wine making activities

    Get PDF
    The present innovation project attempts to bolster the promotion and diffusion of wine-making activities through the introduction of 'dynamic sensory stimulation' technology (DSS). The first objective of this paper is to describe the implementation of an interactive lounge that uses this technology for the display of some organoleptic characteristics of pisco and wine. DSS technology is outfitted with synchronized equipment which provides the visitors with an integral, sensory experience consisting of climatic stimulation, similar to the one of the vineyard (principally in regard to temperature and relative humidity); olfactory stimulation with different aromas via a controlled spray (simulating the collection of smells associated with the processes of fermentation and distillation); scientific-gustatory stimulation (technical tasting); and audiovisual stimulation through images and sounds typical of a vineyard. The paper's second aim is to describe the perception and satisfaction level of the visitors of the interactive lounge. The results indicate that it is possible to utilize DSS technology in an interactive lounge in order to further the diffusion of wine-making activities in Arequipa, Peru

    Properties of Portland Cement Mortar with Substitutions of Natural and Expanded Perlite

    Get PDF
    The present research deals with the feasibility of using high-temperature pozzolans such as Natural Perlite (NP) and Expanded Perlite (EP), different dosagues of additions were made to mortars in order to perform their mechanical properties. Mortars were subjected to destructive tests in hardened state: compression, tension, flexion and adhesion strength; as well as non-destructive tests in hardened state: ultrasonic pulse velocity (UPV), electrical resistivity (ER), density (ρ) and total porosity (PT); in addition to attack by sodium sulfate at 90 days. The percentages of the substitutions were 5%, 10%, 15%, 20% and 30% by weight of Portland cement mass (PC) relative to a control mortar (cement-sand-water). With the partial replacement of the cement and according to the tests carried out, it can be observed that the problem of durability and CO2 emissions is significantly reduced and, consequently, an energy saving and a lower environmental impact are promoted

    Efecto de las fuentes de polen sobre el rendimiento en la extracción de aceite y perfil de ácidos grasos de las semillas de dátil (Phoenix dactylifera L.) cultivar Medjool de México

    Get PDF
    The present investigation aimed to assess the effect of pollen sources on the mass, dimension, oil content and fatty acid profile of the seeds from female palms of the Medjool date cultivar. The palms were pollinated with Deglet Noor, Khadrawy, Medjool and Zahidi cultivars. In addition, three palms were pollinated as the treatment control. The fatty acids were evaluated by gas chromatography-mass spectrometry. The surface morphology of date seed powder was examined using SEM, before and after n-hexane interaction. The seeds of the Medjool treatment had the greatest mass (1.42 g), but the lowest oil content (5.37% w/w); the control seeds showed smaller mass (1.21 g), but higher oil content (13.57% w/w). The proportion of fatty acids varied significantly among the treatments with respect to the control. The most abundant fatty acids were oleic (C18:1), lauric (C12:0), myristic (C14:0), palmitic (C16:0), linoleic (C18:2), and stearic (C18:0). Together these fatty acids presented a composition between 98.3 and 98.67% for treatments, and 99.0% for the control. The results indicate that the pollen sources from Deglet Noor, Khadrawy, Medjool and Zahidi cultivars had a significant effect on mass, dimension, oil content and fatty acid profile of the seeds of the date cultivar Medjool. The date seed oil could be used as edible oil, in food products, and in pharmaceutical and cosmetic applications.La presente investigación tuvo como objetivo evaluar el efecto de las fuentes de polen, sobre la masa, dimensión, contenido de aceite y el perfil de ácidos grasos de las semillas de dátil del cultivar Medjool. Las palmas hembras del cultivar Medjool fueron polinizadas con cultivares Deglet Noor, Khadrawy, Medjool y Zahidi. Además, tres palmas fueron polinizadas como tratamiento control. Los ácidos grasos se evaluaron por cromatografía de gases-espectrometría de masas. La morfología de la superficie del polvo de semillas de dátil se examinó utilizando un equipo SEM, antes y después de la interacción n-hexano. Las semillas del tratamiento Medjool resultaron con mayor masa (1,42 g), pero menor contenido de aceite (5,37% p/p); la semilla control, mostró una masa más pequeña (1,21 g), pero un mayor contenido de aceite (13,57% p/p). La composición de ácidos grasos varió significativamente entre los tratamientos con respecto al control. Los ácidos grasos mayoritarios fueron: oleico (C18:1), láurico (C12:0), mirístico (C14:0), palmítico (C16:0), linoleico (C18:2) and esteárico (C18:0). En total, estos ácidos grasos alcanzan una composición entre 98.3 y 98.67% para los tratamientos, y 99.0% para el control. Los resultados indican que la fuente de polen de los cultivares Deglet Noor, Khadrawy, Medjool y Zahidi tiene un efecto significativo sobre la masa, dimensión, contenido de aceite y el perfil de ácidos grasos de la semilla del cultivar de dátil Medjool. El aceite de la semilla de dátil, podría usarse como aceite comestible, productos alimenticios, aplicaciones farmacéuticas y cosméticas

    Effects of habitat deterioration on the population genetics and conservation of the jaguar

    Get PDF
    Over the past century, human activities and their side effects have significantly threatened both ecosystems and resident species. Nevertheless, the genetic patterns of large felids that depend heavily on large and well-conserved continuous habitat remain poorly studied. Using the largest-ever contemporary genetic survey of wild jaguars (Panthera onca), we evaluated their genetic diversity and population structure in natural (Brazilian Amazon) and highly modified habitats (e.g. Cerrado, Caatinga) including those close to the northern (Yucatan, Mexico) and southern (Pantanal) edge of the species’ distribution range. Data from our set of microsatellites revealed a pronounced genetic structure, with four genetically differentiated geographic areas. Geographic distance was not the only factor influencing genetic differentiation through the jaguar range. Instead, we found evidence of the effects of habitat deterioration on genetic patterns: while the levels of genetic diversity in the Amazon forest, the largest continuum habitat for the species, are high and consistent with panmixia across large distances, genetic diversity near the edge of the species distribution has been reduced through population contractions. Mexican jaguar populations were highly differentiated from those in Brazil and genetically depauperated. An isolated population from the Caatinga showed the genetic effects of a recent demographic decline (within the last 20–30 years), which may reflect recent habitat degradation in the region. Our results demonstrate that the jaguar is highly sensitive to habitat fragmentation especially in human-dominated landscapes, and that in Brazil, the existing but limited genetic connectivity in the central protected areas should be maintained. These conclusions have important implications for the management of wide-ranging species with high dispersal and low population density. The restoration of ecological connectivity between populations over relatively large scales should be one of the main priorities for species conservation.Peer reviewe

    Relationship between Serum Concentration of Uric Acid and Insulin Secretion among Adults with Type 2 Diabetes Mellitus

    Get PDF
    To determine the relationship between serum concentrations of uric acid and insulin secretion with hyperglycaemic clamp technique among adults with type 2 diabetes mellitus (DM2) without hyperuricemia, we carried out a cross-sectional study on 45 patients of both gender. We observed correlation between uric acid with male gender r = 0.710 (P = 0.001). Also correlation between uric acid and total insulin secretion was positive r = 0.295 (P = 0.049). As well as a positive correlation adjusted for body mass index was demonstrated for the first, second, and total phases of insulin secretion, respectively, r = 0.438 (P = 0.022), r = 0.433 (P = 0.022), and r = 0.439 (P = 0.024). Serum concentration of uric acid showed a positive relationship with the total phase of insulin secretion; even in states prior to hyperuricemia, uric acid can play an important role in the function of the beta cell in patients with DM2
    corecore