New di(hetero)arylethers and di(hetero)arylamines in the thieno[3,2-b]pyridine series: Synthesis, growth inhibitory activity on human tumor cell lines and non-tumor cells, effects on cell cycle and on programmed cell death

New fluorinated and methoxylated di(hetero)arylethers and di(hetero)arylamines were prepared functionalizing the 7-position of the thieno[3,2-blpyridine, using copper (C-O) or palladium (C N) catalyzed couplings, respectively, of the 7-bromothieno[3,2-blpyridine, also prepared, with ortho, meta and para fluoro or methoxy phenols and anilines. The compounds obtained were evaluated for their growth inhibitory activity on the human tumor cell lines MCF-7 (breast adenocarcinoma), NCI-H460 (non-small cell lung cancer), HCI15 (colon carcinoma), HepG2 (hepatocellular carcinoma) and HeLa (cervical carcinoma). The most active compounds, a di(hetero)arylether with a methoxy group in the meta position relative to the ether function and two di(hetero)arylamines with a methoxy group either in the ortho or in the meta position relative to the NH, were further tested at their GI(50) concentrations on NCI-H460 cells causing pronounced alterations in the cell cycle profile and a strong and significant increase in the programmed death of these cells. The fluorinated and the other methoxylated compounds did not show important activity, presenting high GI(50) values in all the cell lines tested. Furthermore, the hepatotoxicity of the compounds was assessed using porcine liver primary cells (PLP2), established by some of us. Results showed that one of the most active compounds was not toxic to the non-tumor cells at their GI(50) concentrations showing to be the most promising as antitumoral.The authors would like to thank to the Foundation for the Science and Technology (PCT Portugal) for financial support through the NMR Portuguese network (Bruker 400 Avance III-Univ Minho); to FCT and FEDER-COMPETE/QREN/EU for financial support through the research unities PEst-C/QUI/UI686/2011 and PEst-OE/AGR/UI0690/2011, the research project PTDC/QUI-QUI/111060/2009 and the post-Doctoral grants attributed to R.C.C. (SFRH/BPD/68344/2010) and R.T.L. (SRH/BPD/68787/2010). IPATIMUP is an Associate Laboratory of the Portuguese Ministry of Science, Technology and Higher Education and is partially supported by FCT

Modelling of the effect of ELMs on fuel retention at the bulk W divertor of JET

Effect of ELMs on fuel retention at the bulk W target of JET ITER-Like Wall was studied with multi-scale calculations. Plasma input parameters were taken from ELMy H-mode plasma experiment. The energetic intra-ELM fuel particles get implanted and create near-surface defects up to depths of few tens of nm, which act as the main fuel trapping sites during ELMs. Clustering of implantation-induced vacancies were found to take place. The incoming flux of inter-ELM plasma particles increases the different filling levels of trapped fuel in defects. The temperature increase of the W target during the pulse increases the fuel detrapping rate. The inter-ELM fuel particle flux refills the partially emptied trapping sites and fills new sites. This leads to a competing effect on the retention and release rates of the implanted particles. At high temperatures the main retention appeared in larger vacancy clusters due to increased clustering rate

On the mechanisms governing gas penetration into a tokamak plasma during a massive gas injection

A new 1D radial fluid code, IMAGINE, is used to simulate the penetration of gas into a tokamak plasma during a massive gas injection (MGI). The main result is that the gas is in general strongly braked as it reaches the plasma, due to mechanisms related to charge exchange and (to a smaller extent) recombination. As a result, only a fraction of the gas penetrates into the plasma. Also, a shock wave is created in the gas which propagates away from the plasma, braking and compressing the incoming gas. Simulation results are quantitatively consistent, at least in terms of orders of magnitude, with experimental data for a D 2 MGI into a JET Ohmic plasma. Simulations of MGI into the background plasma surrounding a runaway electron beam show that if the background electron density is too high, the gas may not penetrate, suggesting a possible explanation for the recent results of Reux et al in JET (2015 Nucl. Fusion 55 093013)

Tritium distributions on W-coated divertor tiles used in the third JET ITER-like wall campaign

Tritium (T) distributions on tungsten (W)-coated plasma-facing tiles used in the third ITER-like wall campaign (2015–2016) of the Joint European Torus (JET) were examined by means of an imaging plate technique and β-ray induced x-ray spectrometry, and they were compared with the distributions after the second (2013–2014) campaign. Strong enrichment of T in beryllium (Be) deposition layers was observed after the second campaign. In contrast, T distributions after the third campaign was more uniform though Be deposition layers were visually recognized. The one of the possible explanations is enhanced desorption of T from Be deposition layers due to higher tile temperatures caused by higher energy input in the third campaign