Homogeneous Liquid Phase Transfer of Graphene Oxide into Epoxy Resins

© 2017 American Chemical Society.The quality of polymer composite materials depends on the distribution of the filler in the polymer matrix. Due to the presence of the oxygen functional groups, graphene oxide (GO) has a strong affinity to epoxy resins, providing potential opportunity for the uniform distribution of GO sheets in the matrix. Another advantage of GO over its nonoxidized counterpart is its ability to exfoliate to single-atomic-layer sheets in water and in some organic solvents. However, these advantages of GO have not yet been fully realized due to the lack of the methods efficiently introducing GO into the epoxy resin. Here we develop a novel homogeneous liquid phase transfer method that affords uniform distribution, and fully exfoliated condition of GO in the polymer matrix. The most pronounced alteration of properties of the cured composites is registered at the 0.10%-0.15% GO content. Addition of as little as 0.10% GO leads to the increase of the Young's modulus by 48%. Moreover, we demonstrate successful introduction of GO into the epoxy matrix containing an active diluent-modifier; this opens new venues for fabrication of improved GO-epoxy-modifier composites with a broad range of predesigned properties. The experiments done on reproducing the two literature methods, using alternative GO introduction techniques, lead to either decrease or insignificant increase of the Young's modulus of the resulting GO-epoxy composites

Homogeneous Liquid Phase Transfer of Graphene Oxide into Epoxy Resins

© 2017 American Chemical Society.The quality of polymer composite materials depends on the distribution of the filler in the polymer matrix. Due to the presence of the oxygen functional groups, graphene oxide (GO) has a strong affinity to epoxy resins, providing potential opportunity for the uniform distribution of GO sheets in the matrix. Another advantage of GO over its nonoxidized counterpart is its ability to exfoliate to single-atomic-layer sheets in water and in some organic solvents. However, these advantages of GO have not yet been fully realized due to the lack of the methods efficiently introducing GO into the epoxy resin. Here we develop a novel homogeneous liquid phase transfer method that affords uniform distribution, and fully exfoliated condition of GO in the polymer matrix. The most pronounced alteration of properties of the cured composites is registered at the 0.10%-0.15% GO content. Addition of as little as 0.10% GO leads to the increase of the Young's modulus by 48%. Moreover, we demonstrate successful introduction of GO into the epoxy matrix containing an active diluent-modifier; this opens new venues for fabrication of improved GO-epoxy-modifier composites with a broad range of predesigned properties. The experiments done on reproducing the two literature methods, using alternative GO introduction techniques, lead to either decrease or insignificant increase of the Young's modulus of the resulting GO-epoxy composites

Design of High-Relaxivity Polyelectrolyte Nanocapsules Based on Citrate Complexes of Gadolinium(III) of Unusual Composition

Through nuclear magnetic relaxation and pH-metry, the details of the complexation of gadolinium(III) ions with citric acid (H4L) in water and aqueous solutions of cationic polyelectrolytes are established. It is shown that the presence of poly(ethylene imine) (PEI) in solution affects magnetic relaxation behavior of gadolinium(III) complexes with citric acid (Cit) to a greater extent than polydiallyldimethylammonium chloride (PDDC). A large increase in relaxivity (up to 50 mM−1s−1) in the broad pH range (4–8) is revealed for the gadolinium(III)–citric acid–PEI system, which is particularly strong in the case of PEI with the molecular weight of 25 and 60 kDa. In weakly acidic medium (pH 3–7), the presence of PEI results in the formation of two tris-ligand associates [Gd(H2L)3]3− and [Gd(H2L)2(HL)]4−, which do not exist in aqueous medium. In weakly alkaline medium (pH 7–10), formation of ternary complexes Gd(III)–Cit–PEI with the Gd(III)–to–Cit ratio of 1:2 is evidenced. Using transmission electron microscopy (TEM) and dynamic light scattering techniques (DLS), the formation of the particles with the size of 50–100 nm possessing narrow molecular-mass distribution (PDI 0.08) is determined in the solution containing associate of PEI with tris-ligand complex [Gd(H2L)2(HL)]4−

NMR-Relaxometric Investigation of Mn(II)-Doped Polyoxometalates in Aqueous Solutions

Solution behavior of K;5[(Mn(H2O))PW11O39]·7H2O (1), Na3.66(NH4)4.74H3.1[(MnII(H2O))2.75(WO(H2O))0.25(α-B-SbW9O33)2]·27H2O (2), and Na4.6H3.4[(MnII(H2O)3)2(WO2)2(β-B-TeW9O33)2]·19H2O (3) was studied with NMR-relaxometry and HPLC-ICP-AES (High Performance Liquid Chromatography coupled with Inductively Coupled Plasma Atomic Emission Spectroscopy). According to the data, the [(Mn(H2O))PW11O39]5− Keggin-type anion is the most stable in water among the tested complexes, even in the presence of ethylenediaminetetraacetic acid (EDTA) or diethylenetriaminepentaacetic acid (DTPA). Aqueous solutions of 2 and 3 anions are less stable and contain other species resulting from dissociation of Mn2+. Quantum chemical calculations show the change in Mn2+ electronic state between [Mn(H2O)6]2+ and [(Mn(H2O))PW11O39]5−

Homogeneous Liquid Phase Transfer of Graphene Oxide into Epoxy Resins

The quality of polymer composite materials depends on the distribution of the filler in the polymer matrix. Due to the presence of the oxygen functional groups, graphene oxide (GO) has a strong affinity to epoxy resins, providing potential opportunity for the uniform distribution of GO sheets in the matrix. Another advantage of GO over its nonoxidized counterpart is its ability to exfoliate to single-atomic-layer sheets in water and in some organic solvents. However, these advantages of GO have not yet been fully realized due to the lack of the methods efficiently introducing GO into the epoxy resin. Here we develop a novel homogeneous liquid phase transfer method that affords uniform distribution, and fully exfoliated condition of GO in the polymer matrix. The most pronounced alteration of properties of the cured composites is registered at the 0.10%–0.15% GO content. Addition of as little as 0.10% GO leads to the increase of the Young’s modulus by 48%. Moreover, we demonstrate successful introduction of GO into the epoxy matrix containing an active diluent-modifier; this opens new venues for fabrication of improved GO-epoxy-modifier composites with a broad range of predesigned properties. The experiments done on reproducing the two literature methods, using alternative GO introduction techniques, lead to either decrease or insignificant increase of the Young’s modulus of the resulting GO–epoxy composites

T2- and T1 relaxivities and magnetic hyperthermia of iron-oxide nanoparticles combined with paramagnetic Gd complexes

The present paper reports the synthesis of iron-oxide nanoparticles (diameter 12.8 +/- 2.2 nm) coated with silica shell doped with paramagnetic Gd(III)-based complexes. The resulting nanoparticles with a silica shell thickness of about 45 nm have an average diameter of 113.1 +/- 14.3 nm and feature high transverse and longitudinal relaxivities (356 and 25 mM(-1) s(-1), respectively) at 1.5 T and 25 degrees C on a medical whole body NMR scanner. It has been also revealed using magnetic heating measurements that the prepared core-shell nanoparticles possess a high specific adsorption rate of around 236 W/g in aqueous media. The surface of the composite nanoparticles was decorated by amino-groups for a greater cellular uptake behaviour. The cell viability measurements reveal the concentration-dependent cytotoxicity of the nanoparticles, which agrees well with the high content of Gd(III) complexes in the nanomaterial. The obtained results show that the core-shell design of nanoparticles with superparamagnetic and paramagnetic parts can be promising for high transverse (and longitudinal) relaxivity as well as magnetic hyperthermia.Web of Science1332art. no. 4