189 research outputs found
Pressure-induced Jahn-Teller suppression in Rb2CuCl4( H2O )2: Pseudo-Jahn-Teller effect
In this work we investigate the variation of the local structure around Cu2+ as well as the crystal structure in Rb2CuCl4(H2O)2 through x-ray absorption spectroscopy (XAS) and x-ray diffraction (XRD) as a function of pressure. We show that the application of pressure induces a local structural change in the Jahn-Teller (JT) CuCl4(H2O)22− complex from an axially elongated complex to a compressed one, yielding disappearance of the JT distortion related to the four in-plane Cl− ligands, which are responsible for the antiferrodistortive structure displayed by the crystal at ambient pressure. According to the Pseudo-Jahn-Teller (PJT) theory (electron-phonon coupling E⊗e), the presence of water ligands enhances the JT release at pressures well below the metallization pressure. The results are compared with recent pressure experiments on A2CuCl4 layered perovskites and heteronuclear CuCl4L2 complex series, L :Cl→H2O→NH3, and explained on the basis of the PJT model
Frictional behavior of oceanic transform faults and its influence on earthquake characteristics
Author Posting. © American Geophysical Union, 2012. This article is posted here by permission of American Geophysical Union for personal use, not for redistribution. The definitive version was published in Journal of Geophysical Research 117 (2012): B04315, doi:10.1029/2011JB009025.We use a three-dimensional strike-slip fault model in the framework of rate and state-dependent friction to investigate earthquake behavior and scaling relations on oceanic transform faults (OTFs). Gabbro friction data under hydrothermal conditions are mapped onto OTFs using temperatures from (1) a half-space cooling model, and (2) a thermal model that incorporates a visco-plastic rheology, non-Newtonian viscous flow and the effects of shear heating and hydrothermal circulation. Without introducing small-scale frictional heterogeneities on the fault, our model predicts that an OTF segment can transition between seismic and aseismic slip over many earthquake cycles, consistent with the multimode hypothesis for OTF ruptures. The average seismic coupling coefficient χ is strongly dependent on the ratio of seismogenic zone width W to earthquake nucleation size h*; χ increases by four orders of magnitude as W/h* increases from ∼1 to 2. Specifically, the average χ = 0.15 ± 0.05 derived from global OTF earthquake catalogs can be reached at W/h* ≈ 1.2–1.7. Further, in all simulations the area of the largest earthquake rupture is less than the total seismogenic area and we predict a deficiency of large earthquakes on long transforms, which is also consistent with observations. To match these observations over this narrow range of W/h* requires an increase in the characteristic slip distance dc as the seismogenic zone becomes wider and normal stress is higher on long transforms. Earthquake magnitude and distribution on the Gofar and Romanche transforms are better predicted by simulations using the visco-plastic model than the half-space cooling model.This work was supported by NSF-EAR award 1015221,
NSF-OCE award 1061203, and a J. Lamar Worzel Assistant Scientist Fund
to Y. Liu at WHOI.2012-10-2
Heterogeneous coupling of the Sumatran megathrust constrained by geodetic and paleogeodetic measurements
Geodetic and paleogeodetic measurements of interseismic strain above the Sumatran portion of the Sunda subduction zone reveal a heterogeneous pattern of coupling. Annual banding in corals provides vertical rates of deformation spanning the last half of the 20th century, and repeated GPS surveys between 1991 and 2001 and continuous measurements at GPS stations operated since 2002 provide horizontal velocities. Near the equator, the megathrust is locked over a narrow width of only a few tens of kilometers. In contrast, the locked fault zone is up to about 175 km wide in areas where great interplate earthquakes have occurred in the past. Formal inversion of the data reveals that these strongly coupled patches are roughly coincident with asperities that ruptured during these events. The correlation is most spectacular for rupture of the M_w 8.7 Nias-Simeulue earthquake of 2005, which released half of the moment deficit that had accumulated since its previous rupture in 1861, suggesting that this earthquake was overdue. Beneath the Mentawai islands, strong coupling is observed within the overlapping rupture areas of the great earthquakes of 1797 and 1833. The accumulated slip deficit since these events is slowly reaching the amount of slip that occurred during the 1833 earthquake but already exceeds the slip that occurred during the 1797 earthquake. Thus, rerupture of part of the Mentawai patch in September 2007 was not a surprise. In contrast, coupling is low below the Batu islands near the equator and around Enggano island at about 5°S, where only moderate earthquakes (M_w < 8.0) have occurred in the past two centuries. The correlation of large seismic asperities with patches that are locked during the interseismic period suggests that they are persistent features. This interpretation is reinforced by the fact that the large locked patches and great ruptures occur beneath persistent geomorphologic features, the largest outer arc islands. Depth- and convergence-rate-dependent temperature might influence the pattern of coupling, through its effect on the rheology of the plate interface, but other influences are required to account for the observed along-strike heterogeneity of coupling. In particular, subduction of the Investigator Fracture Zone could be the cause for the low coupling near the equator
How phyllosilicate mineral structure affects fault strength in Mg-rich fault systems
The clay mineralogy of fault gouges has important implications for the frictional properties of faults, often identified as a major factor contributing to profound fault weakness. This work compares the frictional strength of a group of Mg‐rich minerals common in the Mg‐Al‐Si‐O compositional space (talc, saponite, sepiolite, and palygorskite) by conducting triaxial frictional tests with water or argon as pore fluid. The studied minerals are chemically similar but differ in their crystallographic structure. Results show that fibrous Mg‐rich phyllosilicates are stronger than their planar equivalents. Frictional strength in this group of minerals is highly influenced by strength of the atomic bonds, continuity of water layers within the crystals, and interactions of mineral surfaces with water molecules, all of which are dictated by crystal structure. The formation and stability of the minerals studied are mainly controlled by small changes in pore fluid chemistry, which can lead to significant differences in fault strength
Density functional theory study of the multimode Jahn-Teller effect – ground state distortion of benzene cation
The multideterminental-DFT approach performed to analyze Jahn-Teller (JT) active molecules is described. Extension of this method for the analysis of the adiabatic potential energy surfaces and the multimode JT effect is presented. Conceptually a simple model, based on the analogy between the JT distortion and reaction coordinates gives further information about microscopic origin of the JT effect. Within the harmonic approximation the JT distortion can be expressed as a linear combination of all totally symmetric normal modes in the low symmetry minimum energy conformation, which allows calculating the Intrinsic Distortion Path, IDP, exactly from the high symmetry nuclear configuration to the low symmetry energy minimum. It is possible to quantify the contribution of different normal modes to the distortion, their energy contribution to the total stabilization energy and how their contribution changes along the IDP. It is noteworthy that the results obtained by both multideterminental-DFT and IDP methods for different classes of JT active molecules are consistent and in agreement with available theoretical and experimental values. As an example, detailed description of the ground state distortion of benzene cation is given
Advances in mass spectrometry-based post-column bioaffinity profiling of mixtures
In the screening of complex mixtures, for example combinatorial libraries, natural extracts, and metabolic incubations, different approaches are used for integrated bioaffinity screening. Four major strategies can be used for screening of bioactive mixtures for protein targets—pre-column and post-column off-line, at-line, and on-line strategies. The focus of this review is on recent developments in post-column on-line screening, and the role of mass spectrometry (MS) in these systems. On-line screening systems integrate separation sciences, mass spectrometry, and biochemical methodology, enabling screening for active compounds in complex mixtures. There are three main variants of on-line MS based bioassays: the mass spectrometer is used for ligand identification only; the mass spectrometer is used for both ligand identification and bioassay readout; or MS detection is conducted in parallel with at-line microfractionation with off-line bioaffinity analysis. On the basis of the different fields of application of on-line screening, the principles are explained and their usefulness in the different fields of drug research is critically evaluated. Furthermore, off-line screening is discussed briefly with the on-line and at-line approaches
Acceleration of slip motion in deep extensions of seismogenic faults in and below the seismogenic region
Density Functional Studies on the Lone Pair Effect of the Trivalent Group (V) Elements: I. Electronic Structure, Vibronic Coupling, and Chemical Criteria for the Occurrence of Lone Pair Distortions in AX 3
An EPR investigation of the phase transitions and cooperative ordering phenomena of pentaamminecopper(II) polyhedra in Cu(NH3)5X2 [X=BF4, CIO4; Br]
- …