Field experimental study of traffic-induced turbulence on highways

This paper is focused on traffic-induced turbulence (TIT) analysis from a field campaign performed in 2011, using ultrasonic anemometers deployed in the M-12 Highways, Madrid (Spain). The study attempts to improve knowledge about the influence of traffic-related parameters on turbulence. Linear relationships between vehicle speed and turbulent kinetic energy (TKE) values are found with coefficients of determination (R2) of 0.75 and 0.55 for the lorry and van respectively. The vehicle-induced fluctuations in the wind components (u', v' and w') showed the highest values for the longitudinal component (v) because of the wake-passing effect. In the analysis of wake produced by moving vehicles it is indicated how the turbulence dissipates in relation to a distance d and height h. The TKE values were found to be higher at the measuring points closer to the surface during the wake analysis.This work was supported by the OASIS Research Project that was co financed by CDTI (Spanish Science and Innovation Ministry) and developed with the Spanish companies: Iridium, OHL Concesiones, Abertis, Sice, Indra, Dragados, OHL, Geocisa, GMV, Asfaltos Augusta, Hidrofersa, Eipsa, PyG, CPS, AEC and Torre de Comares Arquitectos s.l and 16 research centres

Energy harvesting from vehicular traffic over speed bumps: A review

Energy used by vehicles to slow down in areas of limited speed is wasted. A traffic energy-harvesting device (TEHD) is capable of harvesting vehicle energy when passing over a speed bump. This paper presents a classification of the different technologies used in the existing TEHDs. Moreover, an estimation of the energy that could be harvested with the different technologies and their cost has been elaborated. The energy recovered with these devices could be used for marking and lighting of roads in urban areas, making transportation infrastructures more sustainable and environmentally friendly

Interindividual variability of the modulatory effects of repetitive transcranial magnetic stimulation on cortical excitability

Repetitive transcranial magnetic stimulation (rTMS) appears to have effects on cortical excitability that extend beyond the train of rTMS itself. These effects may be inhibitory or facilitatory and appear to depend on the frequency, intensity, duration and intertrain interval of the rTMS. Many studies assume facilitatory effects of high-frequency rTMS and inhibitory effects of low-frequency rTMS. Nevertheless, the interindividual variability of this modulation of cortical excitability by rTMS has not been systematically investigated. In this study, we applied 240 pulses of rTMS at 90% of the subjects' motor threshold to their motor cortex at different frequencies (1, 10, 15 and 20 Hz) and examined the effects on motor evoked potentials (frequency tuning curve). Although the averaged group data showed a frequency-dependent increase in cortical excitability, each subject had a different pattern of frequency tuning curve, i.e. a different modulatory effect on cortical excitability at different rTMS frequencies. The interindividual variability of these modulatory effects was still high, though less so, when the number of rTMS pulses was increased to 1600. These findings illustrate the degree of variability of the rTMS effects in the human brain.Supported in part by grants from the Cellular Science Research Foundation, Yoshida Science Foundation, Japan North America Medical Exchange Foundation, the Stanley Vada Foundation, the National Alliance for Research and Schizophrenia and Depression, and the National Institute of Mental Health (RO1MH57980)Medicin

Integration of a zero dead-volume PDMS rotary switch valve in a miniaturised (bio)electroanalytical system

This work features the design, fabrication and characterisation of a miniaturised electroanalytical lab on a chip that allows the performance of a complete bioassay, from the capture of magnetic particles through their functionalisation and sample incubation to the detection of electroactive reaction products. The system is built using mainly polymeric materials such as PMMA and PDMS and fast prototyping techniques such as milling and moulding. The system also includes a set of microelectrodes, photo-lithographed on a silicon chip. The novelty lies in the design of the rotary microvalve, which contains a microreactor so that various reaction and incubation steps can be carried out in isolation from the detection event with zero dead volume. This avoids contamination and fouling of the electrodes by proteins or other organic matter, and extends the useful lifetime of the detector. The system operation is demonstrated by a model example, consisting in the functionalisation of streptavidin-coated magnetic particles with biotinylated β-galactosidase over periods ranging from 5 to 15 minutes, at which point the particles saturate. Although the system is intended for the development of enzyme-based electrochemical bioassays, the concept of its rotary microreactor can be applied more broadly.Peer reviewe

Influence of early colour degradation of asphalt pavements on their thermal behaviour

Environmental goals such as the reduction of fossil fuel consumption or greenhouse gas (GHG) emissions through the development of new renewable energy sources have led to the emergence of the so called asphalt solar collectors. Moreover, in recent years, engineers are devoting increased interest to the effect of the thermal loads on the mechanical behaviour of pavements. Several approaches to these topics can be found in the literature. However, a study of the influence of the colour degradation suffered by pavements on their thermal behaviour is still necessary since both the efficient application of the asphalt collectors and the proper study of the effect of the solar radiation on the asphalt pavement behaviour are directly affected by the loss of colour occurring as time goes by. Therefore, the thermal behaviour of two different asphalt mixes was studied before and after being subjected to a colour degradation process. The degradation of five different asphalt mixes was studied and the results were compared to those obtained in the access roads to seven low volume car parks. The final results show that there are large differences between the two asphalt mixes with different gradations and densities. The importance attributed by other authors to conductivity was also confirmed. Furthermore, the results showed that it was possible to simulate the early colour degradation suffered by a low volume road. Finally, a slight reduction in temperature and energy collection capacity was measured after the colour degradation process

Experimental characterization and performance evaluation of geothermal grouting materials subjected to heating–cooling cycles

In recent years, the increasing rise in environmental awareness among energy consumers has led to an increasing use of renewable energies such as the geothermal energy. An important role in the efficient exploitation of the geothermal resource is played by the grouting material placed in the borehole between the pipes and the ground. Actually, the use of proper grouts is essential to provide an effective heat transfer between the ground and the heat carrier fluid in the pipes, and also to comply with the mechanical and environmental demands. However, when it comes to the construction of the GHP installations, the grout is especially required to be easy to work with (workable) and for this reason more water than required is sometimes added. In order to assess the suitability of grouting materials with significant water/solid ratios, the thermal conductivity, mechanical strength and permeability of five different grouts and grout–pipe specimens were measured for their laboratory characterization. In addition, the grouts were subjected to heating and cooling cycles to evaluate their durability with time in terms of the potential degradation of the materials and the loss of quality of the grout–pipe interface. According to the results obtained, the grouts here tested are appropriate for most of the geothermal heat pump installations, especially for those with low to medium ground thermal properties.The authors wish to express their gratitude to the Ministerio de Economía y Competitividad which funded this study within the Spanish National Plan for Scientific and Technical Research and Innovation (INNPACTO program) through the research project IPT-2011-0877-920000

Durability of geothermal grouting materials considering extreme loads

The concern about the massive use of the non-renewable and very limited fossil fuels together with the well-known effects of the global warming makes it more necessary the efficient use of the current forms of renewable energy generation. Because of the crucial role played by the grouting materials in the Ground Source Heat Pumps (GSHP), a proper selection of these elements should be made based on a deep knowledge of their performance. In this paper, thermal conductivity, mechanical strength and grout-pipe permeability of four different highly workable grouts have been tested before and after they were subjected to wet-dry and freeze-thaw durability treatments. Results obtained demonstrated the harmful effects of using a large amount of mixing water in grouts subjected to those extreme loads. However, the use of these type of grouts with very good workability is still possible in GSHP installations with balanced thermal designs provided that regular operational and environment conditions are considered.The authors wish to express their gratitude to the Ministry of Economy and Competitiveness which funded this study within the Spanish National Plan for Scientific and Technical Research and Innovation (INNPACTO program) through the research project IPT-2011-0877-920000. The authors are also grateful to all the organizations and companies participating in this project: Sacyr Industrial, Universidad Politécnica de Madrid and Cype

Long-Term Changes in the Water Mass Properties in the Balearic Channels Over the Period 1996–2019

The analysis of a 24-year time series of Conductivity-Temperature-Depth (CTD) casts collected in the Balearic Channels (1996–2019) has allowed detecting and quantifying long-term changes in water mass properties in the Western Mediterranean. For the complete period, the intermediate waters have experienced warming and salting at rates of 1.4°C/100yr and 0.3–0.6/100yr for the Western Intermediate Water, and 1°C/100yr and 0.3–0.4/100yr for the Levantine Intermediate Water. The density of these two water masses has not changed. The deep waters, defined as those denser than 29.1 kg/m3, showed positive trends in temperature, salinity, and density (0.8°C/100yr, 0.2/100yr, and 0.02 kg.m–3/100yr, respectively). The high temporal variability of the upper layer makes the detection of long-term changes more difficult. Nevertheless, combining CTD data with temperature data from the oceanographic station at L’Estartit and simulated data from the NCEP/NCAR reanalysis, it can be established that the Atlantic Water increased its temperature at a rate of 2.1–2.8°C/100yr and likely its salinity at a rate of 0.6/100yr. The water column absorbed heat at a rate equivalent to 1–1.2 W/m2. All these trends are much higher than those reported in previous works (more than double in some cases). The warming of the water column produced an increase in the thermosteric component of sea level. However, this increase was compensated by the decrease in the halosteric component. Besides these changes, other alterations related to the Western Mediterranean Transition have been observed over shorter periods. The temperature and salinity of the intermediate waters increased before the winter of 2004/2005 and then the temperature and salinity of the deep waters increased dramatically in 2005. The density of the deep water reached values unprecedented before 2005. Deep and intermediate waters were uplifted by the presence of such dense deep waters. The arrival of warmer and saltier intermediate waters from the Eastern Mediterranean is also observed, mainly after 2010.Postprin

Follow-up with Telemedicine in Early Discharge for COPD Exacerbations: Randomized Clinical Trial (TELEMEDCOPD-Trial)

The results reported by different studies on telemonitoring in patients with chronic obstructive pulmonary disease (COPD) have been contradictory, without showing clear benefits to date. The objective of this study was to ascertain whether an early discharge and home hospitalization telehealth program for patients with COPD exacerbation is as effective as and more efficient than a traditional early discharge and home hospitalization program. A prospective experimental non-inferiority study, randomized into two groups (telemedicine/control) was conducted. The telemedicine group underwent monitoring and was required to transmit data on vital constants and ECGs twice per day, with a subsequent telephone call and 2 home visits by healthcare staff (intermediate and at discharge). The control group received daily visits. The main variable was time until first exacerbation. The secondary variables were: number of exacerbations; use of healthcare resources; satisfaction; quality of life; anxiety-depression; and therapeutic adherence, measured at one and 6 months of hospital discharge. A total of 116 patients were randomized (58 to each group) without significant differences in baseline characteristics or time until first exacerbation, i.e. median 48 days (pp. 25-75:23-120) in the control group, and 47 days (pp. 25-75:19-102) in the intervention group; p = 0.52). A significant decrease in the number of visits was observed in the intervention versus the control group, 3.8 ± 1 vs 5.1 ± 2(p = 0.001), without significant differences in the number of exacerbations. In conclusion follow-up via a telemedicine program in early discharge after hospitalization is as effective as conventional home follow up, being the cost of either strategy not significantly different.This study was awarded a Health Research Fund (Fondo de Investigaciones Sanitarias/FIS) grant, dossier No. PI12/01161 of the Carlos III Institute of Health and the Ministry of Sciences, Innovation and Universities.S