Characterisation of optical phonons within epitaxial Ge2Sb2Te5/InAs(111) structures

This is the final version. Available on open access from Elsevier via the DOI in this recordData availability; The data that support the findings of this study are available from the corresponding author upon reasonable request.Femto-second pump-probe and micro-Raman spectroscopy (RS) measurements have been made to identify optical phonons in Ge2Sb2Te5/InAs(111) and an InAs(111) substrate. A theory of transient stimulated Raman scattering (TSRS) incorporating the Raman tensor predicts which phonon modes may be observed in transient reflectance (R) and anisotropic reflectance (AR) pump-probe measurements, and how their amplitudes depend upon angles φ and θ that describe the orientation of the pump and probe beam electric fields within the sample plane. AR measurements of an InAs(111) substrate revealed the 6.5 THz transverse optical phonon with amplitude proportional to sin(2(θ−φ)), as expected for both TSRS and the specular optical Kerr effect (SOKE), confirming that TSRS and SOKE are equivalent descriptions of the same phenomenon. The AR responses of Ge2Sb2Te5/InAs(111) revealed a single coherent optical phonon (COP) mode at about 3.4 THz with sin(2(θ−φ)) amplitude variation that confirms the -like character of the mode and hence the underlying cubic structure of the epilayer. This mode was also observed in the R measurement for one sample, with amplitude independent of φ and θ as predicted by TSRS theory. Both R and AR signals were heavily damped, which is attributed to dephasing of , and modes that become non-degenerate due to structural distortions. RS measurements revealed three modes for Ge2Sb2Te5/InAs(111) and three modes for InAs(111). Taken together the TSRS and RS measurements provide rich information about optical phonons in the phase change material Ge2Sb2Te5 and the InAs(111) surface.Engineering and Physical Sciences Research Council (EPSRC

Inter-hemispheric EEG coherence analysis in Parkinson's disease : Assessing brain activity during emotion processing

Parkinson’s disease (PD) is not only characterized by its prominent motor symptoms but also associated with disturbances in cognitive and emotional functioning. The objective of the present study was to investigate the influence of emotion processing on inter-hemispheric electroencephalography (EEG) coherence in PD. Multimodal emotional stimuli (happiness, sadness, fear, anger, surprise, and disgust) were presented to 20 PD patients and 30 age-, education level-, and gender-matched healthy controls (HC) while EEG was recorded. Inter-hemispheric coherence was computed from seven homologous EEG electrode pairs (AF3–AF4, F7–F8, F3–F4, FC5–FC6, T7–T8, P7–P8, and O1–O2) for delta, theta, alpha, beta, and gamma frequency bands. In addition, subjective ratings were obtained for a representative of emotional stimuli. Interhemispherically, PD patients showed significantly lower coherence in theta, alpha, beta, and gamma frequency bands than HC during emotion processing. No significant changes were found in the delta frequency band coherence. We also found that PD patients were more impaired in recognizing negative emotions (sadness, fear, anger, and disgust) than relatively positive emotions (happiness and surprise). Behaviorally, PD patients did not show impairment in emotion recognition as measured by subjective ratings. These findings suggest that PD patients may have an impairment of inter-hemispheric functional connectivity (i.e., a decline in cortical connectivity) during emotion processing. This study may increase the awareness of EEG emotional response studies in clinical practice to uncover potential neurophysiologic abnormalities

A knowledge-driven GIS modeling technique for groundwater potential mapping at the Upper Langat Basin, Malaysia.

The aim of this paper is to use a knowledge-driven expert-based geographical information system (GIS) model coupling with remote-sensing-derived parameters for groundwater potential mapping in an area of the Upper Langat Basin, Malaysia. In this study, nine groundwater storage controlling parameters that affect groundwater occurrences are derived from remotely sensed imagery, available maps, and associated databases. Those parameters are: lithology, slope, lineament, land use, soil, rainfall, drainage density, elevation, and geomorphology. Then the parameter layers were integrated and modeled using a knowledge-driven GIS of weighted linear combination. The weightage and score for each parameter and their classes are based on the Malaysian groundwater expert opinion survey. The predicted groundwater potential map was classified into four distinct zones based on the classification scheme designed by Department of Minerals and Geoscience Malaysia (JMG). The results showed that about 17% of the study area falls under low-potential zone, with 66% on moderate-potential zone, 15% with high-potential zone, and only 0.45% falls under very-high-potential zone. The results obtained in this study were validated with the groundwater borehole wells data compiled by the JMG and showed 76% of prediction accuracy. In addition statistical analysis indicated that hard rock dominant of the study area is controlled by secondary porosity such as distance from lineament and density of lineament. There are high correlations between area percentage of predicted groundwater potential zones and groundwater well yield. Results obtained from this study can be useful for future planning of groundwater exploration, planning and development by related agencies in Malaysia which provide a rapid method and reduce cost as well as less time consuming. The results may be also transferable to other areas of similar hydrological characteristics

Selective formation of tungsten nanowires

We report on a process for fabricating self-aligned tungsten (W) nanowires with polycrystalline silicon core. Tungsten nanowires as thin as 10 nm were formed by utilizing polysilicon sidewall transfer technology followed by selective deposition of tungsten by chemical vapor deposition (CVD) using WF6 as the precursor. With selective CVD, the process is self-limiting whereby the tungsten formation is confined to the polysilicon regions; hence, the nanowires are formed without the need for lithography or for additional processing. The fabricated tungsten nanowires were observed to be perfectly aligned, showing 100% selectivity to polysilicon and can be made to be electrically isolated from one another. The electrical conductivity of the nanowires was characterized to determine the effect of its physical dimensions. The conductivity for the tungsten nanowires were found to be 40% higher when compared to doped polysilicon nanowires of similar dimensions

Study of the Emitted Dose After Two Separate Inhalations at Different Inhalation Flow Rates and Volumes and an Assessment of Aerodynamic Characteristics of Indacaterol Onbrez Breezhaler® 150 and 300 μg

Onbrez Breezhaler® is a low-resistance capsule-based device that was developed to deliver indacaterol maleate. The study was designed to investigate the effects of both maximum flow rate (MIF) and inhalation volume (Vin) on the dose emission of indacaterol 150 and 300 μg dose strengths after one and two inhalations using dose unit sampling apparatus (DUSA) as well as to study the aerodynamic characteristics of indacaterol Breezhaler® using the Andersen cascade impactor (ACI) at a different set of MIF and Vin. Indacaterol 150 and 300 μg contain equal amounts of lactose per carrier. However, 150 μg has the smallest carrier size. The particle size distribution (PSD) of indacaterol DPI formulations 150 and 300 μg showed that the density of fine particles increased with the increase of the primary pressure. For both strengths (150 μg and 300 μg), ED1 increased and ED2 decreased when the inhalation flow rate and inhaled volume increased. The reduction in ED1 and subsequent increase in ED2 was such that when the Vin is greater than 1 L, then 60 L/min could be regarded as the minimum MIF. The Breezhaler was effective in producing respirable particles with an MMAD ≤5 μm irrespective of the inhalation flow rate, but the mass fraction of particles with an aerodynamic diameter <3 μm is more pronounced between 60 and 90 L/min. The dose emission of indacaterol was comparable for both dose strengths 150 and 300 μg. These in vitro results suggest that a minimum MIF of 60 L/min is required during routine use of Onbrez Breezhaler®, and confirm the good practice to make two separate inhalations from the same dose

Hybrid off-river augmentation system as an alternative raw water resource: the hydrogeochemistry of abandoned mining ponds

The use of water from abandoned mining ponds under a hybrid off-river augmentation system (HORAS) has been initiated as an alternative water resource for raw water. However, it raises the questions over the safety of the use of such waters. In this study, the hydrogeochemical analysis of the waters is presented to assess the degree to which the water has been contaminated. Comparisons were made between sampling sites, i.e. abandoned mining ponds, active sand mining ponds and the receiving streams within Bestari Jaya, Selangor River basin. The aqueous geochemistry analysis showed different hydrochemical signatures of major elements between sites, indicating different sources of minerals in the water. Discharges from the sand mining ponds were found to contain elevated availability of dissolved concentrations of iron, manganese, lead, copper and zinc, among others. However, the quality of the water (from the main river) that is supplied for potable water consumption is at a satisfactory level despite being partly sourced from the abandoned mining ponds. In fact, all the metal concentrations detected were well below the Malaysia Ministry of Health guideline limits for untreated raw water. In addition, the results of the geochemical index analysis (i.e. geoaccumulation index, enrichment factor and modified contamination factor) showed that the rivers and abandoned mining ponds were generally unpolluted with respect to the metals found in sediments

Wound contraction effects and antibacterial properties of Tualang honey on full-thickness burn wounds in rats in comparison to hydrofibre

<p>Abstract</p> <p>Background</p> <p>Full-thickness burn wounds require excision and skin grafting. Multiple surgical procedures are inevitable in managing moderate to severe full-thickness burns. Wound bed preparations prior to surgery are necessary in order to prevent wound infection and promote wound healing. Honey can be used to treat burn wounds. However, not all the honey is the same. This study aims to evaluate the wound contraction and antibacterial properties of locally-produced <it>Tualang </it>honey on managing full-thickness burn wounds <it>in vivo</it>.</p> <p>Methods</p> <p>Thirty-six female <it>Sprague Dawley </it>rats were randomly divided into three groups. Under anaesthesia, three full-thickness burn wounds were created on the dorsum of the rats. The full-thickness burn wounds were inoculated with a specific organism (10⁴), namely <it>Pseudomonas aeruginosa </it>(n = 12), <it>Klebsiella pneumoniae </it>(n = 12), or <it>Acinetobacter baumannii </it>(n = 12). The three burn wounds were dressed with <it>Tualang </it>honey, hydrofibre and hydrofibre silver respectively. Swab samples were obtained every 3 days (day 3, 6, 9, 12, 15, 18 and 21) for quantitative and semi-quantitative microbiological analyses. Clinical assessments, including observations concerning the appearance and wound size, were measured at the same time.</p> <p>Results</p> <p>There was a rapid 32.26% reduction in wound size by day 6 (<it>p </it>= 0.008) in the <it>Tualang </it>honey-treated wounds, and 49.27% by day 15 (<it>p </it>= 0.005). The wounds remained smaller by day 18 (<it>p </it>< 0.032). <it>Tualang </it>honey-treated rats demonstrated a reduction in bacterial growth in <it>Pseudomonas aeruginosa </it>inoculated wounds (<it>p </it>= 0.005). However, hydrofibre silver and hydrofibre-treated wounds are superior to honey-treated wounds with <it>Acinetobacter baumannii </it>(<it>p </it>= 0.035). There was no statistical significant of antibacterial property in <it>Klebsiella pneumonia </it>inoculated wounds.</p> <p>Conclusions</p> <p><it>Tualang </it>honey has better results with regards to its control of <it>Pseudomonas aeruginosa </it>and its wound contraction effects on full-thickness burn wound <it>in vivo</it>.</p

Panel 7: otitis media:treatment and complications

Objective: We aimed to summarize key articles published between 2011 and 2015 on the treatment of (recurrent) acute otitis media, otitis media with effusion, tympanostomy tube otorrhea, chronic suppurative otitis media and complications of otitis media, and their implications for clinical practice. Data Sources: PubMed, Ovid Medline, the Cochrane Library, and Clinical Evidence (BMJ Publishing). Review Methods: All types of articles related to otitis media treatment and complications between June 2011 and March 2015 were identified. A total of 1122 potential related articles were reviewed by the panel members; 118 relevant articles were ultimately included in this summary. Conclusions: Recent literature and guidelines emphasize accurate diagnosis of acute otitis media and optimal management of ear pain. Watchful waiting is optional in mild to moderate acute otitis media; antibiotics do shorten symptoms and duration of middle ear effusion. The additive benefit of adenoidectomy to tympanostomy tubes in recurrent acute otitis media and otitis media with effusion is controversial and age dependent. Topical antibiotic is the treatment of choice in acute tube otorrhea. Symptomatic hearing loss due to persistent otitis media with effusion is best treated with tympanostomy tubes. Novel molecular and biomaterial treatments as adjuvants to surgical closure of eardrum perforations seem promising. There is insufficient evidence to support the use of complementary and alternative treatments. Implications for Practice: Emphasis on accurate diagnosis of otitis media, in its various forms, is important to reduce overdiagnosis, overtreatment, and antibiotic resistance. Children at risk for otitis media and its complications deserve special attention

Bacteria-inducing legume nodules involved in the improvement of plant growth, health and nutrition

Bacteria-inducing legume nodules are known as rhizobia and belong to the class Alphaproteobacteria and Betaproteobacteria. They promote the growth and nutrition of their respective legume hosts through atmospheric nitrogen fixation which takes place in the nodules induced in their roots or stems. In addition, rhizobia have other plant growth-promoting mechanisms, mainly solubilization of phosphate and production of indoleacetic acid, ACC deaminase and siderophores. Some of these mechanisms have been reported for strains of rhizobia which are also able to promote the growth of several nonlegumes, such as cereals, oilseeds and vegetables. Less studied are the mechanisms that have the rhizobia to promote the plant health; however, these bacteria are able to exert biocontrol of some phytopathogens and to induce the plant resistance. In this chapter, we revised the available data about the ability of the legume nodule-inducing bacteria for improving the plant growth, health and nutrition of both legumes and nonlegumes. These data showed that rhizobia meet all the requirements of sustainable agriculture to be used as bio-inoculants allowing the total or partial replacement of chemicals used for fertilization or protection of crops