Multi-stage scheme for nonlinear Breit-Wheeler pair-production utilising ultra-intense laser-solid interactions

Multi-petawatt (PW) lasers enable intensities exceeding 1023 W cm-2, at which point quantum electrodynamics (QED) processes, such as electron-positron pair-production via the nonlinear Breit-Wheeler process, will play a significant role in laser-plasma interactions. Using 2D QED-particle-in-cell simulations, we present a two-stage scheme in which nonlinear pair-production is induced via an ultra-intense laser-solid interaction. The first stage is the generation of a γ-ray beam, through the interaction of an ultra-intense laser pulse with a thick target, whose features are found to be strongly dependent on collective plasma effects. This compact, high energy γ-ray beam (characterised by a divergence half-angle ∼10° and average photon energy ∼10 MeV) then interacts with two counter-propagating laser pulses. By varying the laser polarisation and angle of incidence, we show that in the case of two circularly polarised laser pulses propagating at an angle equal to the divergence half-angle of the γ-ray beam, the produced positron distribution is highly anisotropic compared to the case of a standard head-on collision

Self-diffusion in binary blends of cyclic and linear polymers

A lattice model is used to estimate the self-diffusivity of entangled cyclic and linear polymers in blends of varying compositions. To interpret simulation results, we suggest a minimal model based on the physical idea that constraints imposed on a cyclic polymer by infiltrating linear chains have to be released, before it can diffuse beyond a radius of gyration. Both, the simulation, and recently reported experimental data on entangled DNA solutions support the simple model over a wide range of blend compositions, concentrations, and molecular weights.Comment: 10 pages, 2 figure

Contemplative Science: An Insider's Prospectus

This chapter describes the potential far‐reaching consequences of contemplative higher education for the fields of science and medicine

Dynamic Control of Laser Produced Proton Beams

The emission characteristics of intense laser driven protons are controlled using ultra-strong (of the order of 10^9 V/m) electrostatic fields varying on a few ps timescale. The field structures are achieved by exploiting the high potential of the target (reaching multi-MV during the laser interaction). Suitably shaped targets result in a reduction in the proton beam divergence, and hence an increase in proton flux while preserving the high beam quality. The peak focusing power and its temporal variation are shown to depend on the target characteristics, allowing for the collimation of the inherently highly divergent beam and the design of achromatic electrostatic lenses.Comment: 9 Pages, 5 figure

Roles and functions of enrolled nurses in Australia: Perspectives of enrolled nurses and registered nurses

Aims and objectives: To determine, from the perspectives of enrolled nurses and registered nurses, the current scope of enrolled nurse practice and to identify the activities that most enrolled nurses frequently performed in their workplace. Background: Enrolled nurse scope of practice in Australia has evolved and expanded over the past decade. However, the unclear role, function and competency differentiation between enrolled nurse and registered nurse leads to role confusion and ongoing professional debate. Design: Exploratory Descriptive Study. Methods: A cross-sectional online survey of enrolled nurses and registered nurses across Australia was conducted examining their levels of agreement on statements related to the scope of practice and the clinical and nonclinical activities that enrolled nurses were required to perform in their workplace. Results: Valid responses were received from 892 enrolled nurses and 1,198 registered nurses. Enrolled nurses mostly agreed that they understood their scope of practice; did not undertake roles for which they were unprepared; sometimes undertook activities other than direct patient care; and believed that they operated equally to many registered nurses. The majority of enrolled nurses reported that they performed tasks mostly related to basic patient care in their workplace. There were a number of significant differences between perspectives of registered nurses and enrolled nurses. Conclusions: Clarifying the roles and scope of practice between the registered nurse and the enrolled nurse is important, and explicit differences in responsibility and accountability between their roles must be clearly articulated to harmonise perceptions about role and capability. Health service providers, policymakers and education providers need to work collaboratively to ensure that facets of enrolled nurse education and scope of practice in line with regulation are affirmed by all concerned. Relevance to clinical practice: Health service providers, policymakers and education providers need to work collaboratively to ensure that facets of enrolled nurse education and scope of practice in line with regulation are affirmed by all concerned

What causes the irregular cycle of the atmospheric tape recorder signal in HCN?

Variations in the mixing ratio of long-lived trace gases entering the stratosphere in the tropics are carried upward with the rising air with the signal being observable throughout the tropical lower stratosphere. This phenomenon, referred to as "atmospheric tape recorder" has previously been observed for water vapor, CO2, and CO which exhibit an annual cycle. Recently, based on Microwave Limb Sounder (MLS) and the Atmospheric Chemistry Experiment Fourier Transform Spectrometer (ACE-FTS) satellite measurements, the tape recorder signal has been observed for hydrogen cyanide (HCN) but with an approximately two-year period. Here we report on a model simulation of the HCN tape recorder for the time period 2002-2008 using the Chemical Lagrangian Model of the Stratosphere (CLaMS). The model can reproduce the observed pattern of the HCN tape recorder signal if time-resolved emissions from fires in Indonesia are used as lower boundary condition. This finding indicates that inter-annual variations in biomass burning in Indonesia, which are strongly influenced by El Nino events, control the HCN tape recorder signal. A longer time series of tropical HCN data will probably exhibit an irregular cycle rather than a regular biannual cycle. Citation: Pommrich, R., R. Muller, J.-U. Grooss, G. Gunther, P. Konopka, M. Riese, A. Heil, M. Schultz, H.-C. Pumphrey, and K. A. Walker (2010), What causes the irregular cycle of the atmospheric tape recorder signal in HCN?, Geophys. Res. Lett., 37, L16805, doi:10.1029/2010GL044056

A novel clinical risk prediction model for sudden cardiac death in hypertrophic cardiomyopathy (HCM Risk-SCD)

n/

Laser-driven X-ray and neutron source development for industrial applications of plasma accelerators

Pulsed beams of energetic X-rays and neutrons from intense laser interactions with solid foils are promising for applications where bright, small emission area sources, capable of multi-modal delivery are ideal. Possible end users of laser-driven multi-modal sources are those requiring advanced non-destructive inspection techniques in industry sectors of high value commerce such as aerospace, nuclear and advanced manufacturing. We report on experimental work that demonstrates multi-modal operation of high power laser-solid interactions for neutron and X-ray beam generation. Measurements and Monte-Carlo radiation transport simulations show that neutron yield is increased by a factor ~ 2 when a 1mm copper foil is placed behind a 2mm lithium foil, compared to using a 2cm block of lithium only. We explore X-ray generation with a 10 picosecond drive pulse in order to tailor the spectral content for radiography with medium density alloy metals. The impact of using >1ps pulse duration on laser-accelerated electron beam generation and transport is discussed alongside the optimisation of subsequent Bremsstrahlung emission in thin, high atomic number target foils. X-ray spectra are deconvolved from spectrometer measurements and simulation data generated using the GEANT4 Monte-Carlo code. We also demonstrate the unique capability of laser-driven X-rays in being able to deliver single pulse high spatial resolution projection imaging of thick metallic objects. Active detector radiographic imaging of industrially relevant sample objects with a 10ps drive pulse is presented for the first time, demonstrating that features of 200µm size are resolved when projected at high magnification