400 research outputs found
Characterisation of heat transfer in high thermal conductivity graphite foam
Paper presented at the 5th International Conference on Heat Transfer, Fluid Mechanics and Thermodynamics, South Africa, 1-4 July, 2007.This paper presents the results of an experimental
investigation of forced convection heat transfer in microcellular
graphite foam of high thermal conductivity. The test section
was designed to be adiabatic with constant heat flux supplied at
the bottom of the channel. The graphite foam heat sinks were
fabricated into different structures and compared with
conventional aluminum heat sinks of the same configurations.
Heat transfer characteristics including local temperature and
Nusselt number distributions for steady flow through the tested
heat sinks were measured and discussed. The results show that
graphite foam heat sinks give better heat transfer performance
as compared to conventional aluminum heat sinks for different
configurations. The highest heat transfer rate is obtained by the
graphite foam heat sink with a fin structure. The study implies
that graphite foam material can offer a combination of
properties ideally suited for applications in high heat flux
thermal management applications where conventional materials
and products are not adequate.cs201
Experimental and Numerical Investigation on Thermal Management of an Outdoor Battery Cabinet
Many forms of electronic equipment such as battery packs and telecom equipment must be stored in harsh outdoor environment. It is essential that these facilities be protected from a wide range of ambient temperatures and solar radiation. Temperature extremes greatly reduce lead-acid based battery performance and shorten battery life. Therefore, it is important to maintain the cabinet temperature within the optimal values between 20oC and 30oC to ensure battery stability and to extend battery lifespan. To this end, cabinet enclosures with proper thermal management have been developed to house such electronic equipment in a highly weather tight manner, especially for battery cabinet.
In this paper, the flow field and temperature distribution inside an outdoor cabinet are studied experimentally and numerically. The battery cabinets house 24 batteries in two configurations namely, two-layer configuration and six-layer configuration respectively. The cabinet walls are maintained at a constant temperature by a refrigeration system. The cabinet’s ability to protect the batteries from an ambient temperature as high as 50oC is studied. An experimental facility is developed to measure the battery surface temperatures and to validate the numerical simulations. The differences between the experimental and computational fluid dynamic (CFD) results are within 5%
On low temperature kinetic theory; spin diffusion, Bose Einstein condensates, anyons
The paper considers some typical problems for kinetic models evolving through
pair-collisions at temperatures not far from absolute zero, which illustrate
specific quantum behaviours. Based on these examples, a number of differences
between quantum and classical Boltzmann theory is then discussed in more
general terms.Comment: 25 pages, minor updates of previous versio
Measurements of the Mass and Full-Width of the Meson
In a sample of 58 million events collected with the BES II detector,
the process J/ is observed in five different decay
channels: , , (with ), (with
) and . From a combined fit of all five
channels, we determine the mass and full-width of to be
MeV/ and
MeV/.Comment: 9 pages, 2 figures and 4 table. Submitted to Phys. Lett.
Shadowing in Inelastic Scattering of Muons on Carbon, Calcium and Lead at Low XBj
Nuclear shadowing is observed in the per-nucleon cross-sections of positive
muons on carbon, calcium and lead as compared to deuterium. The data were taken
by Fermilab experiment E665 using inelastically scattered muons of mean
incident momentum 470 GeV/c. Cross-section ratios are presented in the
kinematic region 0.0001 < XBj <0.56 and 0.1 < Q**2 < 80 GeVc. The data are
consistent with no significant nu or Q**2 dependence at fixed XBj. As XBj
decreases, the size of the shadowing effect, as well as its A dependence, are
found to approach the corresponding measurements in photoproduction.Comment: 22 pages, incl. 6 figures, to be published in Z. Phys.
Measurement of W Polarisation at LEP
The three different helicity states of W bosons produced in the reaction e+
e- -> W+ W- -> l nu q q~ at LEP are studied using leptonic and hadronic W
decays. Data at centre-of-mass energies \sqrt s = 183-209 GeV are used to
measure the polarisation of W bosons, and its dependence on the W boson
production angle. The fraction of longitudinally polarised W bosons is measured
to be 0.218 \pm 0.027 \pm 0.016 where the first uncertainty is statistical and
the second systematic, in agreement with the Standard Model expectation
Search for Anomalous Couplings in the Higgs Sector at LEP
Anomalous couplings of the Higgs boson are searched for through the processes
e^+ e^- -> H gamma, e^+ e^- -> e^+ e^- H and e^+ e^- -> HZ. The mass range 70
GeV < m_H < 190 GeV is explored using 602 pb^-1 of integrated luminosity
collected with the L3 detector at LEP at centre-of-mass energies
sqrt(s)=189-209 GeV. The Higgs decay channels H -> ffbar, H -> gamma gamma, H
-> Z\gamma and H -> WW^(*) are considered and no evidence is found for
anomalous Higgs production or decay. Limits on the anomalous couplings d, db,
Delta(g1z), Delta(kappa_gamma) and xi^2 are derived as well as limits on the H
-> gamma gamma and H -> Z gamma decay rates
Measurement of W Polarisation at LEP
The three different helicity states of W bosons produced in the reaction e+
e- -> W+ W- -> l nu q q~ at LEP are studied using leptonic and hadronic W
decays. Data at centre-of-mass energies \sqrt s = 183-209 GeV are used to
measure the polarisation of W bosons, and its dependence on the W boson
production angle. The fraction of longitudinally polarised W bosons is measured
to be 0.218 \pm 0.027 \pm 0.016 where the first uncertainty is statistical and
the second systematic, in agreement with the Standard Model expectation
- …