193 research outputs found
Exploration of the equilibrium operating space for NSTX-Upgrade
This paper explores a range of high-performance equilibrium scenarios available in the NSTX-Upgrade device [J.E. Menard, submitted for publication to Nuclear Fusion]. NSTX-Upgrade is a substantial upgrade to the existing NSTX device [M. Ono, et al., Nuclear Fusion 40, 557 (2000)], with significantly higher toroidal field and solenoid capabilities, and three additional neutral beam sources with significantly larger current drive efficiency. Equilibria are computed with freeboundary TRANSP, allowing a self consistent calculation of the non-inductive current drive sources, the plasma equilibrium, and poloidal field coil current, using the realistic device geometry. The thermal profiles are taken from a variety of existing NSTX discharges, and different assumptions for the thermal confinement scalings are utilized. The no-wall and idealwall n=1 stability limits are computed with the DCON code. The central and minimum safety factors are quite sensitive to many parameters: they generally increases with large outer plasmawall gaps and higher density, but can have either trend with the confinement enhancement factor. In scenarios with strong central beam current drive, the inclusion of non-classical fast ion diffusion raises qmin, decreases the pressure peaking, and generally improves the global stability, at the expense of a reduction in the non-inductive current drive fraction; cases with less beam current drive are largely insensitive to additional fast ion diffusion. The non-inductive current level is quite sensitive to the underlying confinement and profile assumptions. For instance, for BT=1.0 T and Pinj=12.6 MW, the non-inductive current level varies from 875 kA with ITER-98y,2 thermal confinement scaling and narrow thermal profiles to 1325 kA for an ST specific scaling expression and broad profiles. This sensitivity should facilitate the determination of the correct scaling of transport with current and field to use for future fully non-inductive ST devices. Scenarios are presented which can be sustained for 8-10 seconds, or (20-30)τCR, at βN=3.8-4.5, facilitating, for instance, the study of disruption avoidance for very long pulse. Scenarios have been documented which can operate with βT~25% and equilibrated qmin>1. The value of qmin can be controlled at either fixed non-inductive fraction of 100% or fixed plasma current, by varying which beam sources are used, opening the possibility for feedback qmin control. In terms of quantities like collisionality, neutron emission, non-inductive fraction, or stored energy, these scenarios represent a significant performance extension compared to NSTX and other present spherical torii
Post conjunction detection of Pictoris b with VLT/SPHERE
With an orbital distance comparable to that of Saturn in the solar system,
\bpic b is the closest (semi-major axis \,9\,au) exoplanet that has
been imaged to orbit a star. Thus it offers unique opportunities for detailed
studies of its orbital, physical, and atmospheric properties, and of
disk-planet interactions. With the exception of the discovery observations in
2003 with NaCo at the Very Large Telescope (VLT), all following astrometric
measurements relative to \bpic have been obtained in the southwestern part of
the orbit, which severely limits the determination of the planet's orbital
parameters. We aimed at further constraining \bpic b orbital properties using
more data, and, in particular, data taken in the northeastern part of the
orbit.
We used SPHERE at the VLT to precisely monitor the orbital motion of beta
\bpic b since first light of the instrument in 2014. We were able to monitor
the planet until November 2016, when its angular separation became too small
(125 mas, i.e., 1.6\,au) and prevented further detection. We redetected \bpic b
on the northeast side of the disk at a separation of 139\,mas and a PA of
30 in September 2018. The planetary orbit is now well constrained.
With a semi-major axis (sma) of au (1 ), it
definitely excludes previously reported possible long orbital periods, and
excludes \bpic b as the origin of photometric variations that took place in
1981. We also refine the eccentricity and inclination of the planet. From an
instrumental point of view, these data demonstrate that it is possible to
detect, if they exist, young massive Jupiters that orbit at less than 2 au from
a star that is 20 pc away.Comment: accepted by A&
A expectativa em relação ao treinamento influencia o impacto das ações de capacitação?
Progress towards steady state at low aspect ratio on the National Spherical Torus Experiment (NSTX)
Extension of the TCV operating space towards higher elongation and higher normalized current
Velocity-space sensitivity of the time-of-flight neutron spectrometer at JET
The velocity-space sensitivities of fast-ion diagnostics are often described by so-called weight functions. Recently, we formulated weight functions showing the velocity-space sensitivity of the often dominant beam-target part of neutron energy spectra. These weight functions for neutron emission spectrometry (NES) are independent of the particular NES diagnostic. Here we apply these NES weight functions to the time-of-flight spectrometer TOFOR at JET. By taking the instrumental response function of TOFOR into account, we calculate time-of-flight NES weight functions that enable us to directly determine the velocity-space sensitivity of a given part of a measured time-of-flight spectrum from TOFOR
Relationship of edge localized mode burst times with divertor flux loop signal phase in JET
A phase relationship is identified between sequential edge localized modes (ELMs) occurrence times in a set of H-mode tokamak plasmas to the voltage measured in full flux azimuthal loops in the divertor region. We focus on plasmas in the Joint European Torus where a steady H-mode is sustained over several seconds, during which ELMs are observed in the Be II emission at the divertor. The ELMs analysed arise from intrinsic ELMing, in that there is no deliberate intent to control the ELMing process by external means. We use ELM timings derived from the Be II signal to perform direct time domain analysis of the full flux loop VLD2 and VLD3 signals, which provide a high cadence global measurement proportional to the voltage induced by changes in poloidal magnetic flux. Specifically, we examine how the time interval between pairs of successive ELMs is linked to the time-evolving phase of the full flux loop signals. Each ELM produces a clear early pulse in the full flux loop signals, whose peak time is used to condition our analysis. The arrival time of the following ELM, relative to this pulse, is found to fall into one of two categories: (i) prompt ELMs, which are directly paced by the initial response seen in the flux loop signals; and (ii) all other ELMs, which occur after the initial response of the full flux loop signals has decayed in amplitude. The times at which ELMs in category (ii) occur, relative to the first ELM of the pair, are clustered at times when the instantaneous phase of the full flux loop signal is close to its value at the time of the first ELM
Effects of 59Fe, 65Zn and of three soil types on dry matter yield, chemical composition and nitrogen fixation in Phaseolus vulgaris L. cv. carioca
The aim of this work was to study in greenhouse conditions the effects of two levels of iron and zinc on yield and chemical composition of common bean (Phaseolus vulgaris L.) and on atmospheric nitrogen fixation, in three soils, classified as Terra Roxa Estruturada (TRE), Latossol Vermelho Escuro (LVE), and Podzolico Vermelho Amarelo (PVA). The coefficient of utilization of these micronutrients by this crop and its distribution in above-ground parts and roots were also assessed. The rates for iron were 1.5 and 3.0 ppm, and for zinc, 2.5 and 5.0 ppm. It was applied 7.5 µCi of 59Fe/kg of soil with the lower rate of the stable iron, and 5.0 and 10.0 µCi of Zn/kg of soil in the pots corresponding to the lower and higher rate of the stable zinc, respectively. The plants were harveste at the age of 60 days and nitrogen, phosphorus, potassium, iron and zinc contents were determined. Immediately after harvest, symbiotic nitrogen fixation was assessed, using the acetylene reduction method. The detection of 59Fe and 65zn radioactivity were carried out on nitric percloric extract, by gamma ray spectrometry. The behavior of common bean presented high variation among the three soils, for all the variables. There was no influence of treatments of iron and zinc on dry matter of above ground part and root and also on the weight and number of nodules. The rate of 3.0 ppm of iron decreased the capacity of nodules to fix atmospheric nitrogen in relation to rate of 1.5 ppm, while the rate of 5.0 ppm of zinc increased this capacity, in relation to the rate of 2.5 ppm. There was significative effect of treatments on nitrogen, potassium and zinc contents in above ground part and on nitrogen and zinc contents in the root. The absorption of zinc from the fertilizer and the percentagem of zinc in the plant derived from fertilizer were diretly influenced by rate of zinc The higher coefficient of utilization of zinc from the fertilizer was 4.0%.No presente trabalho, conduzido em casa de vegetação, procuramos estudar os efeitos dos micronutrientes ferro e zinco na produção de materia seca, composição química do feijoeiro (Phaseolus vulgaris L.) e na fixação do nitrogênio atmosférico, em três solos, classificados como Terra Roxa Estruturada (TRE), Latossol Vermelho Escuro (LVE) e Podzólico Vermelho Amarelo (PVA). Procuramos também determinar os índices de aproveitamento destes micronutrientes pelo feijoeiro e sua distribuição na parte aérea e na raiz. O delineamento experimental foi um fatorial 3x7, sendo três solos e sete tratamentos por solo, com três repetições. Nos tratamentos, foram utilizados duas doses de ferro e duas doses de zinco em separado ou combinando as doses menores e maiores destes micronutrientes (Fe1Zn1, Fe2Zn2). As doses de ferro foram 1,5 e 3,0 ppm e as de zinco foram 2,5 e 5,0 ppm. Foram aplicados 7,5 µCi de 59Fe/kg de solo nos vasos correspondentes à dose menor de ferro e 5,0 e 10,0 µCi de 65Zn/kg de solo nos vasos correspondentes respectivamente à dose menor e maior de zinco. Todos os tratamentos receberam uma adubação básica. O comportamento do feijoeiro apresentou grande variação entre os três tipos de solos, para todas as variáveis. Não houve influência dos tratamentos de ferro e zinco na produção de parte aérea e raiz e nem no peso e numero dos nodulos. A dose de 3,0 ppm de ferro diminuiu a capacidade dos nódulos de fixarem nitrogênio atmosférico em relação à dose de 1,5 ppm enquanto que a dose de 5,0 ppm de zinco aumentou esta capacidade, em relação à dose de 2,5 ppm. Houve um efeito significativo dos tratamentos na concentração de nitrogênio, potássio, ferro e zinco na parte aérea e na concentração de nitrogênio, e zinco na raiz. A absorção de zinco dos fertilizantes e a percentagem do zinco na planta proveniente do adubo foram influenciadas diretamente pelas doses de zinco. O maior coeficiente de aproveitamento do zinco do adubo foi de 4,0%
- …