512 research outputs found
Room temperature magneto-optic effect in silicon light-emitting diodes
In weakly spin-orbit coupled materials, the spin-selective nature of
recombination can give rise to large magnetic-field effects, for example on
electro-luminescence from molecular semiconductors. While silicon has weak
spin-orbit coupling, observing spin-dependent recombination through
magneto-electroluminescence is challenging due to the inefficiency of emission
due to silicon's indirect band-gap, and to the difficulty in separating
spin-dependent phenomena from classical magneto-resistance effects. Here we
overcome these challenges to measure magneto-electroluminescence in silicon
light-emitting diodes fabricated via gas immersion laser doping. These devices
allow us to achieve efficient emission while retaining a well-defined geometry
thus suppressing classical magnetoresistance effects to a few percent. We find
that electroluminescence can be enhanced by up to 300\% near room temperature
in a seven Tesla magnetic field showing that the control of the spin degree of
freedom can have a strong impact on the efficiency of silicon LEDs
Cap rock efficiency of geothermal systems in fold-and-thrust belts: Evidence from paleo-thermal and structural analyses in Rosario de La Frontera geothermal area (NW Argentina)
Cap rock characterization of geothermal systems is often neglected despite fracturing may reduce its efficiency and favours fluid migration. We investigated the siliciclastic cap rock of Rosario de La Frontera geothermal system (NW Argentina) in order to assess its quality as a function of fracture patterns and related thermal alteration. Paleothermal investigations (XRD on fine-grained fraction of sediments, organic matter optical analysis and fluid inclusions on veins) and 1D thermal modelling allowed us to distinguish the thermal fingerprint associated to sedimentary burial from that related to fluid migration. The geothermal system is hosted in a Neogene N-S anticline dissected by high angle NNW- and ENE-striking faults. Its cap rock can be grouped into two quality categories: • rocks acting as good insulators, deformed by NNW–SSE and E–W shear fractures, NNE-SSW gypsum- and N-S-striking calcite-filled veins that developed during the initial stage of anticline growth. Maximum paleo-temperatures (< 60 °C) were experienced during deposition to folding phases.• rocks acting as bad insulators, deformed by NNW-SSE fault planes and NNW- and WNW-striking sets of fractures associated to late transpressive kinematics. Maximum paleo-temperatures higher than about 115 °C are linked to fluid migration from the reservoir to surface (with a reservoir top at maximum depths of 2.5 km) along fault damage zones.This multi-method approach turned out to be particularly useful to trace the main pathways of hot fluids and can be applied in blind geothermal systems where either subsurface data are scarce or surface thermal anomalies are lacking.Fil: Maffucci, R.. Universita Degli Studi Della Tuscia; Italia. Universita Degli Studi Roma Tre; ItaliaFil: Corrado, Sveva. Universita Degli Studi Roma Tre; ItaliaFil: Aldega, L.. Instituto de Investigaciones Universitarias Roma la Sapienza; ItaliaFil: Bigi, S.. Instituto de Investigaciones Universitarias Roma la Sapienza; ItaliaFil: Chiodi, Agostina Laura. Consejo Nacional de Investigaciones CientĂficas y TĂ©cnicas. Centro CientĂfico TecnolĂłgico Conicet - Salta. Instituto de Investigaciones en EnergĂa no Convencional. Universidad Nacional de Salta. Facultad de Ciencias Exactas. Departamento de FĂsica. Instituto de Investigaciones en EnergĂa no Convencional; ArgentinaFil: Di Paolo, L.. Eni E&P Division; ItaliaFil: Giordano, G.. Universita Degli Studi Roma Tre; ItaliaFil: Invernizzi, C.. Universita Degli Di Camerino; Itali
Silicon Superconducting Quantum Interference Device
We have studied a Superconducting Quantum Interference SQUID device made from
a single layer thin film of superconducting silicon. The superconducting layer
is obtained by heavily doping a silicon wafer with boron atoms using the Gas
Immersion Laser Doping (GILD) technique. The SQUID device is composed of two
nano-bridges (Dayem bridges) in a loop and shows magnetic flux modulation at
low temperature and low magnetic field. The overall behavior shows very good
agreement with numerical simulations based on the Ginzburg-Landau equations.Comment: Published in Applied Physics Letters (August 2015
High-speed data transfer with FPGAs and QSFP+ modules
We present test results and characterization of a data transmission system
based on a last generation FPGA and a commercial QSFP+ (Quad Small Form
Pluggable +) module. QSFP+ standard defines a hot-pluggable transceiver
available in copper or optical cable assemblies for an aggregated bandwidth of
up to 40 Gbps. We implemented a complete testbench based on a commercial
development card mounting an Altera Stratix IV FPGA with 24 serial transceivers
at 8.5 Gbps, together with a custom mezzanine hosting three QSFP+ modules. We
present test results and signal integrity measurements up to an aggregated
bandwidth of 12 Gbps.Comment: 5 pages, 3 figures, Published on JINST Journal of Instrumentation
proceedings of Topical Workshop on Electronics for Particle Physics 2010,
20-24 September 2010, Aachen, Germany(R Ammendola et al 2010 JINST 5 C12019
The ATLAS barrel level-1 Muon Trigger Sector-Logic/RX off-detector trigger and acquisition board
The ATLAS experiment uses a system of three concentric layers of Resistive Plate Chambers (RPC) detector for the Level-1 Muon Trigger in the air-core barrel toroid region. The trigger algorithm looks for hit coincidences within different detector layers inside the programmable geometrical road which defines the transverse momentum cut. The on-detector electronics that provides the trigger and detector readout functionalities collects input signals coming from the RPC front-end. Trigger and readout data are then sent via optical fibres to the off-detector electronics. Six or seven optical fibres from one of the 64 trigger sectors go to one Sector-Logic/RX module, that later elaborates the collected trigger and readout data, and sends data respectively to the Read-Out Driver modules and to the Central Level-1 Trigger. We present the functionality and the implementation of the VME Sector-Logic/RX module, and the configuration of the system for the first cosmic ray data collected using this module
MIME: A Formal Approach to (Android) Emulation Malware Analysis
In this paper, we propose a new dynamic and configurableapproach to anti-emulation malware analysis, aiming at improving transparencyof existing analyses techniques. We test the effectiveness of existingwidespread free analyzers and we observe that the main problem ofthese analyses is that they provide static and immutable values to theparameter used in anti-emulation tests. Our approach aims at overcomingthese limitations by providing an abstract non-interference-based approachmodeling the fact that parameters can be modified dynamically,and the corresponding executions compared
Supra-oscillatory critical temperature dependence of Nb-Ho bilayers
We investigate the critical temperature Tc of a thin s-wave superconductor
(Nb) proximity coupled to a helical rare earth ferromagnet (Ho). As a function
of the Ho layer thickness, we observe multiple oscillations of Tc superimposed
on a slow decay, that we attribute to the influence of the Ho on the Nb
proximity effect. Because of Ho inhomogeneous magnetization, singlet and
triplet pair correlations are present in the bilayers. We take both into
consideration when solving the self consistent Bogoliubov-de Gennes equations,
and we observe a reasonable agreement. We also observe non-trivial transitions
into the superconducting state, the zero resistance state being attained after
two successive transitions which appear to be associated with the magnetic
structure of Ho.Comment: Main article: 5 pages, 4 figures; Supplementary materials: 4 pages, 5
figure
Radiation test and application of FPGAs in the ATLAS Level 1 Trigger
The front-end system of the Silicon Drift Detectors (SDDs) of the ALICE experiment is made of two ASICs. The first chip performs the preamplification, temporary analogue storage and analogue-to-digital conversion of the detector signals. The second chip is a digital buffer that allows for a significant reduction of the connection from the front-end module to the outside world. In this paper, the results achieved on the first complete prototype of the front-end system for the SDDs of ALICE are presented
Dependence of the energy resolution of a scintillating crystal on the readout integration time
The possibilty of performing high-rate calorimetry with a slow scintillating crystal is studied. In this experimental situation, to avoid pulse pile-up, it can be necessary to base the energy measurement on only a fraction of the emitted light, thus spoiling the energy resolution. This effect was experimentally studied with a BGO crystal and a photomultiplier followed by an integrator, by measuring the maximum amplitude of the signals. The experimental data show that the energy resolution is exclusively due to the statistical fluctuations of the number of photoelectrons contributing to the maximum amplitude. When such number is small its fluctuations are even smaller than those predicted by Poisson statistics. These results were confirmed by a Monte Carlo simulation which allows to estimate, in a general case, the energy resolution, given the total number of photoelectrons, the scintillation time and the integration time
- …