1,181 research outputs found

    Improved red-response in thin film a-Si:H solar cells with soft-imprinted plasmonic back reflectors

    Get PDF
    The impact of controlled nanopatterning on the Ag back contact of an n-i-p a-Si:H solar cell was investigated experimentally and through electromagnetic simulation. Compared to a similar reference cell with a flat back contact, we demonstrate an efficiency increase from 4.5% to 6.2%, with a 26% increase in short circuit current density. Spectral response measurements show the majority of the improvement between 600 and 800 nm, with no reduction in photocurrent at wavelengths shorter than 600 nm. Optimization of the pattern aspect ratio using electromagnetic simulation predicts absorption enhancements over 50% at 660 nm

    Light trapping in ultrathin plasmonic solar cells

    Get PDF
    We report on the design, fabrication, and measurement of ultrathin film a-Si:H solar cells with nanostructured plasmonic back contacts, which demonstrate enhanced short circuit current densities compared to cells having flat or randomly textured back contacts. The primary photocurrent enhancement occurs in the spectral range from 550 nm to 800 nm. We use angle-resolved photocurrent spectroscopy to confirm that the enhanced absorption is due to coupling to guided modes supported by the cell. Full-field electromagnetic simulation of the absorption in the active a-Si:H layer agrees well with the experimental results. Furthermore, the nanopatterns were fabricated via an inexpensive, scalable, and precise nanopatterning method. These results should guide design of optimized, non-random nanostructured back reflectors for thin film solar cells

    Substrate conformal imprint fabrication process of synthetic antiferromagnetic nanoplatelets

    Full text link
    Methods to fabricate and characterize monodisperse magnetic nanoplatelets for fluid/bio-based applications based on spintronic thin-film principles are a challenge. This is due to the required top-down approach where the transfer of optimized blanket films to free particles in a fluid while preserving the magnetic properties is an uncharted field. Here, we explore the use of substrate conformal imprint lithography (SCIL) as a fast and cost-effective fabrication route. We analyze the size distribution of nominal 1.8 um and 120 nm diameter platelets and show the effect of the fabrication steps on the magnetic properties which we explain through changes in the dominant magnetization reversal mechanism as the size decreases. We show that SCIL allows for efficient large-scale platelet fabrication and discuss how application-specific requirements can be solved via process and material engineering

    Quantum Rod Emission Coupled to Plasmonic Lattice Resonances: A Collective Directional Source of Polarized Light

    Get PDF
    We demonstrate that an array of optical antennas may render a thin layer of randomly oriented semiconductor nanocrystals into an enhanced and highly directional source of polarized light. The array sustains collective plasmonic lattice resonances which are in spectral overlap with the emission of the nanocrystals over narrow angular regions. Consequently, different photon energies of visible light are enhanced and beamed into definite directions.Comment: 4 pages, 3 figure

    Mixing Waters: A Cross Cultural Approach to Developing Guidelines for Fishers and Boaters in the Dhimurru Indigenous Protected Area

    Get PDF
    This article demonstrates the importance of indigenous ontologies in cross-cultural or ‘both ways’ coastal conservation management of the Dhimurru Indigenous Protected Area in north east Arnhem Land, Australia. In this action research, selected Yol¿u individuals identified concerns regarding recreational fishing and boating practices of non-Yol¿u. Yol¿u engaged in a discussion of the issues and the subsequent formulation of indigenous management responses. This led to the development of locally relevant guidelines for fishers and boaters with potentially broader applications in other Indigenous Protected Areas and beyond. We explore the ‘both ways’ approach adopted by the Dhimurru Aboriginal Corporation that guides collaboration between Yol¿u and non-Yol¿u. We illustrate how the approach facilitates indigenous ontologies to co-create conservation approaches together with contemporary conservation efforts informed by Western science. We further explore the disjunctures and synergies between the two and argue that these mix and can be compatible as part of the ‘both ways’ approach. In learning from this action research, we reflect on the process of cross-cultural learning and the role of researchers in the cross-cultural co-production of knowledge and the formulation of guidelines for fishers an

    Використання кавітаційних пристроїв в харчовій промисловості

    Get PDF
    We present a direct experimental investigation of the thermal ordering in an artificial analogue of an asymmetric two-dimensional Ising system composed of a rectangular array of nano-fabricated magnetostatically interacting islands. During fabrication and below a critical thickness of the magnetic material the islands are thermally fluctuating and thus the system is able to explore its phase space. Above the critical thickness the islands freeze-in resulting in an arrested thermalized state for the array. Determining the magnetic state we demonstrate a genuine artificial two-dimensional Ising system which can be analyzed in the context of nearest neighbor interactions

    Generic nano-imprint process for fabrication of nanowire arrays

    Full text link
    A generic process has been developed to grow nearly defect free arrays of (heterostructured) InP and GaP nanowires. Soft nanoimprint lithography has been used to pattern gold particle arrays on full 2 inch substrates. After lift-off organic residues remain on the surface, which induce the growth of additional undesired nanowires. We show that cleaning of the samples before growth with piranha solution in combination with a thermal anneal at 550 C for InP and 700 C for GaP results in uniform nanowire arrays with 1% variation in nanowire length, and without undesired extra nanowires. Our chemical cleaning procedure is applicable to other lithographic techniques such as e-beam lithography, and therefore represents a generic process.Comment: 12 pages, 4 figures, 2 table

    Childbirths and the Prevalence of Potential Risk Factors for Adverse Perinatal Outcomes among Asylum Seekers in The Netherlands:A Five-Year Cross-Sectional Study

    Get PDF
    This five-year cross-sectional study mapped the prevalence of several known risk factors for adverse perinatal outcomes in asylum-seeking women in The Netherlands. Characteristics of 2831 registered childbirths among residents of asylum seekers centers (ASCs) in The Netherlands from 2016 to 2020 were included. Results showed a high general and teenage birthrate (2.15 and 6.77 times higher compared to the Dutch, respectively). Most mothers were pregnant upon arrival, and the number of births was highest in the second month of stay in ASCs. Another peak in births between 9 and 12 months after arrival suggested that many women became pregnant shortly after arrival in The Netherlands. Furthermore, 69.5 percent of all asylum-seeking women were relocated between ASCs at least once during pregnancy, which compromises continuity of care. The high prevalence of these risk factors in our study population might explain the increased rate of adverse pregnancy outcomes in asylum seekers compared to native women found in earlier studies. Incorporating migration-related indicators in perinatal health registration is key to support future interventions, policies, and research. Ultimately, our findings call for tailored and timely reproductive and perinatal healthcare for refugee women who simultaneously face the challenges of resettlement and pregnancy

    Long-term follow-up, quality of life, and survival of patients with Lambert-Eaton myasthenic syndrome

    Get PDF
    ObjectiveTo study survival and to characterize long-term functional impairments and health-related quality of life (HRQOL) of patients with Lambert-Eaton myasthenic syndrome (LEMS).MethodsIn this observational study, survival of patients with LEMS, separately for nontumor (NT) and small cell lung cancer (SCLC), was compared to that of the Dutch general population and patients with SCLC. Disease course in patients with LEMS was recorded retrospectively. Several scales for functional impairments and health-related quality of life were assessed.ResultsWe included 150 patients with LEMS. Survival was similar to that of the general population in 65 patients with NT-LEMS. Tumor survival was significantly longer in 81 patients with SCLC-LEMS compared to patients with non-LEMS SCLC (overall median survival 17 vs 7.0 months, p <0.0001). At diagnosis, 39 (62%) of 63 patients with complete follow-up data were independent for activities of daily living, improving to 85% at the 1-year follow-up. The physical HRQOL composite score (55.9) was significantly lower than in the general population (76.3, p <0.0001) and comparable to that of patients with myasthenia gravis (60.5). The mental HRQOL composite score was 71.8 in patients with LEMS, comparable to that of the general population (77.9, p = 0.19) and patients with myasthenia gravis (70.3).ConclusionsThis study shows that patients with NT-LEMS have normal survival. Patients with SCLC-LEMS have an improved tumor survival, even after correction for tumor stage. A majority of patients with LEMS report a stable disease course and remain or become independent for self-care after treatment
    corecore