Importance of Ecological Factors and Colony Handling for Optimizing Health Status of Apiaries in Mediterranean Ecosystems

We analyzed six apiaries in several natural environments with a Mediterranean ecosystem in Madrid, central Spain, in order to understand how landscape and management characteristics may influence apiary health and bee production in the long term. We focused on five criteria (habitat quality, landscape heterogeneity, climate, management and health), as well as 30 subcriteria, and we used the analytic hierarchy process (AHP) to rank them according to relevance. Habitat quality proved to have the highest relevance, followed by beehive management. Within habitat quality, the following subcriteria proved to be most relevant: orographic diversity, elevation range and important plant species located 1.5 km from the apiary. The most important subcriteria under beehive management were honey production, movement of the apiary to a location with a higher altitude and wax renewal. Temperature was the most important subcriterion under climate, while pathogen and Varroa loads were the most significant under health. Two of the six apiaries showed the best values in the AHP analysis and showed annual honey production of 70 and 28 kg/colony. This high productivity was due primarily to high elevation range and high orographic diversity, which favored high habitat quality. In addition, one of these apiaries showed the best value for beehive management, while the other showed the best value for health, reflected in the low pathogen load and low average number of viruses. These results highlight the importance of environmental factors and good sanitary practices to maximize apiary health and honey productivity

Electronic information sharing in local government authorities: Factors influencing the decision-making process

This is the post-print version of the final paper published in International Journal of Information Management. The published article is available from the link below. Changes resulting from the publishing process, such as peer review, editing, corrections, structural formatting, and other quality control mechanisms may not be reflected in this document. Changes may have been made to this work since it was submitted for publication. Copyright @ 2013 Elsevier B.V.Local Government Authorities (LGAs) are mainly characterised as information-intensive organisations. To satisfy their information requirements, effective information sharing within and among LGAs is necessary. Nevertheless, the dilemma of Inter-Organisational Information Sharing (IOIS) has been regarded as an inevitable issue for the public sector. Despite a decade of active research and practice, the field lacks a comprehensive framework to examine the factors influencing Electronic Information Sharing (EIS) among LGAs. The research presented in this paper contributes towards resolving this problem by developing a conceptual framework of factors influencing EIS in Government-to-Government (G2G) collaboration. By presenting this model, we attempt to clarify that EIS in LGAs is affected by a combination of environmental, organisational, business process, and technological factors and that it should not be scrutinised merely from a technical perspective. To validate the conceptual rationale, multiple case study based research strategy was selected. From an analysis of the empirical data from two case organisations, this paper exemplifies the importance (i.e. prioritisation) of these factors in influencing EIS by utilising the Analytical Hierarchy Process (AHP) technique. The intent herein is to offer LGA decision-makers with a systematic decision-making process in realising the importance (i.e. from most important to least important) of EIS influential factors. This systematic process will also assist LGA decision-makers in better interpreting EIS and its underlying problems. The research reported herein should be of interest to both academics and practitioners who are involved in IOIS, in general, and collaborative e-Government, in particular

Duplicated Laboratory Tests : A Hospital Audit And Evaluation Of A Computerized Alert Intervention

Laboratory testing is necessary when it contributes to the overall clinical management of the patient. Redundant testing, however, is often unnecessary and expensive and contributes to overall reductions in healthcare system efficiency. The purpose of this study is two-fold. First, to evaluate the frequency of ordering duplicate laboratory tests in hospitalized patients and the costs associated with this practice. Second, it was designed to determine if the use of a computerized alert or prompt will reduce the total number of unnecessarily duplicated Acute Hepatitis Profile (AHP) laboratory tests. This two-phase study took place in an inpatient facility that was part of a large tertiary care hospital system in Florida. A retrospective descriptive design was used during Phase 1 was to evaluate six laboratory tests and the frequency of ordering duplicate laboratory tests in hospitalized patients and to determine the associated costs of this practice for a 12-month time period in 2010. A test was considered a duplicate or an unnecessarily repeated test if it followed a previous test of the same type during the patient’s length of stay in the hospital and one in which any change in their values likely would not be clinically significant. A quasi-experimental pre- and post-test design was used during phase 2 was to determine the proportion of duplication of the AHP test before and after the implementation of a computerized alert intervention implemented as part of a system quality improvement process on January 5th, 2011. Data were compared for two 3-month time periods, pre- and post-alert implementation. The AHP test was considered redundant if it followed a previous test of the same type within 15 days of the initial test being final and present in the medical record. In phase 1, including each of the six tests examined, there were a total amount of 53, 351 test ordered, with 10, 375 (19.4%) of these cancelled. Out of the total amount of result final tests iv (n = 42,976), including each of the six tests examined, 4.6-8.7% were redundant. Results of the proportion of duplication of the six selected tests are as follows: AHP 196/2514 (7.8%), Antinuclear Antibody (ANA) 120/2594 (4.6%), B12/Folate level 396/5874 (6.7%), Thyroid Stimulating Hormone (TSH) 1893/21595 (8.7%), Ferritin 384/5171 (7.4%), and Iron/Total iron binding capacity (TIBC) 316/5155 (6.1%). The overall associated yearly cost of redundant testing of these six selected tests was an estimated $419, 218. The largest proportion of redundant tests was the Thyroid Stimulating Hormone level, costing a yearly estimated$300, 987. In Phase 2, prior to introduction of the alert, 674 AHP tests were performed. Of these, 53 (7.9%) were redundant. During the intervention period, 692 AHP tests were performed, of these 18 (2.6%) were redundant. The implementation of the computerized alert was shown to significantly reduce the proportion of AHP tests (Chi-Square: χ2 = df 1, p ≤ 0.001). The differences in the associated costs of duplicated AHP were $5238 dollars in 2010 as compared to$1746 in 2011 post-alert and these differences were significant (Mann Whitney U, Z = -4.04, p ≤ 0.001). Although the proportions of unnecessarily repeated diagnostic tests that were observed during Phase 1 of this study were small, the associated costs could adversely affect hospital revenue and overall healthcare efficiency. The implementation of the AHP computerized alert demonstrated a drop in the proportion of redundant AHP tests and subsequent associated cost savings. It is necessary to perform further research to evaluate computerized alerts on other tests with evidence-based test-specific time intervals, and to determine if such reductions postimplementation of AHP alerts are sustained over time

SURFACE MODIFICATIONS OF REVERSE OSMOSIS MEMBRANES FOR REMOVAL OF BROMIDE AND REDUCTION OF FOULING

Reverse osmosis (RO) is widely used for water reuse and desalination. Although RO membranes are known for their high salt rejection and practical permeate flux, their performance can be impaired by fouling, and their removal of some disinfection byproducts and their precursors (e.g., bromide, N-Nitrosodimethylamine [NDMA]) does not meet drinking water standards. RO membrane modifications have been widely studied to overcome these limitations. In this research, RO membranes were grafted with cationic polymers to induce a positive charge on the RO membrane surface. This modification aimed at enhancing the rejection of negatively charged bromide ions by removing them from solution by binding them to the membrane surface. The results showed that the modified (positively charged) RO membranes achieved lower rejection (82% rejection) for bromide ions compared to the unmodified ones (94.5% rejection). This behavior was likely a result of increased concentration polarization of the bromide ions at the membrane surface and/or increase in porosity of the modified membranes. Calculations based on the film theory indicate that the concentration of bromide ions at the surface of the modified membrane was 1371 ppm compared to 1307 ppm at the surface of the unmodified membrane. Evidently, the polymer attraction energy was not sufficient to keep the bromide ions attached to the membrane surface and prevent their diffusion across the membrane. Although the goal of the modification in the current study (i.e., enhancing removal of bromide ions) was not met, the permeate flux of the modified membrane was improved compared to the unmodified one. The literature suggests that increasing flux after modification is likely a result of increase in membrane pore size and hydrophilicity. In addition to the experimental work conducted in this study, a multi-criteria decision analysis was performed to prioritize research on surface modifications of reverse osmosis membranes. It was found that surface modifications have been mainly focused on reducing membrane fouling and to a much lower extent on removal of disinfection byproducts and their precursors. The RO membrane modification alternatives for fouling reduction and N-Nitrosodimethylamine (NDMA) removal were ranked based on multiple criteria using the Analytical Hierarchy Process (AHP) and the Technique for Order Preference by Similarity to Ideal Solution (TOPSIS). This multi-criteria decision analysis process resulted in the identification of the top five promising modifications to reduce fouling and improve NDMA rejection. Grafting and coating the RO membranes with complex polymeric salts were the highest ranked modification approaches to reduce fouling. Heat-treatment of RO membranes achieved the highest NDMA rejection (98%); however, this technique was the second highest ranked modification approach for NDMA removal because it scored lower for other evaluation criteria

An Overview of Economic Approaches to Information Security Management

The increasing concerns of clients, particularly in online commerce, plus the impact of legislations on information security have compelled companies to put more resources in information security. As a result, senior managers in many organizations are now expressing a much greater interest in information security. However, the largest body of research related to preventing breaches is technical, focusing on such issues as encryption and access control. In contrast, research related to the economic aspects of information security is small but rapidly growing. The goal of this technical note is twofold: i) to provide the reader with an structured overview of the economic approaches to information security and ii) to identify potential research directions

Mathematical Modelling in Engineering & Human Behaviour 2018

This book includes papers in cross-disciplinary applications of mathematical modelling: from medicine to linguistics, social problems, and more. Based on cutting-edge research, each chapter is focused on a different problem of modelling human behaviour or engineering problems at different levels. The reader would find this book to be a useful reference in identifying problems of interest in social, medicine and engineering sciences, and in developing mathematical models that could be used to successfully predict behaviours and obtain practical information for specialised practitioners. This book is a must-read for anyone interested in the new developments of applied mathematics in connection with epidemics, medical modelling, social issues, random differential equations and numerical methods

Wright State University\u27s Symposium of Student Research, Scholarship & Creative Activities from Thursday, October 26, 2023

The student abstract booklet is a compilation of abstracts from students\u27 oral and poster presentations at Wright State University\u27s Symposium of Student Research, Scholarship & Creative Activities on October 26, 2023.https://corescholar.libraries.wright.edu/celebration_abstract_books/1001/thumbnail.jp

Using a group decision method to judge the value of blockchain for an enterprise in supply chain

Blockchain technology recently has become popular. This new way of transaction may bring many benefits for a supply chain. Because of its own attributes, a Blockchain network can create a peer to peer transaction environment which is decentralized, tamper proof, safe and reliable, with no need of a centralized trusted third party. What's more, each of the nodes in the network will have the same ledger providing a permanent record for each transaction in the whole net, which makes it nearly impossible to tamper the record. With this transparency of information, it is much easier to trace back the product information.by Shitao YuIncludes bibliographical reference

Rapid Response Command and Control (R2C2): a systems engineering analysis of scaleable communications for Regional Combatant Commanders

Includes supplementary materialDisaster relief operations, such as the 2005 Tsunami and Hurricane Katrina, and wartime operations, such as Operation Enduring Freedom and Operation Iraqi Freedom, have identified the need for a standardized command and control system interoperable among Joint, Coalition, and Interagency entities. The Systems Engineering Analysis Cohort 9 (SEA-9) Rapid Response Command and Control (R2C2) integrated project team completed a systems engineering (SE) process to address the military’s command and control capability gap. During the process, the R2C2 team conducted mission analysis, generated requirements, developed and modeled architectures, and analyzed and compared current operational systems versus the team’s R2C2 system. The R2C2 system provided a reachback capability to the Regional Combatant Commander’s (RCC) headquarters, a local communications network for situational assessments, and Internet access for civilian counterparts participating in Humanitarian Assistance/Disaster Relief operations. Because the team designed the R2C2 system to be modular, analysis concluded that the R2C2 system was the preferred method to provide the RCC with the required flexibility and scalability to deliver a rapidly deployable command and control capability to perform the range of military operations