427 research outputs found
CF6 jet engine performance deterioration results
The use of the performance baseline from the flight planning manual as a reference to measure changes in cruise fuel flow rates was discussed. For the CF6-6D engine, the introduction of design changes for performance and durability reasons was seen to introduce an average increment relative to this baseline of 3.2% WFM increase at Nl, 2.5% Fn increase at Nl, 0.8% specific fuel consumption (SFC) increase at Fn, and 7 C EGT increase at Nl, while maintaining sufficient SFC margin of the delivered airplane. The effect of revenue service deterioration and performance restoration relative to the reference was shown to be an adder on top of these design effects. A schematic of typical CF6-6D performance through revenue service and airline maintenance is presented in terms of percent cruise SFC relative to an airline datum point (average level upon entering revenue service). The typical changes in SFC margin are shown for airline revenue service through for installations and refurbishments
Acoustic testing of a 1.5 pressure ratio, low tip speed fan (QEP fan B scale model)
A scale model (0.484 scale factor) of a single stage fan designed for a 1.5 pressure ratio and 1160 ft/sec tip speed was tested to determine its noise characteristics. The fan had 26 blades and 60 outlet guide vanes, with vanes spaced two rotor blade aerodynamic chords from the blades. The effects of speed, exhaust nozzle area and fan frame acoustic treatment on the scale model's noise characteristics were investigated
Analytical and experimental studies of acoustic performance of segmented liners in a compressor inlet
The performance of axially segmented (phased) acoustic treatment liners in the inlet of a compressor was investigated. Topics discussed include: (1) the validation of a theoretical procedure to predict propagation and suppression characteristics of duct liners; (2) the in-duct measurement of spinning modes; (3) investigation of phased treatment designs; (4) high Mach inlet acoustic tests; and (5) an experimental investigation of inlet turbulence. The analytical prediction for the multi-segmented treatment was found to provide the correct order of magnitude of suppression and was generally within 50% of that determined experimentally. Refinements required to improve the correlation are identified. Suppression due to high subsonic Mach number flow effects was found to become significant above an average throat Mach number of 0.65 to 0.7 and 20 PNdB was achieved with an average throat Mach number in the range of 0.80 to 0.85. For the measured turbulence in the inlet, including the axial and circumferential turbulence intensities and the axial integral length scale, data are presented with and without an inlet screen showing that the screen reduced the turbulence intensities and that the BPF noise was reduced as a consequence
CF6-6D engine short-term performance deterioration
Studies conducted as part of the NASA-Lewis CF6 jet engine diagnostics program are summarized. An 82-engine sample of DC-10-10 aircraft engine checkout data that were gathered to define the extent and magnitude of CF6-6D short term performance deterioration were analyzed. These data are substantiated by the performance testing and analytical teardown of CF6-6D short term deterioration engine serial number (ESN) 451507
Acoustic testing of a 1.5 pressure ratio low tip speed fan with a serrated rotor (QEP fan B scale model)
A scale model of the bypass flow region of a 1.5 pressure ratio, single stage, low tip speed fan was tested with a serrated rotor leading edge to determine its effects on noise generation. The serrated rotor was produced by cutting teeth into the leading edge of the nominal rotor blades. The effects of speed and exhaust nozzle area on the scale models noise characteristics were investigated with both the nominal rotor and serrated rotor. Acoustic results indicate the serrations reduced front quadrant PNL's at takeoff power. In particular, the 200 foot (61.0 m) sideline noise was reduced from 3 to 4 PNdb at 40 deg for nominal and large nozzle operation. However, the rear quadrant maximum sideline PNL's were increased 1.5 to 3 PNdb at approach thust and up to 2 PNdb at takeoff thust with these serrated rotor blades. The configuration with the serrated rotor produced the lowest maximum 200 foot (61.0 m) sideline PNL for any given thust when the large nozzle (116% of design area) was employed
Measuring and Reducing the Cognitive Load for the End Users of Complex Systems
With the proliferation of complex computer systems, end users face a never-ending increase in the numbernof tasks, methods, inputs, passwords, usernames (and so on) when using online and standalone computerbased systems and applications. This paper examines a method and approach to measure how complex a system is to use, and how to reduce the complexity of such systems by minimising the requirement for human inputs as much as possible, in order to reduce the cognitive load for that user, or group of users. This paper addresses a study completed around using virtualised computer management systems interfacesof two well-known products AWS (Amazon Web Services), Oracle Cloud, and compares the complexity of the steps and interface for end users to a private cloud less well-known system called the IDE (Intelligent Design Engine). By using a set of derived formula, we examine how this can be applied to systems that have qualitative data feedback from the experiment process, and how to convert this effectively into quantitative data. This data is then analysed numerically using a unique approach to provide additional and meaningful results based of the original end user data
Effects of Desk-Bike Cycling on Phonological Working Memory Performance in Adolescents With Attention Deficit Hyperactivity Disorder
We investigated the effects of active workstations on cognitive control functions in individuals diagnosed with Attention Deficit Hyperactivity Disorder (ADHD). In a fully counterbalanced randomized control design, we examined the effects of cycling on a desk bike on phonological working memory (WM) in 18 adolescents with ADHD. Adolescents performed a phonological WM test across two separate sessions during which they either cycled or not. It was hypothesized that participants would perform better on the WM task while cycling as compared to seated-rest. Results showed that total WM performance was not affected by desk-bike cycling. Exploratory analyses suggested that cycling during more difficult trials (i.e., high WM demands) is beneficial for WM performance. More research is needed to shed light on how task difficulty moderates the potential compensatory effect of desk-bike cycling on WM performance in adolescent ADHD participants
Direct and Constructivist Instructional Design: A Comparison of Efficiency Using Mental Workload and Task Performance
This paper investigates the efficiency of two instructional design conditions: a traditional design based on the direct instruction approach to learning and its extension with a collaborative activity based upon the community of inquiry approach to learning. This activity was built upon a set of textual trigger questions to elicit cognitive abilities and support knowledge formation. A total of 115 students participated in the experiments and a number of third-level computer science classes where divided in two groups. A control group of learners received the former instructional design while an experimental group also received the latter design. Subsequently, learners of each group individually answered a multiple-choice questionnaire, from which a performance measure was extracted for the evaluation of the acquired factual, conceptual and procedural knowledge. Two measures of mental workload were acquired through self-reporting questionnaires: one unidimensional and one multidimensional. These, in conjunction with the performance measure, contributed to the definition of a measure of efficiency. Evidence showed the positive impact of the added collaborative activity on efficiency
Regional Income Convergence in Portugal (1991-2002)
Our research aims to address the problem of inequality in income distribution from a different perspective than the usual. We intend to verify if geography influences the pattern of inequality, that is, if the standard of living varies from region to region and if, in the process of growth, spatial units in Portugal have been converging in terms of most relevant variables, such as income. We search the answers to these questions by introducing the treatment of convergence between smaller territorial units, the municipalities as individuals. We intend to evaluate convergence or divergence in income growth and test empirically the theoretical hypothesis that β-convergence, although necessary, is not a sufficient condition for σ-convergence. To study convergence, we use information about GDP and wages for NUTS III regions, and wages for municipalities. We observe spatial dependence between municipalities, so we estimate spatial econometric models to test convergence. With regard to conditional convergence between municipalities, the model most appropriate is the one which includes in the explanatory variables the weight of primary sector employment, leading us to conclude that this variable distinguishes the "steady state" of the small economies. Variables like the activity rate and percentage of active population with higher education also reveal highly significant on the growth of wages, reflecting the different contexts of the labor market at regional level
LOFAR tied-array imaging and spectroscopy of solar S bursts
Context. The Sun is an active source of radio emission that is often associated with energetic phenomena ranging from nanoflares to coronal mass ejections (CMEs). At low radio frequencies (<100 MHz), numerous millisecond duration radio bursts have been reported, such as radio spikes or solar S bursts (where S stands for short). To date, these have neither been studied extensively nor imaged because of the instrumental limitations of previous radio telescopes.
Aims. Here, LOw Frequency ARray (LOFAR) observations were used to study the spectral and spatial characteristics of a multitude of S bursts, as well as their origin and possible emission mechanisms.
Methods. We used 170 simultaneous tied-array beams for spectroscopy and imaging of S bursts. Since S bursts have short timescales and fine frequency structures, high cadence (~50 ms) tied-array images were used instead of standard interferometric imaging, that is currently limited to one image per second.
Results. On 9 July 2013, over 3000 S bursts were observed over a time period of ~8 h. S bursts were found to appear as groups of short-lived (<1 s) and narrow-bandwidth (~2.5 MHz) features, the majority drifting at ~3.5 MHz s-1 and a wide range of circular polarisation degrees (2−8 times more polarised than the accompanying Type III bursts). Extrapolation of the photospheric magnetic field using the potential field source surface (PFSS) model suggests that S bursts are associated with a trans-equatorial loop system that connects an active region in the southern hemisphere to a bipolar region of plage in the northern hemisphere.
Conclusions. We have identified polarised, short-lived solar radio bursts that have never been imaged before. They are observed at a height and frequency range where plasma emission is the dominant emission mechanism, however, they possess some of the characteristics of electron-cyclotron maser emission
- …