239 research outputs found
Development of a Thermal Management System for Electrified Aircraft
This paper describes the development and optimization of a conceptual thermal management system for electrified aircraft. Here, a vertical takeoff and landing (VTOL) vehicle is analyzed with the following electrically sourced heat loads considered: motors, generators, rectifiers, and inverters. The vehicle will employ liquid-cooling techniques in order to acquire, transport, and reject waste heat from the vehicle. The purpose of this paper is to threefold: 1) Present a potential modeling framework for system level thermal management system simulation, 2) Analyze typical system characteristics, and 3) Perform optimization on a system developed for a specific vehicle to minimize weight gain, power utilization, and drag. Additionally, the paper will study the design process, specifically investigating the differences between steady state and transient sizing, comparing simulation techniques with a lower fidelity option and quantifying expected error
Highly Dispersive Spin Excitations in the Chain Cuprate Li2CuO2
We present an inelastic neutron scattering investigation of Li2CuO2 detecting
the long sought quasi-1D magnetic excitations with a large dispersion along the
CuO2-chains studied up to 25 meV. The total dispersion is governed by a
surprisingly large ferromagnetic (FM) nearest-neighbor exchange integral
J1=-228 K. An anomalous quartic dispersion near the zone center and a
pronounced minimum near (0,0.11,0.5) r.l.u. (corresponding to a spiral
excitation with a pitch angle about 41 degree point to the vicinity of a 3D
FM-spiral critical point. The leading exchange couplings are obtained applying
standard linear spin-wave theory. The 2nd neighbor inter-chain interaction
suppresses a spiral state and drives the FM in-chain ordering below the Ne'el
temperature. The obtained exchange parameters are in agreement with the results
for a realistic five-band extended Hubbard Cu 3d O 2p model and L(S)DA+U
predictions.Comment: 6 pages, 4 figures, submitted to Europhys. Let
Coalescent angiogenesis—evidence for a novel concept of vascular network maturation
Angiogenesis describes the formation of new blood vessels from pre-existing vascular structures. While the most studied mode of angiogenesis is vascular sprouting, specific conditions or organs favor intussusception, i.e., the division or splitting of an existing vessel, as preferential mode of new vessel formation. In the present study, sustained (33-h) intravital microscopy of the vasculature in the chick chorioallantoic membrane (CAM) led to the hypothesis of a novel non-sprouting mode for vessel generation, which we termed "coalescent angiogenesis." In this process, preferential flow pathways evolve from isotropic capillary meshes enclosing tissue islands. These preferential flow pathways progressively enlarge by coalescence of capillaries and elimination of internal tissue pillars, in a process that is the reverse of intussusception. Concomitantly, less perfused segments regress. In this way, an initially mesh-like capillary network is remodeled into a tree structure, while conserving vascular wall components and maintaining blood flow. Coalescent angiogenesis, thus, describes the remodeling of an initial, hemodynamically inefficient mesh structure, into a hierarchical tree structure that provides efficient convective transport, allowing for the rapid expansion of the vasculature with maintained blood supply and function during development
Effect of Biomimetic Mineralization on Enamel and Dentin: A Raman and EDX Analysis
Objective
To investigate the effect of an experimental biomimetic mineralization kit (BIMIN) on the chemical composition and crystallinity of caries-free enamel and dentin samples in vitro. Methods
Enamel and dentin samples from 20 human teeth (10 for enamel; 10 for dentin) were divided into a control group without treatment and test samples with BIMIN treatment. Quantitative analysis of tissue penetration of fluoride, phosphate, and calcium was performed using energy-dispersive X-ray spectroscopy (EDX). Mineralization depth was measured by Raman spectroscopy probing the symmetric valence vibration near 960 cm−1 as a marker for crystallinity. EDX data was statistically analyzed using a paired t-test and Raman data was analyzed using the Student’s t-test. Results
EDX analysis demonstrated a penetration depth of fluoride of 4.10 ± 3.32 μm in enamel and 4.31 ± 2.67 μm in dentin. Calcium infiltrated into enamel 2.65 ± 0.64 μm and into dentin 5.58 ± 1.63 μm, while the penetration depths for phosphate were 4.83 ± 2.81 μm for enamel and 6.75 ± 3.25 μm for dentin. Further, up to 25 μm of a newly mineralized enamel-like layer was observed on the surface of the samples. Raman concentration curves demonstrated an increased degree of mineralization up to 5–10 μm into the dentin and enamel samples. Significance
Biomimetic mineralization of enamel and dentin samples resulted in an increase of mineralization and a penetration of fluoride into enamel and dentin
Harmonic Forcing Amplitude Effects in Globally Unstable Transonic Wing Flow
This work concerns the phenomenon of shock buffet and its mutual interaction with the flexible wing structure. The latter aspect is key to our contribution, since, even though renewed interest in edge-of-the-envelope flow unsteadiness can be observed in recent years, the multidisciplinary aeroelastic interaction is typically overlooked. Previous work by Timme [1] applied stability theory to a large aircraft wing, specifically the NASA Common Research Model, to reveal a global instability linked to shock buffet. Herein, we expand upon that work by adding the dimension of wing vibration to scrutinise its impact on the flow unsteadiness. We consider fluid-structure interaction solving the unsteady Reynolds-averaged Navier–Stokes equations with an industry-grade computational fluid dynamics solver to model the aerodynamics and a modal structural model of the actual wind-tunnel geometry to describe the flexible wing. Our focus experimental flow condition is a reference free-stream Mach number of 0.85 with a chord Reynolds number of 5 × 106 and a supercritical angle of attack of 3.75◦ . Results show that the initial aerodynamic unsteadiness, when started from a well converged static aeroelastic solution (validated with wind-tunnel data), is nearly independent of the presence of the flexible wing structure as long as the amplitudes are small. Indeed wing vibration follows the dominant shock-buffet excitation. Once transitioned into the non-linear aerodynamic regime (while noting that at the time of writing a longer time history is still required), most of the structural degrees-of-freedom are active close to their respective natural frequencies and also within the shock-buffet frequency range. An aeroelastic global stability analysis presented in our companion paper [2] has revealed that several of these modes become unstable due to the fluid-structure coupling. Overall the impact of the flexible wing results in lower amplitudes in integrated aerodynamic coefficients with a broader frequency content peaking around the first bending frequencies and the shock-buffet frequency range, which is in contrast to the rigid (yet statically deformed) wing where the shock-buffet excitation clearly dominates
Novel compounds with antiangiogenic and antiproliferative potency for growth control of testicular germ cell tumours
Translational models for vascular cognitive impairment: a review including larger species.
BACKGROUND: Disease models are useful for prospective studies of pathology, identification of molecular and cellular mechanisms, pre-clinical testing of interventions, and validation of clinical biomarkers. Here, we review animal models relevant to vascular cognitive impairment (VCI). A synopsis of each model was initially presented by expert practitioners. Synopses were refined by the authors, and subsequently by the scientific committee of a recent conference (International Conference on Vascular Dementia 2015). Only peer-reviewed sources were cited. METHODS: We included models that mimic VCI-related brain lesions (white matter hypoperfusion injury, focal ischaemia, cerebral amyloid angiopathy) or reproduce VCI risk factors (old age, hypertension, hyperhomocysteinemia, high-salt/high-fat diet) or reproduce genetic causes of VCI (CADASIL-causing Notch3 mutations). CONCLUSIONS: We concluded that (1) translational models may reflect a VCI-relevant pathological process, while not fully replicating a human disease spectrum; (2) rodent models of VCI are limited by paucity of white matter; and (3) further translational models, and improved cognitive testing instruments, are required
- …