Human and natural controls on erosion in the Lower Jinsha River, China

The lower Jinsha River has the highest sediment yield rates of the entire Yangtze watershed; these high yields have previously been attributed to a mix of the local geologic setting as well as intensive human land use, particularly agriculture. Prior studies have not quantified long-term background rates of sediment generation, making it difficult to know if modern sediment yield is elevated relative to the long-term rate of sediment generation. Using in situ 10Be in detrital river sediments, we measured sediment generation rates for tributaries to the lower Jinsha River. We find that the ratio of modern sediment yield to long-term sediment generation rate is 5.9 ± 2.8 (mean, 1 SD, n = 5), which is significantly higher than that elsewhere in western China and implies contemporary rates of sediment export far exceed long-term rates of sediment generation by weathering on hillslopes (1.9 ± 1.6 [median, 1 SD, n = 20]; [Schmidt et al., 2017]). Long-term (thousand year) rates of sediment generation correlate best with the steepness of the upstream watershed, a result found around the world. In contrast, modern sediment yield and the ratio of sediment yield to sediment generation rates correlate best with agricultural land use and distance to the nearest dam. Modern (1950s–1980s) sediment yield and the ratio of sediment yield to sediment generation rate also correlate well with percent of the watershed containing landslides observable today. The significantly higher modern sediment yield, lack of correlation between percent of the basin with landslides and long-term rates of sediment generation, and widespread deforestation and agriculture in the region suggest that landslide scars observable today are at least in part a result of human-induced land use change. Thus, we conclude that a mix of geologic setting and human activity control high contemporary sediment yield rates in the region

Influence of topography and human activity on apparent in situ 10Be-derived erosion rates in Yunnan, SW China

In order to understand better if and where erosion rates calculated using in situ 10Be are affected by contemporary changes in land use and attendant deep regolith erosion, we calculated erosion rates using measurements of in situ 10Be in quartz from 52 samples of river sediment collected from three tributaries of the Mekong River (median basin areaD46.5 km2). Erosion rates range from 12 to 209mm kyr-1 with an area-weighted mean of 117±49mm kyr-1 (1 standard deviation) and median of 74mm kyr-1.We observed a decrease in the relative influence of human activity from our steepest and least altered watershed in the north to the most heavily altered landscapes in the south. In the areas of the landscape least disturbed by humans, erosion rates correlate best with measures of topographic steepness. In the most heavily altered landscapes, measures of modern land use correlate with 10Be-estimated erosion rates but topographic steepness parameters cease to correlate with erosion rates. We conclude that, in some small watersheds with high rates and intensity of agricultural land use that we sampled, tillage and resultant erosion has excavated deeply enough into the regolith to deliver subsurface sediment to streams and thus raise apparent in situ 10Be-derived erosion rates by as much as 2.5 times over background rates had the watersheds not been disturbed

!Cuba! river water chemistry reveals rapid chemical weathering, the echo of uplift, and the promise of more sustainable agriculture

For the first time in more than half a century, a joint Cuban/American science team has worked together to quantify the impacts of chemical weathering and sustainable agriculture on river water quality in Cuba - the largest and most populous Caribbean island. Such data are critical as the world strives to meet sustainable development goals and for understanding rates of landscape change in the tropics, an understudied region. To characterize the landscape, we collected and analyzed water samples from 25 rivers in central Cuba where upstream land use varies from forested to agricultural. Cuban river waters bear the fingerprint of the diverse rock types underlying the island, and many carry exceptionally high dissolved loads. Chemical denudation rates are mostly among the top 25% globally and are similar to those measured in other Caribbean islands. High rates of solute export and the distinct composition of the waters in specific basins suggest flow paths that bring river source waters into contact with fresh, weatherable rock - unusual in a warm, wet, tropical climate where weathering should extend deep below the surface. Tectonically driven uplift likely maintains the supply of weatherable material, leading to channel incision and, thus, to the exposure of bedrock in many river channels. Despite centuries of agriculture, the impact on these rivers\u27 biogeochemistry is limited. Although river water in many central Cuban rivers has high levels of E. coli bacteria, likely sourced from livestock, concentrations of dissolved nitrogen are far lower than other areas where intensive agriculture is practiced, such as the Mississippi River Basin. This suggests the benefits of Cuba\u27s shift to conservation agriculture after 1990 and provides a model for more sustainable agriculture worldwide

Hydrogen and Metal Line Absorption Around Low-Redshift Galaxies in Cosmological Hydrodynamic Simulations

We study the physical conditions of the circum-galactic medium (CGM) around z=0.25 galaxies as traced by HI and metal line absorption, using cosmological hydrodynamic simulations that include galactic outflows. Using lines of sight targeted at impact parameters from 10 kpc to 1 Mpc around galaxies with halo masses from 10^11-10^13 M_solar, we study the physical conditions and their variation with impact parameter b and line-of-sight velocity delta v in the CGM as traced by HI, MgII, SiIV, CIV, OVI, and NeVIII absorbers. All ions show a strong excess of absorption near galaxies compared to random lines of sight. The excess continues beyond 1 Mpc, reflecting the correlation of metal absorption with large-scale structure. Absorption is particularly enhanced within about v<300 km/sec and roughly 300 kpc of galaxies (with distances somewhat larger for the highest ion), approximately delineating the CGM; this range contains the majority of global metal absorption. Low ions like MgII and SiIV predominantly arise in denser gas closer to galaxies and drop more rapidly with b, while high ions OVI and NeVIII trace more diffusely distributed gas with a comparatively flat radial profile; CIV is intermediate. All ions predominantly trace T~10^4-4.5 K photo-ionised gas at all b, but when hot CGM gas is present (mostly in larger halos), we see strong collisionally-ionised OVI and NeVIII at b <= 100 kpc. Larger halo masses generally produce more absorption, though overall the trends are not as strong as that with impact parameter. These findings arise using our favoured outflow scalings as expected for momentum-driven winds; with no winds, the CGM gas remains mostly unenriched, while our outflow model with a constant velocity and mass loading factor produce hotter, more widely dispersed metals.Comment: 26 pages, 15 figures, published in MNRAS. Updates to citations from previous versio

The AMANDA Neutrino Telescope: Principle of Operation and First Results

AMANDA is a high-energy neutrino telescope presently under construction at the geographical South Pole. In the Antarctic summer 1995/96, an array of 80 optical modules (OMs) arranged on 4 strings (AMANDA-B4) was deployed at depths between 1.5 and 2 km. In this paper we describe the design and performance of the AMANDA-B4 prototype, based on data collected between February and November 1996. Monte Carlo simulations of the detector response to down-going atmospheric muon tracks show that the global behavior of the detector is understood. We describe the data analysis method and present first results on atmospheric muon reconstruction and separation of neutrino candidates. The AMANDA array was upgraded with 216 OMs on 6 new strings in 1996/97 (AMANDA-B10), and 122 additional OMs on 3 strings in 1997/98.Comment: 36 pages, 23 figures, submitted to Astroparticle Physic

BRCA2 polymorphic stop codon K3326X and the risk of breast, prostate, and ovarian cancers

Background: The K3326X variant in BRCA2 (BRCA2*c.9976A&gt;T; p.Lys3326*; rs11571833) has been found to be associated with small increased risks of breast cancer. However, it is not clear to what extent linkage disequilibrium with fully pathogenic mutations might account for this association. There is scant information about the effect of K3326X in other hormone-related cancers. Methods: Using weighted logistic regression, we analyzed data from the large iCOGS study including 76 637 cancer case patients and 83 796 control patients to estimate odds ratios (ORw) and 95% confidence intervals (CIs) for K3326X variant carriers in relation to breast, ovarian, and prostate cancer risks, with weights defined as probability of not having a pathogenic BRCA2 variant. Using Cox proportional hazards modeling, we also examined the associations of K3326X with breast and ovarian cancer risks among 7183 BRCA1 variant carriers. All statistical tests were two-sided. Results: The K3326X variant was associated with breast (ORw = 1.28, 95% CI = 1.17 to 1.40, P = 5.9x10- 6) and invasive ovarian cancer (ORw = 1.26, 95% CI = 1.10 to 1.43, P = 3.8x10-3). These associations were stronger for serous ovarian cancer and for estrogen receptor–negative breast cancer (ORw = 1.46, 95% CI = 1.2 to 1.70, P = 3.4x10-5 and ORw = 1.50, 95% CI = 1.28 to 1.76, P = 4.1x10-5, respectively). For BRCA1 mutation carriers, there was a statistically significant inverse association of the K3326X variant with risk of ovarian cancer (HR = 0.43, 95% CI = 0.22 to 0.84, P = .013) but no association with breast cancer. No association with prostate cancer was observed. Conclusions: Our study provides evidence that the K3326X variant is associated with risk of developing breast and ovarian cancers independent of other pathogenic variants in BRCA2. Further studies are needed to determine the biological mechanism of action responsible for these associations

LSST: from Science Drivers to Reference Design and Anticipated Data Products

(Abridged) We describe here the most ambitious survey currently planned in the optical, the Large Synoptic Survey Telescope (LSST). A vast array of science will be enabled by a single wide-deep-fast sky survey, and LSST will have unique survey capability in the faint time domain. The LSST design is driven by four main science themes: probing dark energy and dark matter, taking an inventory of the Solar System, exploring the transient optical sky, and mapping the Milky Way. LSST will be a wide-field ground-based system sited at Cerro Pach\'{o}n in northern Chile. The telescope will have an 8.4 m (6.5 m effective) primary mirror, a 9.6 deg$^2$ field of view, and a 3.2 Gigapixel camera. The standard observing sequence will consist of pairs of 15-second exposures in a given field, with two such visits in each pointing in a given night. With these repeats, the LSST system is capable of imaging about 10,000 square degrees of sky in a single filter in three nights. The typical 5$\sigma$ point-source depth in a single visit in $r$ will be $\sim 24.5$ (AB). The project is in the construction phase and will begin regular survey operations by 2022. The survey area will be contained within 30,000 deg$^2$ with $\delta<+34.5^\circ$, and will be imaged multiple times in six bands, $ugrizy$, covering the wavelength range 320--1050 nm. About 90\% of the observing time will be devoted to a deep-wide-fast survey mode which will uniformly observe a 18,000 deg$^2$ region about 800 times (summed over all six bands) during the anticipated 10 years of operations, and yield a coadded map to $r\sim27.5$. The remaining 10\% of the observing time will be allocated to projects such as a Very Deep and Fast time domain survey. The goal is to make LSST data products, including a relational database of about 32 trillion observations of 40 billion objects, available to the public and scientists around the world.Comment: 57 pages, 32 color figures, version with high-resolution figures available from https://www.lsst.org/overvie

Fracture fixation in the operative management of hip fractures (FAITH): an international, multicentre, randomised controlled trial

© 2017 Elsevier Ltd Background Reoperation rates are high after surgery for hip fractures. We investigated the effect of a sliding hip screw versus cancellous screws on the risk of reoperation and other key outcomes. Methods For this international, multicentre, allocation concealed randomised controlled trial, we enrolled patients aged 50 years or older with a low-energy hip fracture requiring fracture fixation from 81 clinical centres in eight countries. Patients were assigned by minimisation with a centralised computer system to receive a single large-diameter screw with a side-plate (sliding hip screw) or the present standard of care, multiple small-diameter cancellous screws. Surgeons and patients were not blinded but the data analyst, while doing the analyses, remained blinded to treatment groups. The primary outcome was hip reoperation within 24 months after initial surgery to promote fracture healing, relieve pain, treat infection, or improve function. Analyses followed the intention-to-treat principle. This study was registered with ClinicalTrials.gov, number NCT00761813. Findings Between March 3, 2008, and March 31, 2014, we randomly assigned 1108 patients to receive a sliding hip screw (n=557) or cancellous screws (n=551). Reoperations within 24 months did not differ by type of surgical fixation in those included in the primary analysis: 107 (20%) of 542 patients in the sliding hip screw group versus 117 (22%) of 537 patients in the cancellous screws group (hazard ratio [HR] 0·83, 95% CI 0·63–1·09; p=0·18). Avascular necrosis was more common in the sliding hip screw group than in the cancellous screws group (50 patients [9%] vs 28 patients [5%]; HR 1·91, 1·06–3·44; p=0·0319). However, no significant difference was found between the number of medically related adverse events between groups (p=0·82; appendix); these events included pulmonary embolism (two patients [\u3c1%] vs four [1%] patients; p=0·41) and sepsis (seven [1%] vs six [1%]; p=0·79). Interpretation In terms of reoperation rates the sliding hip screw shows no advantage, but some groups of patients (smokers and those with displaced or base of neck fractures) might do better with a sliding hip screw than with cancellous screws. Funding National Institutes of Health, Canadian Institutes of Health Research, Stichting NutsOhra, Netherlands Organisation for Health Research and Development, Physicians\u27 Services Incorporated