44 research outputs found
Analysis of Writing Inks on Paper Using Direct Analysis in Real Time Mass Spectrometry
Ink analysis is central to questioned document examination. We applied direct analysis in real time mass spectrometry (DART MS) to ballpoint, gel, and fluid writing ink analysis. DART MS acquires the mass spectrum of an ink while it is still on a document without altering the appearance of the document. Spectra were acquired from ink on a variety of papers, and the spectrum of the blank paper could be subtracted out to produce a cleanly isolated ink spectrum in most cases. Only certain heavy or heavily processed papers interfered. The time since an ink is written on paper has a large effect on its spectrum. DART spectra change radically during the first few months after an ink is written as the more volatile components evaporate, but the spectra stabilize after that. A library-search study involving 166 well-aged inks assessed the ability to identify inks from their DART spectra. The aggregate success rate was 92%
Differentiating Writing Inks Using Direct Analysis in Real Time Mass Spectrometry
Writing ink analysis is used in establishing document authenticity and the sources and relative ages of written entries. Most analytical methods require removing samples or visibly altering the document. Nondestructive, in situ analysis of writing inks on paper without visible alteration is possible using mass spectrometry with a new ion source called Direct Analysis in Real Time. Forty-three different black and blue ballpoint, black fluid, and black gel inks were examined. Both dyes and persistent but thermally labile components of the inks contribute to the mass spectra, principally as protonated molecules [M1H]1. Numerous ink components were identified from the spectra. The spectra were placed in a searchable library, which was then challenged with two spectra from each of the 43 inks. The best match for each of the challenge spectra was correct for all but one ink, which matched with a very similar ink by the same manufacturer
Real-Time Monitoring of the Mechanical Properties of a Soy Protein and Rubber Polymer during its Production Using Transient Infrared Spectroscopy
Soy protein-based polymers offer promising performance properties, but their characteristics are sensitively dependent on production conditions, so on-line monitoring could help provide the needed control during production. Mid-infrared spectroscopy combined with partial least squares offer the needed analysis, but the opacity of many materials in the mid-infrared limits its conventional application. Transient infrared spectroscopy is a method of acquiring mid-infrared spectra from moving streams in real time that avoids the opacity problem. We apply transient infrared spectroscopy to a polymer of soy protein and polyisoprene-graft-maleic anhydride– modified natural rubber during its compounding extrusion to measure tensile strength and Young’s modulus
Upper limit map of a background of gravitational waves
We searched for an anisotropic background of gravitational waves using data
from the LIGO S4 science run and a method that is optimized for point sources.
This is appropriate if, for example, the gravitational wave background is
dominated by a small number of distinct astrophysical sources. No signal was
seen. Upper limit maps were produced assuming two different power laws for the
source strain power spectrum. For an f^-3 power law and using the 50 Hz to 1.8
kHz band the upper limits on the source strain power spectrum vary between
1.2e-48 Hz^-1 (100 Hz/f)^3 and 1.2e-47 Hz^-1 (100 Hz /f)^3, depending on the
position in the sky. Similarly, in the case of constant strain power spectrum,
the upper limits vary between 8.5e-49 Hz^-1 and 6.1e-48 Hz^-1.
As a side product a limit on an isotropic background of gravitational waves
was also obtained. All limits are at the 90% confidence level. Finally, as an
application, we focused on the direction of Sco-X1, the closest low-mass X-ray
binary. We compare the upper limit on strain amplitude obtained by this method
to expectations based on the X-ray luminosity of Sco-X1.Comment: 11 pages, 9 figures, 2 table
Upper limit map of a background of gravitational waves
We searched for an anisotropic background of gravitational waves using data
from the LIGO S4 science run and a method that is optimized for point sources.
This is appropriate if, for example, the gravitational wave background is
dominated by a small number of distinct astrophysical sources. No signal was
seen. Upper limit maps were produced assuming two different power laws for the
source strain power spectrum. For an f^-3 power law and using the 50 Hz to 1.8
kHz band the upper limits on the source strain power spectrum vary between
1.2e-48 Hz^-1 (100 Hz/f)^3 and 1.2e-47 Hz^-1 (100 Hz /f)^3, depending on the
position in the sky. Similarly, in the case of constant strain power spectrum,
the upper limits vary between 8.5e-49 Hz^-1 and 6.1e-48 Hz^-1.
As a side product a limit on an isotropic background of gravitational waves
was also obtained. All limits are at the 90% confidence level. Finally, as an
application, we focused on the direction of Sco-X1, the closest low-mass X-ray
binary. We compare the upper limit on strain amplitude obtained by this method
to expectations based on the X-ray luminosity of Sco-X1.Comment: 11 pages, 9 figures, 2 table
Search of the Orion spur for continuous gravitational waves using a loosely coherent algorithm on data from LIGO interferometers
We report results of a wideband search for periodic gravitational waves from isolated neutron stars within the Orion spur towards both the inner and outer regions of our Galaxy. As gravitational waves interact very weakly with matter, the search is unimpeded by dust and concentrations of stars. One search disk (A) is 6.87° in diameter and centered on 20h10m54.71s+33°33′25.29′′, and the other (B) is 7.45° in diameter and centered on 8h35m20.61s-46°49′25.151′′. We explored the frequency range of 50-1500 Hz and frequency derivative from 0 to -5×10-9 Hz/s. A multistage, loosely coherent search program allowed probing more deeply than before in these two regions, while increasing coherence length with every stage. Rigorous follow-up parameters have winnowed the initial coincidence set to only 70 candidates, to be examined manually. None of those 70 candidates proved to be consistent with an isolated gravitational-wave emitter, and 95% confidence level upper limits were placed on continuous-wave strain amplitudes. Near 169 Hz we achieve our lowest 95% C.L. upper limit on the worst-case linearly polarized strain amplitude h0 of 6.3×10-25, while at the high end of our frequency range we achieve a worst-case upper limit of 3.4×10-24 for all polarizations and sky locations. © 2016 American Physical Society
The population of merging compact binaries inferred using gravitational waves through GWTC-3
We report on the population properties of 76 compact binary mergers detected with gravitational waves below a false alarm rate of 1 per year through GWTC-3. The catalog contains three classes of binary mergers: BBH, BNS, and NSBH mergers. We infer the BNS merger rate to be between 10 and 1700 and the NSBH merger rate to be between 7.8 and 140 , assuming a constant rate density versus comoving volume and taking the union of 90% credible intervals for methods used in this work. Accounting for the BBH merger rate to evolve with redshift, we find the BBH merger rate to be between 17.9 and 44 at a fiducial redshift (z=0.2). We obtain a broad neutron star mass distribution extending from to . We can confidently identify a rapid decrease in merger rate versus component mass between neutron star-like masses and black-hole-like masses, but there is no evidence that the merger rate increases again before 10 . We also find the BBH mass distribution has localized over- and under-densities relative to a power law distribution. While we continue to find the mass distribution of a binary's more massive component strongly decreases as a function of primary mass, we observe no evidence of a strongly suppressed merger rate above . The rate of BBH mergers is observed to increase with redshift at a rate proportional to with for . Observed black hole spins are small, with half of spin magnitudes below . We observe evidence of negative aligned spins in the population, and an increase in spin magnitude for systems with more unequal mass ratio