Hybrid Software Development Approaches in Practice: A European Perspective

Agile and traditional development approaches are used in combination in todays software development. To improve the understanding and to provide better guidance for selecting appropriate development approaches, it is important to analyze such combinations in practice. Results obtained from an online survey strongly confirm that hybrid development approaches are widely used in industry. Our results show that hybrid development approaches: (i) have become reality for nearly all companies; (ii) are applied to specific projects even in the presence of company-wide policies for process usage; (iii) are neither planned nor designed but emerge from the evolution of different work practices; and, (iv) are consistently used regardless of company size or industry secto

Effects of cutting and maturity on lycopene concentration of fresh-cut tomatoes during storage at different temperatures

To investigate the changes in lycopene concentration of fresh-cut tomato during storage, tomato fruits at different stages of maturity were cut into 7 mm slices and stored at temperatures varying from 2°C to 16°C. To assess the effect of cutting, intact fruit were stored in an additional experiment at 5°C. Cutting did not change the accumulation of lycopene in fruit stored at 5°C, compared to intact fruit. The lycopene concentration of the tomato slices stored at different temperatures showed net increases of lycopene concentration for all maturity stages tested at temperatures of 8°C and higher. At lower temperatures no increases or small decreases were observed. The lycopene concentration was considered to be the net result of production and degradation of lycopene. Kinetic models for different pathways were tested. The reaction rate constant for lycopene formation at 8°C was estimated at 2.16 ± 0.24 ¿ 10-2 µg/mg.day. The estimated activation energy for the lycopene formation (92.4 ± 7.3 kJ/mol) indicates that this process is highly dependent on temperature. The degradation rate constant was estimated at 2.99 ± 0.61 ¿ 10-2 (1/day) and, over the temperature range studied, the degradation rate was not dependent on temperature

Kalman filter tracking and vertexing in a silicon detector for neutrino physics

This article describes the application of Kalman filter techniques for the tracking and vertexing of particles inside the NOMAD-STAR detector a silicon vertex detector installed in NOMAD, one of the neutrino oscillation experiments at the CERN-SPS. The use of the Kalman filter simplifies computationally the tracking and vertex procedure for NOMAD-STAR. The alignment of NOMAD-STAR is shown as an example of the application of the Kalman filter for tracking purposes. The accuracy of the method is such that one obtains alignment residuals between 9 and 12~$\mu$m. Furthermore, a preliminary measure of the impact parameter (with an RMS $\sim 36~\mu$m) illustrates the vertexing capabilities of this technique

The Drift Chambers Of The Nomad Experiment

We present a detailed description of the drift chambers used as an active target and a tracking device in the NOMAD experiment at CERN. The main characteristics of these chambers are a large area, a self supporting structure made of light composite materials and a low cost. A spatial resolution of 150 microns has been achieved with a single hit efficiency of 97%.Comment: 42 pages, 26 figure

ECFA Detector R&D Panel, Review Report

Two special calorimeters are foreseen for the instrumentation of the very forward region of an ILC or CLIC detector; a luminometer (LumiCal) designed to measure the rate of low angle Bhabha scattering events with a precision better than 10$^{-3}$ at the ILC and 10$^{-2}$ at CLIC, and a low polar-angle calorimeter (BeamCal). The latter will be hit by a large amount of beamstrahlung remnants. The intensity and the spatial shape of these depositions will provide a fast luminosity estimate, as well as determination of beam parameters. The sensors of this calorimeter must be radiation-hard. Both devices will improve the e.m. hermeticity of the detector in the search for new particles. Finely segmented and very compact electromagnetic calorimeters will match these requirements. Due to the high occupancy, fast front-end electronics will be needed. Monte Carlo studies were performed to investigate the impact of beam-beam interactions and physics background processes on the luminosity measurement, and of beamstrahlung on the performance of BeamCal, as well as to optimise the design of both calorimeters. Dedicated sensors, front-end and ADC ASICs have been designed for the ILC and prototypes are available. Prototypes of sensor planes fully assembled with readout electronics have been studied in electron beams.Comment: 61 pages, 51 figure

Performance of Long Modules of Silicon Microstrip Detectors

This note describes the performance of modules assembled with up to twelve silicon microstrip detectors. These modules were built for the instrumented Silicon Target (STAR) that has been installed in the NOMAD spectrometer. Laboratory and test beam results are compared with model predictions. For a module of nine detectors, test beam results indicate a signal--to--noise ratio of 19, a hit finding efficiency of 99.8\% and a spatial resolution of 6.0 $\mu$m. Laboratory measurements indicate that modules of twelve detectors exhibit a signal--to--noise ratio of the order of 16

Production properties of K*(892) vector mesons and their spin alignment as measured in the NOMAD experiment

First measurements of K*(892) mesons production properties and their spin alignment in nu_mu charged current (CC) and neutral current (NC) interactions are presented. The analysis of the full data sample of the NOMAD experiment is performed in different kinematic regions. For K*+ and K*- mesons produced in nu_mu CC interactions and decaying into K0 pi+/- we have found the following yields per event: (2.6 +/- 0.2 (stat.) +/- 0.2 (syst.))% and (1.6 +/- 0.1 (stat.) +/- 0.1 (syst.))% respectively, while for the K*+ and K*- mesons produced in nu NC interactions the corresponding yields per event are: (2.5 +/- 0.3 (stat.) +/- 0.3 (syst.))% and (1.0 +/- 0.3 (stat.) +/- 0.2 (syst.))%. The results obtained for the rho00 parameter, 0.40 +/- 0.06 (stat) +/- 0.03 (syst) and 0.28 +/- 0.07 (stat) +/- 0.03 (syst) for K*+ and K*- produced in nu_mu CC interactions, are compared to theoretical predictions tuned on LEP measurements in e+e- annihilation at the Z0 pole. For K*+ mesons produced in nu NC interactions the measured rho00 parameter is 0.66 +/- 0.10 (stat) +/- 0.05 (syst).Comment: 20 p

Search for the exotic Θ+\Theta^+ resonance in the NOMAD experiment

A search for exotic Theta baryon via Theta -> proton +Ks decay mode in the NOMAD muon neutrino DIS data is reported. The special background generation procedure was developed. The proton identification criteria are tuned to maximize the sensitivity to the Theta signal as a function of xF which allows to study the Theta production mechanism. We do not observe any evidence for the Theta state in the NOMAD data. We provide an upper limit on Theta production rate at 90% CL as 2.13 per 1000 of neutrino interactions.Comment: Accepted to European Physics Journal

A Precise Measurement of the Muon Neutrino-Nucleon Inclusive Charged Current Cross-Section off an Isoscalar Target in the Energy Range 2.5 < E_\nu < 40 GeV by NOMAD

We present a measurement of the muon neutrino-nucleon inclusive charged current cross-section, off an isoscalar target, in the neutrino energy range $2.5 \leq E_\nu \leq 40$ GeV. The significance of this measurement is its precision, $\pm 4$% in $2.5 \leq E_\nu \leq 10$ GeV, and $\pm 2.6$% in $10 \leq E_\nu \leq 40$ GeV regions, where significant uncertainties in previous experiments still exist, and its importance to the current and proposed long baseline neutrino oscillation experiments.Comment: 14 pages, 3 figures, submitted to Phys.Lett.

Shower development of particles with momenta from 15 GeV to 150 GeV in the CALICE scintillator-tungsten hadronic calorimeter

We present a study of showers initiated by electrons, pions, kaons, and protons with momenta from 15 GeV to 150 GeV in the highly granular CALICE scintillator-tungsten analogue hadronic calorimeter. The data were recorded at the CERN Super Proton Synchrotron in 2011. The analysis includes measurements of the calorimeter response to each particle type as well as measurements of the energy resolution and studies of the longitudinal and radial shower development for selected particles. The results are compared to Geant4 simulations (version 9.6.p02). In the study of the energy resolution we include previously published data with beam momenta from 1 GeV to 10 GeV recorded at the CERN Proton Synchrotron in 2010.Comment: 35 pages, 21 figures, 8 table