Structure of 36Ca under the Coulomb magnifying glass

Artículo escrito por un elevado número de autores, solo se referencian el que aparece en primer lugar, el nombre del grupo de colaboración, si le hubiere, y los autores pertenecientes a la UAMDetailed spectroscopy of the neutron-deficient nucleus Ca36 was obtained up to 9 MeV using the Ca37(p,d)Ca36 and the Ca38(p,t)Ca36 transfer reactions. The radioactive nuclei, produced by the LISE spectrometer at GANIL, interacted with the protons of the liquid hydrogen target CRYPTA, to produce light ejectiles (the deuteron d or triton t) that were detected in the MUST2 detector array, in coincidence with the heavy residues identified by a zero-degree detection system. Our main findings are (i) a similar shift in energy for the 11+ and 21+ states by about -250 keV, as compared with the mirror nucleus S36; (ii) the discovery of an intruder 02+ state at 2.83(13) MeV, which appears below the first 2+ state, in contradiction with the situation in S36; and (iii) a tentative 03+ state at 4.83(17) MeV, proposed to exhibit a bubble structure with two neutron vacancies in the 2s1/2 orbit. The inversion between the 02+ and 21+ states is due to the large mirror energy difference (MED) of -516(130) keV for the former. This feature is reproduced by shell model calculations, using the sd-pf valence space, predicting an almost pure intruder nature for the 02+ state, with two protons (neutrons) being excited across the Z=20 magic closure in Ca36 (S36). This mirror system has the largest MEDs ever observed, if one excludes the few cases induced by the effect of the continuu

Photon recycling in Fabry-Perot micro-cavities based on Si3_3N4_4 waveguides

We present a numerical analysis and preliminary experimental results on one-dimensional Fabry-Perot micro-cavities in Si$_3$N$_4$ waveguides. The Fabry-Perot micro-cavities are formed by two distributed Bragg reflectors separated by a straight portion of waveguide. The Bragg reflectors are composed by a few air slits produced within the Si$_3$N$_4$ waveguides. In order to increase the quality factor of the micro-cavities, we have minimized, with a multiparametric optimization tool, the insertion loss of the reflectors by varying the length of their first periods (those facing the cavity). To explain the simulation results the coupling of the fundamental waveguide mode with radiative modes in the Fabry-Perot micro-cavities is needed. This effect is described as a recycling of radiative modes in the waveguide. To support the modelling, preliminary experimental results of micro-cavities in Si$_3$N$_4$ waveguides realized with Focused Ion Beam technique are reported.Comment: 5 pages, 5 figure

Regulatory T cell defects in adult autoimmune hepatitis

n/

Gap maps and intrinsic diffraction losses in one-dimensional photonic crystal slabs

A theoretical study of photonic bands for one-dimensional (1D) lattices embedded in planar waveguides with strong refractive index contrast is presented. The approach relies on expanding the electromagnetic field on the basis of guided modes of an effective waveguide, and on treating the coupling to radiative modes by perturbation theory. Photonic mode dispersion, gap maps, and intrinsic diffraction losses of quasi-guided modes are calculated for the case of self-standing membranes as well as for Silicon-on-Insulator structures. Photonic band gaps in a waveguide are found to depend strongly on the core thickness and on polarization, so that the gaps for transverse electric and transverse magnetic modes most often do not overlap. Radiative losses of quasi-guided modes above the light line depend in a nontrivial way on structure parameters, mode index and wavevector. The results of this study may be useful for the design of integrated 1D photonic structures with low radiative losses.Comment: 9 pages, 8 figures, submitted to Physical Review

Ac conductivity and dielectric properties of CuFe1−xCrxO2 : Mg delafossite

The electrical and dielectric properties of CuFe(1−x)Cr(x)O(2) (0 ≤ x ≤ 1) powders, doped with 3% of Mg and prepared by solid-state reaction, were studied by broadband dielectric spectroscopy in the temperature range from −100 to 150 °C. The frequency-dependent electrical and dielectric data have been discussed in the framework of a power law conductivity and complex impedance and dielectric modulus. At room temperature, the ac conductivity behaviour is characteristic of the charge transport in CuFe1−xCrxO2 powders. The substitution of Fe3+ by Cr3+ results in an increase in dc conductivity and a decrease in the Cu+–Cu+ distance. Dc conductivity, characteristic onset frequency and Havriliak–Negami characteristics relaxation times are thermally activated above −40 °C for x = 0.835. The associated activation energies obtained from dc and ac conductivity and from impedance and modulus losses are similar and show that CuFe1−xCrxO2 delafossite powders satisfy the BNN relation. Dc and ac conductivities have the same transport mechanism, namely thermally activated nearest neighbour hopping and tunnelling hopping above and below −40 °C, respectively

Quantitative trait loci for flowering time and inflorescence architecture in rose

The pattern of development of the inflorescence is an important characteristic in ornamental plants, where the economic value is in the flower. The genetic determinism of inflorescence architecture is poorly understood, especially in woody perennial plants with long life cycles. Our objective was to study the genetic determinism of this characteristic in rose. The genetic architectures of 10 traits associated with the developmental timing and architecture of the inflorescence, and with flower production were investigated in a F 1 diploid garden rose population, based on intensive measurements of phenological and morphological traits in a field. There were substantial genetic variations in inflorescence development traits, with broad-sense heritabilities ranging from 0.82 to 0.93. Genotypic correlations were significant for most (87%) pairs of traits, suggesting either pleiotropy or tight linkage among loci. However, non-significant and low correlations between some pairs of traits revealed two independent developmental pathways controlling inflorescence architecture: (1) the production of inflorescence nodes increased the number of branches and the production of flowers; (2) internode elongation connected with frequent branching increased the number of branches and the production of flowers. QTL mapping identified six common QTL regions (cQTL) for inflorescence developmental traits. A QTL for flowering time and many inflorescence traits were mapped to the same cQTL. Several candidate genes that are known to control inflorescence developmental traits and gibberellin signaling in Arabidopsis thaliana were mapped in rose. Rose orthologues of FLOWERING LOCUS T (RoFT), TERMINAL FLOWER 1 (RoKSN), SPINDLY (RoSPINDLY), DELLA (RoDELLA), and SLEEPY (RoSLEEPY) co-localized with cQTL for relevant traits. This is the first report on the genetic basis of complex inflorescence developmental traits in rose

Move, hold and touch: A framework for Tangible gesture interactive systems

© 2015 by the authors. Technology is spreading in our everyday world, and digital interaction beyond the screen, with real objects, allows taking advantage of our natural manipulative and communicative skills. Tangible gesture interaction takes advantage of these skills by bridging two popular domains in Human-Computer Interaction, tangible interaction and gestural interaction. In this paper, we present the Tangible Gesture Interaction Framework (TGIF) for classifying and guiding works in this field. We propose a classification of gestures according to three relationships with objects: move, hold and touch. Following this classification, we analyzed previous work in the literature to obtain guidelines and common practices for designing and building new tangible gesture interactive systems. We describe four interactive systems as application examples of the TGIF guidelines and we discuss the descriptive, evaluative and generative power of TGIF

Difference between penetration and damping lengths in photonic crystal mirrors

Different mirror geometries in two-dimensional photonic crystal slabs are studied with fully-vectorial calculations. We compare their optical properties and, in particular, we show that, for heterostructure mirrors, the penetration length associated with the delay induced by distributed reflection is not correlated to the characteristic damping length of the electromagnetic energy distribution in the mirror. This unexpected result evidences that the usual trade-off between short damping lengths and large penetration lengths that is classically encountered in distributed Bragg reflectors can be overcome with carefully designed photonic crystal structures.Comment: to be published in Applied Physics Letters, 4 pages, 4 figure

Preparation and characterization of the defect–conductivity relationship of Ga-doped ZnO thin films deposited by nonreactive radio-frequency–magnetron sputtering

Ga-doped ZnO (ZnO:Ga) thin films were prepared by radio-frequency–magnetron sputtering on conventional glass substrates at room temperature. The structural, electrical, and optical properties of these films as a function of argon pressure and film thicknesses were studied. All the films crystallized with the hexagonal wurtzite structure. The x-ray diffraction studies show that the ZnO:Ga films are highly oriented with their crystallographic c-axis perpendicular to the substrate. We discuss a methodology of using a “standardized platform” for comparison of samples deposited at different pressures, which provides an insight into the defect–resistivity relationship of each sample with respect to their microstructure. After the first annealing, the electrical properties of the films are dependent on the atmosphere used during postdeposition annealing treatment. A resistivity of 2.5 × 10−3 Ω · cm was obtained after vacuum annealing, and the films became an insulator after air annealing. The reproducibility of this treatment was verified. The average transmittance of all ZnO:Ga thin films is more than 85% in the visible range