11 research outputs found
Search for gravitational-wave bursts in LIGO data from the fourth science run
The fourth science run of the LIGO and GEO 600 gravitational-wave detectors,
carried out in early 2005, collected data with significantly lower noise than
previous science runs. We report on a search for short-duration
gravitational-wave bursts with arbitrary waveform in the 64-1600 Hz frequency
range appearing in all three LIGO interferometers. Signal consistency tests,
data quality cuts, and auxiliary-channel vetoes are applied to reduce the rate
of spurious triggers. No gravitational-wave signals are detected in 15.5 days
of live observation time; we set a frequentist upper limit of 0.15 per day (at
90% confidence level) on the rate of bursts with large enough amplitudes to be
detected reliably. The amplitude sensitivity of the search, characterized using
Monte Carlo simulations, is several times better than that of previous
searches. We also provide rough estimates of the distances at which
representative supernova and binary black hole merger signals could be detected
with 50% efficiency by this analysis.Comment: Corrected amplitude sensitivities (7% change on average); 30 pages,
submitted to Classical and Quantum Gravit
Prospects for observing and localizing gravitational-wave transients with Advanced LIGO, Advanced Virgo and KAGRA
We present possible observing scenarios for the Advanced LIGO, Advanced Virgo and KAGRA gravitational-wave detectors over the next decade, with the intention of providing information to the astronomy community to facilitate planning for multi-messenger astronomy with gravitational waves. We estimate the sensitivity of the network to transient gravitational-wave signals, and study the capability of the network to determine the sky location of the source. We report our findings for gravitational-wave transients, with particular focus on gravitational-wave signals from the inspiral of binary neutron star systems, which are the most promising targets for multi-messenger astronomy. The ability to localize the sources of the detected signals depends on the geographical distribution of the detectors and their relative sensitivity, and 90% credible regions can be as large as thousands of square degrees when only two sensitive detectors are operational. Determining the sky position of a significant fraction of detected signals to areas of 5â 20 deg2 requires at least three detectors of sensitivity within a factor of âŒ2 of each other and with a broad frequency bandwidth. When all detectors, including KAGRA and the third LIGO detector in India, reach design sensitivity, a significant fraction of gravitational-wave signals will be localized to a few square degrees by gravitational-wave observations alone
Construction of KAGRA: An underground gravitational-wave observatory
The major construction and initial-phase operation of a second-generation gravitational-wave detector, KAGRA, has been completed. The entire 3 km detector is installed underground in a mine in order to be isolated from background seismic vibrations on the surface. This allows us to achieve a good sensitivity at low frequencies and high stability of the detector. Bare-bones equipment for the interferometer operation has been installed and the first test run was accomplished in March and April of 2016 with a rather simple configuration. The initial configuration of KAGRA is called iKAGRA. In this paper, we summarize the construction of KAGRA, including a study of the advantages and challenges of building an underground detector, and the operation of the iKAGRA interferometer together with the geophysics interferometer that has been constructed in the same tunnel. © The Author(s) 2018. Published by Oxford University Press on behalf of the Physical Society of Japan
Prospects for observing and localizing gravitational-wave transients with Advanced LIGO, Advanced Virgo and KAGRA
We present possible observing scenarios for the Advanced LIGO, Advanced Virgo and KAGRA gravitational-wave detectors over the next decade, with the intention of providing information to the astronomy community to facilitate planning for multi-messenger astronomy with gravitational waves. We estimate the sensitivity of the network to transient gravitational-wave signals, and study the capability of the network to determine the sky location of the source. We report our findings for gravitational-wave transients, with particular focus on gravitational-wave signals from the inspiral of binary neutron star systems, which are the most promising targets for multi-messenger astronomy. The ability to localize the sources of the detected signals depends on the geographical distribution of the detectors and their relative sensitivity, and 90 % credible regions can be as large as thousands of square degrees when only two sensitive detectors are operational. Determining the sky position of a significant fraction of detected signals to areas of 5â20deg2 requires at least three detectors of sensitivity within a factor of ⌠2 of each other and with a broad frequency bandwidth. When all detectors, including KAGRA and the third LIGO detector in India, reach design sensitivity, a significant fraction of gravitational-wave signals will be localized to a few square degrees by gravitational-wave observations alone