Determination of the hydrodynamic performance of marine propellers using fibre Bragg gratings

Downloading of the abstract is permitted for personal use only. A critical aspect in the design of marine propellers is their hydrodynamic performance which, when evaluated experimentally, requires a number of parameters to be monitored at the same time, i.e.The thrust and torque a propeller generates as well as the propeller shaft and vessel speed. In this investigation, three of those parameters are measured using Fibre Bragg Grating-based sensors, thus allowing for computationally derived performance values to be verified. For that purpose, open water tests were carried out where an instrumented propeller shaft was installed into a research vessel and measurements taken, evaluated and the results compared favorably with advanced computer-based simulations

Underwater free-vibration analysis of full-scale marine propeller using a Fibre Bragg Grating-based sensor system

A detailed experimentally-based study has been carried out on instrumented, full-scale marine propeller blades in order to investigate their vibration behaviour, both in air and underwater. To obtain data with minimum perturbation to the characteristics of the blades, a Fibre Bragg Grating-based sensor network system was designed and implemented, for the first time. The individual vibration frequencies at each measurement point and thus the broader vibration patterns seen for each of the blades were obtained, with excitation both in air and in water and the results are compared favourably with those obtained from Finite Element (FE) analysis. The vibration patterns obtained show that the same modes of vibration occur in air and in water, although in some natural frequencies the mode order is seen to change from one blade to another on the same propeller. The extensive performance survey carried out and experimental data obtained have also shown that while the effect of the added mass of water on the natural frequencies of the blades in the fundamental modes is considerable, this effect diminishes as the natural frequencies of the blades increase. The results obtained from the optical fibre sensor network were compared to those from previous work in this area using different and less satisfactory techniques and it was confirmed that the ratio of the natural frequencies in water to those in air increases in a linear manner as the frequencies were increasing. Additionally, the natural frequencies of a blade were measured under different depths of propeller immersion

Fiber bragg grating-based system for 2-D analysis of vibrational modes of a steel propeller blade

This paper reports results obtained using fiber Bragg grating (FBG)-based sensors to investigate the displacement mode shapes of a cantilevered steel propeller blade, using FBG arrays for vibration monitoring for the first time. The experimental data obtained are cross compared with those from a finite element analysis of the same blade, undertaken using proprietary software. In the experimental configuration used, a network of gratings, forming a series of sensor arrays, was mounted on the blade under study to monitor its bending modes, while a further set was mounted perpendicular to this array to monitor torsional modes. To obtain the shape of the strain modes generated in the blade at specific frequencies, the dynamic response of the FBG arrays, as a function of time, was captured and then processed using Fourier transform algorithms to show the natural frequencies of the blade. As a result, the displacement modes shapes for the bending, torsional, and coupled modes of the first nine natural frequencies of the plate were obtained. The experimental data show very good agreement with theoretical analysis. This paper demonstrates the potential of using the lightweight, minimally invasive sensing technique described for the analysis of propeller blades and, thus, illustrating an effective method to overcome the deleterious effects of propellers seen in some commercial propeller designs

Optical fibre sensing: A solution for industry

Optical fibres have been explored widely for their sensing capability to meet increasing industrial needs, building on their success in telecommunications. This paper provides a review of research activities at City University of London in response to industrial challenges through the development of a range of fibre Bragg grating (FBG)-based sensors for transportation structural monitoring. For marine propellers, arrays of FBGs mapped onto the surface of propeller blades allow for capturing vibrational modes, with reference to simulation data. The research funded by EU Cleansky programme enables the development of self-sensing electric motor drives to support 'More Electric Aircraft' concept. The partnership with Faiveley Brecknell Willis in the UK enables the integration of FBG sensors into the railway current-collecting pantographs for real-time condition monitoring when they are operating under 25kV conditions

Radiographic comparison of five different techniques for injection into the distal sesamoid bursa in cattle

Summary Numerous techniques for injection into the distal sesamoid bursa (navicular bursa) have been described, especially in equine, but there are few specific descriptions regarding this practice being done in cattle. Five different techniques were compared for injection into the distal sesamoid bursa in cattle including distal plantar approach parallel with the coronary band, proximal plantar approach, distal plantar approach parallel with the sole, abaxial approach, and distal interphalangeal joint injection. The results revealed that the numbers of needle insertion until proper placement is significantly less in the DIPJ and the DPPS techniques compared to the others (P<0.05). Also, based on the times of contrast agent injection after the correct successful needle insertion, there were significant differences between DIPJ with DPPCB, PP30 and the Ab45 techniques (P<0.05). According to the absence of direct communication between the distal sesamoid bursa and distal interphalangeal joint, the placement of the needle through distal plantar approach parallel with the sole was suggested

Continuous combined microwave and hot air treatment of apples for fruit fly (Bactrocera tryoni and B. jarvisi) disinfestation

Apples at 24 ± 2 °C were heated in a pilot scale hot air assisted (40 °C) continuous pentagonal microwave system, to evaluate the effectiveness of this treatment on insect mortality (variety Mutsu) and fruit quality (variety Granny Smith). An average temperature of 53.4 ± 1.3 °C at core, bottom and flesh of the apple was recorded at the end of the treatment. One hundred percent mortality of the most tolerant stage of Queensland fruit fly (Bactrocera tryoni, Froggatt) and Jarvis's fruit fly (Bactrocera jarvisi, Tryon), were observed when the Mortality value (M52, equivalent time of isothermal treatment at 52 °C) at the slowest heating point applicable for each experiment was ≥ 50 min and ≥ 37 min, respectively. Results showed that microwave heat treatment is effective for insect disinfestation without any adverse impact on total soluble solids, flesh or peel firmness of the treated apples. The treated apples recorded a significantly higher pH and lower ion leakage than the untreated apples after 3 or 4 weeks. Therefore, the microwave heat treatment has the potential to be developed as an alternative chemical free quarantine treatment against economically significant insect pests. Industrial relevance Hot air assisted microwave heating of fruits and vegetables, is more cost effective compared to vapour heat treatment and ionising radiation for disinfestation of insects. Microwave treatment is environmentally friendly compared to fumigation and chemical treatments. Hot air assisted microwave disinfestation can be performed at farms or centralised pack houses since the capital cost would be comparatively lower than vapour heat or ionising radiation treatments

Community Violence Exposure and Conduct Problems in Children and Adolescents with Conduct Disorder and Healthy Controls

Exposure to community violence through witnessing or being directly victimized has been associated with conduct problems in a range of studies. However, the relationship between community violence exposure (CVE) and conduct problems has never been studied separately in healthy individuals and individuals with conduct disorder (CD). Therefore, it is not clear whether the association between CVE and conduct problems is due to confounding factors, because those with high conduct problems also tend to live in more violent neighborhoods, i.e., an ecological fallacy. Hence, the aim of the present study was: (1) to investigate whether the association between recent CVE and current conduct problems holds true for healthy controls as well as adolescents with a diagnosis of CD; (2) to examine whether the association is stable in both groups when including effects of aggression subtypes (proactive/reactive aggression), age, gender, site and socioeconomic status (SES); and (3) to test whether proactive or reactive aggression mediate the link between CVE and conduct problems. Data from 1178 children and adolescents (62% female; 44% CD) aged between 9 years and 18 years from seven European countries were analyzed. Conduct problems were assessed using the Kiddie-Schedule of Affective Disorders and Schizophrenia diagnostic interview. Information about CVE and aggression subtypes was obtained using self-report questionnaires (Social and Health Assessment and Reactive-Proactive aggression Questionnaire (RPQ), respectively). The association between witnessing community violence and conduct problems was significant in both groups (adolescents with CD and healthy controls). The association was also stable after examining the mediating effects of aggression subtypes while including moderating effects of age, gender and SES and controlling for effects of site in both groups. There were no clear differences between the groups in the strength of the association between witnessing violence and conduct problems. However, we found evidence for a ceiling effect, i.e., individuals with very high levels of conduct problems could not show a further increase if exposed to CVE and vice versa. Results indicate that there was no evidence for an ecological fallacy being the primary cause of the association, i.e., CVE must be considered a valid risk factor in the etiology of CD

Who Said or What Said? Estimating Ideological Bias in Views Among Economists

There exists a long-standing debate about the influence of ideology in economics. Surprisingly, however, there is no concrete empirical evidence to examine this critical issue. Using an online randomized controlled experiment involving economists in 19 countries, we examine the effect of ideological bias on views among economists. Participants were asked to evaluate statements from prominent economists on different topics, while source attribution for each statement was randomized without participants’ knowledge. For each statement, participants either received a mainstream source, an ideologically different less-/non-mainstream source, or no source. We find that changing source attributions from mainstream to less-/non-mainstream, or removing them, significantly reduces economists’ reported agreement with statements. Using a model of Bayesian updating we examine two competing hypotheses as potential explanations for these results: unbiased Bayesian updating versus ideologically-biased Bayesian updating. While we find no evidence in support of unbiased updating, our results are consistent with biased Bayesian updating. More specifically, we find that changing/removing sources (1) has no impact on economists’ reported confidence with their evaluations; (2) similarly affects experts/non-experts in relevant areas; and (3) affects those at the far right of the political spectrum much more significantly than those at the far left. Finally, we find significant heterogeneity in our results by gender, country, PhD completion country, research area, and undergraduate major, with patterns consistent with the existence of ideological bias