Tryptophan metabolism, its relation to inflammation and stress markers and association with psychological and cognitive functioning: Tasmanian Chronic Kidney Disease pilot study

Raw Data in five data sheets including Patients relevant metadata, quantified metabolites (given at Οg/L as well as Οmol/L), psychology measures, common medication and comorbidities. (XLS 58 kb

Photolithographic patterning of conducting polyaniline films via flash welding

In this work, two significant advances in photolithographic patterning of polyaniline (PANI) films are reported. Firstly, flash welding was enhanced through the use of polymeric substrates, enabling complete penetration of the welding of PANI films with thicknesses ranging from 5 to over 14 mu m, significantly thicker than reported previously. Masking of parts of the PANI films during flash welding enabled the formation of adjacent conducting and insulating regions as the welding changes the electrical properties of the film. Raman spectroscopy was used to determine the sharpness of these edges, and indicated that the interface between the flash welded and masked regions of the PANI films was typically less than 15 mu m wide. Secondly, using longpass filters, light with a wavelength less than 570 nm was found not to contribute to the welding process. This was confirmed by the use of a 635 nm laser diode for welding the PANI films. This novel approach enabled patterning of PANI films using a direct writing technique with a narrow wavelength light source

Robust open cellular porous polymer monoliths made from cured colloidal gels of latex particles

The coagulation of oppositely charged latexes, prepared from the soap-free emulsion polymerisation of styrene using water as the reaction medium, resulted in the obtainment of colloidal gels that were porous in nature and held together by electrostatic interactions. Chemical crosslinking, involving the introduction of a water-soluble crosslinker, resulted in the obtainment of stronger chemical bonds between particles affording a rigid porous material known as a monolith. It was found that, in a simpler approach, these materials could be prepared using a single latex where the addition of ammonium persulfate both resulted in the formation of the colloidal gel and initiated the crosslinking process. The pore size of the resulting monoliths was predictable as this was observed to directly correlate to the particle diameter, with larger pores achieved using particles of increased size. All gels obtained in this work were highly mouldable and retained their shape, which allowed for a range of formats to be easily prepared without the requirement of a mould

Impact of opioid-free analgesia on pain severity and patient satisfaction after discharge from surgery: multispecialty, prospective cohort study in 25 countries

Background: Balancing opioid stewardship and the need for adequate analgesia following discharge after surgery is challenging. This study aimed to compare the outcomes for patients discharged with opioid versus opioid-free analgesia after common surgical procedures.Methods: This international, multicentre, prospective cohort study collected data from patients undergoing common acute and elective general surgical, urological, gynaecological, and orthopaedic procedures. The primary outcomes were patient-reported time in severe pain measured on a numerical analogue scale from 0 to 100% and patient-reported satisfaction with pain relief during the first week following discharge. Data were collected by in-hospital chart review and patient telephone interview 1 week after discharge.Results: The study recruited 4273 patients from 144 centres in 25 countries; 1311 patients (30.7%) were prescribed opioid analgesia at discharge. Patients reported being in severe pain for 10 (i.q.r. 1-30)% of the first week after discharge and rated satisfaction with analgesia as 90 (i.q.r. 80-100) of 100. After adjustment for confounders, opioid analgesia on discharge was independently associated with increased pain severity (risk ratio 1.52, 95% c.i. 1.31 to 1.76; P < 0.001) and re-presentation to healthcare providers owing to side-effects of medication (OR 2.38, 95% c.i. 1.36 to 4.17; P = 0.004), but not with satisfaction with analgesia (beta coefficient 0.92, 95% c.i. -1.52 to 3.36; P = 0.468) compared with opioid-free analgesia. Although opioid prescribing varied greatly between high-income and low- and middle-income countries, patient-reported outcomes did not.Conclusion: Opioid analgesia prescription on surgical discharge is associated with a higher risk of re-presentation owing to side-effects of medication and increased patient-reported pain, but not with changes in patient-reported satisfaction. Opioid-free discharge analgesia should be adopted routinely

On-line solvent exchange system: automation from extraction to analysis

Removal of organic solvent from sample extracts is required before analysis by reversed phase HPLC to preserve chromatographic performance and allow for bigger injection volumes, boosting sensitivity. Herein, an automated on-line extraction evaporation procedure is integrated with HPLC analysis. The evaporation occurs inside a 200 μm microfluidic channel confined by a vapor permeable membrane. A feedback control algorithm regulates evaporation rate keeping the output flow rate constant. The evaporation process across this membrane was firstly characterized with water/solvent mixtures showing organic solvent removal capabilities. This system allowed continuous methanol, ethanol and acetonitrile removal from samples containing up to 80% organic solvent. An evaporative injection procedure was developed demonstrating the use of the device for fully integrated extract reconstitution coupled to HPLC analysis, applied to analysis of the antibiotic chloramphenicol in milk samples. Sample reconstitution and collection was performed in less than 10 min and can be executed simultaneously to HPLC analysis of the previous sample in a routine workflow, thus having minimal impact on the total sample analysis time when run in a sequence

Molecular Weight and Tacticity of Oligoacrylates by Capillary Electrophoresis-Mass Spectrometry

International audienceOligo(acrylic acid) efficiently stabilizes polymeric particles, especially particles produced by reversible addition-fragmentation chain transfer (RAFT) (as hydrophilic block of an amphiphilic copolymer). Capillary electrophoresis (CE) has a far higher resolution power to separate these oligomers than the commonly used size exclusion chromatography. Coupling CE to electrospray ionization mass spectrometric detection unravels the separation mechanism. CE separates these oligomers, not only according to their degree of polymerization, but also according to their tacticity, in agreement with NMR analysis. Such analysis will provide insight into the role of these oligomers as stabilizers in emulsion polymerization, and into the mechanism of the RAFT polymerization with respect to degree of polymerization and tacticity