Comparison of the meteorology and surface energy balance at Storbreen and Midtdalsbreen, two glaciers in southern Norway

We compare 5 years of meteorological records from automatic weather stations (AWSs) on Storbreen and Midtdalsbreen, two glaciers in southern Norway, located approximately 120 km apart. The records are obtained from identical AWSs with an altitude difference of 120 m and cover the period September 2001 to September 2006. Air temperature at the AWS locations is found to be highly correlated, even with the seasonal cycle removed. The most striking difference between the two sites is the difference in wind climate. Midtdalsbreen is much more under influence of the large-scale circulation with wind speeds on average a factor 1.75 higher. On Storbreen, weaker katabatic winds are dominant. The main melt season is from May to September at both locations. During the melt season, incoming and net solar radiation are larger on Midtdalsbreen, whereas incoming and net longwave radiation are larger on Storbreen, primarily caused by thicker clouds on the latter. The turbulent fluxes are a factor 1.7 larger on Midtdalsbreen, mainly due to the higher wind speeds. Inter-daily fluctuations in the surface energy fluxes are very similar at the AWS sites. On average, melt energy is a factor 1.3 larger on Midtdalsbreen, a result of both larger net radiation and larger turbulent fluxes. The relative contribution of net radiation to surface melt is larger on Storbreen (76%) than on Midtdalsbreen (66%). As winter snow depth at the two locations is comparable in most years, the larger amount of melt energy results in an earlier disappearance of the snowpack on Midtdalsbreen and 70% more ice melt than on Storbreen. We compare the relative and absolute values of the energy fluxes on Storbreen and Midtdalsbreen with reported values for glaciers at similar latitudes. Furthermore, a comparison is made with meteorological variables measured at two nearby weather stations, showing that on-site measurements are essential for an accurate calculation of the surface energy balance and melt rate

The Effects of Next-Nearest-Neighbor Interactions on the Orientation Dependence of Step Stiffness: Reconciling Theory with Experiment for Cu(001)

Within the solid-on-solid (SOS) approximation, we carry out a calculation of the orientational dependence of the step stiffness on a square lattice with nearest and next-nearest neighbor interactions. At low temperature our result reduces to a simple, transparent expression. The effect of the strongest trio (three-site, non pairwise) interaction can easily be incorporated by modifying the interpretation of the two pairwise energies. The work is motivated by a calculation based on nearest neighbors that underestimates the stiffness by a factor of 4 in directions away from close-packed directions, and a subsequent estimate of the stiffness in the two high-symmetry directions alone that suggested that inclusion of next-nearest-neighbor attractions could fully explain the discrepancy. As in these earlier papers, the discussion focuses on Cu(001).Comment: 8 pages, 3 figures, submitted to Phys. Rev.

Pervasive cold ice within a temperate glacier-implications for glacier thermal regimes, sediment transport and foreland geomorphology

© Author(s) 2019. Published by Copernicus Publications on behalf of the European Geosciences Union.This study suggests that cold-ice processes may be more widespread than previously assumed, even within temperate glacial systems. We present the first systematic mapping of cold ice at the snout of the temperate glacier Midtdalsbreen, an outlet of the Hardangerjøkulen icefield (Norway), from 43 line kilometres of ground-penetrating radar data. Results show a 40 m wide cold-ice zone within the majority of the glacier snout, where ice thickness is <10 m. We interpret ice to be cold-based across this zone, consistent with basal freeze-on processes involved in the deposition of moraines. We also find at least two zones of cold ice up to 15 m thick within the ablation area, occasionally extending to the glacier bed. There are two further zones of cold ice up to 30 m thick in the accumulation area, also extending to the glacier bed. Cold-ice zones in the ablation area tend to correspond to areas of the glacier that are covered by late-lying seasonal snow patches that reoccur over multiple years. Subglacial topography and the location of the freezing isotherm within the glacier and underlying subglacial strata likely influence the transport and supply of supraglacial debris and formation of controlled moraines. The wider implication of this study is the possibility that, with continued climate warming, temperate environments with primarily temperate glaciers could become polythermal in forthcoming decades with (i) persisting thinning and (ii) retreat to higher altitudes where subglacial permafrost could be and/or become more widespread. Adversely, the number and size of late-lying snow patches in ablation areas may decrease and thereby reduce the extent of cold ice, reinforcing the postulated change in the thermal regime.Peer reviewedFinal Published versio

Out-of-hours care in western countries: assessment of different organizational models

Contains fulltext : 81655.pdf (publisher's version ) (Open Access)BACKGROUND: Internationally, different organizational models are used for providing out-of-hours care. The aim of this study was to assess prevailing models in order to identify their potential strengths and weaknesses. METHODS: An international web-based survey was done in 2007 in a sample of purposefully selected key informants from 25 western countries. The questions concerned prevailing organizational models for out-of-hours care, the most dominant model in each country, perceived weaknesses, and national plans for changes in out-of-hours care. RESULTS: A total of 71 key informants from 25 countries provided answers. In most countries several different models existed alongside each other. The Accident and Emergency department was the organizational model most frequently used. Perceived weaknesses of this model concerned the coordination and continuity of care, its efficiency and accessibility. In about a third of the countries, the rota group was the most dominant organizational model for out-of-hours care. A perceived weakness of this model was lowered job satisfaction of physicians. The GP cooperative existed in a majority of the participating countries; no weaknesses were mentioned with respect to this model. Most of the countries had plans to change the out-of-hours care, mainly toward large scale organizations. CONCLUSION: GP cooperatives combine size of scale advantages with organizational features of strong primary care, such as high accessibility, continuity and coordination of care. While specific patients require other organizational models, the co-existence of different organizational models for out-of-hours care in a country may be less efficient for health systems

Gaming with eutrophication: Contribution to integrating water quantity and quality management at catchment level

The Metropolitan Region of Sao Paulo (MRSP) hosts 18 million inhabitants. A complex system of 23 interconnected reservoirs was built to ensure its water supply. Half of the potable water produced for MRSP's population (35 m3/s) is imported from a neighbour catchment, the other half is produced within the Alto Tietê catchment, where 99% of the population lives. Perimeters of land use restriction were defined to contain uncontrolled urbanization, as domestic effluents were causing increasing eutrophication of some of these reservoirs. In the 90's catchment committees and sub committees were created to promote discussion between stakeholders and develop catchment plans. The committees are very well structured "on paper". However, they are not very well organised and face a lack of experience. The objective of this work was to design tools that would strengthen their discussion capacities. The specific objective of the AguAloca process was to integrate the quality issue and its relation to catchment management as a whole in these discussions. The work was developed in the Alto Tietê Cabeceiras sub-catchment, one of the 5 sub catchments of the Alto-Tietê. It contains 5 interconnected dams, and presents competitive uses such as water supply, industry, effluent dilution and irrigated agriculture. A RPG was designed following a companion modelling approach (Etienne et al., 2003). It contains a friendly game-board, a set of individual and collective rules and a computerized biophysical model. The biophysical model is used to simulate water allocation and quality processes at catchment level. It articulates 3 modules. A simplified nutrient discharge model permits the estimation of land use nutrient exportation. An arc-node model simulates water flows and associated nutrient charges from one point of the hydrographical network to another. The Vollenweider model is used for simulating specific reservoir dynamics. The RPG allows players to make individual and collective decisions related to water allocation and the management of its quality. Impacts of these decisions are then simulated using the biophysical model. Specific indicators of the game are then updated and may influence player's behaviour (actions) in following rounds. To introduce discussions on the management of water quality at a catchment level, an issue that is rarely explicitly dealt with, four game sessions were implemented involving representatives of basin committees and water and sanitation engineers. During the game session, the participants took advantage of the water quality output of the biophysical model to test management alternatives such as rural sewage collection or effluent dilution. The biophysical model accelerated calculations of flows and eutrophication rates that were then returned to the game board with explicit indicators of quantity and quality. Players could easily test decisions impacting on qualitative water processes and visualize the simulation results directly on the game board that was representing a friendly, virtual and simplified catchment. The Agualoca game proved its ability to turn complex water processes understandable for a non totally initiated public. This experience contributed to a better understanding of multiple-use water management and also of joint management of water quality and quantity. (Résumé d'auteur

Direct observation of the tube model in F-actin solutions

Mutual uncrossability of polymers generates topological constraints on their conformations and dynamics, which are generally described using the tube model. We imaged confinement tubes for individual polymers within a F-actin solution by sampling over many successive micrographs of fluorescently labeled probe filaments. The resulting average tube width shows the predicted scaling behavior. Unexpectedly, we found an exponential distribution of tube curvatures which is attributed to transient entropic trapping in network void spaces.Comment: 6 pages, 4 figure

Competing mechanisms for step meandering in unstable growth

The meander instability of a vicinal surface growing under step flow conditions is studied within a solid-on-solid model. In the absence of edge diffusion the selected meander wavelength agrees quantitatively with the continuum linear stability analysis of Bales and Zangwill [Phys. Rev. B {\bf 41}, 4400 (1990)]. In the presence of edge diffusion a local instability mechanism related to kink rounding barriers dominates, and the meander wavelength is set by one-dimensional nucleation. The long-time behavior of the meander amplitude differs in the two cases, and disagrees with the predictions of a nonlinear step evolution equation [O. Pierre-Louis et al., Phys. Rev. Lett. {\bf 80}, 4221 (1998)]. The variation of the meander wavelength with the deposition flux and with the activation barriers for step adatom detachment and step crossing (the Ehrlich-Schwoebel barrier) is studied in detail. The interpretation of recent experiments on surfaces vicinal to Cu(100) [T. Maroutian et al., Phys. Rev. B {\bf 64}, 165401 (2001)] in the light of our results yields an estimate for the kink barrier at the close packed steps.Comment: 8 pages, 7 .eps figures. Final version. Some errors in chapter V correcte

Diffusion processes and growth on stepped metal surfaces

We study the dynamics of adatoms in a model of vicinal (11m) fcc metal surfaces. We examine the role of different diffusion mechanisms and their implications to surface growth. In particular, we study the effect of steps and kinks on adatom dynamics. We show that the existence of kinks is crucially important for adatom motion along and across steps. Our results are in agreement with recent experiments on Cu(100) and Cu(1,1,19) surfaces. The results also suggest that for some metals exotic diffusion mechanisms may be important for mass transport across the steps.Comment: 3 pages, revtex, complete file available from ftp://rock.helsinki.fi/pub/preprints/tft/ or at http://www.physics.helsinki.fi/tft/tft_preprints.html (to appear in Phys. Rev. B Rapid Comm.

Image resonance in the many-body density of states at a metal surface

The electronic properties of a semi-infinite metal surface without a bulk gap are studied by a formalism that is able to account for the continuous spectrum of the system. The density of states at the surface is calculated within the GW approximation of many-body perturbation theory. We demonstrate the presence of an unoccupied surface resonance peaked at the position of the first image state. The resonance encompasses the whole Rydberg series of image states and cannot be resolved into individual peaks. Its origin is the shift in spectral weight when many-body correlation effects are taken into account