Cataract in professionals exposed to solar radiation: a cross sectional study

Purpose: To find out frequency of cataract in seaside workers and possible factors associated to its development. Study Design: Cross sectional observational. Place and Duration of Study: Tyrrhenian coast of Tuscany (Italy), between Rosignano Marittimo and Cecina municipalities in July 2021. Methods: Ninety-eight seaside workers were selected through convenience sampling technique. All the working subjects selected for this study had a bilateral natural vision equal to or greater than 6/10 in the anamnestic data collection, declared they had not eye diseases in the past and rarely used protective glasses during their work. Results: The mean age of 98 outdoor workers is 40. Patients with the cataract are older than people without cataract (median 41 vs 38) (p < 0.001) and have a lower visual acuity (0.6 vs 0.7) (p < 0.001); stratifying by job, refraction state and Intra Ocular Pressure (IOP), there aren’t significant association with cataract. The multivariate analysis confirms that age and visual acuity are associated with the development of the cataract (OR 1.99 and 0.01, respectively). Conclusion: Although senile cataract is an age related disease but Visually significant cataract is seen in persons working outdoors for longer hours

Onset of chaotic dynamics in a ball mill: attractors merging and crisis induced intermittency

In mechanical treatment carried out by ball milling, powder particles are subjected to repeated high-energy mechanical loads which induce heavy plastic deformations together with fracturing and cold-welding events. Owing to the continuous defect accumulation and interface renewal, both structural and chemical transformations occur. The nature and the rate of such transformations have been shown to depend on variables, such as impact velocity and collision frequency that depend, in turn, on the whole dynamics of the system. The characterization of the ball dynamics under different impact conditions is then to be considered a necessary step in order to gain a satisfactory control of the experimental set up. In this paper we investigate the motion of a ball in a milling device. Since the ball motion is governed by impulsive forces acting during each collision, no analytical expression for the complete ball trajectory can be obtained. In addition, mechanical systems exhibiting impacts are strongly nonlinear due to sudden changes of velocities at the instant of impact. Many different types of periodic and chaotic impact motions exist indeed even for simple systems with external periodic excitation forces. We present results of the analysis on the ball trajectory, obtained from a suitable numerical model, under growing degree of impact elasticity. A route to high dimensional chaos is obtained. Crisis and attractors merging are also found

Equivalence between free quantum particles and those in harmonic potentials and its application to instantaneous changes

This is an open access article distributed under the terms of the Creative Commons Attribution License (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly citedIn quantum physics the free particle and the harmonically trapped particle are arguably the most important systems a physicist needs to know about. It is little known that, mathematically, they are one and the same. This knowledge helps us to understand either from the viewpoint of the other. Here we show that all general time-dependent solutions of the free-particle Schrodinger equation can be mapped to solutions of the Schrodinger equation for harmonic potentials, both the trapping oscillator and the inverted `oscillator'. This map is fully invertible and therefore induces an isomorphism between both types of system, they are equivalent. A composition of the map and its inverse allows us to map from one harmonic oscillator to another with a different spring constant and different center position. The map is independent of the state of the system, consisting only of a coordinate transformation and multiplication by a form factor, and can be chosen such that the state is identical in both systems at one point in time. This transition point in time can be chosen freely, the wave function of the particle evolving in time in one system before the transition point can therefore be linked up smoothly with the wave function for the other system and its future evolution after the transition point. Such a cut-and-paste procedure allows us to describe the instantaneous changes of the environment a particle finds itself in. Transitions from free to trapped systems, between harmonic traps of different spring constants or center positions, or, from harmonic binding to repulsive harmonic potentials are straightforwardly modelled. This includes some time dependent harmonic potentials. The mappings introduced here are computationally more efficient than either state-projection or harmonic oscillator propagator techniques conventionally employed when describing instantaneous (non-adiabatic) changes of a quantum particle's environmentPeer reviewe

The Release of Tissue Factor Pathway Inhibitor and Platelet Factor 4 After Heparin Injection in Patients with Thrombocytosis.

Platelet factor 4 (PF4) and tissue factor pathway inhibitor (TFPI) are two proteins with high affinity for heparin. They are each stored in platelets, as well as on endothelial cell surfaces, from where both are displaced or released following an injection of heparin with a rapid and marked increase in serum levels. Prior work has demonstrated that the platelet count is one of the factors affecting the levels of heparin-releasable PF4. We therefore characterized the response to a dose of intravenous heparin previously demonstrated to completely displace PF4 from the non-platelet pool in subjects with normal or increased platelet counts. Seventeen patients with essential thrombocytosis (ET), 10 patients with polycythemia vera and high platelet counts (PV-H), 7 patients with polycythemia vera and normal platelet counts (PV-N) and 10 controls received an initial bolus of 40 I.U./kg of unfractionated heparin, followed 2 hours later by a 2nd bolus of a fixed dose of 1000 I.U. TFPI activity did not show any variation among the different groups, either before (TFPI) or after (HR-TFPI) the first bolus of heparin: ET, TFPI 92.6 ± 21.5%, HR-TFPI 298.3 ± 165.8; PV-H, TFPI 91.5 ± 32.0, HR-TFPI 210 ± 1.0; PV-N, TFPI 69.4 ± 24.0, HR-TFPI 203.0 ± 79.0; C, TFPI 109.5 ± 33.5, HR-TFPI 234.0 ± 60.4. TFPI activity returned to basal values prior to the 2nd injection of heparin, which again elicited a rise in TFPI, albeit smaller due to the lower level of heparin injected. In contrast to the lack of any difference between groups with respect to TFPI, the level of heparin-releasable PF4 (HR-PF4) was significantly higher in ET and PV-H patients compared to PV-N patients or controls. However when normalized for platelet count, both PV-H and PV-N had HR-PF4 levels after the 1st heparin injection that were significantly higher than observed in ET patients (PV-H 1.163 + 0.108, PV-N 1.411 + 0.019, ET 0.737 + 0.086 ng/10/3 platelets) supporting an increased platelet activation in PV. Thus, although platelets contain approximately 5-10% of the total amount of TFPI in plasma, they do not affect the major intravascular pool of TFPI mobilizable by heparin. However, since the concentration at the site of vessel wall injury is enhanced several-fold, TFPI could play a role in competing with PF4 to limit thrombus formation in patients with high platelet count

Construction and commissioning of a technological prototype of a high-granularity semi-digital hadronic calorimeter

A large prototype of 1.3m3 was designed and built as a demonstrator of the semi-digital hadronic calorimeter (SDHCAL) concept proposed for the future ILC experiments. The prototype is a sampling hadronic calorimeter of 48 units. Each unit is built of an active layer made of 1m2 Glass Resistive Plate Chamber(GRPC) detector placed inside a cassette whose walls are made of stainless steel. The cassette contains also the electronics used to read out the GRPC detector. The lateral granularity of the active layer is provided by the electronics pick-up pads of 1cm2 each. The cassettes are inserted into a self-supporting mechanical structure built also of stainless steel plates which, with the cassettes walls, play the role of the absorber. The prototype was designed to be very compact and important efforts were made to minimize the number of services cables to optimize the efficiency of the Particle Flow Algorithm techniques to be used in the future ILC experiments. The different components of the SDHCAL prototype were studied individually and strict criteria were applied for the final selection of these components. Basic calibration procedures were performed after the prototype assembling. The prototype is the first of a series of new-generation detectors equipped with a power-pulsing mode intended to reduce the power consumption of this highly granular detector. A dedicated acquisition system was developed to deal with the output of more than 440000 electronics channels in both trigger and triggerless modes. After its completion in 2011, the prototype was commissioned using cosmic rays and particles beams at CERN.Comment: 49 pages, 41 figure

Performance of Glass Resistive Plate Chambers for a high granularity semi-digital calorimeter

A new design of highly granular hadronic calorimeter using Glass Resistive Plate Chambers (GRPCs) with embedded electronics has been proposed for the future International Linear Collider (ILC) experiments. It features a 2-bit threshold semi-digital read-out. Several GRPC prototypes with their electronics have been successfully built and tested in pion beams. The design of these detectors is presented along with the test results on efficiency, pad multiplicity, stability and reproducibility.Comment: 16 pages, 15 figure

Angioside: The role of Angiogenesis and Hypoxia in Lung Neuroendocrine Tumours According to Primary Tumour Location in Left or Right Parenchyma

Well-differentiated lung neuroendocrine tumours (Lu-NETs), classified as typical (TC) and atypical (AC) carcinoids, represent 30% of NETs. Angiogenesis plays an essential role in NET development and progression. A higher vascular network is a marker of differentiation, with positive prognostic implications. Materials and Methods: We retrospectively evaluated microvessel density (MVD) by CD34 immunohistochemical (IHC) staining and hypoxia by IHC staining for Hypoxia-inducible factor 1α (HIF-1α), comparing right- and left-lung parenchyma in 53 lung NETs. Results: The median age was 66 years (39–81), 56.6% males, 24.5% AC, 40.5% left-sided tumours and 69.8% TNM stage I. The mitotic count was <2/10 per 10 HPF in 79.2%, and the absence of necrosis in 81.1%, 39.6% with Ki67, was ≤2%. The MVD, the number of vessels and the average vessel area median values were significantly higher in the right than the left parenchyma (p: 0.025, p: 0.019, p: 0.016, respectively). Hypoxia resulted present in 14/19 (73.6%) left tumours and in 10/20 (50%) right tumours in the parenchyma (p: 0.129). Conclusions: This study suggests a biological rationale for a different angiogenesis and hypoxia according to the Lu-NETs’ location. In our study, left primary tumours were less vascularized and most likely to present hypoxia than right primary tumours. This finding could have potentially useful prognostic and predictive implications for Lu-NETs

the role of adjuvant therapy in resectable sba a different clinicians attitude with a relevant impact on outcome

n/

Emulsion sheet doublets as interface trackers for the OPERA experiment

New methods for efficient and unambiguous interconnection between electronic counters and target units based on nuclear photographic emulsion films have been developed. The application to the OPERA experiment, that aims at detecting oscillations between mu neutrino and tau neutrino in the CNGS neutrino beam, is reported in this paper. In order to reduce background due to latent tracks collected before installation in the detector, on-site large-scale treatments of the emulsions ("refreshing") have been applied. Changeable Sheet (CSd) packages, each made of a doublet of emulsion films, have been designed, assembled and coupled to the OPERA target units ("ECC bricks"). A device has been built to print X-ray spots for accurate interconnection both within the CSd and between the CSd and the related ECC brick. Sample emulsion films have been extensively scanned with state-of-the-art automated optical microscopes. Efficient track-matching and powerful background rejection have been achieved in tests with electronically tagged penetrating muons. Further improvement of in-doublet film alignment was obtained by matching the pattern of low-energy electron tracks. The commissioning of the overall OPERA alignment procedure is in progress.Comment: 19 pages, 19 figure