Triethylphosphite as a network forming agent enhances in-vitro biocompatibility and corrosion protection of hybrid organic-inorganic sol-gel coatings for Ti6Al4V alloys

The biocompatibility and life of metallic implants can be enhanced through improving the biocompatibility and corrosion protection characteristics of the coatings used with these materials. In this study, triethylphosphite (TEP) was used to introduce phosphorus into organic-inorganic hybrid silica based sol gel coatings prepared using γ-methacryloxypropyltrimethoxysilane and tetramethylorthosilicate. Addition of TEP dramatically increased the rate of intermolecular condensation and resulted in materials showing greater cross linking. Protein (fibrinogen) uptake, osteoblast in vitro biocompatibility and corrosion resistance was enhanced in coatings containing TEP. Although higher concentrations of phosphorus supported the greatest improvement in biocompatibility, a compromise in the phosphorus concentration used would be required if corrosion resistance was most desirable parameter for optimisation. Films prepared by dip coating on Ti6Al4V alloys from these sols offer a promising alternative to wholly metallic prostheses

Controlled Rate Thermal Analysis (CRTA) as New Method to Control the Specific Surface in Hydroxyapatite Thin Coatings

The control of the texture in synthetic hydroxyapatite ceramics had limited their application in the field of the materials for bone implantation, even more when it is used as a filling in cements and other formulations in orthopedic surgery. The present article shows preliminary results demonstrating the effectiveness of a modification of the controlled rate thermal analysis (CRTA), developed by J. Rouquerol, used for the preparation of ceramic materials with controlled textural characteristics, during the formation of ceramic powders of synthetic hydroxyapatite at low temperatures. The thermal treatments of the hydroxyapatite were carried out in a device connected to a computer, to control temperature and pressure system, keeping the decomposition speed constant. Results, reported when preparing ceramic powders of hydroxyapatite at 300 and 850°C under controlled pressure, using synthetic hydroxyapatite with a Ca/P molar ratio equal to 1.64, were checked using IR spectroscopy and X‐ray diffraction, showed that the formed phase corresponds to that of crystalline hydroxyapatite, even at 300°C of maximum temperature. Values of specific surface (BET) between 17 and 66 m2/g, with pore size in the range of 50–300 Å in both cases are obtained by N2 absorption isotherms, when analyzing the isotherms of nitrogen absorption

Verifying transactional requirements of web service compositions using temporal logic templates

Lecture notes in computer science, 2013, vol. 8180 LNCS (Part 1)Ensuring reliability in Web service compositions is of crucial interest as services are composed and executed in long-running, distributed mediums that cannot guarantee reliable communications. Towards this, transactional behavior has been proposed to handle and undo the effects of faults of individual components. Despite significant research interest, challenges remain in providing an easy-to-use, formal approach to verify transactional behavior of Web service compositions before costly development. In this paper, we propose the use of temporal logic templates to specify component-level and composition-level transactional requirements over a Web service composition. These templates are specified using a simple format, configured according to scope and cardinality, and automatically translated into temporal logic. To verify design conformance to a set of implemented templates, we employ model checking. We propose an algorithm to address state space explosion by reducing the models into semantically equivalent Kripke structures. Our approach facilitates the implementation of expressive transactional behavior onto existing complex services, as demonstrated in our experimental study.Scott Bourne, Claudia Szabo, and Quan Z. Shen

Native Oxide Films on AZ31 and AZ61 Commercial Magnesium Alloys – Corrosion Behaviour, Effect on Isothermal Oxidation and Sol–gel Thin Film Formation

The authors present a review of their recent research work in an endeavour to interpret the influence of native oxide films on the corrosion behaviour of commercial AZ31 and AZ61 magnesium alloys or on the oxidation kinetics in air at 200°C. The tendency of some of these thin films to be sufficiently protective in mild or weak corrosive environments is examined. For obtaining oxide films with different protective properties, some of the specimens are tested with the surface in the as-received condition, while others are tested immediately after mechanical polishing. The technique applied to characterise thin (thickness of just a few nanometres) oxide films present on the surface of alloys has basically been XPS (X-ray photoelectron spectroscopy) in combination with ion sputtering. Oxidation resistance of the alloys is quantified by thermo gravimetric (TG) curves and their corrosion rate is evaluated by Electrochemical Impedance Spectroscopy (EIS) and hydrogen evolution measurement in chloride solutions with different aggressivity. Emphasis is placed on the possible effects of: (a) the different thickness of the native oxide films formed on the polished surfaces on the corrosion behaviour of the alloys; and (b) the different film homogeneity and uniformity on the oxidation results. Finally, an attempt will be made to learn more about the influence of the native oxide films that cover the substrate on the subsequent growth and protective behaviour of the sol–gel coatings

Higher miscarriage rate in subfertile women with endometriosis receiving unbiopsied frozen-warmed single blastocyst transfers

Background: Assisted reproductive technology treatment is recommended to overcome endometriosis-associated infertility but current evidence is controversial. Endometriosis is associated with lower antral follicle count (AFC) and oocyte yield but similar clinical outcomes compared to controls. Unaffected ovarian stimulation response and embryological outcomes but lower clinical pregnancy and live birth rates and higher miscarriage rates have been reported, implying direct impact on endometrial receptivity. With evidence emerging on the benefit of frozen-warmed and blastocyst stage transfer, we investigated ART outcomes in endometriosis using homogeneous case-control groups.Methods: This is a retrospective observational case-control study including n = 66 frozen-warmed unbiopsied single blastocyst transfers of patients with endometriosis and n = 96 of women exhibiting idiopathic sterility. All frozen-warmed transfers followed artificial endometrial preparation. Results: In control women, the mean number of oocytes recovered at oocyte pick up was higher compared to women with endometriosis (15.3 ± 7.1 vs. 12.7 ± 5.2, p = 0.025) but oocyte maturation index (mature oocytes/total oocytes at oocyte pick up) was significantly higher for endometriosis (48.2% vs. 34.0%, p = 0.005). The same was shown for the subgroup of 44 endometriosis patients after endometrioma surgery when compared with controls (49.1% vs. 34.0%, p = 0.014). Clinical pregnancy rate was not higher in endometriosis but was close to significance (47.0% vs. 32.3%, p = 0.059) while live birth rate was comparable (27.3% vs. 32.3%, p = 0.746). Miscarriage rate was higher in the endometriosis group (19.7% vs. 7.3%, p = 0.018). A significantly higher AFC was observed in the control group in comparison with the endometriosis group (16.3 ± 7.6 vs. 13.4 ± 7.0, p = 0.014). Live birth rate did not differ when comparing all endometriosis cases (p = 0.746), ASRM Stage I/II and Stage III/IV (p = 0.348 and p = 0.888) with the control group but the overall pregnancy rate was higher in ASRM Stage I/II (p = 0.034) and miscarriage rate was higher in ASRM Stage III/IV (p = 0.030) versus control.Conclusion: Blastocyst transfers in women with endometriosis originate from cycles with lower AFC but higher share of mature oocytes than in control women, suggesting that endometriosis might impair ovarian reserve but not stimulation response. A higher miscarriage rate, independent of blastocyst quality may be attributed to an impact of endometriosis on the endometrium beyond the timing of implantation

Double vitrification and warming does not compromise the chance of live birth after single unbiopsied blastocyst transfer

STUDY QUESTION: Does double vitrification and thawing of an embryo compromise the chance of live birth after a single blastocyst transfer? SUMMARY ANSWER: The live birth rate (LBR) obtained after double vitrification was comparable to that obtained after single vitrification. WHAT IS KNOWN ALREADY: Double vitrification-warming (DVW) is commonly practiced to accommodate surplus viable embryos suitable for transfer, to allow retesting of inconclusively diagnosed blastocysts in preimplantation genetic testing (PGT), and to circumvent limitations associated with national policies on embryo culture in certain countries. Despite its popularity, the evidence concerning the impact of DVW practice on ART outcomes is limited and lacking credibility. This is the first thorough investigation of clinical pregnancy and LBR following DVW in the case where the first round of vitrification occurred at the zygote stage and the second round occurred at the blastocyst stage in the absence of biopsy. STUDY DESIGN, SIZE, DURATION: This is a retrospective observational analysis of n = 407 single blastocyst transfers whereby embryos created by IVF/ICSI were vitrified-warmed once (single vitrification-warming (SVW) n = 310) or twice (DVW, n = 97) between January 2017 and December 2021. PARTICIPANTS/MATERIALS, SETTING, METHODS: In the SVW group, blastocysts were vitrified on Day 5/6 and warmed on the day of embryo transfer (ET). In the DVW group, two pronuclear (2PN) zygotes were first vitrified-warmed and then re-vitrified on Day 5/6 and warmed on the day of ET. Exclusion criteria were ETs from PGT and vitrified-warmed oocyte cycles. All of the ETs were single blastocyst transfers performed at the University Hospital Zurich in Switzerland following natural or artificial endometrial preparation. MAIN RESULTS AND THE ROLE OF CHANCE: The biochemical pregnancy rate, clinical pregnancy rate (CPR), and LBR were all comparable between the DVW and SVW groups. The CPR for DVW was 44.3% and for SVW it was 42.3% (P = 0.719). The LBR for DVW was 30.9% and for SVW it was 28.7% (P = 0.675). The miscarriage rate was additionally similar between the groups: 27.9% for DVW and 32.1% for SVW groups (P = 0.765). LIMITATIONS, REASONS FOR CAUTION: The study is limited by its retrospective nature. Caution should be taken concerning interpretation of these findings in cases where DVW occurs at different stages of embryo development. WIDER IMPLICATIONS OF THE FINDINGS: The result of the present study on DVW procedure provides a framework for counselling couples on their chance of clinical pregnancy per warming cycle. It additionally provides confidence and reassurance to laboratory professionals in certain countries where national policies limit embryo culture strategies making DVW inevitable. STUDY FUNDING/COMPETING INTEREST(S): This work was supported by the University Research Priority Program ‘Human Reproduction Reloaded’ of the University of Zurich. The authors have no conflict of interest related to this study to declare

Organic-inorganic hybrid coatings containing phosphorus precursors prepared by sol–gel on Ti6Al4V alloy: electrochemical and in-vitro biocompatibility evaluation

The durability and long-term success of metallic implants are enhanced through the molecular scale design of biocompatible and corrosion resistant surface coatings. To pursue this hypothesis, we have developed a new class of organic-inorganic (O-I) hybrid nanocomposite coatings based on tetramethylorthosilicate (TMOS) and γ-methacryloxypropyltrimethoxysilane (MAPTMS) as organofunctional alkoxysilanes precursors and dimethyltrimethylsilylphosphite (DMTMSP) as a phosphorus precursor. Addition of DMTMSP to TMOS-MAPTMS hybrids increased the extent of intermolecular condensation and cross-linking observed. Both normal human osteoblast in-vitro biocompatibility and corrosion resistance were enhanced in coatings containing DMTMSP. Though increasing phosphorous content correlated with biocompatibility, a compromise in the amount of phosphorus incorporated would be required if corrosion resistance was the most desirable parameter for optimization, at least for single coat systems. Evaluation of the electrochemical behaviour and the in-vitro biocompatibility show that films prepared using these materials by dip coating onto Ti6Al4V alloys offer a promising alternative to simpler coatings and wholly metallic prostheses

Understanding the benefit of metformin use in cancer treatment

Biguanides have been developed for the treatment of hyperglycemia and type 2 diabetes. Recently, metformin, the most widely prescribed biguanide, has emerged as a potential anticancer agent. Epidemiological, preclinical and clinical evidence supports the use of metformin as a cancer therapeutic. The ability of metformin to lower circulating insulin may be particularly important for the treatment of cancers known to be associated with hyperinsulinemia, such as those of the breast and colon. Moreover, metformin may exhibit direct inhibitory effects on cancer cells by inhibiting mammalian target of rapamycin (mTOR) signaling and protein synthesis. The evidence supporting a role for metformin in cancer therapy and its potential molecular mechanisms of action are discussed

Environmental, maternal, and reproductive risk factors for childhood acute lymphoblastic leukemia in Egypt : a case-control study

BACKGROUND\ud Acute lymphocytic leukemia (ALL) is the most common pediatric cancer. The exact cause is not known in most cases, but past epidemiological research has suggested a number of potential risk factors. This study evaluated associations between environmental and parental factors and the risk for ALL in Egyptian children to gain insight into risk factors in this developing country.\ud METHODS\ud We conducted a case-control design from May 2009 to February 2012. Cases were recruited from Children's Cancer Hospital, Egypt (CCHE). Healthy controls were randomly selected from the general population to frequency-match the cumulative group of cases by sex, age groups (<1; 1 - 5; >5 - 10; >10 years) and region of residence (Cairo metropolitan region, Nile Delta region (North), and Upper Egypt (South)). Mothers provided answers to an administered questionnaire about their environmental exposures and health history including those of the father. Odds ratios (ORs) and 95 % confidence intervals (CI) were calculated using logistic regression with adjustment for covariates.\ud RESULTS\ud Two hundred ninety-nine ALL cases and 351 population-based controls frequency-matched for age group, gender and location were recruited. The risk of ALL was increased with the mother's use of medications for ovulation induction (ORadj = 2.5, 95 % CI =1.2 -5.1) and to a lesser extend with her age (ORadj = 1.8, 95 % CI = 1.1 - 2.8, for mothers ≥ 30 years old). Delivering the child by Cesarean section, was also associated with increased risk (ORadj = 2.01, 95 % CI =1.24-2.81).\ud CONCLUSIONS\ud In Egypt, the risk for childhood ALL appears to be associated with older maternal age, and certain maternal reproductive factors

ICAR: endoscopic skull‐base surgery

n/