153 research outputs found
Cell spreading on quartz crystal microbalance elicits positive frequency shifts indicative of viscosity changes
Cell attachment and spreading on solid surfaces was investigated with a home-made quartz crystal microbalance (QCM), which measures the frequency, the transient decay time constant and the maximal oscillation amplitude. Initial interactions of the adsorbing cells with the QCM mainly induced a decrease of the frequency, coincident with mass adsorption. After about 80min, the frequency increased continuously and after several hours exceeded the initial frequency measured before cell adsorption. Phase contrast and fluorescence microscopy indicated that the cells were firmly attached to the quartz surface during the frequency increase. The measurements of the maximal oscillation amplitude and the transient decay time constant revealed changes of viscoelastic properties at the QCM surface. An important fraction of these changes was likely due to alterations of cytosolic viscosity, as suggested by treatments of the attached cells with agents affecting the actin and microtubule cytoskeleton. Our results show that viscosity variations of cells can affect the resonance frequency of QCM in the absence of apparent cell desorption. The simultaneous measurements of the maximal oscillation amplitude, the transient decay time constant and the resonance frequency allow an analysis of cell adsorption to solid substratum in real time and complement cell biological method
Saharan dust events at the Jungfraujoch: detection by wavelength dependence of the single scattering albedo and analysis of the events during the years 2001 and 2002
International audienceScattering and absorption coefficients have been measured continuously at several wavelengths since March 2001 at the high altitude site Jungfraujoch (3580 m a.s.l.). From these data, the wavelength dependences of the Ångström exponent and particularly of the single scattering albedo are determined. While the exponent of the single scattering albedo is usually positive, it becomes negative during Saharan dust events (SDE) due to the greater size of the mineral aerosols and to their different chemical composition. This change in the sign of the single scattering exponent turns out to be a simple means for detecting Saharan dust events. The occurrence of SDE detected by this new method was largely confirmed by visual inspection of filter colors and by studying long-range back-trajectories. An examination of SDE over a 22 months period shows that SDE are more frequent during the March?June period as well as during October and November. The trajectory analysis indicated a mean traveling time of 96.5 h with the most important source countries situated in the northern and north-western part of the Saharan desert. Most of the SDE do not lead to a detectable increase of the 48 h total suspended particulate matter (TSP) at the Jungfraujoch. During Saharan dust events, the average contribution of this dust to hourly TSP at the JFJ is 16 ?g/m3, which corresponds to an annual mean of 0.8 ?g/m3 or 24% of TSP
Recommended from our members
Effects of the prewhitening method, the time granularity and the time segmentation on the Mann-Kendall trend detection and the associated Sen's slope
The most widely used non-parametric method for trend analysis is the Mann-Kendall test associated with the Sen's slope. The Mann-Kendall test requires serially uncorrelated time series, whereas most of the atmospheric processes exhibit positive autocorrelation. Several prewhitening methods have been designed to overcome the presence of lag-1 autocorrelation. These include a prewhitening, a detrending and/or a correction for the detrended slope and the original variance of the time series. The choice of which prewhitening method and temporal segmentation to apply has consequences for the statistical significance, the value of the slope and of the confidence limits. Here, the effects of various prewhitening methods are analyzed for seven time series comprising in-situ aerosol measurements (scattering coefficient, absorption coefficient, number concentration and aerosol optical depth), Raman Lidar water vapor mixing ratio and the tropopause and zero degree levels measured by radio-sounding. These time series are characterized by a broad variety of distributions, ranges and lag-1 autocorrelation values and vary in length between 10 and 60 years. A common way to work around the autocorrelation problem is to decrease it by averaging the data over longer time intervals than in the original time series. Thus, the second focus of this study is evaluation of the effect of time granularity on long-term trend analysis. Finally, a new algorithm involving three prewhitening methods is proposed in order to maximize the power of the test, to minimize the amount of erroneous detected trends in the absence of a real trend and to ensure the best slope estimate for the considered length of the time series
Characterization of aerosol hygroscopicity using Raman lidar measurements at the EARLINET station of Payerne
This study focuses on the analysis of aerosol hygroscopicity using remote sensing techniques. Continuous observations of aerosol backscatter coefficient (ßaer), temperature (T) and water vapor mixing ratio (r) have been performed by means of a Raman lidar system at the aerological station of MeteoSwiss at Payerne (Switzerland) since 2008. These measurements allow us to monitor in a continuous way any change in aerosol properties as a function of the relative humidity (RH). These changes can be observed either in time at a constant altitude or in altitude at a constant time. The accuracy and precision of RH measurements from the lidar have been evaluated using the radiosonde (RS) technique as a reference. A total of 172 RS profiles were used in this intercomparison, which revealed a bias smaller than 4¿%¿RH and a standard deviation smaller than 10¿%¿RH between both techniques in the whole (in lower) troposphere at nighttime (at daytime), indicating the good performance of the lidar for characterizing RH. A methodology to identify situations favorable to studying aerosol hygroscopicity has been established, and the aerosol hygroscopicity has been characterized by means of the backscatter enhancement factor (fß). Two case studies, corresponding to different types of aerosol, are used to illustrate the potential of this methodology. The first case corresponds to a mixture of rural aerosol and smoke particles (smoke mixture), which showed a higher hygroscopicity (f355ß=2.8 and f1064ß=1.8 in the RH range 73¿%–97¿%) than the second case, in which mineral dust was present (f355ß=1.2 and f1064ß=1.1in the RH range 68¿%–84¿%). The higher sensitivity of the shortest wavelength to hygroscopic growth was qualitatively reproduced using Mie simulations. In addition, a good agreement was found between the hygroscopic analysis done in the vertical and in time for Case I, where the latter also allowed us to observe the hydration and dehydration of the smoke mixture. Finally, the impact of aerosol hygroscopicity on the Earth's radiative balance has been evaluated using the GAME (Global Atmospheric Model) radiative transfer model. The model showed an impact with an increase in absolute value of 2.4¿W¿m-2 at the surface with respect to the dry conditions for the hygroscopic layer of Case I (smoke mixture).Peer ReviewedPostprint (published version
Towards the profiling of the atmospheric boundary layer at European scale—introducing the COST Action PROBE
n/
Saharan dust events at the Jungfraujoch: detection by wavelength dependence of the single scattering albedo and first climatology analysis
International audienceScattering and absorption coefficients have been measured continuously at several wavelengths since March 2001 at the high altitude site Jungfraujoch (3580ma.s.l.). From these data, the wavelength dependences of the Ångström exponent and particularly of the single scattering albedo are determined. While the exponent of the single scattering albedo usually increases with wavelength, it decreases with wavelength during Saharan dust events (SDE) due to the greater size of the mineral aerosol particles and their different chemical composition. This change in the sign of the single scattering exponent turns out to be a sensitive means for detecting Saharan dust events. The occurrence of SDE detected by this new method was confirmed by visual inspection of filter colors and by studying long-range back-trajectories. An examination of SDE over a 22-month period shows that SDE are more frequent during the March-June period as well as during October and November. The trajectory analysis indicated a mean traveling time of 96.5h, with the most important source countries situated in the northern and north-western part of the Saharan desert. Most of the SDE do not lead to a detectable increase of the 48-h total suspended particulate matter (TSP) concentration at the Jungfraujoch. During Saharan dust events, the average contribution of this dust to hourly TSP at the Jungfraujoch is 16µg/m3, which corresponds to an annual mean of 0.8µg/m3 or 24% of TSP
Investigation of the Planetary Boundary Layer in the Swiss Alps Using Remote Sensing and In Situ Measurements
The development of the planetary boundary layer (PBL) has been studied in a complex terrain using various remote sensing and in situ techniques. The high-altitude research station at Jungfraujoch (3,580m a.s.l.) in the Swiss Alps lies for most of the time in the free troposphere except when it is influenced by the PBL reaching the station, especially during the summer season. A ceilometer and a wind profiler were installed at Kleine Scheidegg, a mountain pass close to Jungfraujoch, located at an altitude of 2,061ma.s.l. Data from the ceilometer were analyzed using two different algorithms, while the signal-to-noise ratio of the wind profiler was studied to compare the retrieved PBL heights. The retrieved values from the ceilometer and wind profiler agreed well during daytime and cloud-free conditions. The results were additionally compared with the PBL height estimated by the numerical weather prediction model COSMO-2, which showed a clear underestimation of the PBL height for most of the cases but occasionally also a slight overestimation especially around noon, when the PBL showed its maximum extent. Air parcels were transported upwards by slope winds towards Jungfraujoch when the PBL was higher than 2,800ma.s.l. during cloud-free cases. This was confirmed by the in situ aerosol measurements at Jungfraujoch with a significant increase in particle number concentration, particle light absorption and scattering coefficients when PBL-influenced air masses reached the station in the afternoon hours. The continuous aerosol in situ measurements at Jungfraujoch were clearly influenced by the local PBL development but also by long-range transport phenomena such as Saharan dust or pollution from the south
Recommended from our members
Driving factors of aerosol properties over the foothills of central Himalayas based on 8.5 years continuous measurements
This study presents analysis of in situ measurements conducted over the period 2005–2014 in the Indian Himalayas to give a thorough overview of the factors and causes that drive aerosol properties. Aerosol extensive properties (namely, particle number concentration, scattering coefficient, equivalent black carbon, PM2.5, and PM10) have 1.5–2 times higher values in the early to late afternoon than during the night, and a strong seasonality. The interannual variability is ±20% for both PM2.5 and total particle number concentration. Analysis of the data shows statistically significant decreasing trends of −2.3 μg m−3 year−1 and −2.7 μg m−3 year−1 for PM2.5 and PM10, respectively, over the study period. The mountainous terrain site (Mukteshwar, MUK) is primarily under the influence of air from the plains. This is due to convective transport processes that are enhanced by local and mesoscale topography, leading to pronounced valley/mountain winds and consequently to atmospheric boundary layer air lifting from the plains below. The transport from plains is evident in seasonal‐diurnal patterns observed at MUK. The timing of the patterns corresponds with changes in turbulence and water vapor (q). According to our analysis, using these as proxies is a viable method for examining boundary layer influence in the absence of direct atmospheric boundary layer height measurements. Comparing the measurements with climate models shows that even regional climate models have problems capturing the orographic influence accurately at MUK, highlighting the importance of long‐term direct measurements at multiple points to understand aerosol behavior in mountainous areas
Recommended from our members
Long-term trends of black carbon and particle number concentration in the lower free troposphere in Central Europe
Background: The implementation of emission mitigation policies in Europe over the last two decades has generally improved the air quality, which resulted in lower aerosol particle mass, particle number, and black carbon mass concentration. However, little is known whether the decreasing particle concentrations at a lower-altitude level can be observed in the free troposphere (FT), an important layer of the atmosphere, where aerosol particles have a longer lifetime and may affect climate dynamics. In this study, we used data from two high-Alpine observatories, Zugspitze-Schneefernerhaus (ZSF) and Jungfraujoch (JFJ), to assess the long-term trends on size-resolved particle number concentrations (PNCs) and equivalent black carbon (eBC) mass concentration separated for undisturbed lower FT conditions and under the influence of air from the planetary boundary layer (PBL) from 2009 to 2018. Results: The FT and PBL-influenced conditions were segregated for both sites. We found that the FT conditions in cold months were more prevalent than in warm months, while the measured aerosol parameters showed different seasonal patterns for the FT and PBL-influenced conditions. The pollutants in the PBL-influenced condition have a higher chance to be transported to high-altitudes due to the mountainous topography, leading to a higher concentration and more distinct seasonal variation, and vice versa. The long-term trends of the measured aerosol parameters were evaluated and the decreased aerosol concentrations were observed for both FT and PBL-influenced conditions. The observed decreasing trends in eBC concentration in the PBL-influenced condition are well consistent with the reported trends in total BC emission in Germany and Switzerland. The decreased concentrations in the FT condition suggest that the background aerosol concentration in the lower FT over Central Europe has correspondingly decreased. The change of back trajectories in the FT condition at ZSF and JFJ was further evaluated to investigate the other possible drivers for the decreasing trends. Conclusions: The background aerosol concentration in the lower FT over Central Europe has significantly decreased during 2009–2018. The implementation of emission mitigation policies is the most decisive factor and the decrease of the regional airmass occurrence over Central Europe also has contributed to the decreasing trends. © 2021, The Author(s)
- …