Annular honeycomb seals: Test results for leakage and rotordynamic coefficients; comparisons to labyrinth and smooth configurations

Test results are presented for leakage and rotordynamic coefficients for seven honeycomb seals. All seals have the same radius, length, and clearance; however, the cell depths and diameters are varied. Rotordynamic data, which are presented, consist of the direct and cross-coupled stiffness coefficients and the direct damping coefficients. The rotordynamic-coefficient data show a considerable sensitivity to changes in cell dimensions; however, no clear trends are identifiable. Comparisons of test data for the honeycomb seals with labyrinth and smooth annular seals show the honeycomb seal had the best sealing (minimum leakage) performance, followed in order by the labyrinth and smooth seals. For prerotated fluid entering the seal, in the direction of shaft rotation, the honeycomb seal has the best rotordynamic stability followed in order by the labyrinth and smooth. For no prerotation, or fluid prerotation against shaft rotation, the labyrinth seal has the best rotordynamic stability followed in order by the smooth and honeycomb seals

A test apparatus and facility to identify the rotordynamic coefficients of high-speed hydrostatic bearings

A facility and apparatus are described which determine stiffness, damping, and added-mass rotordynamic coefficients plus steady-state operating characteristics of high speed hydrostatic journal bearings. The apparatus has a current top speed of 29,800 rpm with a bearing diameter of 7.62 cm (3 in.). Purified warm water, 55 C (130 F), is used as a test fluid to achieve elevated Reynolds numbers during operation. The test-fluid pump yields a bearing maximum inlet pressure of 6.9 Mpa (1000 psi). Static load on the bearing is independently controlled and measured. Orthogonally mounted external shakers are used to excite the test stator in the direction of, and perpendicular to, the static load. The apparatus can independently calculate all rotordynamic coefficients at a given operating condition

An Experimental Study of Transvenous Defibrillation Using a Coronary Sinus Catheter

Peer Reviewedhttp://deepblue.lib.umich.edu/bitstream/2027.42/71902/1/j.1540-8167.1989.tb01561.x.pd

Monophasic Action Potential Duration During Programmed Electrical Stimulation

Peer Reviewedhttp://deepblue.lib.umich.edu/bitstream/2027.42/73599/1/j.1540-8159.1991.tb04156.x.pd

Post-aragonite phases of CaCO3_{3} at lower mantle pressures

The stability, structure and properties of carbonate minerals at lower mantle conditions has significant impact on our understanding of the global carbon cycle and the composition of the interior of the Earth. In recent years, there has been significant interest in the behavior of carbonates at lower mantle conditions, specifically in their carbon hybridization, which has relevance for the storage of carbon within the deep mantle. Using high-pressure synchrotron X-ray diffraction in a diamond anvil cell coupled with direct laser heating of CaCO$_{3}$ using a CO$_{2}$ laser, we identify a crystalline phase of the material above 40 GPa $-$ corresponding to a lower mantle depth of around 1,000 km $-$ which has first been predicted by \textit{ab initio} structure predictions. The observed $sp^{2}$ carbon hybridized species at 40 GPa is monoclinic with $P2_{1}/c$ symmetry and is stable up to 50 GPa, above which it transforms into a structure which cannot be indexed by existing known phases. A combination of \textit{ab initio} random structure search (AIRSS) and quasi-harmonic approximation (QHA) calculations are used to re-explore the relative phase stabilities of the rich phase diagram of CaCO$_{3}$. Nudged elastic band (NEB) calculations are used to investigate the reaction mechanisms between relevant crystal phases of CaCO$_{3}$ and we postulate that the mineral is capable of undergoing $sp^{2}$-$sp^{3}$ hybridization change purely in the $P2_{1}/c$ structure $-$ forgoing the accepted post-aragonite $Pmmn$ structure.Comment: 12 pages, 8 figure

Dichloroacetate enhances myocardial functional and metabolic recovery following global ischemia

This study was undertaken to determine the effect of dichloroacetate (DCA) on myocardial functional and metabolic recovery following global ischemia. Sixteen isolated rabbit hearts were subjected to 120 minutes of mildly hypothermic (34[deg]C) cardioplegic arrest with multi-dose, modified St. Thomas' cardioplegia. Following ischemia, hearts were reperfused with either a physiologic salt solution (PSS) as controls, (CON, N = 10), or PSS containing DCA (DCA, N = 6) at a concentration of 1 mmol/L. Functional and metabolic indices were determined at baseline and at 15, 30, and 45 minutes of reperfusion. Results were analyzed using analysis of variance (ANOVA, Sheffe F test) and significance was defined as P 2) was increased in the DCA versus CON hearts (71 +/- 10% of baseline, v 51 +/- 19%). Diastolic compliance during reperfusion was improved in those hearts receiving DCA, as was myocardial mechanical use efficiency (DP/MVO2). Correction of myocardial tissue pH to baseline values was similar in both groups, indicating that the beneficial effect on functional recovery seen with DCA was not solely related to amelioration of acidosis. The enhanced myocardial function and improved metabolic status noted with DCA may result from increased oxidative phosphorylation due to altered pyruvate dehydrogenase (PDH) activity.Peer Reviewedhttp://deepblue.lib.umich.edu/bitstream/2027.42/31660/1/0000594.pd

Damping behavior of 3D woven metallic lattice materials

Cu and NiCr metallic lattice materials of two different micro-architectures were manufactured with a 3D weaving process. Dynamic mechanical analysis experiments demonstrated that the damping properties of these materials are much greater than their bulk counterparts and were found to have damping loss coefficients comparable to polymers, but with much higher maximum use temperatures. The magnitude of the damping phenomenon is characterized experimentally, and the importance of Coulomb (frictional) damping and inertial damping are investigated using a finite element mode

Final report on LDRD project : single-photon-sensitive imaging detector arrays at 1600 nm.

The key need that this project has addressed is a short-wave infrared light detector for ranging (LIDAR) imaging at temperatures greater than 100K, as desired by nonproliferation and work for other customers. Several novel device structures to improve avalanche photodiodes (APDs) were fabricated to achieve the desired APD performance. A primary challenge to achieving high sensitivity APDs at 1550 nm is that the small band-gap materials (e.g., InGaAs or Ge) necessary to detect low-energy photons exhibit higher dark counts and higher multiplication noise compared to materials like silicon. To overcome these historical problems APDs were designed and fabricated using separate absorption and multiplication (SAM) regions. The absorption regions used (InGaAs or Ge) to leverage these materials 1550 nm sensitivity. Geiger mode detection was chosen to circumvent gain noise issues in the III-V and Ge multiplication regions, while a novel Ge/Si device was built to examine the utility of transferring photoelectrons in a silicon multiplication region. Silicon is known to have very good analog and GM multiplication properties. The proposed devices represented a high-risk for high-reward approach. Therefore one primary goal of this work was to experimentally resolve uncertainty about the novel APD structures. This work specifically examined three different designs. An InGaAs/InAlAs Geiger mode (GM) structure was proposed for the superior multiplication properties of the InAlAs. The hypothesis to be tested in this structure was whether InAlAs really presented an advantage in GM. A Ge/Si SAM was proposed representing the best possible multiplication material (i.e., silicon), however, significant uncertainty existed about both the Ge material quality and the ability to transfer photoelectrons across the Ge/Si interface. Finally a third pure germanium GM structure was proposed because bulk germanium has been reported to have better dark count properties. However, significant uncertainty existed about the quantum efficiency at 1550 nm the necessary operating temperature. This project has resulted in several conclusions after fabrication and measurement of the proposed structures. We have successfully demonstrated the Ge/Si proof-of-concept in producing high analog gain in a silicon region while absorbing in a Ge region. This has included significant Ge processing infrastructure development at Sandia. However, sensitivity is limited at low temperatures due to high dark currents that we ascribe to tunneling. This leaves remaining uncertainty about whether this structure can achieve the desired performance with further development. GM detection in InGaAs/InAlAs, Ge/Si, Si and pure Ge devices fabricated at Sandia was shown to overcome gain noise challenges, which represents critical learning that will enable Sandia to respond to future single photon detection needs. However, challenges to the operation of these devices in GM remain. The InAlAs multiplication region was not found to be significantly superior to current InP regions for GM, however, improved multiplication region design of InGaAs/InP APDs has been highlighted. For Ge GM detectors it still remains unclear whether an optimal trade-off of parameters can achieve the necessary sensitivity at 1550 nm. To further examine these remaining questions, as well as other application spaces for these technologies, funding for an Intelligence Community post-doc was awarded this year

The James Webb Space Telescope Mission

Twenty-six years ago a small committee report, building on earlier studies, expounded a compelling and poetic vision for the future of astronomy, calling for an infrared-optimized space telescope with an aperture of at least $4m$. With the support of their governments in the US, Europe, and Canada, 20,000 people realized that vision as the $6.5m$ James Webb Space Telescope. A generation of astronomers will celebrate their accomplishments for the life of the mission, potentially as long as 20 years, and beyond. This report and the scientific discoveries that follow are extended thank-you notes to the 20,000 team members. The telescope is working perfectly, with much better image quality than expected. In this and accompanying papers, we give a brief history, describe the observatory, outline its objectives and current observing program, and discuss the inventions and people who made it possible. We cite detailed reports on the design and the measured performance on orbit.Comment: Accepted by PASP for the special issue on The James Webb Space Telescope Overview, 29 pages, 4 figure

Genetic mechanisms of critical illness in COVID-19.

Host-mediated lung inflammation is present1, and drives mortality2, in the critical illness caused by coronavirus disease 2019 (COVID-19). Host genetic variants associated with critical illness may identify mechanistic targets for therapeutic development3. Here we report the results of the GenOMICC (Genetics Of Mortality In Critical Care) genome-wide association study in 2,244 critically ill patients with COVID-19 from 208 UK intensive care units. We have identified and replicated the following new genome-wide significant associations: on chromosome 12q24.13 (rs10735079, P = 1.65 × 10-8) in a gene cluster that encodes antiviral restriction enzyme activators (OAS1, OAS2 and OAS3); on chromosome 19p13.2 (rs74956615, P = 2.3 × 10-8) near the gene that encodes tyrosine kinase 2 (TYK2); on chromosome 19p13.3 (rs2109069, P = 3.98 ×  10-12) within the gene that encodes dipeptidyl peptidase 9 (DPP9); and on chromosome 21q22.1 (rs2236757, P = 4.99 × 10-8) in the interferon receptor gene IFNAR2. We identified potential targets for repurposing of licensed medications: using Mendelian randomization, we found evidence that low expression of IFNAR2, or high expression of TYK2, are associated with life-threatening disease; and transcriptome-wide association in lung tissue revealed that high expression of the monocyte-macrophage chemotactic receptor CCR2 is associated with severe COVID-19. Our results identify robust genetic signals relating to key host antiviral defence mechanisms and mediators of inflammatory organ damage in COVID-19. Both mechanisms may be amenable to targeted treatment with existing drugs. However, large-scale randomized clinical trials will be essential before any change to clinical practice