3,493 research outputs found
Measurements of Pilot Time Delay as Influenced by Controller Characteristics and Vehicles Time Delays
A study to measure and compare pilot time delay when using a space shuttle rotational hand controller and a more conventional control stick was conducted at NASA Ames Research Center's Dryden Flight Research Facility. The space shuttle controller has a palm pivot in the pitch axis. The more conventional controller used was a general-purpose engineering simulator stick that has a pivot length between that of a typical aircraft center stick and a sidestick. Measurements of the pilot's effective time delay were obtained through a first-order, closed-loop, compensatory tracking task in pitch. The tasks were implemented through a space shuttle cockpit simulator and a critical task tester device. The study consisted of 450 data runs with four test pilots and one nonpilot, and used three control stick configurations and two system delays. Results showed that the heavier conventional stick had the lowest pilot effective time delays associated with it, whereas the shuttle and light conventional sticks each had similar higher pilot time delay characteristics. It was also determined that each control stick showed an increase in pilot time delay when the total system delay was increased
Partial vs. full support of the heart with a continuous-flow left ventricular assist device : implications for myocardial recovery.
INTRODUCTION: Heart failure is a major and growing public health concern. Although heart failure has been considered an inexorable and progressive disorder, emerging evidence suggests that some patients may have reversible left ventricular dysfunction. Indeed, recent reports have documented the potential for myocardial recovery in humans in response to prolonged mechanical circulatory support with a left ventricular assist device (LVAD). However, myocardial recovery remains uncommon, and a strategy of unloading the failing left ventricle with a continuous-flow (non-pulsatile) LVAD has not been specifically developed to promote favorable myocardial remodeling. As a preliminary investigation, we developed a bovine model of chronic, ischemic heart failure and quantified the effects of different levels of support with a continuous-flow LVAD on myocardial mechanoenergetics. METHODS: Normal cows (n=8) and cows with chronic, ischemic heart failure (n=9) were studied. To induce heart failure, 90 µm micro spheres were percutaneously injected into the left main coronary artery. Heart failure developed over 60 days. In an acute surgery, a continuous-flow LVAD was implanted and operated at Low Partial Support (~1.5 L/min support, aortic valve opening every beat), High Partial Support (~3 L/min support, aortic valve opening every beat) and Full Support (~5 L/min, aortic valve maintained closed, left ventricle maximally unloaded). Cardiac and systemic arterial hemodynamics were measured with flow probes and pressure catheters. Myocardial blood flow was mapped with 15 µm fluorescent-labeled microspheres. After termination, molecular and histological markers of heart failure were quantified. RESUL TS: In normal animals, increasing levels of non-pulsatile support deranged the profile of cardiac and arterial hemodynamics. As cardiac workload decreased, myocardial vascular resistance increased, and myocardial blood flow decreased. The ratio between blood supply and demand did not change and indicated appropriate coronary autoregulation and the presence of an intact coronary reserve. Animals with chronic, ischemic heart failure exhibited hallmark signs of severe left ventricular systolic dysfunction that included a 50% reduction in ejection fraction, left ventricular dilatation, decreased cardiac output and arterial pressures, decreased end-organ blood flow, severe myocardial fibrosis, myocyte hypertrophy, and increased myocardial apoptosis. In animals with chronic heart failure, increasing levels of non-pulsatile support similarly deranged the profile of cardiac and arterial hemodynamics. As cardiac workload decreased, myocardial vascular resistance increased. However myocardial blood flow did not change and indicated a lack of a coronary reserve. Importantly, during full but not partial support, the ratio between blood supply and demand improved significantly to levels observed in normal control animals. CONCLUSIONS: After the implantation of an LVAD, full but not partial support of the failing left ventricle with an LVAD normalizes the myocardial blood supply/demand relationship. In the immediate postoperative period, the left ventricle should be completely unloaded. Chronic studies are necessary to determine whether a transition to partial support may prevent myocardial atrophy and fibrosis that is seen with prolonged full support. Our bovine model of chronic, ischemic heart failure is appropriate for such a study
Morpho-anatomical and physiological traits of Agrostis castellana living in an active geothermal alteration field
Agrostis castellana is one of the few plants colonizing one of the most extreme geothermal alteration fields characterized by low pH and high temperature of soil. The study of species surviving in these multi-stress habitats can help to know more in deep the adaptive ability of plants. In this work morpho-anatomical, functional and physiological traits of leaves of A. castellana living few meters from fumaroles were studied, focusing on their putative ecological significance. Some typical xeromorphic traits occurred in the leaves of these plants: abundant cutinization, cell wall thickening, slightly convolute and adaxially ribbed leaf blades, tissutal reinforcements by sclereids, pubescence, protected stomata and densely packed mesophyll. Abundant pectins, important in both water balance adjusting and as monosaccharide source, were observed in epidermal cell walls. Despite the low value of relative water content, indicative of a disturbed hydric state, oxidative damage, in terms of lipid peroxidation, indicative of membrane damage, was significantly lower than in other plants of the same environment, probably tanks to an adequate antioxidant response based mainly on enzymatic machinery. Interestingly catalase activity was not inhibited by extreme conditions of the geothermal alteration field as in other plants of the same habitat. In conclusion, a cooperation of xeromorphic traits and antioxidant response seems to make A. castellana able to survive in such a prohibitive environment
Complete (k,3)-arcs from quartic curves
Complete (Formula presented.) -arcs in projective planes over finite fields are the geometric counterpart of linear non-extendible Near MDS codes of length (Formula presented.) and dimension (Formula presented.). A class of infinite families of complete (Formula presented.) -arcs in (Formula presented.) is constructed, for (Formula presented.) a power of an odd prime (Formula presented.). The order of magnitude of (Formula presented.) is smaller than (Formula presented.). This property significantly distinguishes the complete (Formula presented.) -arcs of this paper from the previously known infinite families, whose size differs from (Formula presented.) by at most (Formula presented.)
Non-minimum tensor rank Gabidulin codes
The tensor rank of some Gabidulin codes of small dimension is investigated. In particular, we determine the tensor rank of any rank metric code equivalent to an 8-dimensional Fq-linear generalized Gabidulin code in Fq4Ă—4. This shows that such a code is never minimum tensor rank. In this way, we detect the first infinite family of Gabidulin codes which are not minimum tensor rank
Dynamic Identification as a Tool to Constrain Numerical Models for Structural Analysis of Historical Buildings
Operational modal analysis (OMA), also known as output-only or ambient vibration test (AVT), has become in last decades a powerful approach for a wide range of applications in the field of civil engineering. When historical structures are investigated this approach is particularly appealing avoiding shaking the structure artificially. This paper discusses the assessment of the dynamic behavior of the Baptistery of San Giovanni in Firenze (Italy). Based on experimental results obtained through a temporary network of seismic sensors, the enhanced frequency domain decomposition (EFDD) technique is employed to evaluate frequencies and mode shapes. These modal parameters are subsequently used to calibrate a 3D finite element (FE) model of the Baptistery. Genetic algorithm (GA) technique is employed for calibration, thus allowing to obtain an accurate and robust numerical model. To verify the effects introduced by the number of identified modal parameters on the model updating procedure several analyses are in addition performed. This paper, providing an illustrative case study in the field of health monitoring of monumental structures, confirms that the OMA technique is able to derive effective information on the dynamic behavior of historical buildings, which in turn is useful to tune reliable and robust numerical models to be employed for structural analysis
Analytical and numerical seismic assessment of heritage masonry towers
Abstract
The new Italian building code, published in 2018 [MIT in NTC 2018: D.M. del Ministero delle Infrastrutture e dei trasporti del 17/01/2018. Aggiornamento delle Norme Tecniche per le Costruzioni (in Italian), 2018], explicitly refers to the Italian “Guidelines for the assessment and mitigation of the seismic risk of the cultural heritage” [PCM in DPCM 2011: Direttiva del Presidente del Consiglio dei Ministri per valutazione e riduzione del rischio sismico del patrimonio culturale con riferimento alle norme tecniche per le costruzioni, G.U. n. 47 (in Italian), 2011] as a reliable source of guidance that can be employed for the vulnerability assessment of heritage buildings under seismic loads. According to these guidelines, three evaluation levels are introduced to analyse and assess the seismic capacity of historic masonry structures, namely: (1) simplified global static analyses; (2) kinematic analyses based on local collapse mechanisms, (3) detailed global analyses. Because of the complexity and the large variety of existing masonry typologies, which makes it particularly problematic to adopt a unique procedure for all existing structures, the guidelines provide different simplified analysis approaches for different structural configurations, e.g. churches, palaces, towers. Among the existing typologies of masonry structures there considered, this work aims to deepen validity, effectiveness and scope of application of the Italian guidelines with respect to heritage masonry towers. The three evaluation levels proposed by the guidelines are here compared by discussing the seismic risk assessment of a representative masonry tower: the Cugnanesi tower located in San Gimignano (Italy). The results show that global failure modes due to local stress concentrations cannot be identified if only simplified static and kinematic analyses are performed. Detailed global analyses are in fact generally needed for a reliable prediction of the seismic performance of such structures.</jats:p
Study of RPC gas mixtures for the ARGO-YBJ experiment
The ARGO-YBJ experiment consists of a RPC carpet to be operated at the
Yangbajing laboratory (Tibet, P.R. China), 4300 m a.s.l., and devoted to the
detection of showers initiated by photon primaries in the energy range 100 GeV
- 20 TeV. The measurement technique, namely the timing on the shower front with
a few tens of particles, requires RPC operation with 1 ns time resolution, low
strip multiplicity, high efficiency and low single counting rate. We have
tested RPCs with many gas mixtures, at sea level, in order to optimize these
parameters. The results of this study are reported.Comment: 6 pages, 3 figures. To be published in Nucl. Instr. Meth. A, talk
given at the "5th International Workshop on RPCs and Related Detectors", Bari
(Italy) 199
Model-following control for an oblique-wing aircraft
A variable-skew oblique wing offers a substantial aerodynamic performance advantage for aircraft missions that require both high efficiency in subsonic flight and supersonic dash or cruise. The most obvious characteristic of the oblique-wing concept is the asymmetry associated with wing-skew angle which results in significant aerodynamic and inertial cross-coupling between the aircraft longitudinal and lateral-directional axes. A technique for synthesizing a decoupling controller while providing the desired stability augmentation. The proposed synthesis procedure uses the cncept of explicit model following. Linear quadratic optimization techniques are used to design the linear feedback system. The effectiveness of the control laws developed in achieving the desired decoupling is illustrated for a given flight condition by application to linearized equations of motion, and also to the nonlinear equations of six degrees of freedom of motion with nonlinear aerodynamic data
- …