Experimental assessment of the variability of concrete air permeability: repeatability, reproducibility and spatial variability

International audienc

Uniaxial Tensile Stress-Strain Relationships of RC Elements Strengthened with FRP Sheets

The shear behavior of fiber-reinforced-polymer–strengthened reinforced concrete (FRP-strengthened RC) members is not fully developed and accurately predicted because of the lack of accurate constitutive laws for the components of the composite members. This paper presents experimental and analytical investigations of tensile stress-strain relationships of concrete and steel in FRP-strengthened RC members. These stress-strain relationships are required in formulations of softened truss models to predict the shear behavior of the FRP-strengthened RC element. Thirteen full-scale FRP-strengthened RC prismatic specimens with different FRP reinforcement ratios, steel reinforcement ratios, and FRP wrapping schemes were tested under uniaxial tension loading. The results show that the tensile behavior of the concrete and steel is altered because of the externally bonded FRP sheets. Modified constitutive laws are proposed and incorporated in the softened membrane model (SMM) to demonstrate through two tests the behavior of FRP-strengthened RC element subjected to pure shear. Moreover, crack spacing and crack width were studied and compared with existing code provisions

Behavior of the parameters of microcrystalline silicon TFTs under mechanical strain

International audienceN-type and P-type microcrystalline silicon top-gate TFTs, processed directly on PEN plastic substrate at maximum temperature of 180 °C, were mechanically stressed. These TFTs were bent by different curvature radii varying between infinite (flat) and 0.5 cm. The tensile stress increases the electron mobility and the compressive stress decreases it. The tensile stress decreases the threshold voltage of N-type TFTs while the compressive stress increases it. These trends are inversed if the type of stress changes OR the type of TFTs changes. The total behavior under mechanical stress is exactly similar to that of single crystalline silicon MOSFETs in nano-scale technologies (90, 65, 45, 32 nm), where nano-scale stress is introduced in the goal to engineer the electrical parameters. The similarity originates from the microcrystalline silicon active layer that behaves like single crystalline silicon even if the stress effects are softened by the grain boundaries and the multiple crystalline orientations of the grains

Continuous Concrete Beams Reinforced With CFRP Bars.

yesThis paper reports the testing of three continuously and two simply supported concrete beams reinforced with carbon fibre reinforced polymer (CFRP) bars. The amount of CFRP reinforcement in beams tested was the main parameter investigated. A continuous concrete beam reinforced with steel bars was also tested for comparison purposes. The ACI 440.1R-06 equations are validated against the beam test results. Test results show that increasing the CFRP reinforcement ratio of the bottom layer of simply and continuously supported concrete beams is a key factor in enhancing the load capacity and controlling deflection. Continuous concrete beams reinforced with CFRP bars exhibited a remarkable wide crack over the middle support that significantly influenced their behaviour. The load capacity and deflection of CFRP simply supported concrete beams are reasonably predicted using the ACI 440.1R-06 equations. However, the potential capabilities of these equations for predicting the load capacity and deflection of continuous CFRP reinforced concrete beams have been adversely affected by the de-bonding of top CFRP bars from concrete

Intercropping Promotes the Ability of Legume and Cereal to Facilitate Phosphorus and Nitrogen Acquisition through Root- Induced Processes

Intercropping of cereal and legume can improve the use of resources for crop growth compared to cropping system. An increase in soil phosphorus (P) and nitrogen (N) acquisition by root-induced biochemical changes of intercropped species has been reported as key processes of facilitation and complementarily between both intercropping legumes and cereals. Indeed, the functional facilitation prevails over interspecific competition under nutrients limiting for crop growth. Results showed that P availability significantly increased in the rhizosphere of both species, especially in intercropping under the P-deficient soil conditions. This increase was associated with high efficiency efficiency in use of rhizobial, plant growth and resource use efficiency as indicated by higher land equivalent ratio (LER) and N nutrition index. In addition, the rhizosphere P availability and nodule biomass were positively correlated (r2 = 0.71**, and r2 = 0.62**) in the intercropped common bean grown at P-deficient soil. The increased P availability presumably improved biomass and yield in intercropping, although it mainly enhanced intercropped maize grain yield. Exploiting belowground parameters in a legume-cereal intercropping is likely necessary to maximize rhizosphere-interspecific interactions as a strategy to improve the symbiotic rhizobial efficiency and microbial activities, as a result of root-induced pH and N availability changes under low P soils

Numerical study of effect of elastomeric stress absorbers on stress reduction in bone-dental implant interface

Objective This paper focused on optimal stress distribution in the mandibular bone surrounding a dental implant and is devoted to the development of a modified Osteoplant® implant type in order to minimize stress concentration in the bone-implant interface. Material and Methods This study investigated 0.4 mm thick layers of two elastomeric stress barriers incorporated into the dental implant using 3-D finite element analysis. Results Overall, this proposed implant provoked lower load transfer in bone-implant interface due to the effect of the elastomers as stress absorbers. The stress level in the bone was reduced between 28% and 42% for three load cases: 75 N, 60 N and 27 N in corono-apical, linguo-buccal and disto-mesial direction, respectively. Conclusion The proposed model provided an acceptable solution for load transfer reduction to the mandible. This investigation also permitted to choose how to incorporate two elastomers into the Osteoplant® implant system

The status of hepatitis C virus infection among people who inject drugs in the Middle East and North Africa.

BACKGROUND AND AIMS: People who inject drugs (PWID) are a key population at high risk of hepatitis C virus (HCV) infection. The aim of this study was to delineate the epidemiology of HCV in PWID in the Middle East and North Africa (MENA). METHODS: Syntheses of data were conducted on the standardized and systematically assembled databases of the MENA HCV Epidemiology Synthesis Project, 1989-2018. Random-effects meta-analyses and meta-regressions were performed. Meta-regression variables included country, study site, year of data collection and year of publication [to assess trends in HCV antibody prevalence over time], sample size and sampling methodology. Numbers of chronically infected PWID across MENA were estimated. The Shannon Diversity Index was calculated to assess genotype diversity. RESULTS: Based on 118 HCV antibody prevalence measures, the pooled mean prevalence in PWID for all MENA was 49.3% [95% confidence interval (CI) = 44.4-54.1%]. The country-specific pooled mean ranged from 21.7% (95% CI = 4.9-38.6%) in Tunisia to 94.2% (95% CI = 90.8-96.7%) in Libya. An estimated 221 704 PWID were chronically infected, with the largest numbers found in Iran at 68 526 and in Pakistan at 46 554. There was no statistically significant evidence for a decline in HCV antibody prevalence over time. Genotype diversity was moderate (Shannon Diversity Index of 1.01 out of 1.95; 52.1%). The pooled mean percentage for each HCV genotype was highest in genotype 3 (42.7%) and in genotype 1 (35.9%). CONCLUSION: Half of people who inject drugs in the Middle East and North Africa appear to have ever been infected with hepatitis C virus, but there are large variations in antibody prevalence among countries. In addition to > 200 000 chronically infected current people who inject drugs, there is an unknown number of people who no longer inject drugs who may have acquired hepatitis C virus during past injecting drug use. Harm reduction services must be expanded, and innovative strategies need to be employed to ensure accessibility to hepatitis C virus testing and treatment

The evolving SARS-CoV-2 epidemic in Africa: insights from rapidly expanding genomic surveillance

Investment in SARS-CoV-2 sequencing in Africa over the past year has led to a major increase in the number of sequences generated, now exceeding 100,000 genomes, used to track the pandemic on the continent. Our results show an increase in the number of African countries able to sequence domestically, and highlight that local sequencing enables faster turnaround time and more regular routine surveillance. Despite limitations of low testing proportions, findings from this genomic surveillance study underscore the heterogeneous nature of the pandemic and shed light on the distinct dispersal dynamics of Variants of Concern, particularly Alpha, Beta, Delta, and Omicron, on the continent. Sustained investment for diagnostics and genomic surveillance in Africa is needed as the virus continues to evolve, while the continent faces many emerging and re-emerging infectious disease threats. These investments are crucial for pandemic preparedness and response and will serve the health of the continent well into the 21st century