Concurrent 43 and 86 GHz Very Long Baseline Polarimetry of 3C273

We present sub-milliarcsecond resolution total intensity and linear polarization VLBI images of 3C273, using concurrent 43 and 86 GHz data taken with the Very Long Baseline Array in May 2002. The structure seen in the innermost jet suggest that we have fortuitously caught the jet in the act of changing direction. The polarization images confirm that the core is unpolarized (fractional polarization m < 1 %) at 86 GHz, but also show well ordered magnetic fields (m ~ 15 %) in the inner jet, at a projected distance of 2.3 pc from the core. In this strongly polarized region, the rotation measure changes across the jet by 4.2 x 10^{4} rad m^{-2} over an angular width of about 0.3 milliarcseconds. If the lack of polarization in the core is also attributed to a Faraday screen, then a rotation measure dispersion > 5.2 x 10^{4} rad m^{-2} must be present in or in front of that region. These are among the highest rotation measures reported so far in the nucleus of any active galaxy or quasar, and must occur outside (but probably close to) the radio emitting region. The transverse rotation measure gradient is in the same sense as that observed by Asada et al and by Zavala and Taylor at greater core distances. The magnitude of the transverse gradient decreases rapidly with distance down the jet, and appears to be variable.Comment: 4 pages, LaTeX, 3 postscript figures, submitted to Astrophysical Journal Letter

Inconsistency in 9 mm bullets : correlation of jacket thickness to post-impact geometry measured with non-destructive X-ray computed tomography

Fundamental to any ballistic armour standard is the reference projectile to be defeated. Typically, for certification purposes, a consistent and symmetrical bullet geometry is assumed, however variations in bullet jacket dimensions can have far reaching consequences. Traditionally, characteristics and internal dimensions have been analysed by physically sectioning bullets – an approach which is of restricted scope and which precludes subsequent ballistic assessment. The use of a non-destructive X-ray computed tomography (CT) method has been demonstrated and validated Kumar et al., 2011); the authors now apply this technique to correlate bullet impact response with jacket thickness variations. A set of 20 bullets (9 mm DM11) were selected for comparison and an image-based analysis method was employed to map jacket thickness and determine the centre of gravity of each specimen. Both intra- and inter-bullet variations were investigated, with thickness variations of the order of 200 um commonly found along the length of all bullets and angular variations of up to 50 um in some. The bullets were subsequently impacted against a rigid flat plate under controlled conditions (observed on a high-speed video camera) and the resulting deformed projectiles were re-analysed. The results of the experiments demonstrate a marked difference in ballistic performance between bullets from different manufacturers and an asymmetric thinning of the jacket is observed in regions of pre-impact weakness. The conclusions are relevant for future soft armour standards and provide important quantitative data for numerical model correlation and development. The implications of the findings of the work on the reliability and repeatability of the industry standard V50 ballistic test are also discussed

X-ray computed tomography (XCT) and chemical analysis (EDX and XRF) used in conjunction for cultural conservation: the case of the earliest scientifically described dinosaur Megalosaurus bucklandii

This paper demonstrates the combined use of X-ray computed tomography (XCT), energy dispersive X-ray spectroscopy (EDX) and X-ray fluorescence (XRF) to evaluate the conservational history of the dentary (lower jaw) of Megalosaurus bucklandii Mantell, 1827, the first scientifically described dinosaur. Previous analysis using XCT revealed that the specimen had undergone at least two phases of repair using two different kinds of plaster, although their composition remained undetermined. Additional chemical analysis using EDX and XRF has allowed the determination of the composition of these unidentified plasters, revealing that they are of similar composition, composed dominantly of ‘plaster of Paris’ mixed with quartz sand and calcite, potentially from the matrix material of the Stonesfield Slate, with the trace presence of chlorine. One of the plasters unusually contains the pigment minium (naturally occurring lead tetroxide; Pb22+Pb4+O4) whilst the other seems to have an additional coating of barium hydroxide (Ba(OH)2), indicating that these likely represent two separate stages of repair. The potential of this combined approach for evaluating problematic museum objects for conservation is further discussed as is its usage in cultural heritage today

Towards in-process x-ray CT for dimensional metrology

X-ray computed tomography (CT) offers significant potential as a metrological tool, given the wealth of internal and external data that can be captured, much of which is inaccessible to conventional optical and tactile coordinate measurement machines (CMM). Typical lab-based CT can take upwards of 30 min to produce a 3D model of an object, making it unsuitable for volume production inspection applications. Recently a new generation of real time tomography (RTT) x-ray CT has been developed for airport baggage inspections, utilising novel electronically switched x-ray sources instead of a rotating gantry. This enables bags to be scanned in a few seconds and 3D volume images produced in almost real time for qualitative assessment to identify potential threats. Such systems are able to scan objects as large as 600 mm in diameter at 500 mm s−1. The current voxel size of such a system is approximately 1 mm—much larger than lab-based CT, but with significantly faster scan times is an attractive prospect to explore. This paper will examine the potential of such systems for real time metrological inspection of additively manufactured parts. The measurement accuracy of the Rapiscan RTT110, an RTT airport baggage scanner, is evaluated by comparison to measurements from a metrologically confirmed CMM and those achieved by conventional lab-CT. It was found to produce an average absolute error of 0.18 mm that may already have some applications in the manufacturing line. While this is expectedly a greater error than lab-based CT, a number of adjustments are suggested that could improve resolution, making the technology viable for a broader range of in-line quality inspection applications, including cast and additively manufactured parts

Faraday rotation in the MOJAVE blazars: 3C 273 a case study

Radio polarimetric observations of Active Galactic Nuclei can reveal the magnetic field structure in the parsec-scale jets of these sources. We have observed the gamma-ray blazar 3C 273 as part of our multi-frequency survey with the Very Long Baseline Array to study Faraday rotation in a large sample of jets. Our observations re-confirm the transverse rotation measure gradient in 3C 273. For the first time the gradient is seen to cross zero which is further indication for a helical magnetic field and spine-sheath structure in the jet. We believe the difference to previous epochs is due to a different part of the jet being illuminated in our observations.Comment: 6 pages, 3 figures. To appear in the proceedings of "Beamed and Unbeamed Gamma-rays from Galaxies", held in Muonio, Finland, April 11-15, 2011. Journal of Physics: Conference Serie

Nonlinear stability of relativistic sheared planar jets

The linear and non-linear stability of sheared, relativistic planar jets is studied by means of linear stability analysis and numerical hydrodynamical simulations. Our results extend the previous Kelvin-Hemlholtz stability studies for relativistic, planar jets in the vortex sheet approximation performed by Perucho et al. (2004a,b) by including a shear layer between the jet and the external medium and more general perturbations. The models considered span a wide range of Lorentz factors ($2.5-20$) and internal energies ($0.08 c^2-60 c^2$) and are classified into three classes according to the main characteristics of their long-term, non-linear evolution. We observe a clear separation of these three groups in a relativistic Mach-number Lorentz-factor plane. Jets with a low Lorentz factor and small relativistic Mach number are disrupted after saturation. Those with a large Lorentz factor and large relativistic Mach number are the stablest, due to the appearance of short wavelength resonant modes which generate local mixing and heating in the shear layer around a fast, unmixed core, giving a plausible solution for the problem of the long-term stability of relativistic jets. A third group is present between them, including jets with intermediate values of Lorentz factor and relativistic Mach number, which are disrupted by a slow process of mixing favored by an efficient and continuous conversion of kinetic into internal energy. In the long term, all the models develop a distinct transversal structure (shear/transition layers) as a consequence of KH perturbation growth, depending on the class they belong to. The properties of these shear layers are analyzed in connection with the parameters of the original jet models.Comment: accepted for publication in A&A (in press). High resolution plots, figures and Appendices of the paper will be found in the online version of the paper in A&A, and on request to [email protected]

Resonant Kelvin-Helmholtz modes in sheared relativistic flows

Qualitatively new aspects of the (linear and non-linear) stability of sheared relativistic (slab) jets are analyzed. The linear problem has been solved for a wide range of jet models well inside the ultrarelativistic domain (flow Lorentz factors up to 20; specific internal energies $\approx 60c^2$). As a distinct feature of our work, we have combined the analytical linear approach with high-resolution relativistic hydrodynamical simulations, which has allowed us i) to identify, in the linear regime, resonant modes specific to the relativistic shear layer ii) to confirm the result of the linear analysis with numerical simulations and, iii) more interestingly, to follow the instability development through the non-linear regime. We find that very high-order reflection modes with dominant growth rates can modify the global, long-term stability of the relativistic flow. We discuss the dependence of these resonant modes on the jet flow Lorentz factor and specific internal energy, and on the shear layer thickness. The results could have potential applications in the field of extragalactic relativistic jets.Comment: Accepted for publication in Physical Review E. For better quality images, please check http://www.mpifr-bonn.mpg.de/staff/mperucho/Research.htm

Involving people with diabetes and the wider community in diabetes research: a realist review protocol.

BACKGROUND: Patient and public involvement in diabetes research is now actively encouraged in different countries because it is believed that involving people with experience of the condition will improve the quality and relevance of the research. However, reviews of patient involvement have noted that inadequate resources, patients' and communities' lack of research knowledge, and researchers' lack of skills to involve patients and communities in research may present significant contextual barriers. Little is known about the extent of patient/community involvement in designing or delivering interventions for people with diabetes. A realist review of involvement will contribute to assessing when, how and why involvement works, or does not work, to produce better diabetes interventions. METHODS/DESIGN: This protocol outlines the process for conducting a realist review to map how patients and the public have been involved in diabetes research to date. The review questions ask the following: How have people with diabetes and the wider community been involved in diabetes research? What are the characteristics of the process that appear to explain the relative success or failure of involvement? How has involvement (or lack of involvement) in diabetes research influenced the development and conduct of diabetes research? The degree of support in the surrounding context will be assessed alongside the ways in which people interact in different settings to identify patterns of interaction between context, mechanisms and outcomes in different research projects. The level and extent of the involvement will be described for each stage of the research project. The descriptions will be critically reviewed by the people with diabetes on our review team. In addition, researchers and patients in diabetes research will be asked to comment. Information from researcher-patient experiences and documents will be compared to theories of involvement across a range of disciplines to create a mid-range theory describing how involvement (or lack of involvement) in diabetes research influences the development and conduct of diabetes research

Disparities of Care for African-Americans and Caucasians with Community-Acquired Pneumonia: A Retrospective Cohort Study

Background\ud African-Americans admitted to U.S. hospitals with community-acquired pneumonia (CAP) are more likely than Caucasians to experience prolonged hospital length of stay (LOS), possibly due to either differential treatment decisions or patient characteristics.\ud \ud Methods\ud We assessed associations between race and outcomes (Intensive Care Unit [ICU] variables, LOS, 30-day mortality) for African-American or Caucasian patients over 65 years hospitalized in the Veterans Health Administration (VHA) with CAP (2002-2007). Patients admitted to the ICU were analyzed separately from those not admitted to the ICU. VHA patients who died within 30 days of discharge were excluded from all LOS analyses. We used chi-square and Fisher's exact statistics to compare dichotomous variables, the Wilcoxon Rank Sum test to compare age by race, and Cox Proportional Hazards Regression to analyze hospital LOS. We used separate generalized linear mixed-effect models, with admitting hospital as a random effect, to examine associations between patient race and the receipt of guideline-concordant antibiotics, ICU admission, use of mechanical ventilation, use of vasopressors, LOS, and 30-day mortality. We defined statistical significance as a two-tailed p ≤ 0.0001.\ud \ud Results\ud Of 40,878 patients, African-Americans (n = 4,936) were less likely to be married and more likely to have a substance use disorder, neoplastic disease, renal disease, or diabetes compared to Caucasians. African-Americans and Caucasians were equally likely to receive guideline-concordant antibiotics (92% versus 93%, adjusted OR = 0.99; 95% CI = 0.81 to 1.20) and experienced similar 30-day mortality when treated in medical wards (adjusted OR = 0.98; 95% CI = 0.87 to 1.10). African-Americans had a shorter adjusted hospital LOS (adjusted HR = 0.95; 95% CI = 0.92 to 0.98). When admitted to the ICU, African Americans were as likely as Caucasians to receive guideline-concordant antibiotics (76% versus 78%, adjusted OR = 0.99; 95% CI = 0.81 to 1.20), but experienced lower 30-day mortality (adjusted OR = 0.82; 95% CI = 0.68 to 0.99) and shorter hospital LOS (adjusted HR = 0.84; 95% CI = 0.76 to 0.93).\ud \ud Conclusions\ud Elderly African-American CAP patients experienced a survival advantage (i.e., lower 30-day mortality) in the ICU compared to Caucasians and shorter hospital LOS in both medical wards and ICUs, after adjusting for numerous baseline differences in patient characteristics. There were no racial differences in receipt of guideline-concordant antibiotic therapies