Do current WIMP direct measurements constrain light relic neutralinos?

New upper bounds on direct detection rates have recently been presented by a number of experimental collaborations working on searches for WIMPs. In this paper we analyze how the constraints on relic neutralinos which can be derived from these results is affected by the uncertainties in the distribution function of WIMPs in the halo. Various different categories of velocity distribution functions are considered, and the ensuing implications for supersymmetric configurations derived. We conservatively conclude that current experimental data do not constrain neutralinos of small mass (below 50 GeV).Comment: 9 pages, 7 figures, typeset with ReVTeX4. The paper may also be found at http://www.to.infn.it/~fornengo/papers/constraints05.ps.gz or through http://www.astroparticle.to.infn.it/index.htm

Displacements analysis of self-excited vibrations in turning

The actual research deals with determining by a new protocol the necessary parameters considering a three-dimensional model to simulate in a realistic way the turning process on machine tool. This paper is dedicated to the experimental displacements analysis of the block tool / block workpiece with self-excited vibrations. In connexion with turning process, the self-excited vibrations domain is obtained starting from spectra of two accelerometers. The existence of a displacements plane attached to the tool edge point is revealed. This plane proves to be inclined compared to the machines tool axes. We establish that the tool tip point describes an ellipse. This ellipse is very small and can be considered as a small straight line segment for the stable cutting process (without vibrations). In unstable mode (with vibrations) the ellipse of displacements is really more visible. A difference in phase occurs between the tool tip displacements on the radial direction and on the cutting one. The feed motion direction and the cutting one are almost in phase. The values of the long and small ellipse axes (and their ratio) shows that these sizes are increasing with the feed rate value. The axis that goes through the stiffness center and the tool tip represents the maximum stiffness direction. The maximum (resp. minimum) stiffness axis of the tool is perpendicular to the large (resp. small) ellipse displacements axis. FFT analysis of the accelerometers signals allows to reach several important parameters and establish coherent correlations between tool tip displacements and the static - elastic characteristics of the machine tool components tested

Mechanisms of the Vertical Secular Heating of a Stellar Disk

We investigate the nonlinear growth stages of bending instability in stellar disks with exponential radial density profiles.We found that the unstable modes are global (the wavelengths are larger than the disk scale lengths) and that the instability saturation level is much higher than that following from a linear criterion. The instability saturation time scales are of the order of one billion years or more. For this reason, the bending instability can play an important role in the secular heating of a stellar disk in the $z$ direction. In an extensive series of numerical $N$-body simulations with a high spatial resolution, we were able to scan in detail the space of key parameters (the initial disk thickness $z_0$, the Toomre parameter $Q$, and the ratio of dark halo mass to disk mass $M_{\rm h} / M_{\rm d}$). We revealed three distinct mechanisms of disk heating in the $z$ direction: bending instability of the entire disk, bending instability of the bar, and heating on vertical inhomogeneities in the distribution of stellar matter.Comment: 22 pages including 8 figures. To be published in Astronomy Letters (v.29, 2003

DECam integration tests on telescope simulator

The Dark Energy Survey (DES) is a next generation optical survey aimed at measuring the expansion history of the universe using four probes: weak gravitational lensing, galaxy cluster counts, baryon acoustic oscillations, and Type Ia supernovae. To perform the survey, the DES Collaboration is building the Dark Energy Camera (DECam), a 3 square degree, 570 Megapixel CCD camera which will be mounted at the Blanco 4-meter telescope at the Cerro Tololo Inter- American Observatory. DES will survey 5000 square degrees of the southern galactic cap in 5 filters (g, r, i, z, Y). DECam will be comprised of 74 250 micron thick fully depleted CCDs: 62 2k x 4k CCDs for imaging and 12 2k x 2k CCDs for guiding and focus. Construction of DECam is nearing completion. In order to verify that the camera meets technical specifications for DES and to reduce the time required to commission the instrument, we have constructed a full sized telescope simulator and performed full system testing and integration prior to shipping. To complete this comprehensive test phase we have simulated a DES observing run in which we have collected 4 nights worth of data. We report on the results of these unique tests performed for the DECam and its impact on the experiments progress.Comment: Proceedings of the 2nd International Conference on Technology and Instrumentation in Particle Physics (TIPP 2011). To appear in Physics Procedia. 8 pages, 3 figure

Diazepam and its metabolites in the mothers' and newborns' hair as a biomarker of prenatal exposure

Pregnant women are exposed to benzodiazepines for therapeutic purposes during gestation. The goal of this study was to evaluate prenatal exposure to benzodiazepines. Time of exposure during course of pregnancy is a significant aspect of fetal exposure to drugs. Benzodiazepine concentration assay in hair of mothers and newborns exposed prenatally to these drugs was performed in the studies. Development, validation and evaluation of benzodiazepine determination method in mothers and their newborns enables assessment of health risks for the child and implementation of adequate therapeutic procedures. We used A LC-ESI-MS/MS method that allowed determination of diazepam (the main benzodiazepine used by pregnant women was diazepam) and its metabolites (nordazepam, oxazepam) in hair of mothers and newborns. LOQ 10 pg/mg of hair was used in the study. Results: concentration of nordazepam was higher than parent drug (diazepam) and higher in newborns’ hair when compared to mothers’. The mean concentrations of diazepam in mothers’ hair were 31.6±36.0 and 34.1±42.4 pg/mg in the second and third trimester of pregnancy respectively. The mean concentration of diazepam in newborns’ hair was higher and reached levels of 53.3±36.5 pg/mg. The mean concentration of nordazepam in the mothers’ hair corresponding to the second and third trimester was 52.9±48.1 and 89.9±122.8 pg/mg, respectively. Nordazepam in the newborns’ hair was detected at the mean level of 108.1±144.2 pg/mg. It was concluded that diazepam and nordazepam are permanently incorporated into the hair structure. Presence of diazepam and its metabolites in newborn’s hair confirms that these benzodiazepines permeate placental barrier. Segmental analysis of mothers’ hair enabled the assessment of drug administration time. Diazepam and its metabolites determined in hair of newborns may serve as biomarkers of prenatal exposure to these drugs. The performed LC-MS/MS analysis was accurate enough to determine even low concentrations of benzodiazepines, at the level of few pg/mg of hair. Levels of diazepam detected in hair of newborns were higher than levels determined in mothers. This may confirm the fact, that fetus’s ability to metabolize diazepam is scarce. Nordazepam was found in higher concentrations in hair of newborns than in hair of mothers, which may suggest that it is cumulated in child’s organism. Other metabolites of diazepam - oxazepam and temazepam - were detected in very few cases, in low concentrations

Joint perception: gaze and the presence of others

Abstract We document a new phenomenon: participants' eye movements are influenced by the belief that they are either looking at pictures alone, or that a person next door is looking at the same pictures. The pictures were in sets of four. One had a positive and one a negative valence, and others were neutral. On a trial by trial basis, eye movements to the negative versus the positive pictures were modulated by participants' belief that they were looking alone or jointly. A second experiment manipulated the beliefs participants had about the person in the next cubicle, in an attempt to tease apart possible explanations for this effect of 'joint perception'. In each case, a minimal sense of cooperation with another appears to produce distinct cognitive effects, in manner similar to that found in studies of 'joint action'. We conclude that there may be a pervasive effect of social context upon cognitive and perceptual processes

Theoretical Directional and Modulated Rates for Direct SUSY Dark Matter Detection

Exotic dark matter together with the vacuum energy (cosmological constant) seem to dominate in the flat Universe. Thus direct dark matter detection is central to particle physics and cosmology. Supersymmetry provides a natural dark matter candidate, the lightest supersymmetric particle (LSP). Furthermore from the knowledge of the density and velocity distribution of the LSP, the quark substructure of the nucleon and the nuclear structure (form factor and/or spin response function), one is able to evaluate the event rate for LSP-nucleus elastic scattering. The thus obtained event rates are, however, very low. So it is imperative to exploit the two signatures of the reaction, namely the modulation effect, i.e. the dependence of the event rate on the Earth's motion, and the directional asymmetry, i.e. the dependence of the rate on the the relative angle between the direction of the recoiling nucleus and the sun's velocity. These two signatures are studied in this paper employing various velocity distributions and a supersymmetric model with universal boundary conditions at large tan(beta).Comment: 11 LATEX pages, 1 table and 4 ps figures included. Paper presented in DARK2002, Fourth Heidelberg International Conference on Dark Matter in Astro- and Particle Physics, Cape Town, South Africa, 4-9 February, 2002, to appear in the proceedings (to be published by Springer Verlag

Dark matter and Colliders searches in the MSSM

We study the complementarity between dark matter experiments (direct detection and indirect detections) and accelerator facilities (the CERN LHC and a $\sqrt{s}= 1$ TeV $e^+e^-$ Linear Collider) in the framework of the constrained Minimal Supersymmetric Standard Model (MSSM). We show how non--universality in the scalar and gaugino sectors can affect the experimental prospects to discover the supersymmetric particles. The future experiments will cover a large part of the parameter space of the MSSM favored by WMAP constraint on the relic density, but there still exist some regions beyond reach for some extreme (fine tuned) values of the supersymmetric parameters. Whereas the Focus Point region characterized by heavy scalars will be easily probed by experiments searching for dark matter, the regions with heavy gauginos and light sfermions will be accessible more easily by collider experiments. More informations on both supersymmetry and astrophysics parameters can be thus obtained by correlating the different signals.Comment: 25 pages, 10 figures, corrected typos and reference adde

Density profiles of dark matter haloes on Galactic and Cluster scales

In the present paper, we improve the "Extended Secondary Infall Model" (ESIM) of Williams et al. (2004) to obtain further insights on the cusp/core problem. The model takes into account the effect of ordered and random angular momentum, dynamical friction and baryon adiabatic contraction in order to obtain a secondary infall model more close to the collapse reality. The model is applied to structures on galactic scales (normal and dwarf spiral galaxies) and on cluster of galaxies scales. The results obtained suggest that angular momentum and dynamical friction are able, on galactic scales, to overcome the competing effect of adiabatic contraction eliminating the cusp. The NFW profile can be reobtained, in our model only if the system is constituted just by dark matter and the magnitude of angular momentum and dynamical friction are reduced with respect to the values predicted by the model itself. The rotation curves of four LSB galaxies from de Blok & Bosma (2002) are compared to the rotation curves obtained by the model in the present paper obtaining a good fit to the observational data. On scales smaller than $\simeq 10^{11} h^{-1} M_{\odot}$ the slope $\alpha \simeq 0$ and on cluster scales we observe a similar evolution of the dark matter density profile but in this case the density profile slope flattens to $\alpha \simeq 0.6$ for a cluster of $\simeq 10^{14} h^{-1} M_{\odot}$. The total mass profile, differently from that of dark matter, shows a central cusp well fitted by a NFW model.Comment: 26 pages; 4 figures A&A Accepte