Performance Analysis of Fractionally Spaced Equalization in Non-linear Multicarrier Satellite Channels

Joint amplification of multiple carriers with a single wideband high power amplifier (HPA) has been considered towards reusing the satellite resources among multiple links to reduce the mission cost. The non-linear characteristic of the HPA, especially near saturation, coupled with the on-board IMUX/ OMUX filters result in non-linear adjacent carrier interference (ACI) and inter-symbol interference (ISI) during multicarrier power amplification. To benefit from the advantages of multicarrier transmissions, on-ground techniques to mitigate the non-linear distortions need to be devised. These techniques include predistortion at the transmitter and equalization at the receiver. Several works have considered the use of multicarrier predistortion along with single carrier equalization. A symbol synchronous equalizer, while being simple to implement, may not necessarily provide for the optimum linear filter. Towards improving the performance, fractionally spaced equalizers (FSE) have been considered. Such receivers are shown to provide enhanced performance by effectively compensating for the group delay distortions. The objective of this work is to consider the use of FSE in the context of multicarrier transmissions over non-linear channels and illustrate their performance enhancement

Multiple-input multiple-output symbol rate signal digital predistorter for non-linear multi-carrier satellite channels

Abstract: A digital predistortion (DPD) scheme is presented for non-linear distortion mitigation in multi-carrier satellite communication channels. The proposed DPD has a multiple-input multiple-output architecture similar to data DPD schemes. However, it enhances the mitigation performance of data DPDs using a multi-rate processing algorithm to achieve spectrum broadening of non-linear operators. Compared to single carrier (single-input single-output) signal (waveform) DPD schemes, the proposed DPD has lower digital processing rate reducing the required hardware cost of the predistorter. The proposed DPD outperforms, in total degradation, both data and signal DPD schemes. Further, it performs closest to a channel bound described by an ideally mitigated channel with limited maximum output power

Effect of amplifier non-linearity on the performance of CDMA communication systems in a Rayleigh fading environment

Thesis (M.Sc.Eng.)-University of KwaZulu-Natal, Durban, 2009.The effect of amplifier non-linearity on the performance of a CDMA communications syste

System Modelling and Design Aspects of Next Generation High Throughput Satellites

Future generation wireless networks are targeting the convergence of fixed, mobile and broadcasting systems with the integration of satellite and terrestrial systems towards utilizing their mutual benefits. Satellite Communications (Sat- Com) is envisioned to play a vital role to provide integrated services seamlessly over heterogeneous networks. As compared to terrestrial systems, the design of SatCom systems require a different approach due to differences in terms of wave propagation, operating frequency, antenna structures, interfering sources, limitations of onboard processing, power limitations and transceiver impairments. In this regard, this letter aims to identify and discuss important modeling and design aspects of the next generation High Throughput Satellite (HTS) systems. First, communication models of HTSs including the ones for multibeam and multicarrier satellites, multiple antenna techniques, and for SatCom payloads and antennas are highlighted and discussed. Subsequently, various design aspects of SatCom transceivers including impairments related to the transceiver, payload and channel, and traffic-based coverage adaptation are presented. Finally, some open topics for the design of next generation HTSs are identified and discussed.Comment: submitted to IEEE Journa

Satellite Communication: Key Enabling Technologies

Satellites have proven to be indispensable for universal communication networking in support of a variety of personal, commercial, and security applications. In an attempt and effort to remain competitive with terrestrial systems, in the context of increasing requirement for the future communication systems. The rapid increase of capacity of terrestrial link in terms of generations (1G to 5G in 2020) can be analogous to satellite communications. The first generation (1G) having a capacity of 5-50 Gbps per satellite, 2010-2020; the second generation (2G) satellite 50-500 Gbps, and 2020-2030; as the needs increase, for instance, as far future needs of the communication for Mars human community, this can be considered as third generation (3G) satellite 0.5-5 Tbps. SatCom are trying to follow the progress in terrestrial in such as: Multicarrier waveforms use, Full Duplex, SDN, MmWave, MIMO technology and profit from the significant research achievements in the area of multiple antenna techniques. This work presents an overview of technologies that revolution terrestrial communication systems and considered as key technologies for 5G with the possibility of its application in satellite communication

Design and Linearization of Energy Efficiency Power Amplifier in Nonlinear OFDM Transmitter for LTE-5G Applications. Simulation and measurements of energy efficiency power amplifier in the presence of nonlinear OFDM transmitter system and digital predistortion based on Hammerstein-Wiener method

This research work has made an effort to understand a novel line of radio frequency power amplifiers (RFPAs) that address initiatives for efficiency enhancement and linearity compensation to harmonize the fifth generation (5G) campaign. The objective is to enhance the performance of an orthogonal frequency division multiplexing-long term evolution (OFDM-LTE) transmitter by reducing the nonlinear distortion of the RFPA. The first part of this work explores the design and implementation of 15.5 W class AB RF power amplifier, adopting a balanced technique to stimulate efficiency enhancement and redeeming exhibition of excessive power in the transmitter. Consequently, this work goes beyond improving efficiency over a linear RF power amplifier design; in which a comprehensive investigation on the fundamental and harmonic components of class F RF power amplifier using a load-pull approach to realise an optimum load impedance and the matching network is presented. The frequency bandwidth for both amplifiers was allocated to operate in the 2.620-2.690 GHz of mobile LTE applications. The second part explores the development of the behavioural model for the class AB power amplifier. A particular novel, Hammerstein-Wiener based model is proposed to describe the dynamic nonlinear behaviour of the power amplifier. The RF power amplifier nonlinear distortion is approximated using a new linear parameter approximation approach. The first and second-order Hammerstein-Wiener using the Normalised Least Mean Square Error (NLMSE) algorithm is used with the aim of easing the complexity of filtering process during linear memory cancellation. Moreover, an enhanced adaptive Wiener model is proposed to explore the nonlinear memory effect in the system. The proposed approach is able to balance between convergence speed and high-level accuracy when compared with behavioural modelling algorithms that are more complex in computation. Finally, the adaptive predistorter technique is implemented and verified in the OFDM transceiver test-bed. The results were compared against the computed one from MATLAB simulation for OFDM and 5G modulation transmitters. The results have confirmed the reliability of the model and the effectiveness of the proposed predistorter.Fundacão para a Ciência e a Tecnologia, Portugal, under European Union’s Horizon 2020 research and innovation programme ... grant agreement H2020-MSCA-ITN- 2016 SECRET-722424 I also acknowledge the role of the National Space Research and Development Agency (NASRDA) Sokoto State Government Petroleum Technology Trust Fund (PTDF

System Modelling and Design Aspects of Next Generation High Throughput Satellites

As compared to terrestrial systems, the design of Satellite Communication (SatCom) systems require a different approach due to differences in terms of wave propagation, operating frequency, antenna structures, interfering sources, limitations of onboard processing, power limitations and transceiver impairments. In this regard, this letter aims to identify and discuss important modeling and design aspects of the next generation High Throughput Satellite (HTS) systems. First, communication models of HTSs including the ones for multibeam and multicarrier satellites, multiple antenna techniques, and for SatCom payloads and antennas are highlighted and discussed. Subsequently, various design aspects of SatCom transceivers including impairments related to the transceiver, payload and channel, and traffic-based coverage adaptation are presented. Finally, some open topics for the design of next generation HTSs are identified and discussed

Formes d'ondes avancées et traitements itératifs pour les canaux non linéaires satellites

L'augmentation de l'efficacité spectrale des transmissions mono-porteuses sur un lien de diffusion par satellite est devenu un défi d'envergure afin de pallier la demande croissante en débits de transmission. Si des techniques émergentes de transmissions encouragent l'utilisation de modulations à ordre élevé telles que les modulations de phase et d'amplitude (APSK), certaines dégradations sont encourues lors du traitement à bord du satellite. En effet, en raison de l'utilisation d'amplificateurs de puissance ainsi que de filtres à mémoires, les modulations d'ordre élevé subissent des distorsions non-linéaires dues à la fluctuation de leur enveloppe, ce qui nécessite des traitements au sein de l'émetteur ou bien au sein du récepteur. Dans cette thèse, nous nous intéressons au traitement de l'interférence non-linéaire au sein du récepteur, avec une attention particulière aux égaliseurs itératifs qui améliorent les performances du système au prix d'une complexité élevée. A partir du modèle temporel des interférences non-linéaires induites par l'amplificateur de puissance, des algorithmes de réception optimaux et sous optimaux sont dérivés, et leurs performances comparées. Des égaliseurs à complexité réduite sont aussi étudiés dans le but d'atteindre un compromis performances-complexité satisfaisant. Ensuite, un modèle des non-linéarités est dérivé dans le domaine fréquentiel, et les égaliseurs correspondants sont présentés. Dans un second temps, nous analysons et dérivons des récepteurs itératifs pour l'interférence entre symboles non linéaire. L'objectif est d'optimiser les polynômes de distributions d'un code externe basé sur les codes de contrôle de parité à faible densité (LDPC) afin de coller au mieux à la sortie de l'égaliseur. Le récepteur ainsi optimisé atteint de meilleures performances comparé à un récepteur non optimisé pour le canal non-linéaire. Finalement, nous nous intéressons à une classe spécifique de techniques de transmissions mono-porteuse basée sur le multiplexage par division de fréquence (SC-OFDM) pour les liens satellites. L'avantage de ces formes d'ondes réside dans l'efficacité de leur égaliseur dans le domaine fréquentiel. Des formules analytiques de la densité spectrale de puissance et du rapport signal sur bruit et interférence sont dérivées et utilisées afin de prédire les performances du système. ABSTRACT : Increasing both the data rate and power efficiency of single carrier transmissions over broadcast satellite links has become a challenging issue to comply with the urging demand of higher transmission rates. If emerging transmission techniques encourage the use of high order modulations such as Amplitude and Phase Shift Keying (APSK) and Quadrature Amplitude Modulation (QAM), some channel impairments arise due to onboard satellite processing. Indeed, due to satellite transponder Power Amplifiers (PA) as well as transmission filters, high order modulations incur non linear distortions due to their high envelope fluctuations which require specific processing either at the transmitter or at the receiver. In this thesis, we investigate on non linear interference mitigation at the receiver with a special focus on iterative equalizers which dramatically enhance the performance at the cost of additional complexity. Based on the time domain model of the non linear interference induced by the PA, optimal and sub-optimal receiving algorithms are proposed and their performance compared. Low complexity implementations are also investigated for the sake of a better complexity-performance trade-off. Then, a non linear frequency domain model is derived and the corresponding frequency equalizers are investigated. In the second part, we analyse and design an iterative receiver for the non linear Inter Symbol Interference (ISI) channel. The objective is to optimize an outer Low Density Parity Check (LDPC) code distribution polynomials so as to best fit the inner equalizer Extrinsic information. The optimized receiver is shown to achieve better performance compared to a code only optimized for linear ISI channel. Finally, we investigate on a specific class of single carrier transmissions relying on Single Carrier Orthogonal Frequency Division Multiplexing (SCO-FDM) for satellite downlink. The advantage of such waveforms lies in their practical receiver implementation in the frequency domain. General analytical formulas of the power spectral density and signal to noise and interference ratio are derived and used to predict the bit error rate for frequency selective multiplexers

Analytical Characterization and Optimum Detection of Nonlinear Multicarrier Schemes

It is widely recognized that multicarrier systems such as orthogonal frequency division multiplexing (OFDM) are suitable for severely time-dispersive channels. However, it is also recognized that multicarrier signals have high envelope fluctuations which make them especially sensitive to nonlinear distortion effects. In fact, it is almost unavoidable to have nonlinear distortion effects in the transmission chain. For this reason, it is essential to have a theoretical, accurate characterization of nonlinearly distorted signals not only to evaluate the corresponding impact of these distortion effects on the system’s performance, but also to develop mechanisms to combat them. One of the goals of this thesis is to address these challenges and involves a theoretical characterization of nonlinearly distorted multicarrier signals in a simple, accurate way. The other goal of this thesis is to study the optimum detection of nonlinearly distorted, multicarrier signals. Conventionally, nonlinear distortion is seen as a noise term that degrades the system’s performance, leading even to irreducible error floors. Even receivers that try to estimate and cancel it have a poor performance, comparatively to the performance associated to a linear transmission, even with perfect cancellation of nonlinear distortion effects. It is shown that the nonlinear distortion should not be considered as a noise term, but instead as something that contains useful information for detection purposes. The adequate receiver to take advantage of this information is the optimum receiver, since it makes a block-by-block detection, allowing us to exploit the nonlinear distortion which is spread along the signal’s band. Although the optimum receiver for nonlinear multicarrier schemes is too complex, due to its necessity to compare the received signal with all possible transmitted sequences, it is important to study its potential performance gains. In this thesis, it is shown that the optimum receiver outperforms the conventional detection, presenting gains not only relatively to conventional receivers that deal with nonlinear multicarrier signals, but also relatively to conventional receivers that deal with linear, multicarrier signals. We also present sub-optimum receivers which are able to approach the performance gains associated to the optimum detection and that can even outperform the conventional linear, multicarrier schemes